This thesis aims at determining the heat losses in a property vent stack and its roof valve. Upon request of a company, the vent stack is analysed for possible heat recovering solutions to be implemented, while relining of the drain system is executed and with a suitable payback time for the economic investments. The heat loss calculations are based on data for properties that are located in the Stockholm region, but also easy to change depending on the situation. The calculations are done on pipes made out of cast iron, which still is the most common type of drain pipe in Sweden, and these are the pipes that relining is usually made on. The calculations that needed to take several variables into account have been done in MatlabR2014a and the thermos dynamical properties that were used in those calculations have been extracted from EES.Three different types of heat losses in the vent stack have been taken into consideration in this thesis.

AbstractAt Saltvikens copperindustry, which is located in the municipality of Oskarshamn, copper was refined from sulphiteore some hundred years ago. The ore underwent several steps in the process before the final product was received. These steps all had an influence on the environment through discharge of heavy metals. The area where the copper industry was located is today considered to be of specific national interest due to its valuable nature and cultural values, as well as its value for recreational outdoor activities. Therefore, it is important to determine the present level of contamination and if any transport of contaminants have occurred, and to identify the risks that are associated with the site both at present and in a longer time perspective.Thirtynine soil samples and 16 sediment samples have been analyzed.

When single-family lots are valued for development of new Residential areas,the valuation is influenced by several factors. The valuation is a matter ofdefinition that varies according to its interpreter. Previous research conductedin other countries, has identified a number of value-influencing factors. Thesefactors are the basis for this study.The study's purpose is to highlight the value-influencing factors thatcustomers value and are looking for in the choice of single-family lots. Thestudy also seeks to determine if there is an unknown difference between howprofessionals and clients value single-family lots.The study showed that the value factors considered important for customersand also professionals are consistent and applicable with the factors reportedfrom previous research.

Införandet av en ny upplåtelseform, ägarlägenheter kommer förmodligen att ske den 1 april 2009. Många intressanta frågor har väckts kring den nya upplåtelseformen och en av dessa frågor handlar om ägarlägenheter kan bidra till att minska segregationen i de mest utsatta områdena i landet. Syftet med detta examensarbete är att undersöka om ägarlägenheter kan minska segregationen i Malmö. Utgångspunkten är att förstå segregationsproblematiken i staden och hur ägarlägenheter eventuellt skulle kunna påverka detta. Studien grundar sig på en kvalitativ metod då vi har genomfört sex strukturerade intervjuer med personer som på olika sätt är engagerade i bostadsfrågor i Malmö. Vi har den deduktiva ansatsen som utgångspunkt då hypotesen Ägarlägenheter kan minska segregationen i Malmö skapats för att besvara vår huvudfrågeställning.

Bakgrund: Sexualitet är viktigt för alla individer då det ingår i människans fysiska och mentala behov. För äldre personer oavsett sexuell läggning (hetero? bi? homosexuell) är sexualitet viktigt för upplevelsen av ett hälsosamt liv. Forskning visar att många äldre saknar just kärlek och en fysisk nära kontakt. Patienters sexuella uttryck i form av verbala och sexuella handlingar kan skapa oro hos personalen då de saknar kunskap inom detta område.

Historiskt sett har bostadsfastigheter begränsats till den areal som krävs för att fastigheten väsentligen ska få karaktär av en bostadstomt. En ökad efterfrågan på ett attraktivt landsbygdsboende resulterade i ändringar av fastighetsbildningslagen, vilket gjorde det möjligt att bilda stora bostadsfastigheter med kombinerat ändamål, helt i linje med den gällande glesbygdspolitiken. Fortfarande fanns det dock restriktioner mot att tillföra skogsmark till bostadsfastigheter för att skydda det produktiva skogsbruket. Lantmäteriet tog därför fram arbetsrekommendationer för att underlätta möjligheten att tillföra skogsskiften, bland annat för uttag av husbehovsved. Denna studie hade syftet att undersöka hur lagändringen med efterföljande arbetsrekommendationer påverkat bildandet av stora bostadsfastigheter på landsbygden.Varför människor flyttar är en viktig fråga för både forskare inom området och politiker, eftersom regionalpolitik bör anpassas till var människor vill bo och varför de väljer att flytta dit.

The purpose of this master thesis is to attract attention to the undefined spaces of our urban landscape and emphasize the need of these spaces in the city. The different values of these spaces are here clearly presented so that they can be considered when real estate developers show a particular interest in any one of these undefined spaces. The term undefinied spaces can mean a lot of things. The spaces that I now choose to define as undefined spaces are neither planned nor designed. It could for instance be a piece of leftover land in between two Residential areas, or as times change, a formerly planned area might be forgotten and left to its own.

AbstractThis report intends through a case study to investigate if lightweight concrete isappropriate as main material in the outer wall of a seven storey Residential building.A technical design is carried out in accordance with the definitions and requirementsfor passive houses, given by FEBY?s1 ?Demand specification for passive houses?.A literature review is also carried out for a comparison between regular bolt wall andlight weight concrete wall, with a focus on the safety of moisture.The lightweight concrete block used in the report is as a celblock produced by thecompany H+H Sweden AB.The methods used have resulted in compliance with requirements andrecommendations from authorities. Calculations of energy, noise and moisture riskassessment has been carried out.The work has resulted in the conclusion that the lightweight concrete itself is notable to isolate in the extent necessary to obtain chosen U-value of 0,1 W/m2 ° C,without getting to thick. Therefore additional insulation is needed. There are fewrelevant reference objects built with only light weight concrete.

AbstractThis report intends through a case study to investigate if lightweight concrete isappropriate as main material in the outer wall of a seven storey Residential building.A technical design is carried out in accordance with the definitions and requirementsfor passive houses, given by FEBY?s1 ?Demand specification for passive houses?.A literature review is also carried out for a comparison between regular bolt wall andlight weight concrete wall, with a focus on the safety of moisture.The lightweight concrete block used in the report is as a celblock produced by thecompany H+H Sweden AB.The methods used have resulted in compliance with requirements andrecommendations from authorities. Calculations of energy, noise and moisture riskassessment has been carried out.The work has resulted in the conclusion that the lightweight concrete itself is notable to isolate in the extent necessary to obtain chosen U-value of 0,1 W/m2 ° C,without getting to thick. Therefore additional insulation is needed. There are fewrelevant reference objects built with only light weight concrete.

Bakgrund: Sexualitet är viktigt för alla individer då det ingår i människans fysiska och mentala behov. För äldre personer oavsett sexuell läggning (hetero? bi? homosexuell) är sexualitet viktigt för upplevelsen av ett hälsosamt liv. Forskning visar att många äldre saknar just kärlek och en fysisk nära kontakt. Patienters sexuella uttryck i form av verbala och sexuella handlingar kan skapa oro hos personalen då de saknar kunskap inom detta område.

AbstractA master thesis in business administration 30 hp, Jönköping International Business School, Spring semester 2012.Authors: Sarah Henningsson & Jim BörefeltSupervisor: Urban ÖsterlundTitle: Commercial real estate investment ? Factors from an investor perspectiveBackground and problem: In this study, we focused on the real estate investor and the factors and issues that may arise and affect real estate investment decisions. It has been put in relation to the other parties in the process of assessing and affecting real estate investment decision. The parties that we studied are real estate investors, banks, brokers and appraisers.Purpose: This study aims to describe and explain the factors that affect commercial real estate investments for investors, credit assessment conducted by the bank and valuation made by the broker and appraiser.Delimitations: We have chosen to limit the study to commercial real estates including Residential, retail and office properties, industrial properties and combinations thereof. Agriculture buildings and forestry plots are not examined.

The public interest in central living in today?s cities has led to an increasing effect of traffic noise pollution, and today 20% of the inhabitants in Sweden suffer from noise a level that exceeds the limits. At the same time the traffic keeps increasing, and recent researches shows that traffic noise pollution and several of today?s most common health issues are connected, for example, reduction of performance, sleeping issues and cardiovascular diseases. For this cause rules, guidelines and environmental goals has been developed, as well as software?s which calculates the levels of pollution, all this to investigate and improve the environment.

Arkitektkontoret Sweco Architects i Göteborg har tagit fram ett förslag för ett bostadsområde i Varberg, där Varbergs kommun var beställare. De föreslog att ett eget områdesförslag skulle tas fram i Revit Architecture utifrån de planbestämmelser som gäller i området. Som en fördjupning i detta arbete valdes att även studera arbetsprocessen i programmet samt hur denna process kan tidsoptimeras. Ett problem idag är att en sådan process kan vara tidskrävande och ineffektiv. Syftet med detta arbete var att finna idéer på hur processen kan effektiviseras och att utveckla kunskaperna om Revit.Som en inledning modellerades hur området ser ut idag i Revit utifrån en ritning skapad i AutoCAD.

AbstractA master thesis in business administration 30 hp, Jönköping International Business School, Spring semester 2012.Authors: Sarah Henningsson & Jim BörefeltSupervisor: Urban ÖsterlundTitle: Commercial real estate investment ? Factors from an investor perspectiveBackground and problem: In this study, we focused on the real estate investor and the factors and issues that may arise and affect real estate investment decisions. It has been put in relation to the other parties in the process of assessing and affecting real estate investment decision. The parties that we studied are real estate investors, banks, brokers and appraisers.Purpose: This study aims to describe and explain the factors that affect commercial real estate investments for investors, credit assessment conducted by the bank and valuation made by the broker and appraiser.Delimitations: We have chosen to limit the study to commercial real estates including Residential, retail and office properties, industrial properties and combinations thereof. Agriculture buildings and forestry plots are not examined.

Arkitektkontoret Sweco Architects i Göteborg har tagit fram ett förslag för ett bostadsområde i Varberg, där Varbergs kommun var beställare. De föreslog att ett eget områdesförslag skulle tas fram i Revit Architecture utifrån de planbestämmelser som gäller i området. Som en fördjupning i detta arbete valdes att även studera arbetsprocessen i programmet samt hur denna process kan tidsoptimeras. Ett problem idag är att en sådan process kan vara tidskrävande och ineffektiv. Syftet med detta arbete var att finna idéer på hur processen kan effektiviseras och att utveckla kunskaperna om Revit.Som en inledning modellerades hur området ser ut idag i Revit utifrån en ritning skapad i AutoCAD.