Abstract This degree project examines how much carbon dioxide that emits during the construction phase of a road project. This is to make it possible to compare how the amount of carbon dioxide differentiates between traditional road construction and Swepave construction, which is PEAB?s alternative way to design roads. To make the comparison a calculation tool has been produced. To compare the amount of carbon dioxide emissions a reference project was needed.

This paper compares and discusses teachers´ nonverbal communication in the classroom. The purpose of the study is to find out what the teachers´ nonverbal communication looks like in the classroom and with that information increase teachers´ awareness of nonverbal communi-cation and its impact on the teaching. Ten teachers at the upper secondary school have been observed for twenty minutes when having a lecture. The result shows that the most common nonverbal expressions are hand and arm gestures used to enhance what is said by the teacher. The result also shows that the nonverbal communication is similar with all observed teachers.

During the spring of 2013 we developed a visual identity for Jönköping Bandy, a bandy association in Jönköping, which was founded in 1947.Jönköping Bandy?s main problem was the low interest for the association by the local people. The association also had problems with the economy, which made it hard for them to merchandise themselves.In Jönköping, there were a lot of sport associations, and therefore, it was difficult to find sponsors. One way to help the association, was to create a good visual identity for them. A visual identity that would reflect on the proper values of the association.The intention was: ?Through graphical design, we want to convey Jönköping Bandy to a larger amount of people, and get increased knowledge in graphical idiom.? and was torn apart into these three questions:What core values does Jönköping Bandy have, and how can we convey them through the visual identity?Which visual materials does Jönköping Bandy need?How do other teams in Allsvenskan Södra merchandise themselves through their websites?The work began with a study of relevant theoretical literature, with focus on graphical design.

There's no doubt today that mankind has contributed to the changing climate byher use of fossil fuels. This must change in the nearby future. The Europeanleaders are expressing concern that renewable energy sources are not beingused to their full potential. The 2001/77/EC Directive on Electricity Productionfrom Renewable Energy Sources was accepted in 2001 to encourage thedevelopment of energy production from renewable sources, which isconsidered a step towards the fulfillment of the goal of the Union, that 12% ofthe gross energy consumption should come from renewable energy sources bythe year 2010.The objective of this thesis is to illuminate the common legislation of the EUregarding renewable energy with regard to goal fulfillment, judicial quality,conflicts with other goals of the EU and other faults. The objective is reachedby a hermeneutic study in which interpretation of written text is the mainmethod.

Since the Chinese economy?s reform in 1980, it has been attracting enormous foreign investments. Many Swedish firms from different sectors such as technology, manufactory production, consumer, service industries and so on, had started their investments in China. China has become the first choice for global manufacturing due to the huge market, continuous economic growth, stable political situation, sound investment environment and the WTO membership. In addition, China's enormous potential in finance, service, infrastructure, telecommunications, wholesales and retail industries will also attract a great deal of foreign capital.

The purpose of this thesis has been to develop a tool for modelling and simulating the nuclear plant Ringhals 3. The model should be used to improve the knowledge on the dynamics of the plant. Ringhals 3 is being upgraded to produce more power and a tool for analyzing the new operating conditions is needed.The work in this thesis has consisted of improving and developing an existing model of Ringhals 3 made with the modelling tool Dymola. The model has been validated by comparing the results of a simulated house load transient with data from the actual plant. Validation shows good agreement with data from the real plant.

Syfte: Huvudsyftet med uppsatsen är att beskriva praktiken inom affiliate marketing ochbloggar inom livsstilssegmentet över en tvåmånaders period. Studien beskriver och framför defaktorer som krävs för att skapa och driva en blogg som attraherar läsare och annonsörer.Design och metod: Uppsatsen presenterar en statistisk analys av de huvudkategorier sombloggare i livsstilssegmentet nyttjar i sitt nätbaserade dagboksskrivande samt en diskursanalysav innehållet i dessa kategorier. Första steget i studien är att lokalisera bloggar som uppfyllerde kriterier som kännetecknar en livsstilsblogg. Det andra steget är att kategorisera inläggen ibloggarna. Det tredje steget är att genom diskurs analysera innehållet i inläggen som tillhör deolika kategorierna.Resultat: En utförlig studie av bloggar inom livsstilssegmentet som dessutom arbetar medaffiliate marketing visar på tendensen att dessa kommunicerar med sina läsare på ett sätt därde eftersträvar ett djupare och mer familiärt förhållande till sina läsare.

There is two dairy farms in Sweden with ability to be opened on both long sides, one outside Hjo and the other one, Brandstadholm, north of Sjöbo. When there is no measures and results or not enough literature about natural ventilation and especially on this kind of air inlet, makes my tests very interesting not only on Alnarp, but among other companies. I would like to find out if there is any air movements direct on the cows, how high/low temperature, air humidity, light intensity and noise standard inside the barn. Does Brandstadholm fulfil the rules and regulations when it comes to climate inside the barn? Could this system become the new dairy barn instead of the conventional barns in Sweden? I am going to focus on the animals environment, after all they are the one who is going to spend the most of the time in the barn. I used five electrical loggers distributed inside the barn to measure the temperature and one of the loggers measured the air humidity, every 15th minute. One logger were placed on the outside which measured both temperature and air humidity.

Flow measurement is one of the greatest challenges in order to calculate efficiency in hydropower. Most hydropower plants in Sweden use differential pressure methods for flow measurement. These methods are dependent on constant conditions in the waterways. A change in these conditions, like turbine improvements, prevents differential pressure methods to verify efficiency improvements. Since efficiency improvements can?t be verified by one measurement system, another method, which isn?t affected by changing conditions, can be used.

Normally the operational amplifier is used as a component in active filter design. The goal for future components in filter design is large bandwith and the use of low supply voltages. The use of current-mode instead of voltage-mode circuits gets a step closer to the required performance. A component that use current as the signal conveying part is the current conveyor. In this report a comparative study between two current conveyor structures of second generation (CCII) is performed.

The aim of this work is to take the first step into a development process, with the intention to find a way of making prehistoric soil fertility a variable in archaeological landscape analysis. A pilot study is performed on the Mälar basin area, where four topographical and geological factors are reclassified and then combined, resulting in a map which expresses a relative indication of agriculture potential. The map is then compared to the distribution of Migration Period graves and gold finds. This, however, does not mean that the technique is tied to a certain prehistoric period. Because the work is intrinsically experimental, the technique as a whole is finally discussed and evaluated, and suggestions of improvements and further studies are made..

I have critically examined heteronormativity as it permeates our society and questioned ?identities? as designed and constructed, leading to certain identities being seen as normal, while others are regarded as abnormal.I have had a discussion with my informants about love, monogamy, amicable and relationships. Every couple has basically isolated themselves after they became a couple and they feel secure with one another. The partnership is very important for my informants, partly because they see the partnership as a legal and economical security. However, these aspects are not crucial to the decision that they chose to marry, for the main reason is love and the desire to take the relationship one step further.

Emotron is a company specialised in developing, producing and marketing equipment to con-trol, monitor and protect processes and machinery driven by electric motors, with an applica-tion focus. Examples of uses for their products are fans, pumps, lifts and cranes.The project is to look at Emotrons end of line test. The company has seen that at the final test-ing there is a bottleneck that restricts the outflow and prevents an increase in the number of tested products.The purpose of this project is to review how Emotrons end-of-line test works today and if there is a possibility to make the test more efficient in such a way that the quality is not at risk, while increasing the outflow of tested products.The projects first step is to look at and analyse what is causing the bottleneck at the end-of-line. When the analysis is complete, the next step is to review whether there is a possibility to solve the bottleneck and if so in what way can this be done. Emotrons most overall objective of the project is to increase the outflow of the number of tested products without jeopardizing the quality.An analysis has been made on frequency inverters, soft starters and shaft power monitors.

Recent turmoil surrounding nuclear power as an energy source, especially since the accidentat Fukushima, has largely contributed to the debate of whether or not nuclear power should beused as an energy source. This study has examined the economic feasibility of replacingForsmark?s 3rd nuclear reactor with a bio fueled power plant, and find out how this could bedone.The power generation that has to be replaced is equal to 1170 MWe. To replace this, 6 largescaleCFB-boilers, each providing over 200 MWe, were necessary. In addition to this, eachboiler required their respective turbine sets, comprising one high-pressure-, and one lowpressureturbine with intermediate reheating capacities.Based on this, a rankine-cycle was modeled using the software EES, to be able to calculatethe total heat required in the power plant.

Issue of study: The development of technology and society is closely linked. Mutual dependency and complex interrelationships make straightforward analysis of issues regarding the future of technology and society hard to perform. Therefore, the study addresses the question of how organizations should describe and analyze the interactions of technology and society in order to gain a better understanding of what the future may bring. Purpose: ? To develop a method for analysis of the future course of issues regarding technology and society in interaction.? To apply and test the developed method through a case study, where it is used to analyze the future of the Russian fuel market.