The climate change the earth today has to face is no longer a global problem when every individual has a responsibility to act. The residents in Sweden have no understanding how their energy consumption affects the environment, nor what measures can be taken to reduce the energy consumption.The use of the energy in new Buildings is considerably lower than in the older ones as conditions have improved and the requirements have been more stringent. As most of the buildings in the future have already been constructed it´s important to take every opportunity for energy efficiency and rebuilding of available buildings will become a significant act. Reconstruction of a building contributes generally to both a reduced individual and a reduced total energy use, while new constructions only keep a low individual energy use but a increase the total energy use. For this reason we present the opportunities for reconstruction, mainly to reach the standards for a passive house..

In the thesis we have shown that it is possible with current technology, to buildneighborhoods that are largely self-sufficient. We have obtained some information aboutongoing work in the field of energy efficient buildings and active house which we have usedto develop a model. The feasibility study for Ranagård we have e.g been forced tofollow laws on groundwater covered, resulting in the construction of basements for singlefamilyhome is not possible. The model that we have built up overtime has been the central part of the work. The model illustrates very well what an activehouse neighborhood means and potential of such an area.

This thesis conducted at the University of Uppsala investigateshow well a prefabricated building component from the manufacturerMasonite Lättelement AB can be incorporated into ahouse projected to accomplish the demanding criteria of a passivehouse. The thesis is organized as a comparison betweenthe prefabricated elements and an on-site built component fromthe passive house area of Oxtorget in Värnamo, Sweden. Theaspects investigated were air leakage, energy, moisture, economyand noise conditions.Results of the comparative analyzes shows that the prefabricatedproducts were capable of accomplishing the requirementsof passive houses and therefore this thesis should beviewed as a basis to confirm that the technology of prefabricatedbuilding components today in Sweden are mature enoughto be a significant part of the passive houses that are to be builtin the near future. The development of prefabricated technologyis of crucial significance if we are to accomplish the goalsof reduced energy consumption by the year 2020..

Background: The most energy efficient houses today are so called passive houses. These houses achieve high energy-efficiency partly by having well insulated walls. U-value describes the amount of heat transfered through a building element, the more insulation, the smaller U-value. A typical passive house wall have a U-value of 0.10 W/m2,°C. The passive houses are primarily made as small family houses and not as a block of apartments.

Energy efficiency has become a very topical issue that has been discussed throughout the European Union for preventing negative environmental impacts that have been associated with the consumption of energy. In the residential sector have mainly municipalities set strict requirements for the reduction of energy consumption while the renewable energy has been asked. Different concepts of low-energy buildings have been developed to reduce the cost of operation and maintenance in existing buildings such as in new ones.This thesis has aimed to minimize the energy cost of a large building which has had low energy consumption features originally. Energy reviews has been initiated in order to be able for showing how the house electricity could be carried out even more efficiently.The work was initiated through a literature study to clearly increase the reliability on the energy subject. Different concepts of low-energy buildings have been treated in connection with its specifications, afterward those have been compared with the obtained results.

The purpose of the house which is the basis of this report is to be able present itself on the market as a relatively cheap and at the same time a climate friendly choice. The house is supposed to be able to be built anywhere in Sweden and the rest of Scandinavia in a short period of time. This puts demand on what kind of heating system the house can have, since not all places have the geographic advantage of being able to use geothermal or district heating. Therefore the heating system choices will only include those that are not limited by their geographic location. The house will be built in modules which only require the groundwork to be done before the house can be erected. In this report "System solutions for plus or passive-housing" a comprehensive literature search has been conducted as well as a number of calculations.

The purpose with this project is to explore and verify three renovating systems for Miljonprogrammet (common expression forbuildings constructed during the years 1965-1975 when over a million houses where built in Sweden) to take measure to thelargely transmission losses of these buildings. Many of the buildings from this period have similar constructions and thereforethe same techniques can be used to renovate several of them. This project only considers the climate scale, although thereare many more factors to concern for to efficient the buildings of Miljonprogrammet.This thesis presents examples of renovations carried out using two of the three renovation systems.The essay presents a reference house of choice on which we apply the three systems and calculate the new U-values,consumption of energy and the investment costs. The new U-values the building is given is matched to the values ofrecommendation for passive houses. Our reference house is a two story apartment building, located in the village ofLammhult, with brick facades at the ends and plaster at the long sides.

Utifrån varumärkesteorier undersöka vilka konsekvenser H&M´s beslut att lansera sitt nya varumärke COS som ett fristående varumärke utan någon synlig koppling till H&M har haft på konsumenternas uppfattning om varumärkena. Vi dragit slutsatsen att konsumenterna påverkas positivt av H&M´s val att övergå till ett House of Brands och lansera COS som ett fristående varumärke. Den osynliga, men samtidigt tydliga kopplingen är en viktig framgångsfaktor..

This master?s degree project concerns the combination of a multi dwelling passive house with solar energy for the generation of electricity and domestic hot water (DHW). Different alternatives with either solar thermal systems or photovoltaic (PV) systems are compared with two reference alternatives producing DHW from electricity or district heating. The economical comparison uses a life cycle cost (LCC) perspective based on the present value of expenditures for investment, energy and annual operating and maintenance.The energy yields from the solar energy systems were calculated by hand and with simulation software. Calculation and dimensioning of PV systems were carried out with a software called PVSYST.

This essay concerns the interpretation of house plans in three-aisled longhouses and hall-buildings, in Scandinavia during Iron Age. Full scale house reconstructions need a better basis of interpretations to understand the patterns of roof supporting post holes in excavated house plans. This has led to the thesis, presented here, that the layout of house plans during Iron Age is based on geometrical proportions. In order to prove this, geometric house plans were applied and compared with excavated house plans in 11different case studies, including the fortification of Fyrkat Denmark. It was found that all house plans in the case studies indicate, that the geometrical proportions 1:2, 1:3 and 2:3 of a given circle must have been used for the basic layout of the roof supporting post holes, using a compass and a straightedge.

I detta examensarbete har energiberäkningar och analyser enligt FEBY12 gjorts på ett radhusområde för att undersöka vad som krävs för att lågenergihusen ska uppnå passivhusstandard. Att uppföra energisnåla byggnader är i dagens samhälle viktigt för alla företag eftersom människor blir allt mer energimedveten och krav från beställare blir allt högre. I arbetet har en modell av radhusområdet modellerats i Revit Architecture för att på ett smidigt sätt få korrekta värden i de olika energiberäkningsprogrammen Vasari, Energihuskalkyl och PHPP. Programmen har helt olika kvalitéer därför har en jämförelse och analys av programmen utförts. Analyser har tydligt visat att det krav som finns för att uppnå passivhusstandard på värmeförlusttalet är betydligt svårare att uppnå än det krav som ställs på den levererade energin. För att uppnå passivhusstandard vidtogs diverse åtgärder såsom U-värde för väggar förbättrades, ventilationsaggregatets verkningsgrad höjdes samt fönsterpartierna reducerades avsevärt.  .

sustainable development by reducing the energy use by EU:s directive of energy efficiency and the UN Convention. The second purpose is to present the technical solutions regarding ventilation and heating system that is being used in passive houses. This was done using 8 passive houses, 4 germany and 4 swedish passive houses. Even the international and Swedish system requirements for passive houses have been addressed in this project. The goal was also to explain how and why the mechanical system in passive houses has developed to the technology used today.

This thesis presents a comparative study of image registration at two picture collection libraries. The two registration systems are analyzed as to the theoretical principles behind them and their practical application, and related to theoretical tools for subject analysis and bibliographic standards. While a growing number of picture collections now digitize their material, generally accepted standards and methods for the registration of digital images are still lacking. Many different systems coexist, often developed in-house in response to ad hoc needs and based on traditional registration tools created for textual documents, resulting in internationally incompatible mixed-format systems. The two picture collections examined here, however, have opted for similar, standardized tools for registration and subject analysis, and while there are differences in their application and focus, they have both considered issues of cross-system compatibility.

The Results of this thesis was the creation of two designed house variants with a module toall the apartments. In addition till the first module there are three other modules ofapartments that can be put in the houses if it so needs. The house are volume prefabricatedand are placed on site in a way that it create an enclosure of the area which faces against thenature and car parks also lies hidden behind these houses.For the actual structure, a cross beam was created to carry the floor above and it is supportby all four walls. The structure between the first and the second floor has no "syll" butinstead there are two differently alternative to linking the floors in order so that it will notmove. The reason with this solution was that there will not be any subsidence when theforces from above are pressed down ward.

The purpose of this study is to examine how employees in an organization using flexible work practices, experience that passive face time influences the evaluated of them. Further, the study aims to understand to what extent that perception of passive face time motivates the employees to spend more time at the office than is necessary for their work situations. The study concludes that employees in general perceive that passive face time does influence how they are evaluated and that this perception motivates employees that are relatively newly employed by the company to spend more time at office..