Sökresultat:
9518 Uppsatser om Test driven development - Sida 8 av 635
Öppna test ja?mfo?rt med blindtest : Hur pa?verkas lyssnarens bedo?mning?
Denna underso?kning so?ker ett svar pa? hur den relativt vana lyssnarens bedo?mning av ljudkvalitet pa?verkas av ett sa? kallat o?ppet test, da?r det som bedo?ms a?r ka?nd fo?r lyssnaren, ja?mfo?rt med ett blindtest, da?r detta objekt a?r oka?nt. Fra?gan appliceras pa? kvalitetsbedo?mningen av digitala kodningstekniker, d.v.s. hur lyssnaren pa?verkas av att valet av kodningsteknik som avlyssnas a?r ka?nd eller inte.
Undersökning av artikulation, nasalitet och förståelighet hos 16- och 19-åringar födda med isolerad gomspalt
This study highlights the differences in articulation, nasality and intelligibility between twenty 16-year-olds and thirteen 19-year-olds born with isolated cleft palate and control groups. The test groups are compared in a longitudinal perspective and based on earlier evaluations of velopharyngeal impairment. Significant differences were found between test groups and control groups using quantitative comparisons based on SVenskt Artikulations- och Nasalitets-TEst and NasometerTM. The longitudinal comparison also showed a positive but not significant development of the speech. Differences emerged in the comparisons based on velopharyngeal impairment but no significance analysis was made.
Dolls 4R: Ett mått på kunskapsutveckling? : En studie om bedömning av studentens kunskapsutveckling
Aim: The aim of this study was to examine a way to measure students? knowledge development by using a self-made measure instrument based on William Doll?s postmodern curriculum.Question: Is it suitable to use an self-made measure instrument based on William Doll?s post-modern curriculum theory to measure development of knowledge?Methods: The study was based on process-hermeneutics and was focused on analysingcollege students? written and oral reflective thoughts. The data was collected over three lessons, where six students? written reflective thoughts were handed in. An observation was carried out each lesson for an extra control of validity.
Vinnare och förlorare på biståndsarenan? : En analys av EU:s biståndsflöden
Aid effectiveness is a reoccuring theme in the social sciences. Maybe rightfully so, as development is slow in many parts of the developing world. Core literature on the matter seems to suggest that aid effectiveness is contingent on recipients? level of corruption. Assuming this to be true, I examine the EU?s disbursements of Official Development Assistance over the past decade by running regressions: is there a relationship between the level of aid received, and a country?s level of corruption? As the EU is one of the largest donors of foreign aid globally, and has the power to shape the global foreign aid agenda, this question puts to the test whether the EU is leading the way, or rather is an obstacle in front.
Företagens aktuariella antaganden - vilka faktorer påverkar dem?
The purpose of our essay is to study the institutional-, demographic and accounting theoretical factors that influence an organisations actuarial commitment.The research was performed through a web based survey, with complimentary telephone interviews, directed to companies listed on Stockholm Stock Exchange A- and O-list on the 30 of November, 2003.Our data was analysed with a Median test, Kolomogorov-Smirnov test, T-test and a Mann-Whitney test. The purpose of the Mann-Whitney test was the low number of respondents that took part in the research. The Kolomogorov-Smirnov test was done to determine whether the population variances was equal or not. The data showed that organisations with a majority of female employees assume a lower salary increase, and a higher average age than other companies with a male majority. Only 2 of 11 hypothesis can be accepted as temporary truths but several other visible relations are indicated in our research, but can not be statistically proved.We think that the major problem with our is the time it was performed.
Automatisk nivåreglering av strålkastare
To be allowed to sell Z-suspended vehicles with dipped beam Xenon or LED lighting, Scania have to develop automatic headlight level control. This master?s thesis aims to be the foundation to that development.The thesis consists of several parts; a market analysis of how competitors to Scania and the general vehicle industry solve this problem; several available principles for detecting the amount of control needed; the construction of a test station for sensors, a control unit and components connected controlled by the control unit; a further theoretical and practical development of one principle ? one rotational sensor connected between the chassis and the back drive axis; a state flow model programmed in Simulink that produces the control signal for the headlight leveling from the sensor input.Lastly the thesis gives some recommendations to the further development and implementation of automatic headlight level control on Scania vehicles..
Server Message Block : En undersökning av potentiella prestandavinster mellan SMB 2.1 och SMB 3.0 i ett befintligt nätverk
Examensarbetet behandlar en jämförelse av Server Message Block 3.0 och föregångaren 2.1 i ett befintligt nätverk. Jämförelsen utfördes i fyra laborationsmiljöer bestående av fyra operativsystem: Windows Server 2008 R2, Windows Server 2012, Windows 7 ochWindows 8. Sammanlagt har fyra tester utförts: Förstudie, Test 1, Test 2 och Test 3. Förstudien utfördes för att testa nätverksprestanda mellan två datorer. De andra testerna satte SMB 2.1 och SMB 3.0 på prov.I Test 1 ansågs SMB 3.0 prestera sämre än SMB 2.1, för att bekräfta resultaten kontaktades Jose Barreto på Microsoft.
Konstruktion och byggnation av testfixtur för 10Gbit/s transpondermoduler
This thesis for the Master of Science degree was performed at Solectron Corporation in Norrköping. The background for the thesis was a need to develop and build two test fixtures to automatize testing and adjusting of transmitter modules (TX-fixture) and receiver modules (RX-fixture) which are head devices in DWDM-systems. The basic elements for the test fixtures are: Test board, switch board and DC/DC board. The main function of the test board is to handle communication between the transmitter and receiver modules and supply voltage to these modules. The test board was insufficient and modified with a microprocessor to handle the communication between the PC and the receiver module.
Test och verifiering av en ny inkapslingsmetod för SiC BJT och MOSFET
The use of silicon carbide (SiC) as a base material in power electronics has manyadvantages, including high breakdown voltage and excellent temperature endurance.However, the packaging of such electronics presents major challenges and there is aneed for packaging that can operate in higher temperature. The purpose of this thesishas been to develop a test method and verify the functionality of SiC powertransistors prototypes with a new packaging technique developed by Swerea IVF AB.It includes setting up an electrical test-bed for power and high temperature cyclingand analysis of the results. Even though test confirmed functionality after thepackaging process, (at room temperature) the performance seemed to have been reduced. This could be a result of the measurement setup and the packaging process.In higher temperature the transistors failed to operate longer than a couple ofminutes which showed the weaknesses in the design and the challenges with this typeof packaging..
Lokal demokratiutveckling - En studie om demokratiutvecklingens orsaker och förutsättningar i Hallands kommuner utifrån ett deltagardemokratiskt perspektiv
The aim of this essay is to study the development of democracy in the Halland province, with focus on participating measures. First and foremost to test earlier research about the causes of the development of democracy, which says that the work takes place with obvious variation between the municipalities and that it is caused by economic resources and experienced problems in the democracy. The purpose is also to conduct a general discussion about the conditions and effects of the development.Thus the method can be characterised as theory consuming because I as far as possible assume the method that has been used in earlier research. Still, my study is limited to the six municipalities of the Halland province and is therefore a study of few cases. One person in each municipality has been interviewed in order to collect a list of all the measures that have been carried out.
Demonstratortest av gassensor baserad på tryckt organisk elektronik och jonledande papper
Researchers at Karlstad University have developed a method for making paper ion conducting. The reasearchers want to test this technique in various applications and produce products that make use of the ion-conducting paper. Hopefully this will drive the development forward and result in new applications for the ion-conducting paper.This study was to test the possibility of manufacturing a gas sensor of conducting paper along with electrodes of conductive polymers printed on the paper. By comparing the paper sensor with an electrochemical cell in which the electrodes of conductive polymer replaces electrodes of metal and ion-conductive paper replaces the liquid electrolyte in the electrochemical cell, it was hoped that it would be possible to measure the oxidation and reduction reactions that a gas could introduce at the electrodes.It was shown that it is possible to measure a potential difference in the range of 0.3 V to 0.5 V between the electrodes when exposing an electrode to 100% oxygen. The reaction that takes place is relatively slow and the reaction rate is partly due to the distance between the electrodes.Since the sensor can measure oxidation and reduction reactions it is possible that, in further development of a sensor, the sensor can be made ??into a versatile sensor with more applications than gas measurement as there are many more ways to oxidize or reduce the electrodes than by exposure to oxygen.During the study there have been discussions and meetings held with various companies in the sensor industry to be able to specify what the market demands of a sensor made ??of paper and the requirements that must be placed on the sensor for it to be interesting for the companies..
Ideella drivkrafter, en studie av Rädda Barnen och Hungerprojektet
Civil society is facing many challenges in modern society and there is a lot of debate about where it is heading - is volunteer work declining or just taking a new form Whichever hypothesis will prove correct in the future, organizations that are dependent on volunteers will need to adapt to the new circumstances. This study aims to examine what forces drive voluntary work at Rädda Barnen (Save the Children Sweden) and Hungerprojektet (The Hunger Project Sweden). Through interviews with employees and volunteers at the two organizations, this study finds that volunteers at Rädda Barnen are primarily driven by values and understanding, and that the volunteers at Hungerprojektet are primarily driven by career and to some extent by values, enhancement and social factors. Understanding these driving forces allow the organizations to adapt to the new circumstances by matching the volunteers interests with the organizations' needs..
Utprövning av Fem Till Femton-formulärets småbarnsversion för utredning av barns utveckling och beteende i åldrarna 25?40 månader
The main purpose was to develop norms for the Five to fifteen questionnaire ? toddlers? version (FTF-S) in children aged 25?40 months. Apartial aim was to validate the language domain of the FTF-S against the linguistic scale in the test Bayley Scales of Infant Development ? thirdedition (Bayley-III). Another partial aim was to analyze parents' experiences of the FTF-S in order to provide suggestions for further development.
Konstruktion av styrelektronik till testfixtur
The focus of this thesis is primarily in electronic construction and describes the design process for a microcontroller circuit board from concept development to prototyping. The client develops test fixtures for automated testing of products within the electronics industry and needs a new controller circuit for the test fixtures that can handle controls and basic testing. An investigation into the needs of such a system is conducted and a prototype printed circuit board assembly is manufactured.The prototype is developed with focus on protection against electrostatic discharges and overvoltage. Among the functions that are included are voltage measurements, communication interfaces and control of input and output currents. Firmware for the prototype is developed and configured to communicate with a PC through USB interface for control and collecting of measurements..
Repeterbarheten hos Schirmer I test
Syfte: Syftet med den här studien var att undersöka repeterbarheten hos Schirmer I test samt att undersöka om det fanns något samband mellan Schirmer I test och enkäten TERTC-DEQ.Metod: 26 personer deltog i studien. Innan första mättillfället fyllde försökspersonerna i ett informerat samtycke och enkäten TERTC-DEQ. De undersöktes med hjälp av ett biomokroskop och deras ögon graderades med hjälp av Efron och CCLRU grading scales innan första mättillfället. Schirmer I test mättes vid tre tillfällen med en veckas mellanrum.Resultat: Resultatet av mätningarna visade att det var låg repeterbarhet hos Schirmer I test om man utför tre upprepade mätningar. Resultatet visade också en korrelation mellan testresultaten och enkäten TERTC-DEQ (r=-0,6184), det vill säga de försökspersonerna som hade ett högt resultat på Schirmer I test hade också en låg summa på enkäten TERTC-DEQ.