The purpose of this project is to analyze earthing systems for houses. By practical measurements and theoretical analyzes consequences of possible faults, that can occur within the facility and in the low-voltage distribution network, is illustrated.  The reason for this project is that nowadays one has to arrange with a main equipotential bonding system for buildings. Apart from that, if necessary, bathrooms must be provided with a supplementary equipotential bonding system.The practical measurements verify that potential differences in facilities may be due to voltage drops in the PEN conductor between the origin of the electrical installation and the power transformer.Based on the theoretical analyzes of possible faults, it is considered that the requirement for  supplementary equipotential bonding systems for bathrooms in most cases can be questioned, when basic insulation, fault protection, residual current devise and main equipotential bonding system already provides an adequate level of protection.A PEN conductor loss may result in a situation where metallic parts attached to the equipotential bonding system starts working as earth electrodes. Equipotential bonding system may also increase the incidence of stray currents. If TN-C-S systems is provided with a local connection to earth a redundant system against PEN conductor loss is obtained.

Stump wood is a hot alternative when the heating plants demands more and more forest fuel. The aim with the study has bean to calculate the costs in four different systems for transportations of stump wood, examine if there are any differences in fuel quality for the stump wood in the different systems, analyse if the fuel quality in stump wood is affected with the time it lays by the road side and how much space the stump wood demands on the road side. To calculate the costs for the different systems a system analysis was carried out, where some of the costs were collected through field studies on Holmen Skog stump experiment and other costs were collected from literature and contacts. Data for the fuel quality study was collected from Eons heat plant in Norrköping. Data for the study of how much space stump wood takes along a roadside was collected from field studies.

An automatic milking (AM) system should be combined with some form of controlled cow traffic to minimize the time spend on fetching cows to milking and to increase the milking frequency. By restricting the hours spent on pasture per day you optimise the AM system use during pasture period. A reason for this is becuase cows do not return to the stable for milking during night which cause that the milking unit stands empty those hours. In organic production it is required that the cows should be able to graze a certain amount of daily dry matter (DM) intake on the pasture. In the county of Dalarna where the farm is located the yield of the pasture is about 3000 kg DM per grazing season and hectar.This means that the pasture area should be 14,25 hectare to 57 milking cows.

To measure losses in a transformer with today?s methods is either slow or insecure. There s a new method developed by Alstom that hasn't been actualize in to a test-system and that has been the assignment in this project. The idea is built on a switched system and a CLR- circuit in the resonant frequency. The test-system has a calculated power-loss that make the efficiency to be as high as 99,8% and in reality over 95%.

The aim with the thesis is to get deeper knowledge in one of the subjects botany, livestock technology or economy. I have chosen to get deeper knowledge in how to store potatoes. How are you going to act to keep the quality on the potato during the storage, with a minimum of weight lost? My aim with this thesis is to get a view over how the potato act in storage space. The storage environment is very important in the storage space.

Den här studien beskriver en konflikt kring en bergvärmetrend för bostadsrättsföreningar som uppstått i Uppsala under hösten 2010 och våren 2011. Konfliktens parter är å ena sidan bostadsrättsföreningar som valt att satsa på bergvärme för att i första hand minska sina uppvärmningskostnader från fjärrvärmen. Å andra sidan majoriteten i Uppsala kommuns miljö- och hälsoskyddsnämnd som är oroliga för trendens miljömässiga effekter, framförallt för elförsörjningen, och förespråkar fjärrvärme. Utifrån två teoretiska perspektiv har jag satt konflikten kring bergvärmetrenden i ett större historiskt och samhälleligt sammanhang. Jag har prövat möjligheten att se konflikten som en konflikt kring fjärrvärme som ett stort tekniskt system med referens till teknikhistorikern Thomas B. Hughes.

With the advance of the modern information society, the importance of reliable identity authentication has increased dramatically. Using biometrics as a means for verifying the identity of a person increases both the security and the convenience of the systems. By using yourself to verify your identity such risks as lost keys and misplaced passwords are removed and by virtue of this, convenience is also increased. The most mature and well-developed biometric technique is fingerprint recognition. Fingerprints are unique for each individual and they do not change over time, which is very desirable in this application.

The study aims to reduce energy consumption in apartment buildings where individual metering and charging of heat is applied. The aim is to develop planning and design for individual metering and charging in apartment buildings.The study is based on literature review, interviews and case study that include analysis of existing documents. Interviews were carried out with the property developer and the involved consultants who planned the apartment building Yasuragi. To investigate the differences the condominium association has noted in heat consumption between flats, the debit values of the heat were used to discern which houses that were furthest from the average consumption. On these flats there were temperature measurements and thermal photo shoots made for discriminating behavior and possible construction techniques which could be the explanation for the heat spread.Boverket shows that the consumption of heat can be reduced by 10-20% after insertion of individual metering and charging in an apartment block.

This thesis aimed to study the interaction between an educational technology system and its users and give suggestions for design improvements. The technology system is called EDIT (Educational Development through Information Technology) and has been developed and applied at Linköping University?s Faculty of Health Science. EDIT supports Problem Based Learning and enables scenarios to be presented through the World Wide Web. The study was divided into two parts.

The print- and mailroom at Gefle Dagblad (GD-tyck) is handling an increasing amount of commercial jobsalong with the newspaper production. Investments have above all been done in the mailroom to be able tooffer commercial costumers a higher degree of finishing and there are plans to expand further in the commercialmarket. GD-tryck is of the opinion that they need to secure the quality of their production to be ableto do such expansion, which is the reason why a quality system of some kind may be appropriate. Howeverthere are no plans to certify such a quality system according to ISO 9001:2000.In this exam report the present methods of working have been analysed from a quality perspective.Suggestions on how GD-tryck should be working with quality development is presented in the fields whereshortage of quality has been discovered. The suggestions taken together do not form a quality system butcan be looked at as ideas of approach to quality fields that have to be developed if a working quality systemshall be accomplished.Many of the quality fields that have been discussed do not have anything to do with technical qualitydirectly but are in some degree requirements for a working quality system.

The aim of this master?s thesis is to investigate how Paul Feyerabend?s anarchistic theory of knowledge can help our understanding of bibliographical classification and to analyse how epistemological assumptions are manifested in bibliographic classification. Paul Feyerabend?s anarchistic theory of knowledge and science is the theoretical approach of this thesis. The first part of the thesis consists of an introduction to bibliographical classification and epistemology.

In Sweden, reduced tillage usually means non-inversion tillage, where primary tillage is carried out using chisel ploughs or disc implements. Primary tillage method is mainly determined by the desired soil loosening and the handling of soil residues. The effect of tillage depth was studied in field experiments in Skåne, Väderstad, Uppsala, Örebro och Västerås in different crops; spring oilseed rape, spring wheat, winter wheat and spring barley.The experiments generally had a randomized block design with the treatments mouldboard ploughing, deep chisel ploughing and shallow chisel ploughing, in some cases also shallow discing and no-tillage. In the experiments the following parameters were determined: seedbed properties, saturated hydraulic conductivity, penetration resistance, number of emerged plants and crop yield (all parameters were not determined in all experiments. Root growth and draught requirement were determined in two separate studies. There were no significant differences between tillage depths in non-inversion tillage in seedbed properties, plant emergence or root development.

Between 1965 and 1974, the Swedish Parliament decided to build one million dwellings, called Million Program. The million program buildings were erected with new, untried design solutions, in a short range of time, and at low cost. The residential buildings from that time are now greatly in need of renovation. The municipal housing company, Gavlega?rdarna, renovates and improves the energy efficiency at some of it?s apartment buildings in the district Sa?tra, Ga?vle.

In this report a systematic working procedure for risk classification of processing equipment from a maintenance point of view is described. How this system has been worked out is also an important part of the report. The classification system is adapted for use in complex processing plants. Preemraff Göteborg has been subject for the underlying study and application of the system.The system aims to give a good overview of the maintenance related risks at the plant. Furthermore, the analysis result is a good motivation for the suggested maintenance activities and as motivation for extended or decreased maintenance resources in total.

The development of IT systems is usually accomplished by some form of system development methodology. It can be performed as the waterfall method, where each phase is completed before the next begins. One of the reasons to follow a development methodology is that the process is more structured, faster and that the product will have higher quality. One risk of not using a system development approach is that the code can be unstructured and difficult to maintain.This paper describes an alternative method in which the development occurred without the use of any system development methodology. This has been possible because there was a clear goal of the program that should be developed.