Meat and fish was the most important food for the Sami people in northern Scandinavia until the beginning of the 20th century. It is not so well known that the Sami people also used a lot of wild plants as food and medicine although that kind of food was relatively common among them until the end of the 19th century. The purpose of this master thesis has been to describe which plants the Sami people used in general and also which plants were the most commonly used, and when and how these plants were harvested. I also wanted to measure the quantities of Angelica archangelica and Rumex acestosa within traditional harvest sites. Furthermore I wanted to find out if the plant use differed among Sami groups geographically.

The jetengines of today are growing in complexity. Reliability for aircraft engines are of extreme importance, mainly due to safety reasons but also economical ones. This master thesis deals with faultdiagnosis in the turbine section of RM12, the engine used in Saab/BAe's Gripen. Three different faults which can occur in the turbine section was studied. These faults are: clogged fuel nozzle, hole in outlet guide vane and sensor fault.

This study deals with the technical and economic feasibility of replacing the nuclear power plant reactor Ringhals 3 with a biofuel power plant. A technical investigation has been executed to determine which of the systems and components that could be reused and which ones would need to be replaced. The investment costs of the reconstruction have also been estimated. The cost of the electricity production has been calculated as well as the emissions of the new biofuel power plant. Based on the established rate of return, the lowest average spot price of electricity that makes the investment profitable has been calculated.

This study was carried out as a commission from Holmen Skog, district ?Egen skog? in Norrköping. During October 2006 several stands were inventoried by aerial photos from helicopter. The stands were those for which the next action proposed was plant inventory or plant check. The photos were interpreted and the number of stems was calculated.

With background in the rapidly growing need to find solutions for sustainable energy production and the increasing interest for wind power, this report was written. With take-off point from the wind power plant Big Glenn, which has been built in the harbour of Gothenburg, a model of the adjacent power grid has been created in Simulink/SimPowerSystems. Parameters for the power grid and its components has been provided by Göteborg Energi Nät, that has also been the supplier of measurement data of produced power, the power need from loads in the vicinity, voltage levels, current values and also the variation of power factor at the wind power plant.The SimPowerSystems model has been used to perform simulations of power flow in the grid. These simulated values have then been compared to the measured values to verify the functionality of the model. Further, the model has been used to perform simulations of a grid fault, which causes a voltage drop.

With background in the rapidly growing need to find solutions for sustainable energy production and the increasing interest for wind power, this report was written. With take-off point from the wind power plant Big Glenn, which has been built in the harbour of Gothenburg, a model of the adjacent power grid has been created in Simulink/SimPowerSystems. Parameters for the power grid and its components has been provided by Göteborg Energi Nät, that has also been the supplier of measurement data of produced power, the power need from loads in the vicinity, voltage levels, current values and also the variation of power factor at the wind power plant.The SimPowerSystems model has been used to perform simulations of power flow in the grid. These simulated values have then been compared to the measured values to verify the functionality of the model. Further, the model has been used to perform simulations of a grid fault, which causes a voltage drop.

This study has investigated how urban vegetation can be used in a multifunctional way to support ecosystem services in urban environments. Nacka municipality is in the start-up phase of building what is to become Nacka city. This provides a unique possibility to study and analyse what role the vegetation play in making the city a healthy living environment and how it needs to be adapted in order to be resilient against changing climate conditions and how the effects of those changes can be regulated. The study further investigates how airborne pollution, caused by urbanization processes, can be regulated or reduced by vegetation or species selection. Methods used in this study were a combination of qualitative interviews and literature studies, seeking to answer the questions: Which specific ecosystem functions are needed in the urban environment and which aspects will influence the ecosystems ability to deliver the functions in demand? And which plant species have the right mechanisms needed to deliver those functions? These questions have been studied and analysed in a local based context where the local conditions ands site specific needs of Nacka define criteria for plant selection.

The building and plant sectors represent a large part of Sweden?s energy use. Putting energy requirements in public procurement as a tool for reducing energy consumption in the building and plant sectors is therefor an opportunity that operators can take advantage of. The aim of this thesis was to map the energy requirements in procurement that operators in the public sector use today in building and plant projects. The analysis was made with respect to if the energy requirements corresponded to the parts with large energy use in building and plant projects and also in which way energy requirements in procurement are written in the contract.

In this study potential health risks for employees in connection with handling of bottom ash and bottom ash water at a Municipal Waste Incineration (MWI) plant have been investigated. Air surrounding the bottom ash and the bottom ash water has been examined. MWI is one of the primary ways to manage solid household waste, and bottom ash is the main solid residue produced by the incineration process. Bottom ash constitutes about 15-20% of the original waste. The bottom ash is extinguished in a water bath (bottom ash water).The study was carried out in a MWI plant in Karlstad, Sweden.

This paper evaluates the prospects for utilizing aquaculture effluents as a nutrient source in organic hydroponic, as is the case in aquaponics. The development of organic hydroponics is dependent on replacing synthetic fertilizers with organically derived nutrients, such as those found in aquaculture effluents. Also, in hydroponic cultivation the establishment of a plant pathogen suppressive micro flora is part of the plant protection strategy. Therefore, both nutritional and microbial qualities of aquaculture water and organic hydroponic nutri-ent solution were analyzed and compared. Results showed both aquaculture water and or-ganic hydroponic solution to be deficient in a number of essential elements, although or-ganic hydroponic solution was closer to recommendations.

A third party access to district heating networks has been proposed in Sweden, to increase the competition on the district heating market. Such third party access could create opportunities for the agricultural sector as an energy producer. This study describes the technical, economical and environmental prerequisites for a farmer cluster to build and run a heating plant, fueled with local wood fuel. The heating plant in the described scenario is 8 MW and will supply a village of 1000 houses, and is fueled with wood chips exclusively. Supplying a heating plant with fuel puts high demands on the logistics, since there need to be a continuous flow of fuel. In the scenario, wood residues from felling and thinning is stored in stacks in the forest, and a few times a year chipped and transported to a storage area at the heating plant. In the study, an estimation of the profitability has been made by estimating the cost of the investment, personnel, operating and maintenance costs and costs for the fuel and ash handling.

This master thesis comprises analysis and dimensioning of a keyed joint between a generator axis and a hub with aid from the FEM-software ANSYS Workbench 13.0.The generator axis is a part of a hydroelectric power station that generates electricity with a reactions turbine, a Kaplan turbine. The existing keyway consists of one parallel key with the width 90 mm and height 45 mm. Due to a planned increase of the power of the generated power with 32 % a design study was needed to see if the keyed joint would be suitable for the extra force. Because of the fact that the axis diameter is bigger than the standards covers/recommends a the keyway had to be re-dimensioned. In an earlier assignment from Skellefteå Kraft AB to Sweco Energuide the keyway was planned to be properly dimensioned, but no final solution was approved.During this master thesis a number of different numerical tests were made.

This master thesis comprises analysis and dimensioning of a keyed joint between a generator axis and a hub with aid from the FEM-software ANSYS Workbench 13.0.The generator axis is a part of a hydroelectric power station that generates electricity with a reactions turbine, a Kaplan turbine. The existing keyway consists of one parallel key with the width 90 mm and height 45 mm. Due to a planned increase of the power of the generated power with 32 % a design study was needed to see if the keyed joint would be suitable for the extra force. Because of the fact that the axis diameter is bigger than the standards covers/recommends a the keyway had to be re-dimensioned. In an earlier assignment from Skellefteå Kraft AB to Sweco Energuide the keyway was planned to be properly dimensioned, but no final solution was approved.During this master thesis a number of different numerical tests were made.

The upstream spawning migration of Atlantic salmon (Salmo salar) at the confluence area between the power-station outlet and the bypass-channel in river Umeälven (flow 430 m3s-1) was compared in 2004 and 2005, two years with different experimental flow-regimes. In 2004 the water flow in the bypass-channel was altered during the day with increased flows during the nights while the water flow in 2005 mainly was altered between the weekdays and weekends. Salmon showed altered migratory behaviour in this confluence area, assessed with telemetry (n=116) and echo-sounding, with up- or downstream responses depending on flow-changes in both the bypass and the power station outlet. Increased turbine flow through the power-station generally attracted salmon into the tunnel outlet area while increased spill-flows facilitated salmon to enter the bypass. Echo-sounding in the confluence area showed an increased swimming activity up- and downstream due to time in the day and flow-rates through the tunnel outlet. No changes in activity could be detected due to increasing or decreasing flow through the hydro-power facility.

This paper appeals to professionals working with green questions. It intends to create a discussion about which plant species that can be established in a fieldlayer of a naturelike planting on fertile agricultural land. To initiate the essay, a studie of which values that can be connected with an establishment of a fieldlayer was performed . A part of Tor Nitzelius Park in Alnarp, a so called naturlike planting on fertile agricultural land, was used as a model for the choice of species. With the aid of soil values, photos and a list of current species, interviews with four ecologists were performed.