The purpose of this Bachelor degree project is to design different types of services that can increase the amount of re-used timber within the building sector and by that means improve their environmental efforts. By examining how the sectors environmental work concerning recycling and re-using timber as a building material is getting on at present, conclusions have been drawn about what further could be done for improvement.The project has shown that there is a scarcity of information and statistics within the sector, but that there are efforts in progress to change this. Questionnaires have been sent to a number of companies working with demolition and utilizing re-usable materials in order to find out what kind of problems there are within the trade. Unfortunately the survey gave insufficient result due to the low reply frequency.It is obvious that active environmental work within the building sector is important and the knowledge acquired while working with the project has led to the design of three suggestions for services regarded as being of interest for improving the negative environmental impact caused by the sector:Suggestion 1 ? Sale of construction parts prior to the demolition of a buildingSuggestion 2 ? Re-utilization circulation when manufacturing buildingsSuggestion 3 ? Education in relation to the purchase of houses  The positive and negative qualities of the suggestions have been examined with SWOT-analysis and further adaptions and the results have been interpreted.

Ocean Modules Sweden AB is a small business active in the field of underwater technology. Thecompany was contacted by the Swedish Defense Materiel Administration (FMV) in order todevelop a new system that would conform to their specific requirements. Two students at theRoyal Institute of Technology (KTH) were consulted in conjunction of this project in order to aidthe development and conceptual design of the system.The primary users of the system are the divers of the Explosive Ordnance Disposal division (EOD)- a branch of the Swedish Armed Forces. The purpose of the product was to incorporate allnecessary functions required by the EOD divers into one single system. The main functions arecommunication between the surface operator and diver, video recording, still imaging, positioning,navigation and ocean floor mapping with sonar.

The aim of this study was to describe and analyze if and in that case how project Speaking English contributes to improved skills in English to pupils in reading and writing difficulties. The project started out in order to give pupils in reading and writing difficulties an alternative to the regular English teaching. The study was carried out in two nine-year compulsory schools. We have conducted interviews with both teachers and pupils to see what they think about the project. According to the teachers we interviewed Speaking English contribute to improved skills for the pupils and they also believe that their chances to pass the 9th grade will increase.

This is a project with the main purpose to create a visual identity and platform for the release of the new started record label Human vs Environment, by finding a form and logotype for the homepage and packaging of the first vinyl ep record by the artist Mr Kaizen. This has also been an exploratory work with the target to get a broader competence in the field of visual communication and increase my understanding of the designs communicative aspects of running a design project with an external partner from concept to finished product..

Introduction: First line managers in the public sector, are under a great pressure from both senior management, leadership, politicians and often from a large group of employees. Few studies have been made on the first-linemanagers psychosocial work environment, even though in the studies found that the manager affects their employees work environment.Aim: How first line managers in municipal elderly describes the psychosocial work environment on the basis of demand-control - support model.Methods: The study was conducted through individual interviews with six first line managers. Respondents were recruited through a strategic selection in a medium-sized municipality in Västernorrland. The interviews were conducted using an interview guide. Qualitative content analysis with an deductive approach was used as a method of interpretation of the results.Results: First line managers point out the difficulty in balancing the requirements and several managers also mentioned the importance of having clear role descriptions and objectives.

This report is a degree paper made for the Engineering program in Technical Chemistry at the School of Engineering, Jönköping University.The intention of the project which is described, is to answer whether HV71 might become environmentally certified according to the criteria of "miljödiplomering". The project also included an investigation of which further steps and measures must be undertaken by the enterprise in order to achieve the certificate. The final part was to implement the necessary requirements for the certification.The report starts with a short background where the origin and function of environmental management is briefly explained.The report continues with how the practical work with the environmental certification was done according to requirements of Jönköping municipality. Motivations behind each part of the process are given as well as explanations of how each part of the process was carried out.The final result of the project was that HV71 took the measures needed to live up to the required demands. After a revision made by Miljöstrategen i Jönköping AB, HV71 passed the demands and became thereby an environmentally certified business..

Young people?s political influence has been surveyed, studied and discussed several times in Sweden during the last decade. There is a fear among the politicians that the young people are not interested in politics, especially not in party politics. On the other hand there is, among the youngsters a feeling of invisibility, not being seen or heard or for that sake respected. There are a lot of formal possibilities for young people?s political influence, but there are not as many real possibilities or situations to actually practice these possibilities.

The dissertation were performed on SP, Technical Institute of Sweden. The dissertation were carried out on the measurement technical department, this dissertation is a part of a bigger project, project ClampCal. One of SP?s returning assignments are flow-measurement. When flow-measurement is performed, the flow has to be stopped so that a meter can be installed in the pipes where measurement is going to take place. At every stop there is time delay in the flow which causes the customers to loose money. This is why SP wanted to find a better solution so that measurement can be done without any stops in the flow. Usage of a so-called Clamp-on meter was considered, but since the measurement uncertainty is too large it takes some investigation on the parts where the largest uncertainties occur and thus find a solution that can diminish the uncertainty as much as possible. The parts that were considered to have an opportunity to reduce measurement uncertainties were the fluid temperature, its characteristics and the pipe geometry and its characteristics. For the fluid temperature a Pt100-sensor with four different radii for various pipes was used.

This degree project has been performed with Mega Teknik AB in Landskrona. The project has resulted in a workplace for the cable installers of Mega Teknik. The workplace contains a workbench and a cart.The first stage in this project was to make an analysis of the current workplace to identify the needs the installers had.The different principle construction proposals of how the workbench would look like and which functions it would have was made during brainstorming, in groups and alone. These proposals were compared against each other using a functional analysis that has been put up to get the principle construction that fulfilled most points in this analysis.The proposal chose for further work was a cart and a bench with a module intends, the table got a formulation that creates a better reach for the installers.This proposal was generated in Catia V5 to get a better overview of the suggested proposal.During the primary structure phase drawings over all the products were made and the components were chosen. Calculations were made and the product got the dimension required.

SFEHA project about a clothing brand and a new kind of showroom that looses it´s structure during the process.But managed to find the core and produced a personal mirror of prints for a greater cause.Sfeh is the brand with quality and humor in focus and the will to push the boundries. With prints based on free drawing and smart thinking as it´s essential base.The project resulted with a various collection with mostly T-shirts but also textile gloves and bed sheets..

Integration of the labor is becoming increasingly topical, with increasing immigration. Labour market integration has been proved to be problematic, partly due to linguistic and cultural differences between the migrant's home country and Sweden. Difficulties with labour market integration have resulted in high numbers of unemployment and dependence on social welfare. Projects VIAM is an employment project conducted by Folkhälsobyrån AB in Västerås, aimed at finding jobs for welfare dependency immigrants. The purpose of this study is to investigate how the informants on Folkhälsobyrån and administrators on the Social service in Västerås has experienced the work of the project VIAM, development issues and the informant´s and administrator´s perception of factors that are influencing immigrant´s employment situation in Västerås.

My project aims to understand more about the methods used in making woven textiles on an industrial level, and how these tech¬niques can be adapted to create object-specific pieces. On visiting the furniture fair in Stockholm, I was surprised to see that most of the textiles used for furniture were so similar, despite the variation in the furniture itself. My project is about creating textile patterns that are specific for each piece.The idea behind the process could be used for any product, but the pattern I created is specifically for the armchair Accent by Yngve Ekström. I wanted to create the feeling of a pattern moving over the surface of the object and adjusting to it. I worked primarily with differences in density.

Background: Knatteskutt is one of the largest organizations in children's sports. Operations are located in approximately 150 cities / areas and have both sports and dance focus. The children are aged 3-7 years and may try several sports activities or dance styles during the semester, focusing on play and motor skills. All who are leaders at Knatteskutt has undergone Swedish Sports Promotion of Child Leaders Training. There are also regional managers around Sweden is as a sounding board for leaders and as an extended arm between the office and the leaders.

Today  Real  estate  companies  face  the  challenge  where  extensive  renovations  on  existinghousing built before 1980 must be performed. Conditions have changed and the housing need performance-­?enhancing measures that meet today's quality. With a current renovation rate,  it  would  take  30  years  to  meet  the  renovation  needs.  The  renovation  rate  must therefore rise dramatically, which requires the real estate companies to act consistently in accordance with commercial principles and in an economically, socially and environmentally responsible way.The  paper  discusses  renovation  strategies  in  four  municipal  housing  companies  in  the Stockholm  suburbs.  The  report  includes  surveys  of  four  ongoing  renovation  projects; Fastighets AB Förvaltaren in Sundbyberg project Hundloken 3, Stiftelsen Signalisten in Solna project Ritorp, Sollentunahem in Sollentuna project Svalgången och Väsbyhem in Upplands Väsby project Dragonvägen. The main purpose of this study was to analyze the practices of redevelopment projects.

Ever since Lipsky wrote about street-level bureaucrats in 1980 the main belief has been that certain characteristics of their jobs make it exceptionally difficult to severely reduce their discretion. However, discretion comes at a price and if public servants abuse their power the legitimacy of government is at risk and ultimately even the democracy.This thesis address this question by analysing the Swedish employment service which in the beginning of 2001 started a project called ?Af Sverige? trying to improve internal rule of law. By comparing two local and fairly equal jobcentres and how the street-level bureaucrats within use their discretion, I seek to find support for my hypotheses that organizing local jobcentres according to the principles of machine bureaucracy plays a significant part in reducing discretion.My findings show that a jobcentre characterised by strict rules, few units, good communications and a forthright manager who delegates formal power to the employees results in a stricter and more uniform application of regulations among the street-level bureaucrats. My conclusion is therefore unambiguous.