The use of silicon carbide (SiC) as a base material in power electronics has manyadvantages, including high breakdown voltage and excellent temperature endurance.However, the packaging of such electronics presents major challenges and there is aneed for packaging that can operate in higher temperature. The purpose of this thesishas been to develop a test method and verify the functionality of SiC powertransistors prototypes with a new packaging technique developed by Swerea IVF AB.It includes setting up an electrical test-bed for power and high temperature cyclingand analysis of the results. Even though test confirmed functionality after thepackaging process, (at room temperature) the performance seemed to have been reduced. This could be a result of the measurement setup and the packaging process.In higher temperature the transistors failed to operate longer than a couple ofminutes which showed the weaknesses in the design and the challenges with this typeof packaging..

The exhaust arrangement on a Scania V8 consists of one manifold at each bank connected to a twin entry turbine (8-2-2). A study in GT-Power has shown improved performance and reduced cylinder to cylinder variations using two manifolds at each bank in combination with a single entry turbine (8-4-1). This thesis work analyses the difference in performance shown in simulation and verify it by engine test.The initial work was focused on simulation in GT-Power. Investigating how exhaust manifold volume and pulses effects the turbine efficiency and the mean effective pressure during the gas exchange. To verify GT-Power simulations four engine tests with different exhaust arrangement have been made.The results from GT-Power simulation indicate that a larger exhaust volume improve the turbine efficiency.

The purpose of this thesis was to design an electrical system for use in a ballistic test at the Swedish National laboratory of forensic science (SKL). The detector unit would use four main parts: coilsystem, transmitter, reciever and indicator. The coilsystem would be based on a balanced system using three coils. One that creates a magneticfield and the other two will sense the differences when a metallobject is in the coilsystem. This report starts out by investigating possible solutions for this specific task followed by a description of the physics that the metaldetector use.

There are several ways of conducting software testing where some may include users and others may include personnel whose work task is to execute test on systems. Although most developers and project managers understand the point of testing the system, it is not always being done and the most common reason is that there is no time for it. However, this is a false assumption as it may instead cause some bugs in the system that would not have been there in the first place if tests had been there to prevent bugs in the code.My purpose for this thesis was to find suggestions for changes in the development process in an ongoing project used by Acino and Svenska Försäkringsfabriken in order to increase the quality of the system used. In this thesis, I have approached the purpose by pursuing a case study of the two companies through observation and interviews. By doing this I acquired the relevant information to make suggestions for change.

Syfte: Syftet med den här studien var att undersöka repeterbarheten hos Schirmer I test samt att undersöka om det fanns något samband mellan Schirmer I test och enkäten TERTC-DEQ.Metod: 26 personer deltog i studien. Innan första mättillfället fyllde försökspersonerna i ett informerat samtycke och enkäten TERTC-DEQ. De undersöktes med hjälp av ett biomokroskop och deras ögon graderades med hjälp av Efron och CCLRU grading scales innan första mättillfället. Schirmer I test mättes vid tre tillfällen med en veckas mellanrum.Resultat: Resultatet av mätningarna visade att det var låg repeterbarhet hos Schirmer I test om man utför tre upprepade mätningar. Resultatet visade också en korrelation mellan testresultaten och enkäten TERTC-DEQ (r=-0,6184), det vill säga de försökspersonerna som hade ett högt resultat på Schirmer I test hade också en låg summa på enkäten TERTC-DEQ.

In this master thesis a robot arm belonging to an automatic milking machine from DeLaval is investigated. The robot arm is controlled by a pneumatic cylinder and a valve. The goal of the master thesis is to investigate instability problems and to find out if it is possible to solve them by using gain scheduling. Gain scheduling is a type of controller where the parameters of the controller are changed during operation, for example depending on the working point. First a nonlinear mathematical model of the system was made.

Simulation means running a model of a system with suitable input and observing the corresponding output. Real-time environment simulation is a special kind of simulation used to simulate a control system's environment in real-time. This is done to test the control system before it is used in its real environment. In this project, computer simulation of a certain kind of environments, called track-based systems, is studied and a general model for track-based systems is developed. In this model, track layouts are represented by graphs, which is a flexible and extensible representation and a method for visualizing these layouts is presented.

Background: The Swedish population is aging [1] and malnutrition is a common problem among elderly people [2]. A method called food registration is used to monitor the patients? nutritional intake, with the purpose of reducing the risk of patients deteriorating in nutritional status during hospitalisation. However, the current method is not satisfactory and many food registration lists are incomplete. [3-6] Thus, patients do not receive a qualitative nutritional care since the assessment of the patients? nutritional status is based on incomplete documentation.Purpose: The purpose of this master thesis is to increase the quality in the nutrition monitoring process in the geriatric units B72 and B74 at Karolinska University Hospital in Huddinge, Sweden.

The aim of this essay is to create an understanding, of how teachers comprehend knowledge, grades and tests in a school context. It is important to get a grip of the different parts of the teacher?s reality. The test, the grades and knowledge are deeply connected as a part of a whole. The teachers view on knowledge can not be understood without asking about the practical parts of their work and understand how the different parts are dependent on each other.The main material consists of interviews with four teachers that work in a public mandatory school in the south suburbs of Stockholm.

The division of Engineering Materials at Linköping University, department of Management and Engineering, conducted a research project concerning Fatigue life of thermal barrier coatings during 2009. During this project equipment to provoke these fatigue failure by rapidly heating and cooling test subjects in cycles, was ordered.Design and manufacturing of the equipment was handled internally at LIU.The equipment was built using a furnace that is lowered and raised over the table where the test subject is placed. To keep the temperature of the furnace a lid slides in place to close the downward facing opening of the furnace when it is in the raised position. On this door there is nozzle that is used to cooling of the test subject by air.To make sure that the equipment can work independently you need an automation controller that can evaluate if movement can occur without danger of collisions. The control system also needs to monitor that all elements are performed according to plan.This degree project is based on a modular system from OPTO 22 and includes the configuration of a PLC that will be supplied with logic and a user interface.The degree project resulted in a graphic interface in which a user can set desired values for different parameters and get information about current values for them.

AimThe aim of the present study was to evaluate physical performance according to ?fysprofilen? in skiers of the Swedish mogul ski team and to compare their physical performance at three test occasions during one year.MethodsAll eight elite mogul skiers at the Swedish national mogul ski team during the seasons 2011/2012 and 2012/2013 participated voluntarily in this study. The test battery ?fysprofilen? was performed at three test occasions, October 2011, May 2012 and October 2012. Muscle strength was evaluated with squats, bench press and grip strength; power was evaluated with power clean, squat jump, countermovement jump with and without arm swing, Harre´s test and the 30 meters sprint.

Small scale internal consumer tests provide a company with a cheap way to get valuable information regarding their products advantages and flaws. Therefore the demand for possibilities to do this kind of test has increased. This report is part of a new sensory project at Unilever. It presents a method for sensory comparison of the company?s own products with the corresponding competitor products.

The occurrence of small amounts of albumin in urine, microalbuminuria (MA), is used both in human- and veterinary medicine as an indicator for patients who have developing proteinuria. Proteinuria can be prerenal, renal or postrenal which is important to establish during an investigation. With conventional methods decreased renal function is not detected until 70 % of renal function is lost. The ability to detect and start a treatment earlier might reverse or slow the progression of disease. The purpose of this study was to investigate the reliability of Heska® E.R.D.-Health Screen?, a test for microalbuminuria in dogs, to detect albuminuria.

Testing has always been an important task in the scope of software quality. Though it has never been as much appreciated within the management of the organisations as the software development has. However testing is becoming more attractive within organisations because it becomes more evident how much money working systems saves in contrast to defect ones. A tester often use testing tools to simplify the work progress. There are a lot of tools nowadays but not many evaluating models which helps the tester to know which one to recommend.

A speech-based material that early can assess a child's hearing is needed to provide an indication of a hearing impaired child's language development. Being able to identify and discriminate between different sounds is a requirement for interpreting speech. Hearing assessments that examine speech perception can therefore, unlike, for example, pure tone audiometry, examine a hearing impaired child's perceptual language skills and provide a basis for intervention.The purpose of this work is to evaluate a new auditory material on 3-year-old children. The auditory material is based on the Ling-6-sounds and the main question was which of the sounds in the test were adequate for test of discrimination. Furthermore, it was investigated how the test works with children aged 3:0?3:11 years and how age and gender affect the result.Twenty-four children aged 3:0?3:11 years were tested using a computer based test.