Hudiksvall Municipality will build a new preschool. The goal is that the pre-school should reflect the municipality's environmental goals and meet building regulations. The wall structures that are compared in the report is an insulated wooden frame and a frame of lightweight concrete blocks from H + HWall structures are compared within the areas of U-values, air tightness, thermal storage capacity, fire ratings, moisture, durability, emissions and environment. In these categories the two wall structures will be rated in a scale from 1 to 5 and then the categories are weighted against each other. The weighting is based on Hudiksvall Municipality's assessment of the categories importanse for their final selection.The results of the comparison show that the concrete structure is recommended for the construction of pre-school with 27.55 points against the wooden structures 23.70 points.

This examination paper is a study of the indoor climate in a theatre and a practice room for orchestras placed in Sickla in Stockholm. The designer of the ventilation system wondered if he had managed too make a good environment for the users and he also wondered which of the rooms that had the most desirable climate. The project includes polls for visitors, interviews of people connected to the rooms and measurements of the physical environment. The results show a small dissatisfaction about the thermal indoor climate, it?s a little bit to cold and the air draws.

This essay ? Discourse and Dissonance ? deals with Mary Shelley?s gothic novel Frankenstein; or, the Modern Prometheus (1818). The focal point is the construction of ?Them and Us?, as defined by scholars such as Stuart Hall, viewed in terms of the following categories: race, gender and family, class, and sexuality. Rather than applying an outside perspective, e.g.

This thesis describes new methods for automatic crack detection in pavements. Cracks in pavements can be used as an early indication for the need of reparation.Automatic crack detection is preferable compared to manual inventory; the repeatability can be better, the inventory can be done at a higher speed and can be done without interruption of the traffic.The automatic and semi-automatic crack detection systems that exist today use Image Analysis methods. There are today powerful methods available in the area of Computer Vision. These methods work in higher dimensions with greater complexity and generate measures of local signal properties, while Image Analyses methods for crack detection use morphological operations on binary images.Methods for digitalizing video data on VHS-cassettes and stitching images from nearby frames have been developed.Four methods for crack detection have been evaluated, and two of them have been used to form a crack detection and classification program implemented in the calculation program Matlab.One image set was used during the implementation and another image set was used for validation. The crack detection system did perform correct detection on 99.2 percent when analysing the images which were used during implementation.

Weathering on rocks is an important component of the world?s geomorphology. One way to measure weathering on rocks is to analyse rock hardness. This is a study conducted in the northern hemisphere on granite rocks in Uppsala, Sweden. A Schmidt hammer is used to create a correlation analysis between the aspects on three glacial erratic boulders and rock weathering.

The energy consumption continues to increase as the use of electronics and energy consuming equipment increases. The use of fossil fuels has to be phased out for this to be sustainable in the long run while the use of renewable energy continues to increase. A renewable energy source is solar energy but the production of heat and electricity are today very expensive compared to other energy sources and an important task for the solar energy market to grow is therefore to minimize the production cost of the solar collectors while increasing its efficiency to produce heat and/or electricity. One way to convert solar energy into heat is by using solar collectors and electricity can be produced by utilizing the produced heat, or by applying solar cells.This thesis aims to recommend a reflective material for the next generation solar collectors from Absolicon and to recommend a commercially available coating for the receiver tube of the solar collector. A market study has been carried out to investigate the cost-related aspects along with the optical and durable aspects for the optical material of the solar collector.

AbstractThis report intends through a case study to investigate if lightweight concrete isappropriate as main material in the outer wall of a seven storey residential building.A technical design is carried out in accordance with the definitions and requirementsfor passive houses, given by FEBY?s1 ?Demand specification for passive houses?.A literature review is also carried out for a comparison between regular bolt wall andlight weight concrete wall, with a focus on the safety of moisture.The lightweight concrete block used in the report is as a celblock produced by thecompany H+H Sweden AB.The methods used have resulted in compliance with requirements andrecommendations from authorities. Calculations of energy, noise and moisture riskassessment has been carried out.The work has resulted in the conclusion that the lightweight concrete itself is notable to isolate in the extent necessary to obtain chosen U-value of 0,1 W/m2 ° C,without getting to thick. Therefore additional insulation is needed. There are fewrelevant reference objects built with only light weight concrete.

AbstractThis report intends through a case study to investigate if lightweight concrete isappropriate as main material in the outer wall of a seven storey residential building.A technical design is carried out in accordance with the definitions and requirementsfor passive houses, given by FEBY?s1 ?Demand specification for passive houses?.A literature review is also carried out for a comparison between regular bolt wall andlight weight concrete wall, with a focus on the safety of moisture.The lightweight concrete block used in the report is as a celblock produced by thecompany H+H Sweden AB.The methods used have resulted in compliance with requirements andrecommendations from authorities. Calculations of energy, noise and moisture riskassessment has been carried out.The work has resulted in the conclusion that the lightweight concrete itself is notable to isolate in the extent necessary to obtain chosen U-value of 0,1 W/m2 ° C,without getting to thick. Therefore additional insulation is needed. There are fewrelevant reference objects built with only light weight concrete.

Ocean Thermal Energy Conversion (OTEC) is a technology that utilizes the temperaturedifference in oceans between the warm surface water and the cold water at 1000 m depthto produce electricity. The purpose of this report is to investigate if OTEC with its synergiescould become a commercially feasible energy solution for a small island. A literature reviewis conducted to explore the different OTEC technologies and to what extent the threesynergies; fresh water, air conditioning and aquaculture, could be used. In order to calculatethe profitability of these synergies there is also a study conducted on the conventionalmethods and cost of fresh water production, aquaculture and air conditioning. A model is setup using a scenario of a small tropical Island with population of 100 000 people.

Legionella can be prevented, the question is how. This report is a degree in construction engineering education at Chalmers University in Gothenburg. A comprehensive written publication for Legionella-safe plumbing installations is not available and therefore requested. The purpose of this report is to present preventative measures against Legionella bacteria growth in tap water and in other systems where Legionella bacteria are a potential problem. Technical solutions are presented including how different systems function and what their advantages and disadvantages are.

In the farrowing pens the amount of bedding material and the quality of the concrete floor has a huge impact on both the sow and the piglets. In this study imbedding of rubber flooring on the solid area in the farrowing pen was used to see if it had any effects on the sows lying behaviour when compared to concrete. Another important aspect was to evaluate if the rubber floorings had a high enough durability to resist the normal wear in a farrowing pen. Concrete flooring is assumed to have a higher thermally conductive effect then rubber which can affect the sow?s chance to cool down.

This thesis deals with cross-country ski clothing for non-competitive women. Women in this category look for different clothing features in comfort and aesthetics than male top athletes, for whom cross-country skiwear today often seems to be designed. In this thesis the demands of these women have been mapped out by an interview with a reference group of users. The ergonomics of exercising in the winter outdoors are naturally a base for the collection. The collection consists of three functional layers of garments.

This thesis considers the use of an oldrock cavern as thermal energy storage.With a large system of differentchillers a model was created to find anappropriate future system. There aremainly two trajectories to take. Eitheran installation of chillers needs to bemade or the rock cavern can be used tomeet the future demand of districtcooling in Solna, Sweden. Additionallythis thesis investigates the possibleuse of different techniques to utilizethe phase change energy of water.Simulation shows that it?s possible toutilize the phase-change energy of afluid; however it?s not economicallyfeasible due to the thermodynamiceffects on the Carnot cycle.

Jämtkraft AB which is a power production company in Sweden has bought two newhydro power units to their station in Hissmofors. The two new generators are using aconcept with sliding stator feet to handle the thermal expansion.The concept with sliding stator feet on hydro electric generators has not beenworking satisfactory on many hydro power stations in Sweden and has caused a lot ofcosts due to long downtimes.The new station in Hissmofors is very important for Jämtkraft AB, and therefore theywant to know how to make sure that the sliding stator feet are working as theyshould. According to theories and a simplified model of the generator the stator feetdisplacement should be around 1 -1,6 mm.The generators are delivered with a surveillance system that will measure thedisplacement of the sliding stator feet. The signal from the system isn?t accessible forJämtkraft AB but it will alarm when the sliding stator feet are malfunctioning.To secure the function of the sliding feet a logger for the surveillance system or adifferent measurement system must be used; if both systems are used Jämtkraft cansecure the function of the surveillance system..

Samtidigt som debatten kring jordens klimatförändring är i full gång har intresset för att miljöcertifiera byggnader vuxit oerhört. För fastighetsägare är det en möjlighet att bevisa för sina hyresgäster och köpare att byggnaden är hållbar. Är en byggnad miljöcertifierad har en oberoende part intygat att den uppfyller en nivå av hållbarhet som bestäms utifrån standardiserade kriterier. Fastighetsägaren kan alltså använda certifikatet i marknadsföringssyfte.Den här studien undersökte om en byggnad som är byggnadsminnesförklarad kan miljöcertifieras med Miljöbyggnad. Målet var att hitta kostnadseffektiva lösningar för att uppfylla de miljöcertifieringskriterier som eventuellt inte uppfylls idag.