The purpose of this thesis has been to determine experimentally how good a peltierelement is to convert waste heat from wood burning. Three different peltier elementswere used in a comparison study. The comparison was mainly done to know howmuch power could be obtained from each element. Even, a circuit with a step-upfunction has been created to give a higher output voltage than the peltier elementitself. The result of the experiments was a low output power, the highest valuereached 2.18W.

Small hydropower plants have been an important source for electricity for many years. During the 70?s the general thought was that nuclear was the future. Around 2000 small waterpower plants were shut down. It wasn?t profitable to invest in.

There is two dairy farms in Sweden with ability to be opened on both long sides, one outside Hjo and the other one, Brandstadholm, north of Sjöbo. When there is no measures and results or not enough literature about natural ventilation and especially on this kind of air inlet, makes my tests very interesting not only on Alnarp, but among other companies. I would like to find out if there is any air movements direct on the cows, how high/low temperature, air humidity, light intensity and noise standard inside the barn. Does Brandstadholm fulfil the rules and regulations when it comes to climate inside the barn? Could this system become the new dairy barn instead of the conventional barns in Sweden? I am going to focus on the animals environment, after all they are the one who is going to spend the most of the time in the barn. I used five electrical loggers distributed inside the barn to measure the temperature and one of the loggers measured the air humidity, every 15th minute. One logger were placed on the outside which measured both temperature and air humidity.

Utvecklingen av förbandsmetoder är viktigt för att utveckla konstruktionslösningar. Under det senaste decenniet har forskning på limmade förband utförts, främst på inlimning av stålstag och plattstål i limträ. Förhoppningen är att spänningen ska fördelas jämnare i förbandet och att brott ska kunna undvikas. Hypotetiskt sett skulle det kunna göra knutpunker utan synliga förband möjliga vilket även skulle gynna arkitekternas önskemål.Genom en sammanställning av tidigare forskning dras en jämförelse mellan testresultaten och en antagen knutpunkt som belastas av egentyngder och variabla laster. På så sätt kan limmets kapacitet konkretiseras.

This work describes a series of glasses, both for people withvisual handicap, and the glasses are not only limited for use onlyby people with poor sight.I have, based on the course Senses, done research and lookedinto how to design glasses for visual handicapped people interms of function, look and expression.I have elaborated with several different glasses and performedmany experiments to come up with my final result, consisting ofa series of glasses.The glasses in the series are made with a weight on one side, onestep on the bottom to get the possibility for the glass to tilt over,which enables you to both hear and see when you have reach acertain amount of substance in the glass.It has also been important for me that the glasses express somethingand get an individual identity.The result became glasses for whiskey, coffee, shots and mullwine..

This report concerns the for Sweden foreign tree species hybrid larch, hybrid aspen and poplar, and focuses on the area Kalmar and Mönsterås municipalities. The report shows that there are not only advantages with these species. The larch, the most common of the alien tree species has the greatest problems due to that its timber is difficult to sell in the area but also the Larch´s poor pulp quality and is more likely to be damaged by wildlife than the spruce is. Hybrid Aspen is much easier to sell and is used like regular aspen for match wood and textile pulp. Its disadvantage is the high cost for plants and to prevent damage from wildlife.

On a request from the water sewage plant Gryaab in Gothenburg a power quality survey was performed. The voltages and currents have continuously been sampled in the incoming 10 kV substation HSP01 from April-August 2008. Power quality measurements were also performed in Gryaabs other 10 kV substation HSP04 fed from HSP01 and at the terminals of the induction motor IN_PU4040 of 1.3 MW which controls one of the four large inflow pumps to the plant. The reason for the latter measurement was due to registered negative transients each time the motor was connected to the grid. The cause of the transients could be explained by the coupling in the substation, the ageing of the motor which could result in damage of the bearings or resonance in the motor circuit which amplifies high frequency harmonics.

This study has been conducted on behalf of Vectura Consulting AB with the purpose to examine how different actors perceive the dimensions of sustainability and sustainable construction. The purpose is also to provide an understanding of existing barriers and opportunities for sustainable construction within the industry and exemplify with different directions for the actors in order to develop sustainability. The study has approach the research problem by using systems theory, developed by Checkland, to identify the relevant system. Other systems theories has been used as an theoretical framework in order to identify barriers and opportunities, which in this study are based on Hughes?s theory about reverse salients and salients.

Tall (Pinus sylvestris L.) är ett av Sveriges viktigaste trädslag. Med ökad efterfrågan på vedråvara samt ökade krav på naturavsättningar är det viktigt att öka produktionen i skogen. Röjning och tidig gödsling ger ökad volymproduktion men kan ge icke önskvärd påverkan på vedegenskaper som ökad mikrofibrillvinkel (MFV). MFV är vinkeln mellan mikrofibrillerna i cellväggens S2-lager och cellens längdaxel och påverkas av ståndort samt konkurrensen om ljus och näringsämnen. Höga MFV resulterar i sämre kvalitet på papper och sågade trävaror.

On a request from the water sewage plant Gryaab in Gothenburg a power quality survey was performed. The voltages and currents have continuously been sampled in the incoming 10 kV substation HSP01 from April-August 2008. Power quality measurements were also performed in Gryaabs other 10 kV substation HSP04 fed from HSP01 and at the terminals of the induction motor IN_PU4040 of 1.3 MW which controls one of the four large inflow pumps to the plant. The reason for the latter measurement was due to registered negative transients each time the motor was connected to the grid. The cause of the transients could be explained by the coupling in the substation, the ageing of the motor which could result in damage of the bearings or resonance in the motor circuit which amplifies high frequency harmonics.

In order to measure the quality of the logs, one can with help of Fast Fourier Transform technique get the signals resonance peaks. With help of these peaks you can see whether the quality of a tree is good or bad. This report contains the work of a where a program has been developed to be able to process a vibration created by an automatic hammer hitting on a log of wood. From the processed signal the program should be able to show both the raw wavesignal and the processed measured data from the resonance peaks. Beyond the raw wavesignal and resonance peaks the program should also be able to control the automatic hammer.

Diesel electric propulsion is in many ways a good alternative to conventional shaft propulsion, both economically and environmentally. There are also many other good side effects which need to be considered, i.e. better manoeuvrability, more efficient use of space and less noise on board. However, there are applications where diesel electric propulsion is not profitable. Large ocean going ships? profitability is much depending on fuel costs and the diesel electric alternative cannot compete on long journeys with large low speed engines.This thesis will treat the aspects of choosing between a diesel electric system and a classic mechanical propulsion system.

To increase the knowledge about the growth of hazel (Corylus avellana)and size distribution of the shoots, circumference and stem diameter wasmeasured in a total of 54 clones in two areas in Östergötland. Further, thewidth of growth rings was determined for separate years. The diameter ofthe stems was measured both out from the centre of the stem andperpendicular to the first measure. The stems showed only a weaktendency to have an oval shape (with the longest side outwards from thecentre). The growth model did not improve when the degree of sunlightof clones was taken into the account.

We have a business proposal. Instead of the consumers visit the country side in order to purshase we are interested in starting a shop with only regional produced products in the city. We have our base in a part of Sweden called Östergötland, therefore we have investigated the market for such a store in Östergötlands biggest city, called Linköping. The conclusion is that the store must sell food produced in the region. Another conlusion is that the store must be located near a bigger supermarket. Our main selling points are quality and that the food is produced in the near region.

On a request from the water sewage plant Gryaab in Gothenburg a power quality survey was performed. The voltages and currents have continuously been sampled in the incoming 10 kV substation HSP01 from April-August 2008. Power quality measurements were also performed in Gryaabs other 10 kV substation HSP04 fed from HSP01 and at the terminals of the induction motor IN_PU4040 of 1.3 MW which controls one of the four large inflow pumps to the plant. The reason for the latter measurement was due to registered negative transients each time the motor was connected to the grid. The cause of the transients could be explained by the coupling in the substation, the ageing of the motor which could result in damage of the bearings or resonance in the motor circuit which amplifies high frequency harmonics.