Gastric and intestinal disorders are common and costly human health problems worldwide. Helicobacter pylori are a gram-negative, pathogen bacteria and the most common cause of duodenal and gastric ulcer in the stomach the intestinal mucosa. Prolonged infection and colonization can lead to chronic gastritis and stomach cancer. H. pylori are present in the gastric and intestinal mucosa of half of the world population and a relation between infection and low socioeconomic status has been shown.

The Island of Öland has one of the best wind climates for land based wind power in Sweden. An objective for the Island is to become self sufficient using electricity from renewable source of energy such as wind. There is currently 55 MW capacity installed on the Island and it is estimated that grid congestion will occasionally occur if more than 135 MW was installed.The aim of this thesis is to investigate he possibilities for load management by smart charging of electric vehicles, EV. The definition of smart charging is that the charging is done to some extent with an ICT-system, (information and communication technology) that correlates wind electricity generation to the charging of electric vehicles. The purpose is to avoid grid congestions on the sub-sea cable that connects Öland to the mainland because that in turn would curtail wind energy production.

The main purpose of this study was to determine the impact of bedding material on the faecal microflora of horses. Another objective was to investigate the hygienic and physical qualities of the bedding materials used and how these may change in the course of the trial period. The bedding materials used were sphagnum peat and wood shavings. Six horses had each material as bedding for a three week period in a change?over experiment.

In 2010, Airwatergreen AB started testing their new technology, the Airwaterwell, an atmospherical water generator of their own design that is running on solar heat, with a production capacity of three litres of water per day and m2. The purpose was to focus on foreign aid organizations as main purchasers for project investments towards rural communities in developing countries that suffer from lack of, or compromised quality of drinking water. In order to further understand if this technology would bring a positive impact in the developing countries, the company contacted the Swedish University of Agriculture for a socio-economic study of the Airwaterwells? potential. The authors elected Cost benefit analysis as the appropriate method for conducting the study and India became the study region because of its many problems with water related issues such as diseases as well as insufficient water supply for households. The regions that this study is based on are Gujarat, Haryana and Uttar Pradesh given their differences in income, health situation and poverty rate.

Background: In the past 10 years private label has increased significantly in the Swedish grocery market. This is an important strategic event, which is a great challenge to suppliers as it causes stiff competition. To handle this situation an increasing number of suppliers have to make the decision whether to produce private label or not.Purpose: The purpose of this study is to find and analyse factors that influence suppliers in the Swedish grocery market to produce private label. On this basis we intend to confirm or develop existing theories within the field of study.Research method: The study has a qualitative approach where empirical data has been gathered through interviews with suppliers and retailers in the Swedish grocery market.Results: This study has identified factors that underlie suppliers? decision to produce private label.

Denna uppsats undersöker en medlemsorganisations roll och betydelse för utvecklingen av en klustermiljö, samt vilka möjligheter en sådan organisation har att förmedla vikten av sina insatser i och utanför ett nätverk. En kvalitativ metod har använts i form av intervjuer med personer inom den offentliga sektorn vars arbetsuppgifter berör näringslivet i Öresundsregionen. Dessutom ligger diskussioner med nyckelpersoner inom organisationen Medicon Valley Academy till grund för den empiriska studien. De teorier som används är: kluster, trippelhelix, regional innovationsteori, nätverk, organising capacity och Key Performance Indicators (KPI). Fem kommuner från den svenska och danska sidan av Öresund utgör tillsammans med Köpenhamns och Skånes motsvarigheter till landsting den insamlade empirin.

Abstract                ?Due diligence - A resource demanding process?Date:                     June 8th 2012Level:                    Master thesis in business economics, 15 ECTSInstitution:           School of Sustainable development of society and technology, Mälardalen UniversityAuthors:                Erdinc Kirik                                  Pär Matsson                               11th January 1987                      31th May 1985Title:                      Due diligence - A resource demanding processTutor:                     Staffan BoströmKeywords:             Due diligence, the acquisition process, acquisitions, business valuationResearchquestions:              What are the main factors that Bank X, Nordea and Almi is focused on an examination of a due diligence for an acquisition, focusing on private limited companies?Does the approach between the various banks and Almi differ?Purpose:                The purpose of this paper is to create a checklist for private limited companies to use in the context of application for fundingMethod:                 The study was based on a qualitative study, based on primary data in terms of interviews in the subject of due diligence. Secondary data used in the study consisted of relevant literature and scientific articles.Conclusion:            The study showed that the respondents in general focuses on the same areas within Due diligence. The most important point which the respondents agreed on was profitability and repayment capacity. In overall, all elements in a Due diligence process that has an impact on profitability is important to examine.

The capacity to extract information from vehicles has the potential to be very beneficial. Performing analysis on information about fuel usage, emission values and other driving properties of a vehicle can lead to great economic and environmental benefits.This report contains descriptions of two prominent systems for retrieving information of this nature from a vehicle, On-Board Diagnostics and FMS-Standard, and of an implementation of FMS-Standard.The conclusion drawn after this investigation is that these systems do indeed offer access to the benefits mentioned earlier, although to varying degrees and with differing prioritisation..

Med en ny vattenreningsdel vill Kalmar Vatten AB (KVAB) sänka sina utsläpp av näringsämnen i Kalmarsund. KVAB har vid tidigare tillfällen uppgraderat det befintliga reningsverket och för att klara framtida energi- och klimatmål planeras därför en nybyggnation. Uppdraget var att framföra olika pumpalternativ till den framtida pumpstationen och ge en LCC-analys för varje alternativ. Två helt skilda pumptyper har utretts, Arkimedespumpen och centrifugalpumpen. Två alternativ för Arkimedespumpen och ett alternativ för centrifugalpumpen har tagits i beaktande.

Kompaktaggregat är ett integrerat FTX- och FVP-system som används i passivhus. Vi har gjortenergiberäkningar i programmet VIP+ för att se hur kompaktaggregatet skulle kunna fungera ipassivhus i Sverige.De resultat vi har fått fram ur VIP+ visar att passivhus med ett installerat kompaktaggregat klararav att nå passivhuskraven ända upp till Skellefteå. De beräknade värdena understiger kraven förpassivhus, men en viss marginal behövs för att kraven ska nås även efter uppförandet avbyggnaden. Vi har även tolkat tekniska uppgifter på ett sätt som enligt oss har en positiv effektför passivhus på kallare orter. Därför tror vi inte att värdena för de tre nordligaste platserna ärhelt tillförlitliga.

AbstractThis master thesis was performed at Scania transmission department in Södertälje, where the manufacturing of gears is done. Today a large amount of manual handling is performed between the machining and the hardening process. Most of the manual handling is done at the heat treatment department. The purpose of this master thesis is to give a suggestion on how to reduce or eliminate the manual handling at the heat treatment department. The possibility to use the same packaging throughout the processes will also be investigated.

Kompaktaggregat är ett integrerat FTX- och FVP-system som används i passivhus. Vi har gjortenergiberäkningar i programmet VIP+ för att se hur kompaktaggregatet skulle kunna fungera ipassivhus i Sverige.De resultat vi har fått fram ur VIP+ visar att passivhus med ett installerat kompaktaggregat klararav att nå passivhuskraven ända upp till Skellefteå. De beräknade värdena understiger kraven förpassivhus, men en viss marginal behövs för att kraven ska nås även efter uppförandet avbyggnaden. Vi har även tolkat tekniska uppgifter på ett sätt som enligt oss har en positiv effektför passivhus på kallare orter. Därför tror vi inte att värdena för de tre nordligaste platserna ärhelt tillförlitliga.

Med en ny vattenreningsdel vill Kalmar Vatten AB (KVAB) sänka sina utsläpp av näringsämnen i Kalmarsund. KVAB har vid tidigare tillfällen uppgraderat det befintliga reningsverket och för att klara framtida energi- och klimatmål planeras därför en nybyggnation. Uppdraget var att framföra olika pumpalternativ till den framtida pumpstationen och ge en LCC-analys för varje alternativ. Två helt skilda pumptyper har utretts, Arkimedespumpen och centrifugalpumpen. Två alternativ för Arkimedespumpen och ett alternativ för centrifugalpumpen har tagits i beaktande.

AbstractThis master thesis was performed at Scania transmission department in Södertälje, where the manufacturing of gears is done. Today a large amount of manual handling is performed between the machining and the hardening process. Most of the manual handling is done at the heat treatment department. The purpose of this master thesis is to give a suggestion on how to reduce or eliminate the manual handling at the heat treatment department. The possibility to use the same packaging throughout the processes will also be investigated.

AbstractThis master thesis was performed at Scania transmission department in Södertälje, where the manufacturing of gears is done. Today a large amount of manual handling is performed between the machining and the hardening process. Most of the manual handling is done at the heat treatment department. The purpose of this master thesis is to give a suggestion on how to reduce or eliminate the manual handling at the heat treatment department. The possibility to use the same packaging throughout the processes will also be investigated.