This report is a bachelor thesis presented at the department of Computer Science andEngineering at Chalmers University of Technology. The aim for the project is to find a simplemethod to measure and display physical quantities in a three dimensional room.The report describes a method to construct a system for measuring differentphysical quantities via sensors. The system must be built in a modular and expandable way tobe adaptable to different tasks.The system explained in the report consists of two parts;A physical scanner with moveable probes for carrying sensors and a microcontroller forcontrolling the probes and communicating with the next part.An application written in Java for storing the measured values and presenting them in a lucidperspective.It is possible to construct the scanner with different designs and circuitry, with multiplexers andflip-flops, to ensure that an unspecified number of probes can be added to the system and thatthey can be operated simultaneously.The Java application is written in a modular way, using a design pattern that separates eachindividual part of the application. It contains exceptions and interfaces that ensure a safe andexpandable application..

This paper examines and compares several different sites in Sweden in addition to one in Mexico regarding whether the ecological requirements theses sites have had during planning and construction has affected the design in any way. Is it possible that, for different reasons, one thinks ?like nature? when one thinks of ecology and, if true, how does this reflect on the spatial and structural design? This paper tries to identify if some sort of general design expression is used in projects with requirements on ecological sustainability. In total, five projects have been compared in different areas such as choice of materials and their composition. These projects have an ecologically sustainable processing of water in common, although most also have ecological consideration in other areas as well.

Take your phone out from your pocket and look at it. Chances are that a certain California-based company made it; in 2013, it was quite likely. If you flip it over and remove the shell you have added (or look through the protective film), you might also learn that it was assembled in China. Flip it over again and look at the picture of something or someone you find great affection for, protected by yet another thin film. While who made it and who assembled it might vary, and it does not matter from now on, the other parts about protective barriers and personalization might be more accurate.

In this report a study is carried out with the aim to identify added values of EPC projects implemented in schools in order to increase the interest of EPC projects on the market. The report examines how the planned maintenance, supervision, maintenance and corrective maintenance is affected, how insurance premiums and terms are affected, the indoor environment and how the tasks of the operating staff is changing. A literature study of energy savings, energy use in schools, maintenance and insurance as well as how energy efficiency improvements are related to the Swedish environmental objectives has been made. Visits were carried out in Ludvika, interviews were also carried out with operation technicians and local strategists in Ludvika as well as employees of insurance companies.Schools often have neglected maintenance and problems with ventilation and indoor environment. Schools also have a large energy saving potential due to their low utilization, mainly because they are empty parts of the year.

Electronic article surveillance (EAS) is widely used in shops and libraries together with an RF-tag attached to the goods or books in order to prevent shoplifting. By implementing the addition of a moisture sensor to the RF-tag, other functions become possible, including the ability to use as an alarm with regards to frozen goods, which have been shipped but which have melted and have, subsequently, refrozen. In- relation to care for the elderly, one time-consuming step involves checking whether there is the necessity for a change of diaper and this can, instead, be based on an RF-tag with an EAS-system alarm. A preliminary investigation was made using the moisture sensors, which involved how the resistance changes when liquid and/or heat is applied. A simulation of the LCCR circuit (RF-tag with the sensor) was conducted in order to determine how the resonance frequency changes for different resistances levels.

This master thesis holds a modelling in Simulink for a physical model of a main battletank tower, a three-phase induction motor and some mechanics. The aim of this work is to connect an earlier project at AerotechTelub, named StabSim to another called Eldris. In StabSim it has been made a Simulink model of the align and stabilisation system in a main battle tank 122 and in Eldris it has been build a physical model of a main battle tank tower. In this thesis the models that differs between Eldris and a real tower is changed in StabSim, and the parts that only exist in Eldris is added, for example a torque generating system which purpose is to make the model to behave like a real tower in control application, although it only has half the inertia as a real tower. The thesis even includes proposing a calculation of the torque that the torque generating system will actuate at the model..

Aquaponics is a food production system consisting of a consecutive cultivation of plants and aquatic animals, fish or shellfish, in recirculating water. The plants feed on the nutritious effluents from the fish tank and bacteria converts ammonia from the fish tank into nitrate that is absorbed by the plants. The plants receive nutrition and the fish gain purified water. The environmental impact of the production of fish meal and fish oil used in conventional fish feed includes a large consumption of fossil fuels with subsequent carbon dioxide emission. The aquaponic system can be made environmentally sustainable and self-supporting if supplemented with a vermicompost/vermiculture for the production of worm protein as a fish feed. Vegetable waste from the hydroponic part of the system can be reused as worm feed in the compost and the protein rich worms can be harvested, dried and grinded and brought back to the aquaculture as fish feed. As a first step in this direction, I have investigated the effect of recycling of vegetable waste in vermicomposts on the growth and number of earthworms (this was evaluated after harvesting). The hypotheses were that earthworms can be cultivated in the vegetable waste and that by adding manure to the vermicompost it is possible to obtain a nutrient content adequate to support a continuous worm harvest, in other words create a vermiculture. Eisenia fetida and Dendrobaena veneta were grown in 20 L bins containing peat mixed with either poultry or cattle manure. The proportions were 70% peat and 30 % manure. Discarded plant parts from lettuce cultivation was added to the vermicomposts (35 g per week) and water was supplied with 0.8 L per week.

Internet grows, so it?s cracking, soon will all IPv4 addresses be allocated and a solution is urgently needed. The new protocol, IPv6 is the solution to this problem. With a size of 128 bits against IPv4s 32 bits gives IPv6 a huge amount of addresses to distribute. The security addition that may be added manually in IPv4 is the standard with the new protocol.

The purpose of this thesis is to find out how clients at Effect Reklambyrå (an advertising agency) view the communication and relationship with Effect. Conclusions are then drawn based on what the clients say. The conclusions show how Effect can improve in these areas.The study uses a qualitative research method since the phenomenon studied is complex and requires deep understanding. A total of 16 interviews took place. Seven clients were interviewed by phone and nine clients participated in a personal interview face-to-face.

This study deals with a research on what the opening sounds in movies tell us about the story that we are about to follow. The purpose is to examine if and how the sound in the first five minutes of the movie contribute in giving information about the film?s genre. The theoretical base includes both genre theory and Michel Chion?s theory on film sound.

In 2010, Airwatergreen AB started testing their new technology, the Airwaterwell, an atmospherical water generator of their own design that is running on solar heat, with a production capacity of three litres of water per day and m2. The purpose was to focus on foreign aid organizations as main purchasers for project investments towards rural communities in developing countries that suffer from lack of, or compromised quality of drinking water. In order to further understand if this technology would bring a positive impact in the developing countries, the company contacted the Swedish University of Agriculture for a socio-economic study of the Airwaterwells? potential. The authors elected Cost benefit analysis as the appropriate method for conducting the study and India became the study region because of its many problems with water related issues such as diseases as well as insufficient water supply for households. The regions that this study is based on are Gujarat, Haryana and Uttar Pradesh given their differences in income, health situation and poverty rate.

The goal of this project was to create a web-based, crowd-sourced, correlational database, that easily allowed users to submit objects and receive correlated objects as results. The webservice was created in the web development languages of HTML, CSS, PHP and Javscript, with MySQL to handle the database. Simultaneous development was kept in check with the aid of the source code management system GIT. Upon completion, the service contained several HTML-views, the ability to add and rate objects, a per-object dedicated page with information parsed from Wikipedia.org, and a view with objects ranked in accordance to the preferences specific to the current user. Roughly a month after the beginning of development, the website was publicly launched and promoted in order to collect data, and improvements were added to the website as needed.

The purpose of this report is to evaluate different methods for identifying states in robot models. Both linear and non-linear filters exist among these methods and are compared to each other. Advantages, disadvantages and problems that can occur during tuning and running are presented. Additional measurements from accelerometers are added and their use with above mentioned methods for state estimation is evaluated. The evaluation of methods in this report is mainly based on simulations in Matlab, even though some experiments have been performed on laboratory equipment.The conclusion indicates that simple non-linear models with few states can be more accurately estimated with a Kalman filter than with an extended Kalman filter, as long as only linear measurements are used.

The present study aimed to replicate Tversky & Kahneman's' survey of 1981 The Asian Disease Problem. A survey was conducted on the Internet (N = 200). An identical problem was added, yet with The Swine Flu as the disease. This was done to be able to investigate if there are any order effects, and also if it matters whether the mentioned disease is fictional or real. The results show the same results as Tversky & Kahneman already noted; positively and negatively framed problems generate different responses from the participants.

This project is a learning CD-ROM production aimed at first-time parents. It is using both sound and images, moving as well as non-moving. The purpose of the production is to be an interesting alternative to traditional books. We have been looking at similar productions like drivers license educational CD-ROMs and encyclopedias for inspiration and ideas on how to proceed. In order to give the content some dynamics, we've also added the element of 3D-animated sequences. The application is supposed to be run as a simple executable file with flash embedded.