The increase of complexity in embedded programming is forcing the development of higher level programminglanguages. These languages not only consist of traditional text based programming but also with graphical programminglanguages such as the programming language G from LabVIEW which is developed by National Instruments and havebeen around since the mid eighties. However since 2004 this language has also been able to program embeddedhardware, using the modules LabVIEW SDK and LabVIEW for ARM. This thesis shows how LabVIEW for ARM converts itsgraphical language G to C and then how C is flashed into the microprocessor. The thesis also takes up the pros and consof using G for embedded development.

This master thesis is an in-depth study of an existing heating system at a household cooperative in Uppsala that has been converted from district heating to a bedrock heat pump system. The study focuses on an economical system optimisation of the building?s complete heating system. The aim was to determine how well a heat pump system in large buildings actually work, find out possible ways to optimize the existing system and point out important system parameters for new heat pump installations in larger buildings.The project points out a possible energy cost reduction of 45 % without investment and further cost reductions with equipment investments. A reduction by 30 % is possible by improvements in the regulation system and 15 % is possible by maintaining the brine system.

The Internet has developed into a marketplace for national and international companies. With relatively small means, a company can reach out to millions of people on a daily basis by placing itself on the Internet. With this report, we wish to suggest how e-businesses can change its strategy to adapt to the new market. Focus is on the Swedish Internet market where Swedes, resident in Sweden, trades with Swedish e-companies active within the Swedish borders. To be able to make suggestions, we will first paint a picture of the Swedish e-commerce market from statistics collected from public sources.

During the last years, the importance of sourcing in firms has increased. Globalization, fierce competition and an increased level of outsourcing are common explanations to why firms have highlighted the potential to realize savings and the value creation that the Purchasing department can generate. One trend that follows in parallel with globalization is an increased pressure from society on firms to take responsibility for the impact that its products and services have on the environment. This responsibility creates even more attention as outsourcing involves trade with suppliers in low wage countries, where the level of environmental and social responsibility is not always satisfying. The Purchasing department, the firm?s interface with suppliers should therefore, together with the firm?s Environmental department, play a key role in the firm?s contribution towards sustainable development.

It has become more common for organization to operate a lot of projects at the same time. These projects affect each other, either in way of resources or technical. Projects in a multi-project environment depend and affect each other, and in most cases they rival about resources, decision-makings and priority. To lead a project portfolio with several projects is a major challenge. The most common problems that occur are vague objective, unclear working conditions, resource shortage and problems of priority.

The goals of this essay are to identify rituals and ritual behavior at the department of archaeology and ancient history at Lund University. To do this a series of empirical examinations was conducted. Observations, interviews and polls revealed that some ritual behavior is in fact present. Two types of rituals were identified; the interaction ritual, as presented by Erving Goffman in the book Interaction Ritual, Essays on Face-to-Face Behavior, in 1967. The second type of ritual is a ?problem solving? ritual, such as meetings.

Diabetes is a widespread disease, which is increasing in the Western World and even in the developing countries. This entail an increasing strain on the medical service when to nurse and treat patients with diabetes type 2. To support and empower the patients in their choices, which will affect them for life, is a challenge to the nurse. The nurse is an important character in nursing care when patients take a more active part in treatments. The aim of this literature review was to exam the factors, which influence diabetes care.

The purpose of the study was to find out how teachers in a school in Kenya conducted the education of mathematics in standard 4-6. The focus was how the teachers worked with children in need of special support in mathematics.To find out the purpose a case study was made with two interviews and seven observations with four teachers on a rural school in Kenya. The following issues were: Which standards were there in the classrooms during lessons in mathematics in Kenya? How did the teachers express the view of children in need of special support? The main conclusion was that different teachers teaching in mathematics looked the same.The teacher was standing in front of the blackboard where the teaching occurred and the pupils were sitting lined up in their benches. The teaching of the pupils was about repetition and imitates the teacher and mostly filling the gap that the teacher made them say.

Sustainability reports have during the last decade had a strong development. Both in terms of establishing a sustainability assurance, in its form, and get it assured together with standards, principles and regulations which organisations and accountants have utilized. The growth of sustainability reports and the choice of getting them assured have in particular favoured the accounting business. Due to this result, some critics have voiced that assuring a sustainability report gain accounting firms more than it gains the actual organisation. Other say that it is necessary in order to increase the credibility and the eligibility of the report, while it also has become a requirement from stakeholders.

The cost for forestry logistics in Sweden is about 25 percent of the total cost of getting the raw material to industry (Anon., 2010). There might be much to gain by taking a look at your supply chains on the logistic side in your company. In this report the logistic chains by Mellanskog for ENA Energi AB in Enköping has been looked in to. ENA Energis plant is a combined power and heating plant and about 99, 5 percent of their fuel consisted of bio energy in year 2009 (ENA Energi, 2011, länk A). The main purpose with this report is to look at three questions: 1. How does the supply chain look today? From forest to industry. 2.

During the period 2009-2013, investments in the Swedish national grid increase by a factor of ten compared to previous years. In order to fulfil their mission to manage the national grid in a safe, efficient and environmentally sound way, Svenska Kraftnät (Swedish National Grid) needs to take all these perspectives into account while planning new investments. To compare and relate perspectives of technology, economy and environment the same yard stick must be used. That yard stick is commonly money. A problem arises however as environmental issues are difficult to price.The purpose of this master?s degree project was to develop a tool for evaluation of environmental impact related to investments in the Swedish national grid.

Evaluation of machinery costs is necessary for selecting appropriate farm machinery. Timeliness cost due to untimely operations is an important component of machinery costs. Timeliness costs can be high for crop sprayers, since pesticide application must be carried out within a short time interval. This Master thesis investigated the timeliness cost and the probability of a suitable workday for spraying. Timeliness factors were estimated for four different crops (oats, spring wheat, winter wheat and barley) using historical weed trial data.

Specialarbete, 15 hpSvenska som andraspråk, SIS 133VT 2012 Handledare: Håkan Jansson.

This report provides a comparison between the products cellular concrete, foam concrete and LECA concrete. The questions to be answered during the work is how the cellular concrete stands up in cost terms to the existing competitors on the market, how the concrete products differ in design work, and in which situations the concrete varieties are preferred to use.Cellular concrete is a variant of ordinary concrete, with the difference that the ballast is exchanged from stone materials to expanded polystyrene beads (EPS). This substitution gives a product with higher insulation values but lower weight than ordinary concrete.The work was carried out by designing a survey which was sent to two hundred randomly chosen companies across Sweden, to see the building industry?s opinion of the product cellular concrete. The survey showed that cellular concrete was equals its competitors in terms of price, while the product was said to be more flexible, quicker and easier to cast.Then some of the companies, who participated in the survey, were interviewed to see more carefully, how the price, the workmanship and the time for casting and dehydration differed between the products.

Bakgrund: Det har visat sig att det i många fall kan vara svårt att jämföra kalkylinformation mellan likartade enheter trots att dessa använder sig av samma kalkyleringsmetoder, särskilt om enheterna i fråga är geografiskt placerade i regioner med olika kalkyleringstraditioner. Det är därför av intresse att undersöka hur kalkylinformationen kan skilja sig åt i dessa fall. Syfte: Syftet är att analysera försäljningsomkostnader med hänseende på deras urval och värdering i kalkyler. Genomförande: Vi har genomfört en casestudie med intervjuer med tre enhetschefer i den svenska divisionen samt med tre engelska chefer för motsvarande enheter i den brittiska divisionen inom en och samma globala koncern. Resultat: Vi finner i vår studie att kalkyltraditioner spelar en stor roll för vad kalkylinformationen visar, men att det även förekommer stora skillnader mellan enheter som har samma kalkyltradition.