The aim of the study was to illustrate how music therapy can be used in the care of patients with schizophrenia and other psychotic illness.The method used was a literature review. Scientific articles were searched in PubMed, Cinahl, PsycINFO och Scopus databases with an outcome of ten articles, with in total 330 participants, that underwent quality and outcomes analysis.The results showed that music therapy could provide potential improvement in the patients' social functions and that it could also improve negative, some positive and general schizophrenia and psychotic symptoms in some patients. The form of music therapy used was often creative music activities with music therapist, with or without structure, or individually customized. The length of treatment varied widely. It was not possible to draw conclusions about which type of music therapy was best.

This paper describes a method for wireless energy transfer via near-field electromagnetic inductionthat is inexpensive, simple and can be applied to almost any type of system, regardless of size andenergy demands.The method uses a primary unit consisting of an oscillator, amplifier and inductive coil thattransfers energy to a secondary unit consisting of a coil, rectifier and voltage regulator. Two typesof oscillators and several amplifier designs were realized and evaluated together with a multitudeof flat coils of both monofilar and bifilar type.The results show that it is important to use an oscillator whose frequency is dependent on theinductance of the connected transmission coil, such as the Colpitts oscillator. This is preferable toan oscillator with a preset frequency, such as a Schmitt-trigger oscillator..

This master thesis in energy optimization was made during the autumn of 2006 at Käppala wastewater treatment plant in Lidingö, Stockholm. A preceding thesis, where all electricity consumption was mapped, showed that the aeration in the biological treatment is the single largest consumer in the plant, and it is therefore of interest to reduce this cost. The oxygen control strategy used at Käppala WWTP is working well from a nutrient removal point of view, but not from an economic one. The last aerobic zones have a very low oxygen consumption during low loading periods which give rise to enhanced dissolved oxygen concentrations with excessive costs and reduced denitrification as a result. But also during periods of normal loading unnecessary high oxygen concentration are sometimes given.By modifying the aeration control strategy three full-scale experiments have been made, with the intention to reduce the air consumption.

Small hydropower plants have been an important source for electricity for many years. During the 70?s the general thought was that nuclear was the future. Around 2000 small waterpower plants were shut down. It wasn?t profitable to invest in.

I denna rapport undersöktes S&P 500 Energy Index genom multipel regressionsanalys. Modellerframställdes genom regression och baserades på data hämtad från börsen. Modellerna angavs iprocentuell ändring respektive absolut ändring. Validitet för varje enskild kovariat testades och en risknivå avgjorde om en kovariat skulle inkluderas i modellen eller inte. Detta ledde till två modeller med bättre kurvanpassning till den givna mängd data över det valda energiindex.

For several years Uppsala University together with several companies has been involved in a WISENET project aimed at improving railway transport security. By placing a sensor system near the wheels of each wagon, the temperature of the bearings can be measured and transmitted to a collector placed centrally on the wagon. This in turn transmits the collected data to RFID receivers placed intermittently along the railway.As the signals are transmitted wirelessly, problems may occur as the antennas get dirty or coated with ice and snow. To determine the effects of these coatings, several tests were performed examining the reflection coefficient S11, the impedance Z11 and the efficiency eta of an antenna, and how they varied when various coatings were placed over the antenna. Examined coatings were ice, snow and water to determine the effects of weather, and various metal-based coatings: powdered iron both pure and partially oxidized, and iron ore granules.

The aim of this research is to find out what environmental impact a wave power park has on the Swedish west coast by creating a consultation paper (?Samrådsunderlag?) for the Lysekilproject at Uppsala University. To highlight the complexity of the problem a system analytic approach was used and illustrated by a Causal Loop Diagram.The overall assessment of the Lysekilprojects wave power park at the Swedish west coast is that it will have a low impact on the environment. This is due to the relative small size of the wave power park and some technical solutions made with the environmental aspect in mind. Artificial reefs and a sanctuary for marine species are effects created by the wave power park and in the longer term the impact will give access to an untapped source of renewable energy, wave energy.

If Swedish companies are to compete with companies in low-cost countries they have to achieve a more efficient production. The purpose of Total Productivity Maintenance (TPM) is to increase the company's profitability by increasing the productivity. TPM is a method that involves all employees and aims to prevent failures in order to increase the availability of existing equipment.The aim of this paper is to evaluate the implementation process of TPM and give recommendations for the further implementation process. The conclusion and the analysis are based on a case study done at a production department at ABB Cewe-Controls facilities in Nyköping. The case study consists mainly of qualitative data from participation observations, surveys and interviews.Commitment of the management is a key factor in the implementation process of TPM.

In 2005, Outokumpu began to implement its system of continuous improvement, OK> 1, at Avesta Jernverk. OK> 1 has not generated sufficient results on plant KPI:s. The purpose of this study is to identify the understanding,  participation and commitment regarding to OK> 1, and to suggest some actions to make OK> 1 more successful with emphasis on these three aspects. The thesis shall also determine whether there are any differences in the attitude towards OK>1 between Blue Collars and White Collars.The study consisted of a survey, and interviews. The output from these methods were processed and analyzed and finally resulted in a SWOT ? analysis and suggested actions for improving the understanding, participation and commitment towards OK>1.

Seabased Industry AB develops system for extracting electrical energy from ocean waves with a Wave Energy Converter (WEC). The components is bought from subcontractors and then assembled into wave energy converters, buoys and marine substations by Seabased. In the future Seabased will produce more of the components themselves to reduce costs and to have better control over tolerances. The production line will also include the painting of the WECs and substations, which is performed in a painting line.The purpose of this thesis work is to study what is required to build a painting line, regarding the types of stations, transporting types and the space needed. This will result in layouts for the painting line.To receive the necessary information about production theory and corrosion and surface treatment, literature concerning this area has been studied.

In today?s computerized society more and more companies choose to utilize new applications that can ease the way of handling the information. For many of us is imperative that the process as efficient as possible if one takes in consideration the size of savings that this new application can bring.The developer of the evaluated system is SYSteam AB Huskvarna and they are the ones that gave us this assignment. The application that we evaluate is SCM (Secure Connection Manager). It is already used today by big companies such as Telia and Ericsson to search for errors in telephone servers placed all over the country.

Sandviksvägen 38 är ett av många flerbostadshus byggt under åren 1961 ? 1975, de såkallade rekordårens bostäder. Byggnaden står inför en omfattande renovering, och då finnsdet samtidigt goda möjligheter att minska byggnadens energiförbrukning. I studien undersöksoch beskrivs ett antal av de åtgärder som kan genomföras. Målet är att föreslå åtgärdspaketför att minska byggnadens specifika energiförbrukning med 20 respektive 50 procent jämförtmed dagens användning.

Arvika Smide is a supplier to the automotive industry with a focus on advanced drop forgings including powertrain and bearings. The great experience and high quality is Arvika Smide?s speciality. Today's competition in the industries puts high demands on the efficiency where each company has a quest for perfection.Arvika Smide has been through the thesis of Karlstad University, called for a situation analysis of aftertreatment whose effectiveness has not been fully desirable. The department includes the production steps blasting, quality control and packaging.The thesis contains the results from the situation analysis and comparisons of the calculations for selected reference period Q4 2009th.

yield optimization, wind energy, sustainability, maintenance..

In the production of pulp, paper and cardboard, a large amount of water is used daily. The water has to be purified in the internal purifying plant before it reaches the receiving body of water. In the biological purifying stage at the Stora Enso Skoghall mill, an aerated basin is used where the microorganisms, using oxygen, oxidize the organic material to carbon dioxide. The air is pumped from the bottom of the basin and the oxygen can then be transported from the air bubbles to the water through diffusion. The problem with aeration of waste water from the forest industry is that wood residues, such as fatty acids, are making the transport of oxygen in water more difficult.