Emission of nitrogen oxides as well as carbon monoxides is an inevitable result of combustion. A Swedish law "Law of environmental fee for emissions of nitrogen oxides as a result of energy production" (lagen om miljöavgift på utsläpp av kväveoxider vid energiproduktion (SFS 1990:613)) controls the emission of NOx from energy production by a system of fees. The system has resulted in a strong approach toward less emissions of NOx among the energy production plants. High emission levels, today exceeding 52 mg/MJsupplied fuel, leads to costs for energy production companies. This paper examines possibilities to reduce the emissions of NOx by optimization of the SNCR-technique in a biofuel fired heat and power plant.

The system tungsten-oxygen has potential of being suitable for decorative coatings since ceramic coatings are often hard and wear resistant, and since modulations in oxygen content or incorporation of small ions could give bright colours. The aim of this report was to investigate the relationship between process parameters and  the properties of the films, with the wear resistance being of special interest.Samples with tungsten to oxygen ratios in the range of 100:0 to 25:75 at% were made using reactive sputter deposition, either with constant gas flow, or gas flow controlled by optical emission of the plasma. The hysteresis of the system, which means that a certain gas flow will cause different pressure and/or target voltage depending on in what way the flow is reached, makes it interesting to control the process where the system makes the steep change from metallic tungsten to ceramic tungsten oxide. This is difficult and thus requires precise control equipment.The samples were analysed using X-ray diffraction, X-ray photoelectron spectroscopy and an empirical wear test suitable for small components like cell phone cover for example, in order to characterize the structure, composition and wear resistance of the coatings. The results could be divided into three groups: (I) tungsten-like, with very low oxygen content; (II) mixed phase and (III) tungsten oxide like, with oxygen content close to 75 at%.

Abstract This degree project examines how much carbon dioxide that emits during the construction phase of a road project. This is to make it possible to compare how the amount of carbon dioxide differentiates between traditional road construction and Swepave construction, which is PEAB?s alternative way to design roads. To make the comparison a calculation tool has been produced. To compare the amount of carbon dioxide emissions a reference project was needed.

Mankind faces a serious threat. Its activities, for example the burning of fossil fuels, have led to an enhancement of the greenhouse effect - something that has given rise to a global warming. The climate is becoming warmer, a change that has important effects on the nature as well as for humans and their society. Sea level rising, extreme temperatures are becoming more common, glaciers and other ice caps melt and storms becomes more intense when they appear. The main cause is the emission of greenhouse gases into the atmosphere - carbon dioxide in particular.

Common species of freshwater mussels may, like the freshwater pearl mussel (Margaritifera margaritifera) have a drastic decline in number and there is several reasons, like sedimentation, a decline of host fishes, introduction of alien species, nutrition leakages from agriculture and pollutants of medic drugs and poison. Ann Gustavsson made in the year of 2007 a study over rejuventation of freshwater great mussels in nine watersystems and considered that the rejuventation within the populations were all along the line poor. This study orients from her work and points to determine if there is a connection between the poor juventation and pollution of nitrogen and phosphorous from industries and private sanitations. The study was performed with the software program ArcGIS9.2 to take out drainage areas for the concerned habitats and contact was made with the concerned authoritys. When it comes to supervision of private sanitations is it the countys and for industries is it the county administrative board.

The work covered in this report includes a literature study of the diesel dual fuel technology(hereinafter referred to as DDF). The literature study covers earlier work that has been doneregarding the use of compressed natural gas (CNG) and diesel in a DDF system. Moreover a onecylinder research diesel engine was fitted with a CNG fuel system for experimental testing. Theinstallation of the engine and the test cell is described. Results from the tests are presentedcovering emissions, heat release and pressure traces from the DDF-concept.During the literature study it was found that most research was related to heavy duty dieselengines.

Detta examensarbete utgår ifrån en artikel i vilken en metod för att skapa holografisk video beskrivs. Syftet med arbetet är att återskapa denna metod. Metoden bygger på projicering av hologram med hjälp av delar från en projektor, en laser och några linser.Först görs en litteraturstudie för att få förståelse över hur metoden fungerar. Här behandlas hur ögat ser djup och vilka olika typer av displayer det finns för att återge tredimensionella holografiska bilder. Vidare beskrivs skillnaden mellan optisk och datorgenererad holografi.

Common species of freshwater mussels may, like the freshwater pearl mussel (Margaritifera margaritifera) have a drastic decline in number and there is several reasons, like sedimentation, a decline of host fishes, introduction of alien species, nutrition leakages from agriculture and pollutants of medic drugs and poison. Ann Gustavsson made in the year of 2007 a study over rejuventation of freshwater great mussels in nine watersystems and considered that the rejuventation within the populations were all along the line poor. This study orients from her work and points to determine if there is a connection between the poor juventation and pollution of nitrogen and phosphorous from industries and private sanitations. The study was performed with the software program ArcGIS9.2 to take out drainage areas for the concerned habitats and contact was made with the concerned authoritys. When it comes to supervision of private sanitations is it the countys and for industries is it the county administrative board.

Green public procurement (GPP) can be used as an instrument to reduce carbon dioxide emissions, and consideration of environmental aspects within public procurement is becoming more common in Sweden and internationally. Two product groups that have been pointed out as especially important are transports and electricity, where the opportunities for public purchasers to reduce emissions are relatively large. This paper studies GPP which aims at reducing emissions, primarily of carbon dioxide, through environmental requirements within these two product groups. A theoretical analysis of cost-effectiveness, transaction costs and effects on technological development is performed, followed by a closer study of how these aspects appear in practice within GPP. The results indicate that a cost-effective allocation of reductions between the two product groups is most likely to be attained if the main part of emission reduction is achieved through environmental requirements on electricity. The cost for emission reduction within transports is relatively high, especially for heavy transports. For transportation services, more generally focused requirements on emission reductions could probably give greater environmental gains, but the existence of transaction costs steer the environmental requirements towards more technology specific types.

This report contains a study of replacing nuclear power with biofuel. The nuclear plant, OKG north of Oskarshamn in Sweden has been chosen and an extensive literature study about the nuclear plant has been implemented. The main aspect of this report is the availability of biofuels and whether it would be economically sustainable. Sweden?s most common biofuels are examined with regard to scope of use and potential.

En marknadsundersökning av förekommande metoder för digitalisering av karosseridetaljer. Olika skannertyper analyserades och en rekommendation av lämplig metod lämnades till uppdragsgivaren. Förutom punktantal beaktades även punktorintering, inskanningskostnad/tid, positioneringssystem och mätrymd. Uppdragsgivaren rekommenderades att använda en optisk skanner för projicering av fransar med ett optiskt spårningssystem. Då tillverkning skall ske i mycket små serier berördes även olika tillverkningsmetoder, som exempelvis hydroformning mot ett formverktyg av aluminium eller kompositcement.

This thesis concerns how the power quality in the grid is affected by the connection of wind power plants. As things are at present, Fortum Distribution AB has a number of wind turbines and wind parks connected to the own grid. As the pressure on building and connecting additional wind power is increasing, so is also the interest of how the already existing wind power generation affects the power quality in the nearby distribution grids. The study is performed by direction of Fortum Distribution AB and is limited to the 10 kV/40 kV-grid in Bohuslän, Sweden. The methods for calculation of power quality are compared to the results of a number of measurements.

A one-cylinder research engine has been used for studies with a Diesel Dual Fuel concept (DDF). DDF is a concept that utilizes a pilot diesel injection to ignite a homogenous natural gas/air mixture. Emissions and engine efficiency have been analyzed in an emission cycle called European Stationary Cycle (ESC) and the knock/pre-ignition problems with this type of engine have been investigated.At low and mid torque levels, an early diesel injection around 60 crank angles degrees (CAD) before top dead center (TDC) was used. At these loads raw NOxemissions was below EURO 6 level (0.2 g/kWh). NOxwas at EURO 5 level over the complete ESC without after treatment and with SCR at high loads it should be possible to reach EURO 6.One issue with DDF is the high HC emission levels.

Denna rapport handlar om optisk koherenstomografi, Optical Coherence Tomography (OCT), en relativt ny teknik som blivit allt mer attraktiv på sjukhusens ögonkliniker. En OCT-apparat används bland annat för diagnosticering av ögonsjukdomar lokaliserade i gula fläcken och runt optiska disken. I maj 2007 köpte Ögonkliniken på Blekingesjukhuset in en 3D OCT-1000 av märket Topcon. Hos denna OCT-apparat finns en mätfunktion, Caliper, som mäter näthinnetjocklek. Studien i denna rapport syftade till att ta reda på vad Caliper mäter, hur den mäter och om den går att lita på.

In Sweden the real estate sector accounts for 33 % of energy consumption and just below 10 % of the emission of carbon dioxide. As a consequence of the external pressure from climate change it?s in everybody?s interest to reduce the energy consumption and thus reduce the emission of carbon dioxide. An additional incentive to reduce the energy consumption is the substantial increase of the energy price since the deregulation of the electricity market in 1996.In this study the techniques that exist to build multi-storey residential buildings with high energy performance will be investigated. Further the study intends to investigate the optimal energy performance from a real estate economic perspective.In order to investigate the optimal energy performance a model has been created with the parameters investment cost, rental revenues, operation and maintenance cost, discount rate and investment horizon.The result shows a relationship between a high investment cost and a high energy performance for newly constructed multi-storey residential buildings.