The purpose of the house which is the basis of this report is to be able present itself on the market as a relatively cheap and at the same time a climate friendly choice. The house is supposed to be able to be built anywhere in Sweden and the rest of Scandinavia in a short period of time. This puts demand on what kind of heating system the house can have, since not all places have the geographic advantage of being able to use geothermal or district heating. Therefore the heating system choices will only include those that are not limited by their geographic location. The house will be built in modules which only require the groundwork to be done before the house can be erected. In this report "System solutions for plus or passive-housing" a comprehensive literature search has been conducted as well as a number of calculations.

Fuel wood is currently the third largest assortment from the forest in Sweden after pulpwood and lumber. Branches and tops i.e. logging residues are one of the assortments of fuel wood which is a common by-product after harvesting nowadays. The way to utilize, disintegrate and transport the logging residues varies between northern and southern Sweden. Branches and tops are collected throughout the year at appropriate stands, but are consumed mainly wintertime.

At SIA TallOil's pellets factory in Latvia wood shavings and saw dust are dried with flue gases from a gas burner. TallOil wants to replace the gas with a biofuel that is available at the pellet plant. The reason for this is the unstable gas market in Europe in combination with the fact that TallOil wants to improve its profile as supplier of renewable bio fuels. In this project the technical and economical possibilities for a fuel conversion to ether bark powder, wood shavings or wood powder have been investigated. These fuels should be burned in one of the following applications: TPS BioSwirl, VTS Multifuel burner or Saxlunds bio fuel combustion plant Due to the fact that the fuel alternatives available are relatively common except for bark powder, the work has mainly been focused on bark powder.

In this essay, several factors in apple tree care (specifically in relation to whether dead wood should be kept or removed) are highlighted for example, aesthetics and biodiversity. To present some background, the essay begins by introducing some previous literature on dead wood. This leads into how dead wood is treated within forestry. Next, previous research on dead wood in fruit trees is mentioned. Cultural and historical management methods are also highlighted.

This final thesis is performed on commission of Torsby forestry administration, Stora Enso Skog. Stora Enso Skog is one of the major forestry companies of Sweden. The main business area is located in and around the region of Bergslagen. During the last decade the practice of forest management has rapidly changed due to a new forest legislation. The new law has resulted in that the production goal is equal to the environmental goal within forestry.

The purpose with this study is to find out how much dead wood we can expect us to find in a Russian reference river and compare with studies from Swedish streams. Dead wood are an important structure for the biodiversity in forest streams, studies have shown that population of trout can increase with up to 300 % when the amount of dead wood are increasing from 0 to 8 ? 16 LWD (Large woody debris)/100 m2. Dead wood are also an important structure for the stream character, formations of dams and pools which are important habitats and reproduction areas for salmon and brown trout. The study where taken place in tributaries to the Russian river Varzuga in the North West part of Russia outside Murmansk. Varzuga has low impact of human activity and is considered to be a reference river to rivers in northern Sweden.

The need of raw material does of course fluctuate but the long term view is an increasing demand due to the growing consumption of sawn timber products, pulp, paper and lately also biomass. This has led to a keener competition for wood. At the same time there is an ongoing structural change of a significant part in the Swedish wood supply market, the private forest owners. In 1992, 22 % of Sweden´s 335 000 private forest owner lived apart from their forest. In 2007 this figure had risen to 36 %.

The purpose with this study is to compare different systems of grain storage from a financial point of view. Grain that is supposed to be fed to laying hens. The systems that were compared were different airtight storage of grain and a system of conventional storage. To make this case study I choose to compare four different systems. In the case study there was one system with bin drying of the grain, two systems with airtight storage of the grain and one system where you buy dried grain during the season. I made several of capital investment appraisal where I found the cost of each system, then I took the cost and divided it with the total grain use and calculated the cost for each kilogram of grain, and also the cost of the feed. Then I compared the cost from my case study with the cost of buying feed. All the systems except for one, gave a lower cost for the hen feed than buying feed from a dealer The best system, witch were bin drying lower the cost with about 80 000:- SEK.

The Swedish pulp and paper industry meets higher demand for energy efficiencyi mprovements with increasing energy prices and changes in the Swedish renewable energy certificate system. One action of energy efficiency improvement is by using secondary heat, that otherwise would have been treated as waste heat, for use in a system with lower temperature demands. The aim of this Master´s thesis is to identify possible secondary heat sources in a typical Swedish pulp and paper mill and to investigate what economic benefits the secondary heat will provide when being used for pre heating of wood chips to a kraft digester.The Master´s thesis focuses on three secondary heat sources; dry warm air, warm water and moisture saturated warm air located inside the pulp or paper mill. Two types of kraft digesters are simulated within this study, a typical Scandinavian digester and a modern twin vessel steam phase digester.Due to quality aspects and low temperature level drying is the drying technology with dry warm air rejected. Using warm water in direct contact with wood chips increases the quantity of water to the evaporation plant and thus reduced pulp or paper production and is therefore also rejected.

At the end of 70s and the beginning of 80s, 18 terminals was built and used for chipping wood residue from clear cuttings. Most of the terminals was terminated before the 2000s but with the high oil- and energy prices that we can see today there might be a place for these terminals again. The goal with the study was to analyze and compare economical differences between 5 different logistical systems, collected data was used with a set of formulas. The systems include long range transport of slash, chips and bundles. Three of the systems include transport by lorry to industry the last two includes a terminal with access to train transport.

Today there is a widespread opinion that the woodmarket and the forest industry are dominated by a traditional way of thinking and not adapted to the customers of today; a lot of products are produced purely on routine. Also, there is a demand for improving the quality of sawn woodproducts. AB Karl Hedin wants to sort this out by increasingly adapt their products to the demands of the market, i.e. through introducing a short wallstud of standard length, "Hedinregeln". At tirst, the wallstud will be produced in lengths of 2,70 m and of guaranteed quality.

During the twenty-first century the price of forest land in Sweden has increased heavily. Buying forest land has become more common and the stakeholders have grown in number. The countries around Sweden have through the globalization become connected in the market of round wood and wood products. The price of forest land and round wood are also close connected. The goal with this report is to make a comparison of forest land prices between Sweden, Denmark, Norway, Finland, Estonia and Latvia and to see how the prices have developed in the period 2000-2011. The prime factor in the comparison, except the direct price difference between the countries, is the round wood prices. The round wood prices give information about the economic situation in the countries and play an important role in the return on the forest land. The prices of forest land shifts heavily between the countries.

The Income Tax Act is enacted what criteria must be met to obtain a tax reduction of household work. Household work is the common term for ROT- and RUT-works. The purpose of the tax reduction is to increase job opportunities and to discourage that undocumented work performs.It is only for the labor cost as tax reduction is given for. The concept of labor cost is defined in law as it is not comprised of cost of materials, equipment or travel. The preliminary work provides no closer explanation what the labor cost includes.

Storage of biomass is often associated with problems such as heat development, dry matter losses and reduction of fuel quality. The rise in temperature can potentially cause a risk of self-ignition in the fuel storage. Moreover, emissions from storage piles can cause health problems in the surrounding. The dry matter losses and reduction of fuel quality can have economical effects. The aim of this thesis project is to develop guidelines on how to store large amount of biomass at Vattenfalls heat and power plants in an optimal way.

Stump wood was used between 1850 and 1950 for production of tar and as firewood. In the 1950s the use decreased because of the introduction of the cheap fossil oil. In the 1970s stump wood became an interesting issue again as a raw material for the pulp industry. Stump lifting has today become a possible source for bioenergy. The objectives with this study were to investigate the productivity of stump lifting and stump extraction, and to analyse the economy.