There is a lack of published material regarding designing graphical user interfaces of so called integrated video uploading services. The term integrated video uploading services refers to homepages that do not have video uploading as its primary purpose but which still offers that service to its visitors. The aim of this thesis was to improve the amount of published material about designing graphical user interfaces for integrated video uploading services. This was done by performing a literature study to find general design guidelines which can be applied to design of integrated video uploading services. Thereafter the functionality and design of dedicated video uploading services was analyzed.

The last few decades the development in the field of electronics has been huge. The components performance gets better at the same time as the manufacturing cost decreases. Many of the design moments that have to be done, are done automatically today, but it can get better. Especially for analog circuit design.At Electronic System in Linköpings universitet, research is in progress to develop a tool that can design analog circuits in reasonable time. It means that it has to size the components (transistors, resistances, capacitances etc), so that the circuit can fulfill the performance requirements.

This thesis is basically a design project aimed to find a safe and reliable automatic safety device, which is designed to be suitable for highly automated industrial situations. This device fits with ABB / Jokab Safety?s fence systems. These are built up around machines to create safety distances. The automatic protection device assist the operator in situations when loading or going in and out of the danger zone.

On a request from the water sewage plant Gryaab in Gothenburg a power quality survey was performed. The voltages and currents have continuously been sampled in the incoming 10 kV substation HSP01 from April-August 2008. Power quality measurements were also performed in Gryaabs other 10 kV substation HSP04 fed from HSP01 and at the terminals of the induction motor IN_PU4040 of 1.3 MW which controls one of the four large inflow pumps to the plant. The reason for the latter measurement was due to registered negative transients each time the motor was connected to the grid. The cause of the transients could be explained by the coupling in the substation, the ageing of the motor which could result in damage of the bearings or resonance in the motor circuit which amplifies high frequency harmonics.

On a request from the water sewage plant Gryaab in Gothenburg a power quality survey was performed. The voltages and currents have continuously been sampled in the incoming 10 kV substation HSP01 from April-August 2008. Power quality measurements were also performed in Gryaabs other 10 kV substation HSP04 fed from HSP01 and at the terminals of the induction motor IN_PU4040 of 1.3 MW which controls one of the four large inflow pumps to the plant. The reason for the latter measurement was due to registered negative transients each time the motor was connected to the grid. The cause of the transients could be explained by the coupling in the substation, the ageing of the motor which could result in damage of the bearings or resonance in the motor circuit which amplifies high frequency harmonics.

On a request from the water sewage plant Gryaab in Gothenburg a power quality survey was performed. The voltages and currents have continuously been sampled in the incoming 10 kV substation HSP01 from April-August 2008. Power quality measurements were also performed in Gryaabs other 10 kV substation HSP04 fed from HSP01 and at the terminals of the induction motor IN_PU4040 of 1.3 MW which controls one of the four large inflow pumps to the plant. The reason for the latter measurement was due to registered negative transients each time the motor was connected to the grid. The cause of the transients could be explained by the coupling in the substation, the ageing of the motor which could result in damage of the bearings or resonance in the motor circuit which amplifies high frequency harmonics.

This thesis aims to present the essential background on how to perform climate changeimpact assessments, and to present the results from a climate impact assessment on waterbalance and nitrate leaching for an arable Swedish soil. The soil is a sandy soil in southwesternSweden, grown with spring cereals. This study is meant to be a benchmark example,and cannot be seen as a regional or national assessment for Sweden, rather as an approachto present and analyze the most important parts of these kinds of assessments.A dynamical simulation model (COUP, Jansson and Karlberg, 2004) was used for thisstudy. The model was parameterized and calibrated against data from an experimental site,located in Mellby in Hallands county, south western Sweden. Measurements were carriedout between 1st of April 1988 and 1st of April 1991.

Reducing the CO2-pollution, resulting from the combustion of fossil coal for energyproduction, is important to affect environmental changes. One way to achieve a reductionis to use the oxy-fuel technology. The technology uses O2 and re-circulated flue gasduring the combustion which results in a flue gas mainly consisting of CO2. The flue gascould then be compressed and stored without environmental effects. A problem thatfollows from the compression is the risk of acidification in sensitive parts of the process.Acidification can occur because of reactions following from the contact of condensedwater and sulphur- and nitrogen-oxides which are also present in the flue gas.This report compiles and evaluates the basis of a scientific unit with the purpose ofexploring the possibilities of extracting impurities of SOx and NOx from the flue gases.The dimensions of the unit are based on basic conditions, defined for an existing oxy-fuelprocess at Chalmers, and on the results of computer modelling.

On a request from the water sewage plant Gryaab in Gothenburg a power quality survey wasperformed. The voltages and currents have continuously been sampled in the incoming 10 kVsubstation HSP01 from April-August 2008. Power quality measurements were also performedin Gryaabs other 10 kV substation HSP04 fed from HSP01 and at the terminals of theinduction motor IN_PU4040 of 1.3 MW which controls one of the four large inflow pumps tothe plant. The reason for the latter measurement was due to registered negative transients eachtime the motor was connected to the grid. The cause of the transients could be explained by thecoupling in the substation, the ageing of the motor which could result in damage of thebearings or resonance in the motor circuit which amplifies high frequency harmonics.

On a request from the water sewage plant Gryaab in Gothenburg a power quality survey wasperformed. The voltages and currents have continuously been sampled in the incoming 10 kVsubstation HSP01 from April-August 2008. Power quality measurements were also performedin Gryaabs other 10 kV substation HSP04 fed from HSP01 and at the terminals of theinduction motor IN_PU4040 of 1.3 MW which controls one of the four large inflow pumps tothe plant. The reason for the latter measurement was due to registered negative transients eachtime the motor was connected to the grid. The cause of the transients could be explained by thecoupling in the substation, the ageing of the motor which could result in damage of thebearings or resonance in the motor circuit which amplifies high frequency harmonics.

In this project an iPhone application for storing food and drink experiences was developed with focus on an easy interaction design. The already existing market of similar applications were studied and evaluated to extract their positive and negative features. Interviews with experts within the food and drink business where made in the pre study to get a good perception of how to divide and categorize the sections in the application. To optimize the usability, workshops with potential users with different technical experiences where continuously held during the development of the design.During the development two variants of development environments where evaluated. The final result of the application was developed in the environment that made the best impression and seemed to be the best alternative.The resulting product has a thought out design meant to be easy to understand, even for the first time users.

As organizations are generating more business intelligence in their systems, more employees need access those systems. As a result some sort of permission management needs to be implemented to ensure the information remain safe. Access Control Matrix (ACM) is one way of managing permissions and is widely used among organizations. The issues that comes with ACM is that the matrix itself gets difficult to manage and overview as its complexity increases with the number of permissions. The study utilizes Action Design Research to develop a tool for visualizing permissions.

The thesis is a case study that deals with public space based on how people use them. Public spaces are an important part of our city life and everyday life. Quality public spaces and places are due to its design and use, which are the primary aspects of this study. Hässleholm has been the location for the case study inventory items. Five different methods have been the basis for the study, and through them it has been possible to study what makes a room usable and unusable and what criteria is necessary for people to want to stay in the public rooms.

On a request from the water sewage plant Gryaab in Gothenburg a power quality survey wasperformed. The voltages and currents have continuously been sampled in the incoming 10 kVsubstation HSP01 from April-August 2008. Power quality measurements were also performedin Gryaabs other 10 kV substation HSP04 fed from HSP01 and at the terminals of theinduction motor IN_PU4040 of 1.3 MW which controls one of the four large inflow pumps tothe plant. The reason for the latter measurement was due to registered negative transients eachtime the motor was connected to the grid. The cause of the transients could be explained by thecoupling in the substation, the ageing of the motor which could result in damage of thebearings or resonance in the motor circuit which amplifies high frequency harmonics.

I denna artikel ämnar vi, genom att studera olika modeller med stöd för olika designsituationer, att skapa en modell som specifikt stöder design av crossmediaproduktioner då en sådan inte existerar i dagsläget. Genom att själva arbeta med en crossmediaproduktion för Non smoking generation fick vi chansen att på nära håll studera designprocessen och kunde på så sätt identifiera dess beståndsdelar och aktörer. Baserat på dessa och i kombination med teorier om design och crossmedia kunde vi skapa en egen modell som kan stödja framtida designers och producenter i deras arbete med designen av crossmedia..