Österbyverken is an industrial estate in Östhammars municipality in Uppland, Sweden. Many different activities have taken place on the estate the last 600 years. During the last 15 years both health and environmental studies have been made by different companies. At the most recent study a great increase of metals in Nerån, a river that runs partly through and partly next to the estate, was identified with mass balances. The purpose of this thesis is to accomplish a deepened study about the reasons for the increase of metals in Nerån.

Formulation and testing of a new type of chainsaw lubricantThe company Agro Oil has come up with the idea of developing an environmentally adapted chainsaw lubricant with a new unusual base fluid. A field test with a tree-harvester shows unsatisfactory low temperature properties and high wear. In this work the viscosity, price and pour point of different combinations of the given base fluid and three other base fluids have been investigated. Desired viscosity and price are determined for different formulations. The new lubricants tested show lower pour points than almost all products on the Swedish market.A test equipment has been developed to investigate the wear.

To better understand how various factors affect the establishment of forest and trees around the tree line-ecotone, this study was conducted in Troms County, Norway. The altitude of different forest and tree limits together with the surrounding vegetation type were collected during August 2011. Comparisons of the collected data were made with previously collected data from the same sites conducted 1914 and 1915. On average the forest limit has expanded with 26 meters in altitude, however, an expansion is not statistically significant for the whole area. The tree limit has significantly expanded in altitude.

Delineation of recharge areas for aquifers is performed in the groundwater mapping process at the Swedish geological survey, SGU. This work is time consuming and performed manually. It is therefore desirable to develop a more general and repeatable method for defining recharge areas for aquifers.The purpose of this study was to investigate two other possible methods to delineate recharge areas for aquifers. The first method was to examine the possibility of using the topography of the bedrock to define the recharge areas for aquifers. To enable this, a method for generating the topography of the bedrock was developed.

This report was written as a final thesis within the Department of forest economics at the Swedish University of Agricultural Sciences as a completion of the M.SC Forestry programme. The aim of this study was to create a model that, with respect to given stock levels, temperature, fuel usage and fuel price, would identify the optimal levels for purchase of bio fuels, optimal levels of incineration of bio fuels and the sum of the present values of all costs. The model would be applicable for a larger district heating plant. Data regarding temperature were received from SMHI. Information considering fuel prices was taken from the Swedish Forest Agency and the facts about fuel usage were collected from a large district heating plant, located in the southwest of Sweden. For the temperature, a sinus curve was adapted to describe the temperature over a year.

During the past few years a vast amount of research has been done to increase the understanding of the complex ecosystem of the Baltic Sea. Modelling and simulations are important tools to increase knowledge of the system. A suitable model must be simple to use and the parameters and variables needed in the model must be easy to access.In this paper a dynamical mass-balance model, CoastMab, which is validated for smaller coastal areas, has been used to predict concentrations and transports of phosphorus in three large coastal areas - the Gulf of Finland, the Gulf of Gdansk and the Gulf of Riga. CoastMab uses ordinary differential equations to regulate inflow, outflow and internal flows. To reflect seasonal variations in temperature and different types of flows the model has a temporal resolution of a month.

AbstractSurface-water includes different kinds of pollutants from traffic and roads. To prevent these pollutants to reach nearby lakes one can construct surface-water ponds on locations with heavy traffic. At Bergviks shopping centre in Karlstad, two ponds, one smaller and one bigger has been constructed in order to decrease the pollutant pressure from the receiving waters of Kattfjorden. Several heavy metals are essential for plants and animals in low concentration but when they occur in higher concentrations, they become toxic to the organism. The larger pond at Bergviks shopping centre has a sedimentation function so the heavy metals sink to the bottom thereby not releasing directly in to Kattfjorden.

The dishwasher is a wide spread product that occurs in many households. It saves the user time,water and energy. When using a dishwasher instead of doing dishes by hand a lot of energy issaved.The importance of lowering the energy consumption does not only come from the consumerwinnings but also from an environmental point of view. Scientists are certain that the globalwarming comes from the emission of green house gasses that is created by human consumptionof oil, gas and coal.Dishwashers today are a lot more energy efficient than older dishwashers, but there are stillmargins to lower the energy consumption. The aim with this project is to investigate thedishwasher and it?s washing cycle, noting different phases and components that contribute towaste of energy.

The aims of this project were to describe the circumstances around dogs being left alone in cars, to investigate owners? knowledge of the risks associated with leaving dogs in cars and the relevant legislation and, finally, to study how changes in the air temperature and air composition in the car affect the dog. The project consisted of a survey of the literature, a questionnaire part and an experimental part. An important conclusion is the importance of the level of knowledge of owners, since there are several ways in which an owner can prevent their dog from heat stroke and, in the case of an eventual accident, their action can have direct consequences in minimizing the long-term damage to the dog and even whether or not it survives. Fewer than half of the owners in the study knew that for a dog suffering heat stroke, the most important thing is to bring the body temperature down. Only a third of dog owners knew that if a dog is left in a warm car and showing signs of heat stress, then the police should be contacted and the dog quickly helped out of the car.

Storing kinetic energy in a flywheel allows for more efficient driving of electricvehicles. Research in this area is in progress at Uppsala University, where a flywheelwith magnetic bearings encased in a vacuum chamber is being constructed. To makethis possible methods for measuring the current through the electromagnets in thebearings and temperatures in the flywheel need to be developed. This has been thepurpose of this report. The current measurement resulted in a resistive method, andthe implementation of eight measurement circuits in the system.

SUMMARY Several studies have shown that weaning pigs are in great need of heat. The reason for this is mainly because the pigs are given very little feed just after weaning. Some of the pig producers of today have tried to get along with these problems by building some kind of hut for the pigs. Some of these pig houses have been included in this study.The study has shown shortcoming functions for the pig cottage. The expected heat increase has not occurred.

Hypothermia during anaesthesia is a well-known phenomenon that may cause several side-effects such as greater risk of postoperative wound infection and increased risk of heart complications. The most efficient way to avoid this is to prevent hypothermia from occurring. The aim of this paper was to compile the research on the most efficient way to prevent hypothermia during anaesthesia for cats and dogs, and to compare these results to how Swedish animal hospitals prevent hypothermia today. To investigate this, a survey was sent out to several animal hospitals around Sweden to see what methods they used to prevent hypothermia in their clinics. It is difficult if not impossible to prevent the body temperature from falling slightly when anaesthesia is induced because of the drug interactions in the body that follow from the drugs given. A 1-1,5°C decrease in body temperature is to be expected and is difficult to avoid.

Lake lowering in sulphide-rich areas is currently a major environmental impact for surface water. This study focuses on whether there is a relationship between a gradient of lake lowering and surface water impacts in areas of sulphide-rich sediments, in order to better understand their contribution of heavy metals and sulfuric acid. Also, is it a reasonable method to use the reduced lake area in order to quantify the gradient? The survey was conducted by collecting water samples from reference lakes and lowered lakes from south to north in coastal areas within the county of Västerbotten. Water samples were then analyzed for TOC, pH, conductivity, anions, base cations, alkalinity, acidity, sulfate, Al, Cd, Fe, Mn, Cu, Zn and Pb.

This study investigates three different methods for evaluating MOE,Modulus of Elasticity, in field measurements. The purpose is toinvestigate the possibility to use dynamic measurement methods infield measurements that hitherto (2010) has been performed with staticmethods. The objects of investigation are 20 glulam beams. The firstfield measurement took place in november 2007 and applied a staticmethod based on the standard SS-EN 408. The second measurement,described in this study, took place during summer 2010, and appliedstatic as well as dynamic methods.The MOE of wood is affected by a range different factors.

A large amount of our time is spent indoors in an artificial climate. To make the experience pleasant there are requirements on the ventilation and the heating system. At the present time the most common form of heating is a radiator system complemented with a ventilation system. A ceiling heating system with combined heating and ventilation can replace the two separated systems. The benefit with a ceiling heating solution is that it saves space since the radiator system is no longer needed.