When drivers overnight in the truck lots of electric energy is consumed by heaters, fans, lights and other extra equipment. If the engine is not running, this energy is taken from the lead/acid batteries of the truck which then needs to be recharged during operating hours. The fact that the charge acceptance of the lead/acid batteries is dependent on the temperature makes it hard to fully recharge the batteries at lower temperatures. A negative charge balance can lead to starting problems within a few days use in cold climate.In this thesis work, the effects of different battery charging concept are evaluated on the most common Scania battery (175Ah). A battery model is implemented in Matlab and some simulations of charging are made.

Glass has sophisticated front properties and are used as facades in high buildings. During cold periods, these glass facades could cause thermal discomfort, due to cold downdraught. Cold downdraught can be countered by placing heaters under glass surfaces. Nowadays technology offers highly insulating windows, which is why there is an interest to investigate the indoor climate with only underfloor heating. The research in this area is limited, and few empirical methods are available.

Many organizations utilize decision support systems in order to handle different tasks and tosupport the decision-making process. Decision support system is a broad term used to referto several different types of systems. These types of systems can handle a wide range ofoperations within the organization. Consequently this will have an impact on differentoperations within the organization. The main aim of this study was to create a betterunderstanding regarding the impact of decision support systems on the various operationswithin the City Council's procurement units which in turn will increase effectiveness.

The master thesis, conducted at Metrima AB, concerns the development of a non-intrusivedistribution meter as a basis for individual tap water billing in apartments.The project is conducted in response to the market interest in individual tap water billing inapartments as an answer to environmental concerns regarding water consumption. Due to thehigh installation cost of traditional water meters, a new method of determining waterconsumption, without having to cut water pipes, is proposed.The proposed method distributes the total water consumption for an apartment complex toindividual apartments according to distribution meters, measuring water run-time, in eachapartment. The water run-time is estimated by measuring the water pipe?s outward vibrationsand temperature changes.A test environment was established and a prototype built, using a tilt- and vibration sensor forvibration sensing and a precision temperature sensor to measure temperature changes. As bothsensors work well in the test environment, further testing was done in 3 apartments for aduration of 5 days.

Lower energy use in buildings is a result of increasingly stringent energy requirements across Europe. When conventional district heating technology is used in areas with low energy consumption heatlosses do not fall even though the amount of energy delivered is reduced. This reduces income for thedistrict heating company. To maintain their economic viability the district heating companies? majorchallenge is to implement new solutions that minimize heat loss.

The work was carried out on Termisk Systemteknisk?s office in Linköping. The aim was to create a computer system with infrared camera technology for quality control and Temperature monitoring of manufacturing processes in industry. The system should be configurable such that it can be used on several different issues, including those where the real-time analysis of camera images is required.The developed system is based on an existing framework, Panola, to deal with measurement results and images in a database. The framework is built for the system continually check for new data , and the task was to create a foundation upon which to build systems that use the framework, but fully or partially utilize direct calls .

Det problem som denna uppsats hade för avsikt att besvara var varför hemautomation inte används i fler hem. Genom resultaten från en enkät som distribuerades kunde slutsatsen att kostnaden för de befintliga lösningar som finns på marknaden idag inte låg i den prisklass våra respondenter ansåg rimlig. Författarna utvecklade då problemet och ställde sig frågan om en hemautomationslösning verkligen måste ha en så hög kostnad som de befintliga lösningarna har idag. För att belysa detta problem implementerades en egen kostnadseffektiv lösning där respondenternas mest önskvärda funktioner togs i beaktande och en testmiljö implementerades utefter dessa. Resultatet blev en hemautomationslösning med stor potential och med en betydligt lägre kostnad än dagens befintliga lösningar..

Due to human influences on the climate an increase in Earth's mean temperature is today an accepted conception. With a rising temperature discussions have started how the climate in an area will change in the future. Equally interesting and important is it also to study the precipitation in an area. Precipitation is the factor, next to temperature, that affects most how a climate in an area looks like and feels. Since precipitation is connected to evaporation the latter parameter is also of interest to study.

Increased understanding of the mechanisms that operate in conjunction with the welding of metal surfaces may help to improve existing manufacturing processes, and to enable new products and combinations of materials. The purpose of the project has therefore been to acquire a deeper understanding of what is happening in the bond for steel and for the factors that form the basis for a bond to develop between metals in the production of laminates by pressing. The merge has been done by pressing and the surfaces after the experiments have been studied in detail in the scanning electron microscope (SEM), energy dispersive X-ray spectroscopy (EDX) and with interferenceprofilometry in Wyko, to provide a greater understanding of the mechanisms that influence the bonding in the interface between metals. The project was limited to contain the materials Docol 1000, HyTens 1200, Aluminum AA3003 and a commercial steel. The parameters varied in the experiments to study their influence closer are temperature, pressure, heat treatment and pretreatment. This has been implemented by pressing with varying temperature and pressure.

The aim of this thesis is to improve the control of urea injection at the combined power and heating plant Framtidens Gärstad (FTG). Tekniska Verken i Linköping AB is the owner of the plant.The FTG plant consists of a boiler where garbage combustion is done. From the combustion nitrogen oxides are emitted. These nitrogen oxides are hazardous to the environment. To reduce the nitrogen oxides, injection of urea into the boiler is used.

The Earths climate is changing at a higher rate, i.e between 1861 and 1994 the annual mean temperature in Scandinavia increased with 0,68º C and according to recent climate models the annual mean temperature is likely to rise with another 3º C during this century.A warmer climate in many ways is associated with changing conditions for lake ecosystems. An expected higher water temperature and a stronger summer stratification of the water column increases the risk of anoxic conditions at the lake bottom. Thus anoxic conditions are likely to cause a phosphate leakage from the sediment, i.e. a higher internal loading of phosphate.In this project, the extremely warm summer of 2002 has been used as an example for a possible scenario for a future climate. By comparing levels of phosphorus in the summer of 2002 with a ten-year median value, a phosphorus related sensitivity to climate change has been analyzed for 55 Swedish lakes.

AbstractWith increasing population and increasing demands for comfort and thus an increase in energy demand, it is necessary to examine various energy-efficiency measures. This work deals with the ability to control the flow through the heating system to achieve the desired comfort with as little energy as possibleA heating system contains of different parts, roughly speaking, you can divide it to three main components: Heat source, Distribution and Heat emitters. All components are working together to bring heat to the building. What is examined in this report are different ways of adjusting the flow and supply temperature and how it affects comfort and energy use in a building.At today ?s date the conventional method is to use a high flow through the heating system, which affects pressure drop and cooling of the fluid.

Running water-pathways have played an important roll in Sweden and frequently been manipulated. One profound change was made during the period of logging when streams were cleared from obstacles as big boulders, sharp bends and side-streams. Dams and different constructions gave control of the stream water and the streams became channel-like with a homogen structure. This interference gave problems for many fish populations and resulted in a shortage of feeding habitat, over-wintering habitat, spawning habitat, unnatural flow regimes, sedimentation, unnatural temperature fluctuations. Many of these historical changes of the watersheds are now subjects for restoration, ie., bring back the streams to what we believed it was before the change. However, what once existed in terms of complexity is now gone and difficult toreplace.

Energy price are on the way up to a high level that will not diminish in the future make us to focus more on the sustainable development for a better solution of residential houses. Passive house or low energy housing are one of the solution to make residential more environment friendly, in same time it´s a financial security using less energy, and saving money. The last 10 years in Germany and all around Europe the concept of passive house been developed, and people aim to know more about these concept that leading the market more attractive for passive houses. A passive house is a well designed building highly insulated and air tight with mechanical ventilated system for the whole building envelope that minimizes the use of energy for heating [1].The housing company Mimer has chosen to invest in low energy consumption in every new housing project.  These future plan projects are decided to use less than 75 kwh per square meter annually in purchased energy [2].This thesis is about new constructed passive houses, and focuses on the evaluations of the temperature, and moisture condition for attic, external walls and joist.

Introduction:By insight in the company and by monitoring the management, the board has an important function in creating trust in governance of the company. Furthermore, the board reduces the asymmetry of information between the owners and the management, which also is the function of the auditor, by auditing how the board governs the company and the accounting. In case the board does not effectively monitor the management, the auditor has to extend its monitoring, which increases the owners agency costs through the audit fee. The board composition can affect how effectively the board practices the monitoringProblem: How is the audit fee affected by the board composition?Purpose: The purpose of this study is to explain how the board composition affects the audit fee.Method: The study uses a quantitative method, where the data was collected from the annual reports of 112 limited companies listed on the NASDAQ OMX Large and Mid Cap lists on January 2, 2012.