Skin temperature is detected through signals in unmyelinated C-fibers and thin myelinated A?-fibers in the peripheral and central nervous system. Disorders in thin nerve fibres are important and not rare but difficult to diagnose by the most common neurophysiological methods. In this pilot study different methods for quantitative sensory testing, QST, were compared to give some ideas about which method could be the most efficient to use in order to point out injuries of the sensory system in clinical practice. The comparison was made between Békésy (separate warmand cold thresholds) and Marstock test (combined warm and cold thresholds).

This is a booklet with information and inspiration about precast retaining walls. The three chapters contain information about concrete as a material, how the surface of the wall can be altered, and a chapter with ideas for a new precast wall. I have obtained information through books, interviews, lectures and fairs. The retaining walls on the market do not correspond to the requirements of the Landscape Architects I have interviewed. I have therefore considered their opinions in the chapter containing my new ideas for new retaining walls.

Nimo Verken AB is the leading producer in the Scandinavia of drying cabinets. The construction has, with small changes, been the same since the 70s with a thermostat and a timer as controlling system. There was a wish to develop a modern cabinet which showed remaining time on a display and with energy saving functions.In this report we go through how it is possible to implement a digital controlling system, where remaining time is shown on a display and where it is possible to choose a preset ?program?.The report first presents the fundamental theory for a PIC, where we describe the different registers, how interrupts are handled, the internal clock function and how data is sent to control the different parts of the construction.Next the report presents and describes the new hardware that is needed, such as the encoder, the temperature sensor and the display.After the theory we describe how the program in the PIC may be drafted. Last in the report we have the result of the tests of the temperature variations and the accuracy of the time..

Norconsult AB has developed a solarhousing concept, a house designed for the warm climate in the Middle East andwith large quantities of solar panels installed. The cooling system for the house was designed in an earlier report, the purpose of this thesis is to investigate the possibility of short and long term storage of thermal energy via an underground energy storage volume.Two different designs of the storage and three different filling materials have been integrated into a model to simulate different cases. The first design consisted of pipes installed in the ground, without insulation. The second design consisted of an insulated concrete box installed to prevent thermal energy from the surrounding soil to flow towards the lower temperature regions within the storage. The three different filling materials were dry saudi sand, water saturated saudi sand and the filling material used by the client for energy storage in Sweden.The results from the simulations show that neither of the designs, regardless of the filling material, managed to extract enough thermal energy from the house to the ground to uphold the demands of indoor climate.

The aim of these two studies was to investigate the possible physiological, behavioural and emotional changes that appear after human-horse interactions and also to find an explanation to why they occur. One aspect that is discussed is whether the wellbeing of humans can be coupled to interacting with horses and of how the animals respond to the interaction. The first study was performed on 9 horses and their owners, both parts being subjects to registrations during 4 different interaction treatments. The second study was performed on 6 horses with registrations only being performed on the horses during 2 different treatments. Nine horses underwent 3 different treatments all performed by their owners (H = stroking of the horses forehead, B = brushing and M = stimulation of the withers) in addition to a control round (K). Each treatment lasted for 4 minutes but observations were performed until after 45 minutes from start.

Storm water is rain and melted snow that runs off, primarily from impervious surfaces.Future storm water management is facing the challenges of increased precipitation, asclimate changes, and increased areas of impervious surfaces due to the expansion anddensification of the cities. Impervious surfaces reduce the potential for water to infiltratein the ground leading to increased surface runoff and higher peak discharge.The runoff coefficient is closely related to the percentage of impervious surfaces andrepresents the maximum percentage of a catchment that can contribute to runoff. In thisstudy, the objective was to evaluate the weighted runoff coefficient for three differenturban types; apartment buildings, townhouses and residential areas and a comparisonbetween today and the 1970`s was made.The runoff coefficient was determined by manual mapping of the different surface typesin each area based on data in the form of orthophotos and aerial photographs. The surfacetypes that were mapped were asphalt, permeable areas, tiles, sand/gravel and roof.Tiles and sand/gravel were the most difficult surface types to map. In order to see towhat extent these categories influenced the weighted runoff coefficient a sensitivityanalysis was carried out and the runoff coefficient based on surface type was changed indifferent scenarios.The results of the sensitivity analysis showed that the surface types tiles and sand/gravelhad little impact on the weighted runoff coefficient which in mainly due to the fact thatthe percentage of these surfaces types of the total area is small.The result of the study showed that the largest change in the runoff coefficient occurredin residential areas where the increase in the percentage of impervious surfaces causedby new roofs in the form of porches and garages and from paved or tiled driveways.

When cylinders for motor saws are manufactured there are high demands on the cylinders strength and wearing qualities. Aluminum is a material with low density and is used by Husqvarna AB for their motor saw cylinders. The aluminum is strengthening with nickel that is attached to the cylinders through electrolysis. When aluminum is in contact with oxygen a film of oxide is formed. To eliminate the oxide and to prevent formation of new oxide zinc is used.

In this project forging of aluminum alloy Al 6026 T9 has been performed in the temperature range of 400 °C ? 470 °C. The alloy which was in the shape of a cylindrical billet was formed in a press with the aim of analyzing the effect of different forging temperatures and required press load for optimal die filling. The component?s dimensions were later measured and compared to a reference piece.

Water is the most essential resource for life. In cases where drinking water is processed from surface water it is important to ensure the raw water is of good quality, and is suitable for processing through the water treatment plant.The drinking water for Västerås is sourced from Västeråsfjärden, in the western side of Lake Mälaren. The city itself is home to marinas, ports, a wastewater treatment plant, the Svartån outlet, sewage pumping stations and stormwater outlets. Because of the negative effects these activities have on surface water quality, Mälarenergi AB is interested in relocating the raw water intake point to Granfjärden, 10 km east of Västeråsfjärden. At Granfjärden the intake point would be less exposed to the activities in Västerås, and could be placed at a greater depth, resulting in better water quality.In this Master?s thesis the water quality and the pollution risks at Västeråsfjärden and Granfjärden sites are compared.

There are many different recommendations on how to keep pelargoniums over winter, but most of the recommendations suggest ?the higher the temperature, the more light and water the pelargonium needs?. The purpose with this paper is to try to explain the best and the worst results that are achieved with different storage alternatives of zonal pelargoniums. The results are based on an orientating investigation carried out in January-February, and a questionnaire that members of the Swedish Pelargonium Society answered to. Both the orientating investigation and the questionnaire showed that zonal pelargoniums are best stored light and cold but frost free. They should be irrigated according to their needs which is when the soil is dry, about every second to third week. Zonal pelargoniums are very resistant to drought and can survive without water for at least 44 days, both when kept under light and cold as well as under light and warm.

The present work is a continuation of the ideas developed in previous projects during my Masters studies that explored the relation between pattern, form and space. Starting from the pattern multiplication for space construction the present project proposes textiles as an assortment of flexible expressions. The purpose of the project is to explore aesthetic and functional potential of textiles for out door temporary structures. This is to create a pattern interface which filters sunlight through a textile surface to offer instant sheltering solutions for out door activities. The project combines research and analyses of outdoor temporary structures and scope of textile in the area.

A computer model based on minimization of the free energy, capable to predict contact angles and spreading transitions between Wenzel and Cassie mode for drops placed on surfaces with different topography were implemented in matlab. Simulations were compared with experiments documented in the literature. These showed that reported transitions between Cassie and Wenzel mode can be explained by minimization of the free energy. In this report, a study on the possibility of constructing water repellent paper surfaces with a combination of treatment with octadecyltrichlorosilane and topography changes, is included..

Stump treatment today requires large quantities of clean water mixed with the protective product Rotstop, to fully cover the stump surface. In order to reduce the water consumption without reducing the coverage of the stump surface, the pressure in the stump treatment device can be increased. Therefore, the Phlebiopsis gigantea (Fr.) Jül. suspension used as a biological control agent to prevent Heterobasidion annosum (Fr.) Bref. infection was pressure-tested.

Today, there are no regulations saying that cows must have access to some kind of shelter at pasture during the summer. In more tropical countries, it is well-known that dairy cows might suffer from heat stress when exposed to sun and high temperatures. The well-being of the cows is thereby reduced and the production may also decrease. In Sweden, no research has been done in the area and therefore it is now a clear need of improved knowledge.The purpose of this study was to investigate the importance of shade for dairy cows in Sweden. The behaviour of 30 cows was examined to see any differences between cows with access to shade and cows without access to shade.

In this report you can get a complete instruction about how to build your own development system for the PIC-processor. This card will be used for laborations for the students at LITH-ITN. With this card you can send new assembler codes (new instructions) down to the microprocessor via the Serialport on your computer. Then the new instructions for the microprocessor will start to execute. We made a solder paste stencil at Campus Norrköping solder paste stencil laboratory.