In modern society in terms of economics and environmental impact, it is important to ensure that a company is as energy efficient as possible to reduce the amount of energy used. About 10 TWh of electricity used annually to pump drives in Swedish industry. Therefore, pumping system has great potential for energy savings.The objective of this report was to determine how much energy and money that can be saved with the insertion of variable speed drive to six pumps on Bleach plant 4 in Skutskär Mill. The work was performed with electrical measurements during one week, analysis of pump curves and the compilation of production data over a year.The results show that four of these six pumps were profitable and yielded an annual saving of 1172 MWh of electricity and 560 000 SEK. With an economic lifetime of 10 years and a discount rate of 6.8% the final result for the entire life-cycle savings became 3 355 000 SEK.

Petro-electric IFVs (Infantry fighting vehicles) or hybrid-IFV?s are not a new phenomenon. During the 1900?s Germany as well as the U.S both tested vehicles constructed with hybrid technology. In spite of several identified advantages, no serving hybrid-IFV exists today.

To design new and high tech products the engineers rely more and more on computer based simulations to investigate the properties and behavior for a component or system.To verify these computer based simulations the dynamic properties for the components of the drivetrain needs to be verified. Therefore measurements of the stiffness and vibrations for the rear axle has been performed. This report show how the measurements has been implemented and evaluated, along with some interesting results for the rear axles properties.The static stiffness for the drive shaft along with the axle-gear has been determined. It is found that the stiffness for the whole rear axle is near the stiffness for the drive shaft, which means that the drive shaft becomes the dominant component of the system and affects the rear axle stiffness the most. The measured stiffness of the driveshaft is close to its theoretical stiffness.The stiffness for solely the hypoid-gear have been calculated using the stiffness for the rear axle and driveshaft, and thus has a range for the stiffness of the hypoid gear been determined.The backlash for the whole rear axle and for some individual components has been determined, where the backlash between pinion and crown-wheel has negligible impact on the total backlash.Measurements of the crown-wheel and pinion movements have been conducted, where the direction of movement is consistent with the theoretical direction of the forces.The vibration measurements show that the vibrations are more severe at certain rotational speeds.

Problem: Is the free cash flow a value relevant accounting measure in relation to the Swedish stock market?Objective: The aim is that by using an investment strategy to examine whether the free cash flow is an accounting measure that could be perceived as value relevant in relation to the Swedish stock market.Method: The paper is based on a quantitative survey of empirical evidence that has been collected from companies listed on the Large and Mid-Cap lists of the Swedish stock market.Theoretical Frame of reference: value relevance, cash flow, portfolio theory, drive theoryResults: It was concluded that the study results conform to the Finnish survey results. The portfolio shows higher returns than the OMX index..

Detta examensarbete reder ut arbetsprinciperna för olika typer av hårddiskskrivskydd; hårdvaruskrivskydd, mjukvaruskrivskydd, hybridskrivskydd och bygelskrivskydd. Slutsatsen av utredningen är att endast hårdvaruskrivskydd Detta examensarbete reder ut arbetsprinciperna för olika typer av hårddiskskrivskydd; hårdvaruskrivskydd, mjukvaruskrivskydd, hybridskrivskydd och bygelskrivskydd. Slutsatsen av utredningen är att endast hårdvaruskrivskydd bedöms ha tillräckligt pålitliga skyddsprinciper, vilket motiveras av dess oberoende från både hårdvara och operativsystem. Vidare undersöks hårdvaruskrivskyddet Image MASSter(TM) Drive Lock från Intelligent Computer Solutions (ICS). Några egentliga slutsatser gick inte dra av kretskonstruktionen, bortsett från att den är uppbyggd kring en FPGA (Xilinx Spartan-II, XC2S15) med tillhörande PROM (XC17S15APC).

This report reflects an examination work performed for Getrag All Wheel Drive AB during the spring of 2005. Among the companies range of products there exists some concern regarding the amount of clamping force and friction on bolted joints caused by the assembly torque.The aim of this project has been to determine if there is a simple way in which to identify and then practically apply testing methods for clamping force and friction through utilization of existing testing equipment.Three separate methods of clamping force and friction determination have been tested in rear drive unit, RDU, at a 30 Nm assembly torque. A fourth and final method, screw elongation with ultrasound, has been used as reference. The methods are:?Torque-Tension test.?Screw elongation with micrometer.?Joint stiffness test.?Screw elongation with ultra sound for reference.The results from tests can be viewed in table below.MethodTorque-TensionMicrometerCs=318 kN/mm Assembled with torque wrenchMicrometerCs=318 kN/mm Assembled on lineUltra-soundCS=311 kN/mm Ultra- soundCS=318 kN/mm Joint stiffnessTheoreticalClamping force-21,8 kN17,6 kN17,3 kN17,6 kN17,1 kN17,3 kNFriction-0,110,1470,1530,1470,1520,149.

Qvarfordt, K (2014). Physical activity on prescription, the individual experience. Thesisin Public Health. School of Health and Work, University of Gävle.In order to increase physical activity and to create a better health licensed staff mayprescribe physical activity to patients. The purpose of this paper is to find out how fiveindividuals experienced getting Physical activity on Prescription, FaR ®.

The thesis focuses on the measurement of situational factors affecting brand loyalty in purchases and consumption. A survey is conducted using previously developed scales and 199 respondents. Results show that for the particular product category (ready-to-drink recovery drinks), purchase frequency and the product experience have stronger effects on loyalty than do situational factors such as type of activity and perceived stress. Implications for managers are discussed and suggestions for further research is presented..

Abstrakt I den här uppsatsen undersöks hur ett narrativ kan drivas inom digitala spel enbart med hjälp av spelmiljön. Syftet är att få förståelse för vad miljöberättande behärskar som en självständig form av berättande och vad författarna kan göra för att uppnå detta mål. För att undersöka problemområdet genomfördes en spelproduktion där metoder framtagna under undersökningens gång applicerades. Produktionen testades av utomstående studenter i medieteknik och resultaten sammanställdes med reflektioner kring vad som uppnåtts och de metoder som applicerats. Undersökningen beskriver arbetsprocessen och metoder och visar hur dessa kan driva ett narrativ med en spelmiljö.

AbstractThis study deals with preschool children's ideas about water in our body. Ten children with the age of four to five were interviewed individually, the interviews were qualitative. The children were also asked to draw their answers and answer questions about a picture that represented the excretory system. The results of my study show that children did not have any knowledge about the water being vital for us. Preschool children had no knowledge of why it is important to drink water.

Recent statistic shows that about 28% of adolescents living in Stockholm drink alcohol at such a high level that their consumption counts as risky drinking. The correct term to use in this matter would be binge drinking adolescents.  In the more wealthy areas of Stockholm this group of binge drinking adolescents counts for as much as a third of the population. In contrast, the adolescents living in exposed areas do not drink nearly as much. Binge drinking adolescents in these areas only counts for 15%, nearly half as much as in the wealthy areas.In light of this the intentions of this study is to investigate which explanatory factors that can clarify the range-rated differences in binge drinking between adolescents in Stockholm.

Abstrakt I den här uppsatsen undersöks hur ett narrativ kan drivas inom digitala spel enbart med hjälp av spelmiljön. Syftet är att få förståelse för vad miljöberättande behärskar som en självständig form av berättande och vad författarna kan göra för att uppnå detta mål. För att undersöka problemområdet genomfördes en spelproduktion där metoder framtagna under undersökningens gång applicerades. Produktionen testades av utomstående studenter i medieteknik och resultaten sammanställdes med reflektioner kring vad som uppnåtts och de metoder som applicerats. Undersökningen beskriver arbetsprocessen och metoder och visar hur dessa kan driva ett narrativ med en spelmiljö. Abstract In this thesis examines how to drive a narrative in digital games using only the game environment.

By using steady-state measurements for predicting emissions under a dynamic drive cycle wouldsave a lot of time and money for the exhaust aftertreatment specialists at Volvo cars. The idea forthis thesis has been to investigate if statistical regression models can be used with good accuracy.Questions included are for example if common operating variables such as engine speed, air-fuelratio etc. is sufficient to predict engine-out emissions over the engine operating range with goodaccuracy. Focus was set on the modelling of warm engine, but also the more complex engineheat-up phase was investigated since it is a great contributor to total emissions. While NOxcouldnot be measured because of malfunctioning measurement equipment, only HC, CO andtemperature at inlet of first catalytic converter has been modelled.

The E-department at GETRAG All Wheel Drive in Köping have problems with the efficiency on parts of their production equipment. The equipment with the most significant efficiency problems are four automated multifunctional production cells that produces housing for rear drive units. The major part of the problem is the large amount of small stops that causes the low efficiency.The department already worked with logging of interruptions and efficiency calculations before this project started. However this work was not done to the extent considered necessary for a systematic follow-up of the interruptions.The aim of this paper is to point out a more effective and systematic way to work with logging of interruptions and the follow-up. In addition the equipment were studied with a method for efficiency calculation that ? if used properly- is a more powerful and a visually better method than the one used by the company today.As the initial current state analysis of the equipment was made a lack of documented knowledge about the equipment was discovered.

SEP Modular Armoured Tactical System is the next generation of military vehicles developedby BAE Systems Hägglunds AB. At present time, BAE Systems Hägglunds AB aredeveloping a 6-wheel electrical hybrid and a conventional 8-wheel vehicle. The questionformulation was summarized as: ?In which ways can the electrical transmission in a hybriddriveline for SEP be designed, when the surrounding fixed interfaces are kept and the unity ofcomponents within SEP is maximized??. The purpose of this master thesis was to study avariety of concepts for hybrid propulsion.