Vattenfall Heat AB is a district heat provider in Drefviken, but has yet to establish any cooling systems in this area. This thesis examines the potential client base within the area today and over the coming 20 years. The feasibility of the most common cooling technologies is evaluated and results show a total potential for an installed capacity of 30 MW providing 50 GWh of cooling per year. One of the examined areas shows good prospect for heat driven absorption chillers during the summer months when the heat load is limited..

What role should science play in democracy? Political scientists often assume that it is possible to demarcate between ?instrumental? and ?moral? knowledge, and argue that citizens and/or politicians should use their moral knowledge to agree upon political goals and then apply the instrumental knowledge of scientists to achieve them. This straightforward view is challenged by writers in science studies, who identify three major problems in the use of science in democracy: uncertainty, risk and hidden values. They suggest that these problems could be solved through citizen participation.In this essay I perform an analysis of the internal logic of their suggestion. Is it likely that citizen participation enhances the democratic decision making process so as to reduce the problems? The internal analysis shows that it is rational to advocate citizen participation by reasons of legitimacy.

In a sustainable society the use of renewable energy and recycling of materials is of high importance. Wastewater treatment plants use large amounts of energy in the processing of wastewater. This study seeks to evaluate wastewater as an energy resource and to examine treatment plants potential to become sustainable energy producers. The study is based upon the internal processes of Himmerfja?rdsverket.

In this thesis, the flows of reactive nitrogen (Nr) in Scania were investigated and quantified. The thesis was also intended to form a basis for comparison between the urban nitrogen flow and other flows of nitrogen within Scania. The management of nitrogen in society has disturbed the natural nitrogen cycle. This is linked to a series of environmental problems such as eutrophication, acidification, global warming and smog. The method used was Substance Flow Analysis (SFA) for Nr. For calculation and flow charts Scania was divided into three subsystems; air, water and society.

Inspiration for this work is from the argumentation, which is about following issue: ``If we are on a good way to leave the bureaucratization``.This paper is a study about Scania. Here I will find out at which level of bureaucratization Scania is ranked on. Scania is one of the leading producers of trucks in the world. It is acompany which works global and the analysis of Scania´s environment is as much as theanalysis of the company's internal organization..

The goal of this Masters thesis is to examine how people at the production department of Arkivator Falköping AB perceive the internal organisational communication transfer and exchange of information, by means of a communication audit. The objectives are also to characterise the communication climate and the respondents satisfaction with the internal organisational communication within the organisation. The results of the study are compared with the companys information policy and with previous research in organisational communication. Answers from different demographic groups within the population are compared. The communication audit was conducted using a modified and added version of a questionnaire originally compiled by the International Communications Association.

Background/Problem: Since the IT-burst in 2000 it has been recession within IT-consultant firms (Sif 2004). The tendency is, however, changing slightly and IT-consultants firms are getting more assignments again (Arbetsmarknadsstyrelsen ? AMS, 2004). IT-consultants firms are however still related to stressed per-sonnel (Handelskammaren 2004; Hallstedt 2001). Another critical factor is the communication between management and workers.

Today's fierce competition means that companies constantly must develop their business and internal processes. Focus on processes and continuous improvement is something that characterizes Lean Production which ICA logistics are applying with their concept Leading Logistics. Standardized routines for handling damaged gods were insufficient at the ICA distribution center in Kungälv. Handling and registration of damaged gods were not performed uniformly, resulting in problems with controlling and monitoring the process.The purpose of this thesis was to analyze and make recommendations how the process of internal handling of damaged gods could be improved. Therefore a comprehensive understanding was needed of the entire material flow through the warehouse and important quality aspects such as product safety and delivery reliability.The methods used are literature reviews, interviews and observations to produce a comprehensive process mapping of the current situation at the distribution center.

In this study we examine trade patterns between Turkey and 13 member states of the European Union and how these have developed over the time period of 1983 ? 2006. To represent the industrial and agricultural goods included in the study we look at the United Nations Standard International Trade Classification (SITC). Following, we investigate internal differences in the EU by selecting four countries each to represent the Northern and Southern countries of the EU. Internal differences were studied in relation to the amount of trade occurring between Turkey and the Northern and Southern countries.

It is important to construct or recreate different types of wetlands and study their retention of nutrients, since knowledge of their effectiveness in this matter is poor. In 2003 a wetland was constructed on an old meadow on the western shore of Lake Bornsjön in central Sweden. The main purpose of the wetland was to reduce the amount of phosphorus entering the lake, which is the back-up water supply for Stockholm when the city cannot obtain water from Lake Mälaren. Large areas around Lake Bornsjön consist of agricultural land and the nutrient concentrations in the inflows to the lake are usually relatively high (approx. 1 mg/l total nitrogen and 0.05-0.1 mg/l total phosphorus).

This thesis is about the effect of political efficacy on societal participation among youths aged 15 to 29. It takes a starting point in the gloomy view of the decline of political participation among citizens in the western world, especially pointing out youths as a threat to democracy. This is a broad subject to take on so my aim becomes a bit more specific. The aim of the thesis is therefore to investigate if belief in ones own capacity and in the responsiveness of the political system affects the actual participation among youths in Europe, independent of a set of alternative predictors. Moreover the thesis is divided into two sub-investigations, one qualitative and one quantitative.

Objective: The papers objective is to create a deeper understanding for whether or not cultural and psychic distance affects corporate establishments in the EU.Method: The results have been gathered through intense data collection through interviews with ScaniaAB and Business Sweden. There has also been extensive research of 36 different companies and their first establishments in different countries. We have then analyzed the results through cultural and psychic distance and through Uppsala University's internationalization process model.Conclusion: The conclusions of this paper are:Corporate establishment often occurs in neighboring countries because of the similarity to the domestic markets which contribute with a greater security.Since the introduction of the EU single market, corporate establishments have become easier within the single market.The cultural and psychic distance does exist within the EU, however the internal market decreases these distances and the impact on corporate establishments.The market commitment is essential to the corporates survival within the new market.Cultural and psychic distance affects small firms more often since their lack of network and experience.Cultural and psychic distances are two different but related phenomena..

This thesis deals with the numerical 3D simulation of a four stroke, spark-ignited, internalcombustion engine, which is mounted on a high performance motorcycle. The work, carried outin collaboration with Politecnico di Milano and MV Agusta, focuses on the simulation of theintake, compression and expansion stroke, including combustion simulation, using an opensource CFD code.Simulation of internal combustion engines offers a great challenge in the field of CFD research.Moving boundaries of the solution domain, caused by the motion of the piston and valves, leadsto deformation of the computational grid, with decreasing quality of the solution as result. Basedon this, a previously developed mesh motion strategy was employed where a number of meshesare used to cover the whole simulation cycle. Within each mesh interval the internal cell pointsof the mesh are moved to account for the boundary motion of the piston and valves. This strategywas previously applied to simplified geometries as well as real engine geometries.

Stabilization of subgrade is an internationally common technique to improve the characteristics of a soft soil. Improving the stiffness and bearing capacity of the subgrade enables the pavement to be designed with reduced depths of subbase and basecourse aggregates. This makes the stabilization technique both economically and environmentally interesting. Both natural and stabilized soils have high inherent property variability that should be considered when the characteristic value is derived. By analyzing the spatial variability in stabilized and natural subgrades it is possible get the parameters needed for reliability?based modeling of soil properties.

In this work, a method was developed and evaluated for calculating the life of welds under the influence of fatigue loads from a vibration environment. Typically, a shaker table is used for testing a component against vibration loads. The shaker table creates a vibration environment that is defined in the frequency domain by a power spectrum.Similarly, a virtual vibration table can be used to calculate the same type of load environment, which can then be used to calculate the expected lifetime. The benefit of this method is that it can be used in design, as well as in simulation of tests before physical verification tests are carried out.Today there are methods for calculating fatigue life of non-welded base material, but since many components contain welded joints, there is a need to apply this method to those types as well. To achieve this, the thesis combines two different areas, which together provide a method for fatigue assessment of welds using a virtual shaker table.The methodology is carried out by modeling the component, and its welded joints, in a finite element program.