This report is a study in voltagelevel in connection with regeneration of brake energy from the tramtype M31 in Gothenburg.In the act of braking, the tram M31 uses electrical braking where the electrical motors generates energy and if possible send it back to the overheadline, where other trams in the nearby can use this regenerated energy for its own driving force. In cases where no other energyconsumers are located in the same section, there is a resistance witch task is to convert this energy into heat. The regulation of this resistance appears to cause an increase in the voltagelevel into far too high levels.Investigations of the trams regulationequipment and its construction have been done. Further have measurements on the overheadline been performed in order to map the voltagevariations during a longer period of time.The result have been showing that the voltagelevel during regeneration often is as high as 880V-920V, more extreme values have not been observed in a large scale. The values are especially high compared to the nominal voltagelevel.

This report is a study in voltagelevel in connection with regeneration of brake energy from the tramtype M31 in Gothenburg.In the act of braking, the tram M31 uses electrical braking where the electrical motors generates energy and if possible send it back to the overheadline, where other trams in the nearby can use this regenerated energy for its own driving force. In cases where no other energyconsumers are located in the same section, there is a resistance witch task is to convert this energy into heat. The regulation of this resistance appears to cause an increase in the voltagelevel into far too high levels.Investigations of the trams regulationequipment and its construction have been done. Further have measurements on the overheadline been performed in order to map the voltagevariations during a longer period of time.The result have been showing that the voltagelevel during regeneration often is as high as 880V-920V, more extreme values have not been observed in a large scale. The values are especially high compared to the nominal voltagelevel.

This is a graduate work at the Swedish University of Agricultural Sciences, The Department of Urban and Rural Development, Ultuna. The purpose of this paper has been to find out and describe principles for designing parks that offers good recreational and aesthetical values and require little amount of carbon dioxide emissions during their maintenance. The purpose has also been to see if it's possible to use city wastewater in some extent to assure the plants water supply and to find other means to make it less necessary to use purified water for watering. Recently made studies as well as older ones show how important green areas are in dense city structures both from a health and a climate perspective. Trees and other plants adsorbs different forms of air pollution and can also lower the temperature in the surrounding area through their transpiration.

Detta examensarbete har utförts på Sapa Heat Transfer i Finspång och har tagit upp frågan med hur den interna hanteringen av produkterna kan orsaka defekter. I arbetet har en typ av defekt undersökts särskilt och denna defekt kan ses som ett exempel. Företaget tillverkar aluminiumband till värmeväxlare, främst till fordonsindustrin. Banden levereras på rullar med en diameter upp till 1700 mm, och en bredd mellan 12 mm och 1440 mm. Syftet med detta examensarbete är undersöka en defekt som är orsakad av den interna hanteringen, det vill säga det som sker mellan produktionsstegen.

Syftet med vår studie är att undersöka de problem som kan uppstå vid en överföring av ett styrinstrument, innehållande Key Performance Indicators, från en organisation till en annan i samband med förvärv. Uppsatsen utgår från en fallstudie av ett företag i kemibranschen. I vår fallstudie använder vi ett abduktivt angreppssätt och en kvalitativ metod. I den teoretiska referensramen utgår vi ifrån teorierna om The Balanced Scorecard och Key Performance Indicators. Empiriinsamlingen har skett med semistrukturerade intervjuer..

This report is a study in voltagelevel in connection with regeneration of brake energy from the tramtype M31 in Gothenburg.In the act of braking, the tram M31 uses electrical braking where the electrical motors generates energy and if possible send it back to the overheadline, where other trams in the nearby can use this regenerated energy for its own driving force. In cases where no other energyconsumers are located in the same section, there is a resistance witch task is to convert this energy into heat. The regulation of this resistance appears to cause an increase in the voltagelevel into far too high levels.Investigations of the trams regulationequipment and its construction have been done. Further have measurements on the overheadline been performed in order to map the voltagevariations during a longer period of time.The result have been showing that the voltagelevel during regeneration often is as high as 880V-920V, more extreme values have not been observed in a large scale. The values are especially high compared to the nominal voltagelevel.

This report is a study in voltagelevel in connection with regeneration of brake energy from the tramtype M31 in Gothenburg.In the act of braking, the tram M31 uses electrical braking where the electrical motors generates energy and if possible send it back to the overheadline, where other trams in the nearby can use this regenerated energy for its own driving force. In cases where no other energyconsumers are located in the same section, there is a resistance witch task is to convert this energy into heat. The regulation of this resistance appears to cause an increase in the voltagelevel into far too high levels.Investigations of the trams regulationequipment and its construction have been done. Further have measurements on the overheadline been performed in order to map the voltagevariations during a longer period of time.The result have been showing that the voltagelevel during regeneration often is as high as 880V-920V, more extreme values have not been observed in a large scale. The values are especially high compared to the nominal voltagelevel.

AbstractThis bachelor thesis was performed at the Royal Institute of Technology in Stockholm on behalf of the Land Survey Authority. The thesis is about fish conservation and division of fishing water at official duty. It is the Land Survey Authority that examines division of fisheries, but before a case can be implemented, certain requirements must be achieved such as FBL 3:8, which prevent divisions that are deleterious for fish conservation. The purpose of this thesis is: to obtain a clearer view how FBL 3:8 should be applied in practice, how the application differs between the offices in central Sweden, and how fish care is regulated at both international and national levels.At an international level, in EU the commercial fishery is regulated through the common fisheries policy (CFP). The fisheries policy consists of a reform that will last for 10 years.

The requirements of good quality and appetizing fast food increases continuously as a consequence of a community where food is always available. The crispiness of French fries is an issue that must be considered in this context, since it tends to decrease and give the fries a soft surface not appreciated by the consumer. To prolong the crispiness, the fries can be coated by a batter, a mix of starches. The batters used often consists of modified starches, e.g. cross-linked, acetylated and dextrinizated to increase and prolong crispiness, flour to stabilize the batter and sodium bicarbonate to make the batter ?rise?.The cross-linked starch keeps the granules in a swelled state and prevents them from breaking when exposed to heat or processing: therefore, it delays the gelatinization and decreases the stickiness of the batter.

This report is focusing on problems with introducing standard enterprise resource planning systems (ERP) in businesses. A study has been carried out on a service and support department at a Swedish heat metering company, SVM North Node. The study aims to help the company become a better customer in choice and customization of a new ERP system. We make a description of the department studied and the work carried out there, on the basis of learning, knowledge and cooperation. As a final point we present some ideas on how computer systems could support their work, hoping that this will result in them making adequate demands on a new ERP system.

Delineation of recharge areas for aquifers is performed in the groundwater mapping process at the Swedish geological survey, SGU. This work is time consuming and performed manually. It is therefore desirable to develop a more general and repeatable method for defining recharge areas for aquifers.The purpose of this study was to investigate two other possible methods to delineate recharge areas for aquifers. The first method was to examine the possibility of using the topography of the bedrock to define the recharge areas for aquifers. To enable this, a method for generating the topography of the bedrock was developed.

This examination work is the final work in our education to become a Bachelor of Science inMechanical Engineering by the University of Lund.The main purpose with this work has been to develop a new effective material handling system for TPPM AB in Lund since the existing system starts to become out of date. The future system that is going to be installed shall have the capacity to support all machines with unit-, semi- and finished goods during full production. The work has also included studying the possibilities to change the material flow in a positive way between the storage and the production when one is using existing buildings.During our work we have been used a simulation program called AutoMod, performing company visits, interviews and reviewed internal and external information to create a picture of what the best conclusion can be. During the work we have contacted five suppliers to receive system solutions and quotatioris. The suppliers, which have been contacted, are Swisslog, Moving, Rocia, Christensen & Hansen and ABB.

Cuttings of Lonicera xylosteum L. were treated with willow extract to study the response in rooting capacity. The extracts were prepared by mixing chopped pieces of Salix x smithiana Willd. with water in a warring blender. The investigation comprised 2 types of salix extracts based on differences and dynamics between twigs in winter dormancy and twigs with new shoots. To explore the rooting response, three tests were made.

Simulations of simulink models using Kalman filters are often very time-consuming. This problem depends mainly on the fact that the Kalman correction has to be performed at each sample instance through the whole simulation. The goal for this thesis work is to reduce that time-consumption for the filtering part (the integration partis treated in a complementary report) of a simulation. Furthermore a Matlab routine to perform parameter tuning and finally a graphical user interface is developed.The filtering part of the simulation in this thesis is based on an Extended Kalman Filter (EKF). The time optimization of this filter considers searching for the possibility to replace the today?s existing Matlab functions that is used to perform the filtering calculations.

This report describes an analysis of WebGL together with JavaScript with the aim to examine its limitations, strengths and weaknesses. This analysis was performed by building a 2D game engine containing some dynamic elements such as water, smoke, fire, light, and more. Different algorithms have been tested and analyzed to provide a clearer picture of how these work together. The report will go through the most basic functions of the game engine and describe briefly how these work.The result shows that JavaScript with WebGL can be considered to be a potent toolsets, despite the difficulties caused by JavaScript.In summary, similar projects can be recommended as Javascript and WebGL proved both fun and incredibly rewarding to work with..