This literature review summarizes available data on infection with the parasitic roundworm, Ascaridia galli, as a cause of disease in poultry, including the consequences of a conversion to alternative production systems. Ascaridia galli has a direct life cycle with resistant eggs that survive and are easily spread in the environment, especially in systems with bedding materials where the faecal contact is high. The infection is usually subclinical but depending on the infection dose, the symptoms range from weight loss and diarrhea to mortality. Factors such as the feed composition and genetic variation among different hybrids clearly affect the establishment rate of the infection. Ascaridia galli will probably become an increasing problem, with a shift from the traditional battery cages to alternative systems where the risk of re-infection is high.

I detta sja?lvsta?ndiga arbete utforskas en la?randeprocess i tonsa?ttningen av ett kortare musikaliskt verk fo?r sa?ng och piano, vilket beskrivs utifra?n ett designteoretiskt la?rande- perspektiv. Studien baseras pa? videoinspelade sja?lvobservationer som pa?ga?tt under 3 ma?naders tid. Analysen av la?randeprocessen sker med hja?lp av designteoretiska be- grepp som la?randets resurser och transformationscykler.

Because of increasing demand of power on Malmbanan the capacity of the existing wires which supply the trains must be increased. This increases the stress on the existing poles and for this reason the system for supplying the loads along the railway is to be removed from the poles and be replaced by some other system. This thesis is a study on a two-level low voltage (1 kV and 0.4 kV) electrical system with the aim to investigate if it can be an alternative to the system used today taking into account the voltages, fault currents and costs.In this thesis the following tasks have been performed:? Gathering of data? Description of basic theory? Loadow and fault current calculations of the system with MATLAB? Life Cycle Cost estimate of the system? Analysis and conclusions from the resultsThe results show that the new system can be an alternative to replace today's system. The simulations and calculations show that the voltage drop is at an acceptable level and that the fault currents are large enough to supply a safe disconnection if a fault occurs at the far end of the system..

The aim of the work was to investigate the possibility to combine information from PPG and bio-acoustic technology to extract information that is related to the blood pressure. The measurements have been carried out with several different configurations. First the relation between arterial sounds and the PPG-signal was studied. After those measurements with both PPG and the bio- acoustic technique was concluded on people in different positions and after riding a bike. The goal was to vary the blood pressure.

The purpose of this study was to evaluate if there is a difference in maximal aerobic power (VO2-max) between walking with poles and without poles. Thirty-four healthy women between the ages of 22 and 60 years participated. They were randomised into two groups, seventeen individuals walked with poles and seventeen walked without poles. Both groups walked four kilometres three times a week, for eight weeks. Each completed a submaximal cycle ergometertest before and after the exercise period.

Abstract The purpose of this essay is to find difficulties and risks in the re-engineering process when restructuring to Model-View-Controller (MVC). A thoroughly theory study has been conducted to be able to understand the important steps in the re-engineering process. The methods and concepts of this essay are re-engineering, UML, system development life cycle, design patterns and MVC. The science approach used is design science where the artifact being developed are a set of models.In the analysis phase of the process the system is analyzed. The result of the analysis is notes of difficulties found and models showing the structure of the system.

This report is based on a thesis that was carried out during spring 2012. The report covers the development of a preliminary study to Performance Sk8. The purpose of the study is to facilitate and contribute inspiration to Performance Sk8 to run an automation project to bring home their production to Sweden from China. The reason is to gain a greater ability to control quality, produce smaller batches and reduce the cycle time to reduce costs.The goal is that the preliminary study shall meet the requirements and wishes Performance Sk8 and other partners defined. The pre study will contain different cost proposals for the automation of selected process and serve as a basis for procurement of the equipment.The pre study has resulted in some proposed solutions to the various steps required to automate Performance Sk8 ?s production.

This literature review summarizes available data on infection with the parasitic roundworm, Ascaridia galli, as a cause of disease in poultry, including the consequences of a conversion to alternative production systems. Ascaridia galli has a direct life cycle with resistant eggs that survive and are easily spread in the environment, especially in systems with bedding materials where the faecal contact is high. The infection is usually subclinical but depending on the infection dose, the symptoms range from weight loss and diarrhea to mortality. Factors such as the feed composition and genetic variation among different hybrids clearly affect the establishment rate of the infection. Ascaridia galli will probably become an increasing problem, with a shift from the traditional battery cages to alternative systems where the risk of re-infection is high.

Köpenhamns cykelvägnät har anor så långt som 100 år tillbaka i tiden och på 1980-talet genomförde stadens cyklister stora demonstrationer för att få politikers och planerares uppmärksamhet, som man ansåg hade förlorat fokus på cykeln i planeringen (Jensen, muntligen, 2011-05-02). I detta arbete presenteras siffror som visar att det idag är fler än en tredjedel av Köpenhamns invånare som cyklar till och från sitt dagliga arbete. Köpenhamns kommun vill öka det antalet och målet idag är att bli världens bästa cykelstad år 2015 (Köpenhamns kommun 2007). För snart tio år sedan upprättade man på Köpenhamns kommun ett dokument, Cycle Policy 2002-2012, innehållandes mål för att förbättra förhållanden för stadens cyklister till år 2012. Detta dokument har studerats närmre i denna uppsats.Som blivande landskapsarkitekt blir jag nyfiken på hur de gått till väga.

En stor del av Trafikverkets budget går till att reparera och underhålla våra broar. Underhållsåtgärder orsakar också trafikproblem med stora miljöutsläpp och samhällskonsekvenser som följd. Eftersom broar vanligtvis dimensioneras för en lång livslängd på 120 år är det viktigt att planera för långsiktiga lösningar och förutse konsekvenserna av kommande underhållsåtgärder. Genom att använda mer underhållsfria material finns möjligheten att minska kostnaderna och koldioxidsläppen.Målet med examensarbetet är att ta reda på hur stora besparingarna är genom att svara på frågan: ?Vilka fördelar erhålls av att använda mer underhållsfria material i broöverbyggnader ur kostnads- och miljösynpunkt??.

The object of this examination project is to produce a method of work sampling at Rapid Granulator AB. The aim is to perform the method at the company and evaluate if it is executable. The study is delimited to the basic construction of the 45-series in the assembly hall.Preparations to produce the method of the work sampling resulted in definitions of activities, a form and a product tree. Several days were spent studying the assembling to learn and understand the entirety.The work sampling result showed a large amount of no value adding time that was used in the assembling. Some of the activities could be reduced and we observed some problems during the assembly process.

This report discusses the constructionof different types of exterior wallconstructions and analyses wall layers.Standard wall constructions from theSwedish building contractors NCC andSkanska and also from the materialproducer Isover have been chosen for theresearch. Life cycle cost analysis hasbeen made to conclude the mostprofitable wall type, seen from asustainable and economic perspective.The calculations have been made for aperiod of 50 years.The report shows that building with wellinsulated walls is a more profitablesolution both economically and whatconcerns sustainability even though thehigher investment. However, when wallssimilar insulation properties are beingcompared, the study proves that lowerinvestment cost is more profitable.The report introduces requiredconstruction techniques of walls inorder that the reader should understandwall constructions with different layersand properties. The essay shows theimportance of properly constructed wallsto avoid air leakage and moisturedamage.The essay has been implemented byliterature studies, contacts with NCCand Skanska and by energy calculationsmade by hand and using the software VIPEnergy..

Inom sjukvården används ? precis som överallt där människor sover ? sängkläder av hygienskäl. Problem med smittspridningar av typen multiresistenta bakterier (MRSA) och spridning av andra sjukdomar har drivit företag som Cellcomb i Karlstad AB till att utveckla engångssängkläder för att förhindra detta. Engångssängkläderna är skyddade av en biofilm som ska ge ökat skydd mot bakterier och fungerar som en barriär så att inte vätska tränger igenom. Problemet är att det inte finns mycket till underlag för hur engångssängkläderna står sig mot vanliga sängkläder ur miljösynpunkt.

This thesis examines how a company can get an effective, high quality, maintenance of their computerized systems. After literary studies concerning the life cycle activity Maintenance we have studied how the maintenance at the department IT Supply of IKEA IT AB in Älmhult is carried out. What steps and measures in the analyzing of results of changes are carried out and if they have predefined processes for changes. Based on the facts we found most important in our literary studies we have created a model and theoretically applied this to the maintenance of a specific system to see what they can work with to further improve the quality and efficiency in their maintenance. The basis for our thesis is literary studies and the collected material has been used as a foundation for the research at the company, which was carried out through interviews. This thesis is based on the question: ?How do the lack of a model for maintenance and the lack of orientation affect the maintenance in a company??.

This thesis considers the use of an oldrock cavern as thermal energy storage.With a large system of differentchillers a model was created to find anappropriate future system. There aremainly two trajectories to take. Eitheran installation of chillers needs to bemade or the rock cavern can be used tomeet the future demand of districtcooling in Solna, Sweden. Additionallythis thesis investigates the possibleuse of different techniques to utilizethe phase change energy of water.Simulation shows that it?s possible toutilize the phase-change energy of afluid; however it?s not economicallyfeasible due to the thermodynamiceffects on the Carnot cycle.