Sök:

Sökresultat:

783 Uppsatser om Parametersättning - Sida 37 av 53

Membranbioreaktorteknik- en framtida lösning på Lundåkraverket? : Membrane bioreactors- A future solution at Lundåkra wastewater treatment plant?

Membrane bioreactors (MBR) combined with biological phosphorous treatment (Bio-P) has been investigated if that could be an alternative to the future expansion with conventional active sludge treatment at Lundåkra wastewater treatment plant (WWTP) in the proximity of Landskrona, Sweden.The results showed that the surface demand in the biological treatment will be reduced with 67% with the MBR-alternative compared to a conventional activated sludge process. The nutrient removal in the MBR-solution was decreased or unchanged for nitrogen-, phosphorous- and organic parameters. However, the energy demand will increase with an estimated cost of approximately 1 million SEK annually. Moreover, the extra chemical consumption is estimated to cost 370 000 SEK annually.The disturbances caused by filamentous bacteria such as sludge dispersal could be resolved with MBR-technology because the membranes are not affected by these organisms. The Bio-P process combined with MBR-technology works if the wastewater recirculates from the membranes to an aerobic zone.In the proposal, there will be a new pre-treatment step, for instance hole screens.

Det postkoloniala temat i Sara Lidmans roman Din tjänare hör : Om det koloniserade subjektet och konflikten mellan ord och jord

Den stora manliga dominansen inom musikbranschen, och dess olika villkor fo?r kvinnor och ma?n, har lett till uppkomsten av organisationer som vill utja?mna ko?nsbalansen. Popkollo fo?rso?ker uppna? detta genom att ordna musikla?ger, speciellt riktade till tjejer.Syftet med min underso?kning a?r att fa?nga unga musicerande tjejers bera?ttelser om sina upplevelser innan, under, och efter ett Popkollo. Dessa upplevelser skildrar jag utifra?n en kvalitativ intervjustudie med 18 kollodeltagare fra?n sommaren 2013.

?Det handlar framf?r allt om att f?rbereda, ligga steget f?re och se vad han beh?ver f?r att lyckas i den h?r situationen? En kvalitativ etnografisk studie om pedagogers st?d och relationsbyggande med barn med autismspektrumtillst?nd i f?rskolan

Allt fler barn f?r diagnosen autismspektrumtillst?nd (AST) b?de i Sverige och internationellt. Forskning visar att barn med AST ?r i behov av ?kat st?d och n?rvaro av pedagoger p? f?rskolan och att pedagoger genom att anv?nda tydligg?rande pedagogik kan skapa st?rre f?rf?rst?else inf?r ?verg?ngar. Forskning visar ocks? att det ?r viktigt att bygga en f?rtroendefull relation till barnen med AST och att det barnen beh?ver mest st?ttning kring ?r ?verg?ngar mellan olika aktiviteter. Det st?rsta sk?let till att det uppst?r sv?righeter f?r barn med AST i f?rskolan ?r dock att pedagoger saknar kunskaper kring bem?tandet av deras olikheter. Denna studie vill synligg?ra vilket st?d pedagogerna erbjuder barn med AST i ?verg?ngar p? f?rskolan och hur detta st?d kan p?verka barnens k?nsla av sammanhang (KASAM).

Utvecklad modell för enklare djurskyddsbedömning : med exempel från mjölkkor i lösdrift

Developed model for easier animal welfare assessment- with examples from dairy cows in loose housingAnimals in captivity are completely dependent on human care. If captive animals are prevented from exhibiting their natural behavior, they may suffer. Animal welfare inspectors, who insure that the animal welfare legislation is followed, use a checklist to assess the situation in the husbandry. This checklist contains only two levels of assessment, which may result in a lack of detail in the assessment of the husbandry. The objective of this report was to develop a more detailed model that provides an overview of the situation in husbandry.

Statistiska metoder för härledning av indata till säkerhetsanalyser inom kärnkraftsområdet

Objective: In recent years there has been an increasing interest within the clinical (medical) science in measuring people?s health. When estimating quality of life, present practise is to use the EQ-5D questionnaire and an index which weighs the different questions. The question is what happens if the individuals estimate there own health, would it differ from the public preferences? The aim is to make a new prediction model based on the opinion of patients and compare it to the present model based on public preferences.Method: A sample of 362 patients with unstable coronary artery disease from the Frisc II trial, valued their quality of life in the acute phase and after 3, 6 and 12 months.

Civilsamh?llets medbest?mmande i stadsplanering ? en f?ruts?ttning f?r h?llbar tillv?xt enligt Agenda 2030

Syfte: Studiens syfte ?r att unders?ka huruvida civilsamh?llets medbest?mmande i stadsplanering sker p? kommunal niv? p? regelbunden och demokratisk grund, i enlighet med Agenda 2030. Teori: Id?n om ?wicked problems? (elaka/trassliga problem) av Horst Rittel och Melvin Webber (1973) anv?nds som teoretiskt ramverk f?r studien. Teorin f?ruts?tter bland annat att det inte finns n?gon gemensam syn p? problem som hanteras inom stadsplanering eftersom olika akt?rer ser p? deras komplexitet utifr?n sina institutionella logiker och uppfattningar.

Reducering av ledtider samt framtagande av kalkylmodell

Rimaster Kisa AB is a member of the Rimaster Group, the corporation was bought from Samhall AB in January 2007. The corporation is producing mechanichs needed by the Rimaster group as well for external costumers. Samhall AB is now functioning as a provider of labor for Rimaster Kisa, as the company is hiring personnel from Samhall AB. The company has earlier have had problems with their lead times being far too long. This has resulted in that the management decided to invest in a new edging press.

A tt köpa och sälja konsulttjänster inom byggsektorn - En undersökning av kompetensupphandling inom offentlig och privat sektor

Syfte ? Att skapa en ny produkt inom kategorin mingelbord, som erbjuder fler användningsområden för att bli mer anpassad för privatpersoner och i hemmamiljö. Att genom en innovativ konstruktion och en kombination av moduliserade- och hantverksdelar skapa en unik produkt på marknaden.Metod ? Grundmetoden för det här arbetet är den första fasen i en produkts liv: produktutvecklingsprocessen; identifiera behovet, planera designprocessen, ta fram kundkraven, utveckla konceptet och till sist utveckla produkten.Resultat ? Designkoncept på ett mingelbord har tagits fram och redovisas i bilder. Dessa bilder är resultatet av en uppmodellering i datorn med hjälp av 3D-progam.

Detektering av in- och utandning vil bilkörning med hjälp av Matlab

Volvo Human Monitoring (VHM) is an ongoing project at Volvo Cars where they measure, amongst other parameters, inhalation and exhalation through a device called Respiratory Inductance Plethysmograph (RIP), on drivers. RIP measures changes in the cross-sectional area of the chest and abdomen. When the driver is in motion, such as when she is turning the vehicle, the cross-sectional area changes and noise in the RIP signal may arise.The noise results in a large number of manual adjustments in the analysis of the RIP signal, which is very time consuming and the validity of the device for measuring inhalation and exhalation is questioned.The purpose of this study was to improve the efficiency of the analysis of the RIP signal. The goal was to create a new data processing tool in Matlab that automatically detects inhalation and exhalation from a RIP signal with higher validity compared to the previous data processing tool.In this study, nine tests were performed on drivers while they were driving in different scenarios such as highway, country road and in city traffic. Inhalation and exhalation was measured using a RIP, a pneumotachograph with a tightly sealed facemask and a thermocouple placed between the nose and mouth, which was used as reference to the RIP.The result of this study was a data processing tool that automatically detects inhalation and exhalation with higher validity compared to the previous data processing tool.

Samband mellan tjockleken hos PVD-skikt och förslitningsbeteendet vid svarvning

This project has as main goal to study the influence of the coating thickness, deposited by arc-PVD- technology, on the wear resistance of coated cemented carbide inserts in three different turning operations. An additional effort has also been made to develop a new test method for evaluating flank wear resistance. Three different coating types (Coating A, Coating B and Coating C) have been studied in three distinctive thicknesses (2, 4 and 6 µm) for each type. For two of the coating types (Coating A and B) special studies has been done with the thickest coating, creating two additional coating versions of the thickest coating, by changing various deposition parameters, with the aim to enhance the cohesive properties of the coating and lower the residual stresses at the cutting edge. The results show increased crater wear resistance with increased coating thickness for all coating types, but the amount of increase changes with coating type (Coating A>B>C).

Kvaliteten hos charkprodukter efter borttagandet av namnskydd, samt införandet av EU:s köttdefinition

Until the 1st of January 2003 there were thirteen processed meat products provided with name protection in Sweden. These products had to contain a certain amount of meat and/or a certain amount of fat to be allowed to carry a recognized name. Among these thirteen products, one could find, for example, meat balls (köttbullar), liver pâté (leverpastej), and Falun sausage (Falukorv). While imports of these products started to increase, the system with name protection lost its ability to guarantee a certain quality for all products sold in Sweden and the legislation was removed on December 31st 2002. At the same time, a common definition of meat was adopted in the European Union.

Feldiagnos för RM12 baserad på identifierade modeller

The jetengines of today are growing in complexity. Reliability for aircraft engines are of extreme importance, mainly due to safety reasons but also economical ones. This master thesis deals with faultdiagnosis in the turbine section of RM12, the engine used in Saab/BAe's Gripen. Three different faults which can occur in the turbine section was studied. These faults are: clogged fuel nozzle, hole in outlet guide vane and sensor fault.

The influence of forestry stands treatments on brown bears (Ursus arctos) habitat selection in Sweden ? an option for Alberta forestry?

The brown bear population in Alberta, Canada has been decreasing, while the Swedish has been increasing and all the affecting parameters are not known. This study examined the difference in these populations to see if an explanation could be found in differences between the forest management. The aim of the paper was to see if stand treatments had an influence of brown bears habitat selection in autumn in Sweden and how the results can be used in Alberta. This was done by analyzing bear positions in Sweden with forest data, and comparing forest management data for the study area in Sweden with forest management data for Alberta. The results displayed that mature forests over 60 years that have been commercially thinned are selected by bears rather than forests over 60 years that have not been commercially thinned in.

VSM och 16 förluster

With background in the rapidly growing need to find solutions for sustainable energy production and the increasing interest for wind power, this report was written. With take-off point from the wind power plant Big Glenn, which has been built in the harbour of Gothenburg, a model of the adjacent power grid has been created in Simulink/SimPowerSystems. Parameters for the power grid and its components has been provided by Göteborg Energi Nät, that has also been the supplier of measurement data of produced power, the power need from loads in the vicinity, voltage levels, current values and also the variation of power factor at the wind power plant.The SimPowerSystems model has been used to perform simulations of power flow in the grid. These simulated values have then been compared to the measured values to verify the functionality of the model. Further, the model has been used to perform simulations of a grid fault, which causes a voltage drop.

Djupströbädd -bra för miljö och djur?

Deep litter is a system for animals kept in separate stalls, loafing and bedding in wind shelters. The litter can consist of different bedding, like straw and peat. The system is allowed to build over and to ensure optimal proportions it is necessary to add new straw regularly and to have good conditions. Important conditions are aerobic state, humidity, amount of organic substance and acceptable temperatures in the litter. The micro organisms are depending on temperature for their living conditions and to get the bottom layer in the litter to start burning.

<- Föregående sida 37 Nästa sida ->