The aim of this project was to describe and to evaluate five small sewage treatment plants in the municipality of Laholm, Sweden, in order to investigate the treatment efficiency and to evaluate if effluents comply with discharge permits. The treatment systems were designed to treat effluents from 90 to 500 population equivalents. A report on the design and the present state of each sewage treatment plant has been made. This was made based upon previous documentation on water quality and by new sampling campaign as there were only a few previous measurements. Data has been evaluated and remedial actions proposed for those treatment plants that don?t fulfill discharge permits.

A wastewater treatment plant has the task to refine the wastewater from substances that should not be released into the environment. The decomposition process can, in a simple way, be described as follows: micro-organisms breathe oxygen and eat unwanted substances. The environment in which the micro-organism lives is known as sludge and the correct amount of oxygen available in the sludge is important for the decomposition to be effective. The oxygenation of the sludge alone stands for about 30% of the plant?s energy consumption.

What makes a Swede betake himself into the Chinese wilderness? How does the Rio Convention influence a plant collector? And who will crack the nut positioned 12 meters up in the crown of a tree? There are many secrets behind the act of collecting plants. In many regards, the documentation of the collection of plants for a Swedish purpose has been unsatisfactory. The focus of the publications is on what plant species that have been found rather than information on how these plants have been collected. Only few results of experimental cultivation are available. There is no doubt that there exists knowledge that has not been publicised yet.

Svensk Växtkraft is the owner of the biogas plant in Västerås. The company is planning to increase their treatment capacity at their biogas plant. In connection to this work it is also possible to make some energy saving changes to the biogas plant. The objective of this study was therefore to make an electricity and heat survey of the biogas plant, a detailed study of the heat consumption in the sanitation step and also a comparison of energy consumption with the present sanitation method and an alternative strategy where the waste is treated in 55 °C during 10 hours (the current method is heating to 70 °C during 1 hour). The energy survey was conducted in close collaboration with staff at the biogas plant. The current during normal operation was measured, power was calculated and multiplied by the time of usage to obtain the energy consumed.

Åmotfors Bruk AB (ÅBAB) has today an inefficient production of steam for the manufacturing of paper. Unpredictable energy prices and modernisation of the current equipment has been the underlying factors to invest in a thermal power plant, mainly driven by garbage. This facility will not only use the steam for paper production, it will also generate electricity through a steam turbine. Today, when a fault on the supplying line occurs which leads to disconnection of the external grid, all the support of electricity to Åmotfors Bruk (ÅB) will disappear. This will lead to major interruptions in the paper production, which will cause severe economical losses.

Helsingborg has the intention to build a train tunnel south of Knutpunkten. This report investigates the hydro geological aspects of the project. Questions at issue that will be answered: 1. Which parameters affect the groundwater level? 2. How will these parameters change within 100 years considering climate changes and what will be the consequences on the groundwater level. According to SMHI climate analysis the climate can change causing increasing precipitation, temperature, and a rising sea level.

Gunnebo House and Gardens was designed during the late 18th century by architect Carl Wilhelm Carlberg as a summer residence for the wealthy merchant John Hall Sr. and his family. The garden consists of formal garden, kitchen garden and English park. For the first two parts several original drawings have been preserved and here a lot of restoration work has been carried out. This paper aims to examine how the English park might have been implemented during John Hall Sr.?s time and to create a plant scheme for the area called ?Engelska kullen? (The English hill).

This report is about the experiments with mixing of the separated water and the vacuum pump seal water at Hellisheiði power plant. This is done to prevent silica scaling and clogging in pipes and reinjection wells as well as eliminating vacuum pump seal water from the plant. The experiments were done in four stages: the first stage comprised of tests with different flows of separated water at 70°C, the second stage was carried out by mixing the separated water at 70°C and the seal water with different amounts of the seal water, the third and the fourth stages were like the first and second but with the separated water at 120°C. The results show that this method is good if the mixture is around 50/50 separated water and seal water, to control the silica scaling in the separated water and to be able to reinject the seal water with the separated water. This does not eliminate the silica scaling in all of the separated water because the amount of separated water is much more than the amount of seal water that comes from the plant. .

A piezoelectric injector was modeled, in this Master Thesis Project which was carried out at Scania CV AB in Södertälje, in GT-Fuel. GT-Fuel is simulation program from Gamma Technology.The simulation model for the piezo injector was divided into a hydro-mechanical system and an electrical system (Piezoelectric element). First the hydro-mechanic model was duplicated from Advance Continuous Simulation Language model (ACSL). The simulation results were then compared to the ACSL, to verify that the hydro-mechanical system was modeled correctly. The simulation results for the electrical model were also compared with a Simulink model.

This study analyses the economic consequences due to ethanol production in Eastern Sweden. The analyses consider the cooperative and the farmers as one vertically integrated company. The area that found the market in this study is illustrated in figure 1. The analyses assume that all members act jointly with the objective of maximizing joint profits at the farm level as well as at the cooperative firm. A mathematical model is created to calculate the optimal use of arable land.

Today produces the wind power 2,5 TWh (TWh = terawatt hours) of Sweden?s total energy input of around 620 TWh. The Parliament has adopted a national planning objective where the wind-based electricity production will increase to 30 TWh in 2020. This requires that landowners will leas there land for wind power to wind energy companies. Such land leasing means that the landowner's business is considered to be a multiple-use.

In order to maintain a high safety level at a nuclear power plant it is important not only to measure the reliability of the components and systems of the plant, but also to investigate how the plant responds to human actions. One of the most hazardous situations in managing a power plant is fire occurring in critical areas. This study concerns the prospect of the local fire brigade to suppress a fire that has started in one of the most critical rooms for maintaining high reactor safety. The model created gives an indication on the possibilities of succeeding in suppressing a fire. In order to get a more reliable fire fighting the following advice are given:- Let the fire brigade go rounds in the plant together with the personnel, during which recommended fire suppressing methods are determined to avoid long preparation time in an actual situation.- Prepare rooms with two subsystems to make them partly with no voltage.- Give the fire brigade better feedback from actual events on nuclear power plants.- Education and training in suppressing fires in electrical equipment.The probabilistic safety assessment strives to be as realistic as possible.

The purpose of this master thesis is to investigate how nearby forests affect the energy production in wind turbines. To reach the purpose a case study is performed on three wind turbines sited on a field in a north-south line at Andersfält in the municipality of Halmstad, Sweden. Approximately 100 meters south of the southern wind turbine a forest is situated. The case study is divided into three sub studies where the difference in energy production, the affect of the forest and a wind meteorology model, WAsP, is studied. The result show that the forest have a significant influence and that the WAsP-model gives an incorrect result of the energy production in wind turbines sited near a forest..

This study presents a methodology that enables the annual average power of a wind turbine to be increased by automatically optimizing it?s airfoil, twist and chord dis- tribution. As a part of the study the software SiteOpt has been developed. This software connects the open source software XFOIL with the blade element momen- tum theory. XFOIL gives lift and drag coefficients which enable the blade element momentum theory to predict the power of a wind turbine at different wind and ro- tational speeds.

The project contains a force analysis of the vertical axis wind turbine Lucia's supporting arms and a measuring device to experimentally measure the forces is made. The forces between the supporting arms and the tower are calculated theoretically and then simulated by a computere. A measuring devise is then designed to measure the forces experimentally. The forces acting on the attachment between the supporting arms and the tower is primarily the centripetal force, gravitational force and the aerodynamic forces on the rotor wings. The maximum forces were theoretically calculated and is 13.38 kN along the x-axis, -0.25 kN along the y-axis and then 0.5 kN along the z-axis.