Hypothermia during anaesthesia is a well-known phenomenon that may cause several side-effects such as greater risk of postoperative wound infection and increased risk of heart complications. The most efficient way to avoid this is to prevent hypothermia from occurring. The aim of this paper was to compile the research on the most efficient way to prevent hypothermia during anaesthesia for cats and dogs, and to compare these results to how Swedish animal hospitals prevent hypothermia today. To investigate this, a survey was sent out to several animal hospitals around Sweden to see what methods they used to prevent hypothermia in their clinics. It is difficult if not impossible to prevent the body temperature from falling slightly when anaesthesia is induced because of the drug interactions in the body that follow from the drugs given. A 1-1,5°C decrease in body temperature is to be expected and is difficult to avoid.

This report is a study in voltagelevel in connection with regeneration of brake energy from the tramtype M31 in Gothenburg.In the act of braking, the tram M31 uses electrical braking where the electrical motors generates energy and if possible send it back to the overheadline, where other trams in the nearby can use this regenerated energy for its own driving force. In cases where no other energyconsumers are located in the same section, there is a resistance witch task is to convert this energy into heat. The regulation of this resistance appears to cause an increase in the voltagelevel into far too high levels.Investigations of the trams regulationequipment and its construction have been done. Further have measurements on the overheadline been performed in order to map the voltagevariations during a longer period of time.The result have been showing that the voltagelevel during regeneration often is as high as 880V-920V, more extreme values have not been observed in a large scale. The values are especially high compared to the nominal voltagelevel.

Too high levels of noise lead to various health problems and cost society billions of SEK peryear. In this thesis we have examined a model of the A40E articulated hauler at VolvoConstruction Equipment in Braås. We have tried to reduce cabin noise in an articulated hauler,while also providing a way on how to proceed with a machine when the cabin does not measureup to the sound requirement. The best way to find leaks were with a reference source of model4205 and its speaker HP 1001 from Brüel & Kjaer in the cab and then walk around and listen towhere the reference source was more prominent. In this way, we found that the edges and theplugs were sensitive areas.

Global warming is a huge issue that humans have contributed to through over-exploitation of natural resources and extensive usage of fossil fuels. Now more than ever, we need to embrace a recycle thinking and reuse our waste, for example through producing biogas from our food waste. The purpose of this report was therefore to identify the energy usage and emissions resulting from the biogas chain which spans from Solna Stad to Uppsala Vatten. Furthermore, potential efficiency improvements were to be identified and proposed. This report focused mainly on the first part of the biogas chain that includes the collection of the food waste and the reloading process.

This thesis has been done in order to ease the process of drawing schematics ofelectrical wiring. The need arose after demand from the government due to a seriesof incidents that took place during the revision of the nuclear power plant in year2009.The task of the project has been to create a computer program that can generate agraphical representation of the electrical components relations. The basis for theprogram has been an example of how the client wants the graphical representation tolook. During the course of the project weekly meetings have occured in which theclient has reviewed the work.The result of the project is a program written in Visual Basic Applications that can berun in Microsoft Excel. The program is capable of generating graphics for a majority ofthe cases.

In this study potential health risks for employees in connection with handling of bottom ash and bottom ash water at a Municipal Waste Incineration (MWI) plant have been investigated. Air surrounding the bottom ash and the bottom ash water has been examined. MWI is one of the primary ways to manage solid household waste, and bottom ash is the main solid residue produced by the incineration process. Bottom ash constitutes about 15-20% of the original waste. The bottom ash is extinguished in a water bath (bottom ash water).The study was carried out in a MWI plant in Karlstad, Sweden.

Abstract In high voltage substations there is an increasing demand for computerized equipment, and automation of operation and supervision. The future primary equipment will provide the possibility to collect more information and to provide better control for improved effectiveness. Since ABB has got a large customer target, each product must be custom made to fulfil the customers (often from different countries) demands. Later these products will be configured by engineers who may not be familiar with the tools used at ABB. This is a very expensive and time consuming.

This thesis has focused on digital born personal archives; how they are different from analog paper archives and possible ways to overbridge these differences. It is also studied how archivists and librarians are dealing with digital archives, what they think about new proactive solutions when collecting private papers and collections and positive and negative effects with this way to work. The thesis is delimitated to only private collections and digital created material. It do not concern digitized material or electronic documents in government or business organizations.The challenges in digital curation and administration are discussed in aspect of the Records Continuum Model. The empirical material is also put in relation to research in Personal Information Management and identity theory.

This master thesis investigates quality procedures and measuring of solid carbide end mills, with the main focus on measuring equipment. The thesis has been written in collaboration with a special production department for solid carbide end mills at Sandvik Coromant in Gimo. The department?s needs and constraints have been the foundation of the project and the main research question is: how to measure end mills in order to ensure good quality of the produced end mills. The project has contained both a theoretical study consisting of a literature review and practical studies in the workshop with the objective to identify an end mill?s main parameters and the relationship between an end mill?s geometry and the manufacturing processes.

This degree projekt deals with Skanska´s safety at the construction site with focus on personal safety equipment. The purpose of this dissertation is to examine how the rules of personal safety equipment are applied and experienced at Skanska´s construction sites.In October 2004 Skanska started a projekt to make the construction sites more safe. With use of a questionnaire we have made a survey at different construction sites. 80 questionaires have been handed out to Skanska´s employees in the southeast region. While they were handed out we conrolled if the employees at Skanska´s construction sites used head protection, easy visible clothing, safety shoes and identification cards.The result of the survey shows how the rules are applied.

This master thesis is a study of a new electronic library reference service-project called Speak instantly to a librarian and the purpose of the thesis is to investigate a new electronic reference service and how the librarians who work with it experience it. This should be seen from an informational society point of view. The study is conducted from two questions: - What needs do the libraries have and how do they argue for the project and the chat-reference service Speak instantly to a librarian? - How do the librarians experience the personal work situation in the new reference service, and its use of chat technology? Together with interviews of a selected group of librarians from the public libraries of Göteborg, Malmö, Nacka and Stockholm, this thesis includes aspects such as the theory of the informational society by Manuel Castells, as well as literary studies of the history of library reference, the development of electronic reference service and the virtual library, and the background and the beginning of the studied project Speak instantly to a librarian. The thesis also contains an overlook of other similar library projects in the United States of America.

In order to maintain a high safety level at a nuclear power plant it is important not only to measure the reliability of the components and systems of the plant, but also to investigate how the plant responds to human actions. One of the most hazardous situations in managing a power plant is fire occurring in critical areas. This study concerns the prospect of the local fire brigade to suppress a fire that has started in one of the most critical rooms for maintaining high reactor safety. The model created gives an indication on the possibilities of succeeding in suppressing a fire. In order to get a more reliable fire fighting the following advice are given:- Let the fire brigade go rounds in the plant together with the personnel, during which recommended fire suppressing methods are determined to avoid long preparation time in an actual situation.- Prepare rooms with two subsystems to make them partly with no voltage.- Give the fire brigade better feedback from actual events on nuclear power plants.- Education and training in suppressing fires in electrical equipment.The probabilistic safety assessment strives to be as realistic as possible.

The purpose with this thesis is to analyse different factors that can explain district heating prices for energy companies in Sweden. We are further interested in examining if the prices is affected by the use of industrial waste heat in their production and the company?s ownership structure. The method applied is a multiple regression analysis using a panel data set of 50 companies over 5 years (2008-2012). The data used is yearly data obtained from the Swedish district heating association.

This report is a study in voltagelevel in connection with regeneration of brake energy from the tramtype M31 in Gothenburg.In the act of braking, the tram M31 uses electrical braking where the electrical motors generates energy and if possible send it back to the overheadline, where other trams in the nearby can use this regenerated energy for its own driving force. In cases where no other energyconsumers are located in the same section, there is a resistance witch task is to convert this energy into heat. The regulation of this resistance appears to cause an increase in the voltagelevel into far too high levels.Investigations of the trams regulationequipment and its construction have been done. Further have measurements on the overheadline been performed in order to map the voltagevariations during a longer period of time.The result have been showing that the voltagelevel during regeneration often is as high as 880V-920V, more extreme values have not been observed in a large scale. The values are especially high compared to the nominal voltagelevel.

The purpose of this thesis has been to determine experimentally how good a peltierelement is to convert waste heat from wood burning. Three different peltier elementswere used in a comparison study. The comparison was mainly done to know howmuch power could be obtained from each element. Even, a circuit with a step-upfunction has been created to give a higher output voltage than the peltier elementitself. The result of the experiments was a low output power, the highest valuereached 2.18W.