The aim of this report is to give a description of a diploma work of 20 points that has been performed during the spring 2006 at Ericsson AB in Borås. The report accounts for the problem and procedure during the diploma work. The software used for this project was embedded in a radio link. The RAM in this radio link was divided into several regions where two were used for memory allocation. The current allocation of memory in the radio link was not optimized with regards to performance, security and memory use and the configuration used made it difficult to determine the memory use of the system and the actual memory need.

The aim of this study is to make clear the conception ?Sustainable Urban Development? through an investigation dealing with how the sustainable goals are attained in today?s Swedish urban planning. And also try to clarify where and why sustainable development is failing or lacking. Besides that I have investigated how actors take position towards urban sustainability. The essay is based on a literature study about sustainable urban development and it?s changes through the time and place.

The Smart Grid technology has during the last decade been established as a way to create a greater flexibility on the electricity grid that will be needed as the development moves towards an increased share of renewable primary energy sources in the electricity production. One part of the Smart Grid technology is the ability to shift loads in time, to adapt to either price or emissions, known as Demand Response. This project, which was conducted at KTH in collaboration with the consulting corporation Capgemini, examines the economic, environmental and social aspects of the Demand Response technology. In the project, three household products are used in a model that derives the potential savings in costs and emissions of CO2e. The results show that the actual savings measured in SEK are small, but that the savings measured in percent can be as high as 20 percent. Reduction of CO2e emissions is slightly lower.

This study examines the connection between Sweden`s crime rate and financial aid, focusing on the effects of social spending on different types of criminal activity in the Swedish municipalities between 2000 and 2022. Using theories such as social support theory and utility maximization, the study investigates the relationship between economic assistance and crimes like theft, attempted murder, drug offenses, and assault. The results suggest a complicated relationship: financial aid is associated with a rise in drug offenses and assaults but a decrease in larceny and robberies, when controlling for all observed and unobserved time invariant factors in the municipal factors (a fixed effects panel data model). However, when we test our model for robustness, the effects disappear meaning that other factors that are time varying in the municipality are biasing our estimates. Examples for this may be factors like peer pressure, substance addiction, and socioeconomic conditions that have a considerable impact on criminal conduct, financial aid alone may not be adequate to curb crime.

Lundbergs Plåt AB is a small company situated in Jönköping. Their main task is to process different kinds of steel such as stainless steel. Lately, they have shown an interest in Lean production.On the basis of the situation mentioned above, we developed the purpose to find and decrease the non value-added wastes in the production at Lundbergs Plåt AB. Out of this, we also developed and answered two questions: Which wastes can be found with help from a value stream mapping (VSM)? In what way can these wastes be reduced and how can these reductions contribute to an improved production? VSM is the method used to find the non value-added wastes.

Seen in many trends and studies, consumers of today feel a growing desire to experience the uniqueness in products and services. This is forcing companies be more innovative and creative in their marketing, in order to distinguish and differentiate themselves and their products/services. We believe that creating a top-to-bottom experience strategy is one way that a company can succeed in this.The purpose of this thesis is to analyze and clarify how a business can reinforce their product experience through a complete experience strategy. In order to demonstrate this we have made a case-study research for the New Wave Group, advising them on how they can place blown glass art at the heart of the town of Kosta.The authors have used qualitative methods and an abductive approach. Four interviews have been completed with executives from the New Wave Group, including the project manager, hotel manager, head of the Kosta Boda smeltery and head of guides and visitors at Kosta museum.

Breast cancer is the most common tumor disease among women in Sweden. About 7000persons, having a median age of 65, are diagnosed each year with this disease. Withmammography screening, breast cancer can be detected in an early stage which improves theoverall survival (OS). 20-30 % of the breast cancer tumors are overexpressing humanepidermal growth factor receptor 2 (HER2), which is a protein that stimulates cell proliferation.Trastuzumab (Herceptin®) is a humanised monoclonal antibody that targets the HER2-proteinand prevent the signals for cell proliferation.Trastuzumab has earlier been used for treatment of metastatic breast cancer. In the year of 2007trastuzumab was approved for adjuvant treatment of patients who has been medicated withsurgery and/or radiation.The aim of this study was to investigate the effects of adjuvant treatment with trastuzumab inHER2-positive breast cancer patients.

The objective of this study is to examine the sustainability of recovering industrial wasteheat from several heat sources in a foundry constructed in a plant belonging to ITT Waterand Wastewater in Emmaboda, Sweden. A triple bottom line perspective will be appliedto achieve this objective. The triple bottom line approach takes into account ecologicaland social performance in addition to financial performance. The technology forrecovering the waste heat is a Borehole Thermal Energy Storage (BTES) which is aconstruction consisting of 140 vertical boreholes, 150 meters deep with an internal spaceof four meters.The calculated amount of energy for storage is approximately 3800 MWh annually. Ofthis amount 2500 MWh are expected to be utilized, while storage losses accounts for theremaining part.

This is a final thesis done at BT, considering one of their forklift truck models called Reflex. The first part of this report is about a preliminary investigation investigating what kind of diagnostic systems BTwants to use, and also which demands there are to meet all expectations on such system. Secondly a diagnostic system, which will show if the drive wheel is worn out, will be presented. In the preliminary investigation, two kinds of diagnostic systems were mentioned. These were Model based diagnosis and Predictive analysis.

Future emission legislation puts great emphasis on increasing the efficiency of the engine, thereby reducing fuel consumption. The tribological contact between cylinder liner and piston ring is where an great amount of energy is lost due to friction, and by reducing these losses an reduction in fuel consumption can be achieved.The aim of this thesis was to evaluate the tested piston ring coatings against a plasma sprayed cylinder liner and rank these combinations of materials for friction and wear resistance. The coatings that were tested was Cr + Al2O3, (Al,Cr)N, two types of CrN and WC / C.The experimental tests were performed with a so-called pin-plate, where used oil with addition of an acidic mixture of sulfuric and nitric acid to mimic the acidic condensate formed when exhausts recirculate, were added with a continuous flow. The results were then analyzed by weighing, studies by optical microscopy and scanning electron microscopy (SEM) and profile measurements.The results from each material combination were that the plasma coated cylinder liner wears too aggressively in order to yield a ranking of the piston ring coatings based on the parameters of friction and wear resistance. It is therefore proposed that an alternative coating on the cylinder liner should be developed, lacking the large abrasive wear on piston rings and that can withstand the corrosive environment resulting in engines equipped with EGR.

SEP Modular Armoured Tactical System is the next generation of military vehicles developedby BAE Systems Hägglunds AB. At present time, BAE Systems Hägglunds AB aredeveloping a 6-wheel electrical hybrid and a conventional 8-wheel vehicle. The questionformulation was summarized as: ?In which ways can the electrical transmission in a hybriddriveline for SEP be designed, when the surrounding fixed interfaces are kept and the unity ofcomponents within SEP is maximized??. The purpose of this master thesis was to study avariety of concepts for hybrid propulsion.

This report is a literature review that aims to describe marketing contexts for mango production in Kenya. The institutional conditions in the country are not well developed for marketing purposes, which causes many difficulties and problems for the society. In Kenya most mango producers are poor small-scale farmers with limited resources. Mango is a perishable commodity and to keep its value and quality it is essential to have the opportunity to sell the mangos in the right time. Inefficient and undeveloped infrastructure and marketing systems hinders the mangos to reach the market in time though, which causes large losses of produce.The Kenyan mango production has increased during the last decade but due to market losses for the producer, the small-scale farmers? profits have not improved.

The component workshop at Atlas Copco inTierp intends to reduce the costs inorder to increase their competitiveness.This thesis examines how the productionmanagement around cylinder washersshould be managed in a way that meetsthe customer needs. The customer to thecylinder washer is Atlas Copcos assemblydepartment in Tierp.The purpose of this thesis is to providean alternative way of managing theproduction. A chapter of theory is addedto give the reader an insight ofdifferent types of production managementsystems as well as the underlyingknowledge needed to get a better readingexperience. An introduction of kanbancan in theory help Atlas Copco in thedirection they strive. It should beclear how the purpose of this thesisaffects the cost for the componentworkshop and also how it relates to thecurrent production.

The Smart Grid technology has during the last decade been established as a way to create a greater flexibility on the electricity grid that will be needed as the development moves towards an increased share of renewable primary energy sources in the electricity production. One part of the Smart Grid technology is the ability to shift loads in time, to adapt to either price or emissions, known as Demand Response. This project, which was conducted at KTH in collaboration with the consulting corporation Capgemini, examines the economic, environmental and social aspects of the Demand Response technology. In the project, three household products are used in a model that derives the potential savings in costs and emissions of CO2e. The results show that the actual savings measured in SEK are small, but that the savings measured in percent can be as high as 20 percent. Reduction of CO2e emissions is slightly lower.

This essay aims to emphasize and clarify the positions that exist within the current globalization debate. The positions are the neo-liberal, the opponents, the pragmatists and the skeptics. The text presents and explains their ideological, moral and political positions and beliefs about the world, the nation state, the society and the individual; in light of Steven Lukes? and Antonio Gramsci's theories regarding the interaction and the relationship between power and hegemony. The methodological starting point is the ideology-critical analysis; in which their arguments in the current globalization debate is highlighted and categorized.