Syftet med denna uppsats är att, utifrån en analys om läkarprofessionens eventuellt förändrade syn på patientbemötandet - gällande både sin egen och patientens roll - kritisera och kontrastera New Public Management och Service Management angående marknadsanpassning av läkar- och patientrollen. Vi utgår från ett tolkande paradigm och använder oss av en kvalitativ metod. Vi kritiserar New Public Management och Service Management inom svensk sjukvård huvudsakligen utifrån Etienne Wengers teori om sociala grupper i samhället, men även utifrån Michel Foucaults och Jean Baudrillards teorier. Empirisk data presenteras tillsammans med teorin och tolkas utifrån teorin. Empirin härstammar från åtta intervjuer och en observation, men består även av sekundärdata i form av artiklar från läkarfackpress.

Biological pest management is defined as control of pests using their natural enemies. This method has been used in Sweden since the 1970´s and it has been developed ever since. Biological pest management is today relatively common among commercial growers but there are good possibilities to apply this method in the home gardens as well. The aim with this thesis is to compile a report from both the companies that are marketing the products and the home gardener´s point of view. This should give a better understanding of the market and how it could be improved. We will give examples of products that represent the different kinds of organisms that are being used in biological pest management. Our hope is that this will be an introduction to all interested in biological pest management. The legislations regarding registration of organisms are still a matter of discussion and are causing problems to producers, distributors and the market in general. Why isn´t biological pest management more common in the home garden? The main reason appears to be the lack of knowledge in the subject. What are the benefits using biological pest management when it requires so much knowledge and it´s more expensive than conventional pest management? With the environmental problems we face today, we hope that every single gardener has an interest in developing an environment as clean as possible, even if only in one's own backyard..

Since 2004, wind power has had the largest installation of new capacity compared to other energy sources in Sweden. Accommodating new wind power may require strengthening or rebuilding of the existing grid in areas where the grid is already loaded to maximum capacity. This master thesis examine the possibility of a new 400/130 kV substation in Yttermalung, Sweden, with a connection to the two neighboring regional grids in Dalarna and Värmland owned by Fortum. This substation would provide a new connection point to the Swedish transmission system as well as an interconnection of the two, currently separated, regional grids. Different expansion scenarios where a substation with and without series compensation or a phase shifting transformer (PST) to control active power flow were studied.

Bachelor thesis, Controller, Program of Master of Science in Business and Economics, School of Business and Economics at Linneaus University in Växjö, Sweden, Course Code: 2FE13E:3, Spring 2012 Authors: Jacob Cedergren, Adam Pettersson, Hampus SkelterwijkSupervisor: Anders JerrelingTitle: The ERP-systems impact of the management control - a case study of VIDA AB Original Title: Affärssystemens påverkan på ekonomistyrningen - en fallstudie på VIDA ABBackground: New technology has given businesses new opportunities to use and store information and the current information systems has changed the way of working in more or less all sectors and operations. ERP-systems have been one of the most important IT innovations in the past decade. The potential of a properly implemented ERP-system is great because it has got the ability to link the company?s different areas together. Despite its many advantages, there are several examples of cases where the acquisition and implementation has been a total failure.

This Master thesis studies how a diversified institutional care organisation can optimise its collective knowledge resources so to manage and distribute this knowledge to different parts of the organisation with help of the organisations intranet. The purpose of the study is to examine if knowledge management and the organisations intranet can be used to create, store, transfer and better use the knowledge within the organisation. Through a case study the thesis will look at different knowledge processes and their relation to the organisations intranet. The case study includes a questionnaire for the whole organisation and qualitative interviews with seven persons from different levels of the organisation. The theoretical framework of the study approaches knowledge management and intranet through four knowledge processes.

Prior studies have shown that earnings management can be used either to inform or to mislead investors about the future performance of a company. However, few studies have examined the impact of earnings management on forecasting return on equity (ROE). The aim of this thesis is to investigate whether the ability to forecast next year's ROE is improved when taking earnings management, measured as discretionary accruals, into account. This is examined by comparing a forecast model that takes the magnitude of discretionary accruals into consideration with a model that does not. The study is based on companies that were listed on the Stockholm Stock Exchange during 2002-2012.

Stabilization of subgrade is an internationally common technique to improve the characteristics of a soft soil. Improving the stiffness and bearing capacity of the subgrade enables the pavement to be designed with reduced depths of subbase and basecourse aggregates. This makes the stabilization technique both economically and environmentally interesting. Both natural and stabilized soils have high inherent property variability that should be considered when the characteristic value is derived. By analyzing the spatial variability in stabilized and natural subgrades it is possible get the parameters needed for reliability?based modeling of soil properties.

Msc in Logistics and Transport Management.

The aim of the thesis is to present a study of what works well and what does not work so well in today?s use of computers in primary care with a special focus on the use of computers in the management of referrals for consultation. In May 2009 a module for electronic consultation referrals was introduced in the computer system Cosmic at the University Hospital in Uppsala. Previously, the primary care units had to use two different systems for management of referrals. Referrals sent internally within primary care have been sent electronically while referrals to the University Hospital or other external units were sent on paper.

The purpose of this project was to create a system which can handle issues, with other words an issue tracking system. The system must create issues, assign issues to a specific user and list all issues for each user. On top of that, each issue should have a log where users can log whatever they want.My part of this project was to implement a client which can fulfill this basic criteria (and a bit more if possible), and communicate with the server which has procedures to be executed by the client.This system is based on Android and has it purpose to be used by mobile devices which support Android. ?Ichnaea? as the system is called, is meant to be used by companies to have human interaction through the network..

The aim of this study was to examine the current and historic mercury(Hg) load of the lake Storjuktan due to its recent exposure to a local potential source of Hg in form of the Sulphide mine Blaikengruvan(2006) and an earlier potential sources of Hg-load, the damming of the lake(1960s). Sediments were extracted using a HTH-sampler, freeze-dried, and analyzed for tot-Hg, LOI and activity of 210Pb and compared to samples extracted prior to the opening of the mine(2006). Constant initial concentration (CIC)-dating model was used for dating the samples. Low levels of Hg (100ng/g) were found throughout the lakes sediment. The highest levels of Hg(220ng/g) was detected at a depth of 4-5cm dating back to the mid 1970:s, suggesting that increased levels of atmospheric Hg rather than damming of the lake has caused the increase of Hg.

To effectively manage a forest resource for both economic and other values good planning is required. The problem is complex since you want to know which forest to cut and when. Often a hierarchical planning structure is applied, including strategic (long-term), tactical, (medium-term) and operational level. Today SCA Forest is one of few forestry companies in the northern Sweden with an integrated forest wood supply and industry. The goals of the company are to supply their own industries with wood and to manage the resources of the forest through a long-term perspective with satisfactory profitability.

Uppsatsen ämnar studera personalrelaterade problem vid en CRM-implementering. Huvudsyftet kan delas upp i fyra delsyften som behandlar vilka implementerings-problemen är, när de uppstår, hur de undviks och hur de bearbetas..

Twitching is frequently used in horse management because of its sedating and pain-relieving effects. In this study, the effects on the horse?s nervous system by twitching were investigated by thermography of the skin temperature. The temperature is regulated by the sympathetic nervous system through postganglionic sfincters at the capillaries of the skin. The effects on the endocrine activity have also been studied by the measuring of ACTH and cortisol in blood plasma.

The thesis was done in collaboration with EAB situated in Smålandsstenar. In the initial discussion faze on doing a thesis with them there was a need to analyze and ensure the strength of an existing product, cantilever racks. This included performing FEM calculations on a model and comparing the results with physical tests.EAB has two models of cantilever racks, a light duty and a heavy duty. Within the heavy duty model series there are five product variants that differ in both size and load capacity. We will be working with the product variant with a load capacity of 1000 kg/arm which is the variant that is in the middle of the series.When we started work on the thesis we did a literature study and couldn?t find any well defined methodology that integrates both product development and computer aided design analysis.