The task of this project was to build an computer processing system for pressureregulation, in which the pressure loss over the open hydrolicvalve should be kept as low as possible. By using an cross connected proportional directional valve the valve problem could be solved. The control- and regulationproblem for the pressureregulation system was solved by using the DAQ- card NI6035E from National Instruments and the computerprogram Automatic Pressure Control 1.0 which has been software developed and written in Visual Basic. The final result showed that correct processvarible was obtained in 0,5 seconds, when the setpoint was changed in the testarea 0 - 2,5 MPa..

As IT service departments in organisations are becoming more complex and customised, the indirect costs are increasing in relation to the total costs. The difficulty of fully estimating and identifying the spread of the cost in the IT service department is increasing. As a result, firms tend to budget the business unit as a total cost rather than as a spread of defined costs. In order to deal with this challenge an ABC calculation will be applied. The Time Driven ABC model will be conducted in OMX´s Servicedesk unit within the IT services.

Young people?s political influence has been surveyed, studied and discussed several times in Sweden during the last decade. There is a fear among the politicians that the young people are not interested in politics, especially not in party politics. On the other hand there is, among the youngsters a feeling of invisibility, not being seen or heard or for that sake respected. There are a lot of formal possibilities for young people?s political influence, but there are not as many real possibilities or situations to actually practice these possibilities.

This thesis work has been performed at the department of diagnosis and dependability at Volvo Car Company, Torslanda. The background of this project is based on interest in ascertaining how different factors possibly can affect a diagnosis method, which has been developed to find leaks in the fuel tank and evaporation system. According to the OBD II requirements leaks with an orifice diameter larger or equal to 0,5 mm, must be detected. The idea of the diagnosis method is to create an over pressure in the system with an air-pump. The current through the pump is measured and correlates to the power consumed by the pump.

Dysfunction of the upper respiratory tract is a common cause of impaired performance and intolerance to exercise in racehorses and include several upper airway obstructions. The ones termed dynamic obstructions are primarily seen during physical exertion and affected horses often appear to be normal during endoscope examination at rest. The correlation between diagnoses made at rest respectively exercise is low, suggesting that an examination at rest alone is likely to be insufficient. The upper respiratory tract is exposed to great differences in pressure throughout the respiratory cycle; variations that are further altered during strenuous exercise and affect the rigidity of upper airway structures. In presence of great fluctuations in pressure, stability is achieved through coordinated and synchronous neuromuscular mechanisms. Due to nerve damage or anatomical abnormalities, these functions may be disrupted and further cause a dynamic collapse of the upper respiratory tract when pressure changes become too severe. The etiology behind the neuromuscular dysfunction is not yet fully understood.

Aim and scientific issuesThe aim was to identify potential health risks, for full-time working parents with small children, caused by time shortage. The intention was to better understand and help this particularly time-pressured group in society to achieve a healthier lifestyle. The identification was built upon their own opinions about possible health risks and upon an interpretation of the health risks from a health promoter?s perspective.How do full-time working parents with young children handle time-shortage in a health perspective, specified in the categories: sleep, recovery, nutrition, physical activity, social health and mental health?What consequences for health does time?shortage have for full-time working parents with young children?What do parents with young children think could help them to obtain a better health in everyday life? MethodThe study was based on a literature overview and semi-structured interviews with 6 people who were strategically selected: the interview objects were all full-time working or studying, had one child under 7 and lived together with a partner. All interviews were recorded using two dictaphones and were implemented, transcribed and analyzed by both writers of this essay to increase the reliability of the results.ResultsTime shortage is shown to be handled especially through priorities in the respondent?s lives.

The aim of this thesis is to study the reading habits of Swedish librarians visualized by librarians from Götabiblioteken ? a collaboration of 14 public libraries in mid-Sweden ? focusing on the reading done on their spare time, even if work-related. We started with a survey sent out to 74 librarians in October 2013, answered by 56, and followed up by interviewing 7 of them in November.We tried to answer these questions:To what extent does the working librarians read on their spare time compared to before they started working?What literature do they read, now compared to before they started working?To what extent does their perception of what they should have read affect their private reading?In what way does a librarian in the beginning of their career differ in reading habits from the reading habits of a librarian with many years in the profession?The result of our study shows that most of the librarians read as much or more than before they started to work. They are more selective in their choice of literature and are affected by their work in it in different ways.

An automatic control system for calibration of pressure indicators has been constructed. This control system can be used as a complement to the calibration system located at AerotechTelub, division MainPartner, in Linköping. The calibration system used today contains some not wanted pressure changes, which is compensated by hand today. The new system presented in this report automates the calibrating process and simplifies the calibration. Suitable hardware as motor, controls card and so on have been found and software in the form of Visual Basic program has been developed.

The objectives of this research were to determine whether the natural rattan resources in Sulawesi, Indonesia can cope with the strongly increased harvesting pressure that has occurred over the last centuries. I was furthermore looking for patterns in the rattan population dynamics that might give a hint on how the harvesting system could be improved to ensure a maximum sustainable yield. To answer these questions, I developed an individual-based model to analyse the dynamics of rattan growth in connection with rattan harvests by locals to identify sustainable levels of rattan harvests around villages in Sulawesi, Indonesia. Scenarios with different harvesting intensities were run to compare the change in harvest amount. For a given harvesting pressure, scenarios with a high number of harvesters and a low harvesting frequency had the same effect as scenarios with high harvesting frequencies and a low number of harvesters.

In Uppsala CHP Plant, there are six pressure reducing valves to reduce the pressure from 15 to 3 bars, before six absorption heat pumps. During the process the energy is conserved but losses occur in form of exergy. The aim of this thesis is to reduce the losses of exergy. This can be done by letting turbines replace the pressure reducing valves.In this thesis an investigation has been done of the conditions today, the conditions after the change from pressure reducing valves to turbines and a comparison of three different types of turbine solutions. The three examined solutions are one turbine, several helical screw expanders and several small turbines in parallel with asynchronous generators.The six absorption heat pumps have been divided into two groups; one group of four and one group of two absorption heat pumps.

Bakgrund och problem: Tidigare studier visar att budgeten fortfarande i hög grad är aktuellsom styrverktyg i svenska företag. De allra flesta företagen i Sverige arbetar med budget somett integrerat verktyg i sin verksamhet. Detta gör det intressant att närmare kartlägga hur verksamheternaanvänder sig av budgeten då få studier har belyst själva budgetprocessen eller hurföretagen arbetar fram sin budget. Vidare är det intressant att titta på hur budgetanvändandetser ut, hur uppställandet av budget går till, hur processen ser ut och hur integreras den färdigabudgeten i styrningen av företaget. Det kan även vara intressant att titta på hur och om företaglyssnat på kritiken och vad dem i så fall gjort för att förbättra och förändra den egna budgetprocessen.Syfte: Huvudsyftet är att kartlägga hur små/medelstora företag i Sverige arbetar med budgetprocessen.Bisyftet är att undersöka respondenternas uppfattning om budgeten.Metod: En enkätundersökning riktad till 20 ekonomichefer/controllers på små/medelstoraföretag i Sverige har genomförts.

Equine metabolic syndrome (EMS) it?s a clinical condition that includes obesity, regional adiposity, insulin resistance (IR) and laminitis. A similar syndrome exists in human medi-cine, the metabolic syndrome (MS), were systemic hypertension also is a prominent fea-ture. The systemic hypertension seen in humans with MS is partly due to a vascular endo-thelial dysfunction with an enhanced endothelin-1 (ET-1) mediated vasoconstriction. There are indications that systemic hypertension might be a feature in EMS as well but if ET-1 is involved in the development of the systemic hypertension in horses is not known.

Stump treatment today requires large quantities of clean water mixed with the protective product Rotstop, to fully cover the stump surface. In order to reduce the water consumption without reducing the coverage of the stump surface, the pressure in the stump treatment device can be increased. Therefore, the Phlebiopsis gigantea (Fr.) Jül. suspension used as a biological control agent to prevent Heterobasidion annosum (Fr.) Bref. infection was pressure-tested.

Background: The global responsibility for multinational companies is a current matter of subject. Now when the world increasingly is getting globalized, economic growth is created, which brings a bigger demand of responsibility on companies. The leading companies from every industry is often becoming the frame for how the production process works and is therefore exposed to outer pressure which, for example, is coming from consumers and the media. Since consumers at present are more aware of what they are buying and where it comes from, it is important that the companies take social responsibility. We have therefore studied three big companies within the clothing industry to see in witch way they are taking their social responsibility.Purpose: Our purpose was to explore how companies within the clothing industry describe their work with Corporate Social Responsibility, code of conducts and where the incentive behind this work is coming from.Method: We have, through a qualitative study, examined how three large companies work with Corporate Social Responsibility.

In recent years the construction industry has been exposed to increased time pressure which has resulted in a higher amount of wastage. Today 35 % of all construction projects in Sweden is "wasted". Time pressure has risen due to increased competition on the market, with more actors entering the construction business, therefore profit margins decreased which has led to a more pressing need for decreasing the amount of wastage.Bravida is Scandinavia's largest supplier of installations and provides specialist services in electrical installations (heating and sanitation), and ventilation. Mahdi Bawaqneh's task was to investigate where, how and why wastage occurs in the company's projects and how to prevent such wastage. The thesis covers the subjects of lean production, communication in projects and planning of projects.