This report relate a concept study that consider a number of different proposals to improve the overcharging system in BAE Systems Ha?gglunds tracked vehicle series BvS10, to maintain sealevel power at extreme altitude.At high altitude the power losses beacuase of the air density that decreases, which results in less fuel can be burned. The decreasing of air density also gives rise to fatigue failure of the turbocharger unless power is reduced.The proposals shall be as required by BAE Systems Ha?gglunds economically sustainable and defensible from a packing perspective. That means the selected solution must have a reasonable price tag and at the same time a minimal impact on adjacent components.The basis for this thesis is based on benchmarking of both the auto industry as the flight industry, to find inspiration and tips for improvement.Some of the concepts have after gathering facts and calculations been excluded while other solutions has been considered as workable and thus interesting for BAE Systems Ha?gglunds.Initially the current turbochargingsystem was analyzed in order to determine the starting point and thus be able to fix the current problems surrounding high altitude driving.

This thesis describes the redesign ofequipment designed for drying bags thatis used in Fresenius Kabis´manufacturing of their nutritionmedicine in Uppsala. The need of thistask arise during the start of thedevelopment of a new packaging line werethis equipment were meant to be used. Anevaluation of the bagdryers capacity andcapability was necessary.The work started with gathering ofinformation from suppliers of the usedcomponents and from the responsibleengineers for this equipment. Aneducation to learn how the equipmentworked and how to operate it were taken.That was followed by the creation of astudy plan were the tests were plannedto test different parameters effect onthe drying result and to see if thebagdryer managed to handle the bags ofthe correct format in the pace that theequipment should be designed for.The test results detected a need ofdesigning a unit with a function thatholds the bags in place while passingthrough the dryer in order to attainhigh quality results. The results werelater used for optimization of thedesign.

Abstract Master Thesis in Business Administration, School of Business and Economics at the Linnaeus University, 2013 Authors: William Funseth and Tobias Åkesson Supervisor: Magnus Willesson Examiner: Sven-Olof Yrjö Collin Title: The liquidity route to more informed investment decisions - A study on the relationship between concentration of ownership and liquidity on Nasdaq OMX. Background and problem: Previous studies have shown that liquidity can explain differences in returns in corporate shares, the company's cost of capital and the valuation of the company. Based on the effects of liquidity we developed a research question concerning how concentration of ownership effects liquidity of corporate shares the studies conducted for companies listed on Nasdaq OMX during a period with major changes on the stock market and is also investigating weather other company-specific differences can explain differences in liquidity. Purpose: The study's purpose is to study the relationship between ownership concentration and liquidity, and whether other factors might explain differences in liquidity. Method: The study is conducted with a quantitative method and it?s based on data collected from 2006-2011 for companies listed on Nasdaq OMX.

Biogas is a gaseous fuel, rich in methane, produced through a biological route in an anaerobic digester. A gas engine generates combined heat and power, which can be used at the farm to reduce energy cost. The process also generates a digestate, with better utilization of nutrient compared to cattle manure. The aim of this study is to analyze the profitability of a farm-scale biogas plant for combined heat and power (CHP) at Wapnö. Wapnö is an agriculture company located in the southern part of Sweden.

Vectors based on lentivirus backbones have revolutionized our ability to transfer genesinto many cell types. Lentiviral vectors integrate into the chromatin of target cells and do not transfer any viral genes causing vector replication. Both of these features arecommonly used in gene therapy and have been used clinically in individuals sufferingfrom cancer, infections and genetic diseases. It has been discovered that T-cells can be genetically modified to be used as effective weapons against cancer: therefore virus mustbe produced to deliver the gene of interest into the T-cells. In this project, lentiviralvectors have been produced to transfer the gene coding for a chimeric antigen receptor(CAR) which is directed to CD19 on B-cells.

The ?civilized? world is in need of fossil fuel in order to function. Hybricon AB is a company in Umeå that is developing a technology that hopefully can reduce parts of this need. They are currently testing their two electrical busses (with Hybrid backup) in city traffic on the roads of Umeå in cooperation with the county of Umeå.                               The busses are originally diesel-busses, but the diesel motor has been replaced with two electrical hub-motors with a power of 145 kW each that are powered by batteries.The batteries are charged at the end station after each route. In case the batteries should run low on capacity during driving, they can be recharged by the so called genset.

Svenska Lantchips is a Swedish SME sized snack manufacturer. Being a small, medium sized, family-owned business with branches throughout the world, they make an interesting company for a case study. The case study I have conducted focuses on the internationalisation process of this family owned company ? how they, despite their size, find ways to keep up an unique business structure, designed for internationalisation.The aim of this essay is to compare Svenska Lantchips? internationalisation process with traditional internationalisation theories and see if these are compatible with this company. The theories used are The Uppsala Model, The Network Model, and The Born Global Theory, with The Born Global Theory representing the younger generation of models.After undertaking an in-depth interview with Michael Hansen, business developer at Svenska Lantchips, I collated a substantial amount of material, which I have used as the basis of this essay.

The Smart Grid technology has during the last decade been established as a way to create a greater flexibility on the electricity grid that will be needed as the development moves towards an increased share of renewable primary energy sources in the electricity production. One part of the Smart Grid technology is the ability to shift loads in time, to adapt to either price or emissions, known as Demand Response. This project, which was conducted at KTH in collaboration with the consulting corporation Capgemini, examines the economic, environmental and social aspects of the Demand Response technology. In the project, three household products are used in a model that derives the potential savings in costs and emissions of CO2e. The results show that the actual savings measured in SEK are small, but that the savings measured in percent can be as high as 20 percent. Reduction of CO2e emissions is slightly lower.

Denna uppsats behandlar en algoritm som löser linjära optimeringsproblem. Algoritmen bygger på en liknande idé som simplexalgoritmen men i denna kan startvärdet även vara en punkt inom tillåtet område eller på randen till detta område. Det behöver inte nödvändigtvis vara en hörnpunkt, vilket simplexalgoritmen kräver. Under algoritmens gång kommer iterationsvärdena att ligga på randen till det tillåtna området för att slutligen hamna i ett hörn. Därefter går iterationsvärdena från hörn till hörn tills slutligen optimum har nåtts.

The structure and performance of grocery distribution in Sweden has changed profoundly since the second world war. Increasing access and usage of the private car, in combination with an accommodating town planning has enhanced the exploitation of scale economies within distribution firms. There is, however, some ambiguity concerning the overall efficiency of the distribution system when the costs associated with travelling and purchasing performed by households are treated as an integrated part of the total distribution cost function. The purpose of this master thesis is to develop the foundation of a spatial optimisation model, which defines the most efficient distribution system. The underlying idea is that the optimal localisation and size of grocery stores is a function of economies of scale within the firms weighed against distributions costs within the households, such as transportation costs.

iProspect is a global digital marketing agency and work primarily with search marketing. They were the first search engine marketing agency in the world when the company started up 1996 in Boston, Massachusetts, and the first in Sweden to offer services in search marketing after establishing themselves on the Swedish market the following year. iProspect can be found in the södermalm office in south central Stockholm. They are a comprehensive agency within search and offer everything from search engine optimization and sponsored links to advertising on social media. They?re goal is to lead developments in search marketing and to keep ahead of competition.

Feline infectious peritonitis (FIP) is a disease that can affect cats and is caused by a feline coronavirus (FCoV). FCoV is spread via the feacal-oral route and many cats are carriers of the virus. Despite that, very few of the carrier cats develop FIP. The explanation of this phenomenon is that the virus has to mutate to be able to cause FIP and in the majority of the carrier cats this mutation never occurs. FIP is very hard to diagnose because the symptoms are diffuse and a completely accurate diagnosis can almost exclusively be established during a postmortem necropsy.

The Smart Grid technology has during the last decade been established as a way to create a greater flexibility on the electricity grid that will be needed as the development moves towards an increased share of renewable primary energy sources in the electricity production. One part of the Smart Grid technology is the ability to shift loads in time, to adapt to either price or emissions, known as Demand Response. This project, which was conducted at KTH in collaboration with the consulting corporation Capgemini, examines the economic, environmental and social aspects of the Demand Response technology. In the project, three household products are used in a model that derives the potential savings in costs and emissions of CO2e. The results show that the actual savings measured in SEK are small, but that the savings measured in percent can be as high as 20 percent. Reduction of CO2e emissions is slightly lower.

The Smart Grid technology has during the last decade been established as a way to create a greater flexibility on the electricity grid that will be needed as the development moves towards an increased share of renewable primary energy sources in the electricity production. One part of the Smart Grid technology is the ability to shift loads in time, to adapt to either price or emissions, known as Demand Response. This project, which was conducted at KTH in collaboration with the consulting corporation Capgemini, examines the economic, environmental and social aspects of the Demand Response technology. In the project, three household products are used in a model that derives the potential savings in costs and emissions of CO2e. The results show that the actual savings measured in SEK are small, but that the savings measured in percent can be as high as 20 percent. Reduction of CO2e emissions is slightly lower.

This thesis describes possibilities for Metso Paper to lower their costs of spray pipes for their pulp wash press TRPE, with maintained good functionality and quality.Information that can be used by competitors has been censored in this version of the essay.To find solutions, alternative suppliers have been contacted and asked to quote. There has also been a new spray pipe designed. The manufacturing costs of the new design have been calculated.The thesis also contains a concept generation of an alternative product to the spray pipes in installations where a high pressure washer is used.To be able to ask other manufacturers of spray pipes to quote, a demand specification based on the currently used spray pipe was made. This was then sent to two alternative suppliers.An investigation of earlier used spray pipes, and the currently used, shows that the nozzles are a big part of the total costs of the spray pipes. To attempt to reduce the nozzles high cost an concept generation was made to find the best solution for a new design.There was a request that it should be possible to change the internal brushes in the spray pipe without cutting and welding.