The improvement programme Six Sigma has often been surrounded by an air of success since it was introduced in the 1980s. Yet there are cases in which introduction of the Six Sigma improvement programme show far from successful results, even complete implementation failures with no traces of the Six Sigma methodology or any improvements after completion of the introduction. These failures can cause severe damage to organizations through direct monetary loss caused by a negative result of the investment. Indirectly the failure can cause confusion in the organization and loss of employee motivation. The conclusions have been derived based on a qualitative case study at a Swedish telecommunications company.

Abstract This degree project examines how much carbon dioxide that emits during the construction phase of a road project. This is to make it possible to compare how the amount of carbon dioxide differentiates between traditional road construction and Swepave construction, which is PEAB?s alternative way to design roads. To make the comparison a calculation tool has been produced. To compare the amount of carbon dioxide emissions a reference project was needed.

The purpose of this project is to get a fully functional, automatic steering system and a variable breaking system with an emergency breaking function to an off road vehicle. This off road vehicle is supposed to work as an aid in military situations. A team of two, Sebastian Attervall and Nichlas Gustafsson, got an order from Jonas Nyårds and the PreeRunners Project to construct a steering system that could manoeuvre an off road vehicle without any human involvement. To make this possible the vehicle would be guided by onboard sensors, cameras and computers. The team where also assigned to construct an automatic breaking system, there also no human would be involved.

 AbstractTitle                                      Continuous improvement ? Motivating ICA´s  personnel to    a greater engagement.Problem                                  Getting ICA: s employees involved with continuing improvements.Purpose                                  To motivate ICA: s employees to a higher degree of commitment and    contributing with ideas and embracing approved improvements. Research questions   - How should the employees be properly motivated to contribute with   suggestions for improvement?  - What message and content should improvements send to inspire the   employees? - Witch channels should be used to capture the employee?s attention? - How can best practice be recognized and how can the knowledge be spread  through the organization?Methodology                          Initially a theory study was completed and from the results a case study were  conducted.Conclusion                             Combining success factors for continuing improvements.  To get the      employees feeling appreciated with their work. Results             By combining ten sucessfactors and trying to see the whole picture.                .

The study explored how a model for conversation partner trainingworked for family members of people with Parkinson's disease. Participants inthe study were three dyads consisting of persons with PD and their carers. Thepurpose of the study consisted in finding out whether the participantsexperienced a change in communication after the intervention, and in findingout if this potential change could be observed in the conversation. The resultsshowed that 4/6 participants experienced an improvement in communicationafter the intervention. This improvement was however not observed in theconversation.

AimThe aim of the present study was to study possible evidence for shock wave therapy on pain and function in patients with plantar fasciitis.Questions1. Does shock wave therapy reduce pain in patients with plantar fasciitis?2. Does shock wave therapy improve function in patients with plantar fasciitis?MethodA systematic review of the literature was performed in the databases PubMed, EMBASE, Cochrane and Cinahl.

This project is about investigation and improvement of a V-plow for the company Swekip. A V- plow is used for snow removal but this product has been found to have deficiencies in its construction, breaking down and not living up to the desired objectives. This is because the product is ordered from a company in China where they have some problems with understanding the purpose of the plow.Initially the existing plow is investigated, all the shortcomings set out and examined, what is wrong and what needs improvement?When the solutions were done they were evaluated and examined that they actually live up to the desired requirements.This assignment is a pure construction project where the majority is implemented in CAD, where models are developed and FE analyses are carried out. But the project also includes a feasibility study, idea study and hydraulic design.The results are presented in the form of a CAD model and associated drawings that will serve as the manufacturing basis for the new V-plow.

Continuous improvement is one of five principles in General Motors ? Global Manufacturing System (GM-GMS). GM-GMS has been used by Saab Automobile AB since 2003 and is a central component for realisation of GM?s vision. Internal audits have discovered problems with one of the tools, practical problem solving (PPS), which needs to be improved.

The purpose of this study was to, through the life stories of four women and their experiences, thoughts and feelings according to a life in drug dependency reach an increased knowledge about how a dependency can arise, continue and be brought to an end. The question at issue were: How do a small amount of women describe and comprehend their experiences, thoughts and feelings according to their drug addiction seen through a process perspective. In order to answer that question three themes were investigated: the road into dependency, living as an addict and the road to recovery from dependency and the time that follows. The study followed a qualitative method and the theoretical approach was hermeneutic. The results were analysed through a process analyse perspective, from the view of the chosen theoretical perspectives, social constructivism, experience perspective and a psychodynamic perspective.

Considering that the current technology is constantly improving, it becomes increasingly important to have an efficient logistics in a company to maintain profitability while achieving a competitive business. Efficient logistics may be accomplished by improving the internal materials handling. In this thesis the internal material handling of steel frames has been studied at a factory in Vaggeryd. The goal of this study is to investigate the problems that exist with the current production flow of products and provide suggestions on how it can be developed to reduce unnecessary handling and movement.The study has a deductive approach where the authors has been using literature studies parallel with empirical analyzes conducted at a company to achieve the purpose of the study. Documentation from the company and interviews with staff and observations form the basis for the data collection carried out.

Researchers, planners, and government agencies agree that road safety for children must be a priority and in particular that children should have a safe and secure way to travel to and from school regardless of age or the distance travelled. In Sweden, child traffic safety is a key part of the country?s Nollvision, a long-term traffic policy goal of ?no deaths or serious injuries?. Unfortunately, many countries have recorded increases in child traffic accidents as the percentage of parents who drive their children to school and thus congestion around schools has increased. Common strategies include traffic safety education for children, the redesign and improvement of traffic infrastructure, bicycle training, and carpooling.This thesis assesses the traffic problem around Ludvigsberg School in the district Valbo in Gävle, Sweden.

When designing roads it?s important to knowwhat loads will bedriven on it. The axles on heavy vehicles can either have super single tires ordual tires which, according to studies, damage the roads differently. The SwedishTransport Administration is developing an understanding for the character ofthese different kinds of axle and tire types on the loads induced on Swedishroads. In this thesis a field study was conducted to determine the distributionbetween axles with super single tires and axles with dual tires on heavy vehicles.A highway, a country road and a national road were investigated during thestudy.

The aim of this study was to design short interventions based on the literature study, which will change the pupils? posture on mathematics and connections between problem-solving in mathematics and everyday life. An experimental group of 17 pupils in fifth grade participated in the study and were educated in everyday mathematics 20 minutes a day during four weeks. The intervention was measured in a pre- and after questionnaire, in order to control the design and discover possible changes in the pupils? posture on mathematics and connections between problems and everyday life.

Since 1 January 2010 it is a requirement to use the European standards, Eurocodes, in Sweden when constructing bridges. One chapter that has caused an extra amount of problems for the engineers is the one about fatigue analysis, which resulted in us doing this thesis.To do this we had to read all of the Eurocodes that direct, or indirect deals with fatigue and calculating of such. We have read the background documents for the Eurocodes and master?s thesis in the subject. We also studied the calculations of bridges constructed by different construction firms.We have chosen to limit the thesis to discuss only road bridges made of concrete due to the lack of method for verification of concrete in the national appendix.

Outside of many Swedish households today, you will find a typical green wastecontainer. This container has not changed since its introduction, despitecomplaints about foul-smelling and its impractical system. Even if the system usedtoday, still is the most optimal choice, there is a lot of newly developedalternatives out there.Its purpose is to get a broader perspective on how a waste management systemcan be developed into a working, land efficiently and aesthetically pleasing systemof humans and the environment in a small residential area.The authors treat the residential area of Jära, Ekhagen, in Jönköping, which ismanaged by JM AB as a problem area in regards to waste management.The issues raised by the authors are the different waste management systems usedin the corresponding areas of the world, how to apply technical andenvironmental as well as the waste management facilities from financial aspects.In the process, the methods used were literature reviews, case studies and aninterview. The case study was done through a modeling of waste managementsystems in the area Jära and an interview was conducted with the company Envacworking with vacuum systems. Studies have been made by different systems n theareas around the world.The results show that using directives and guidance will reduce the environmentalimpact done without replacing the traditional system.