På uppdrag av Saab har en grupp studenter på Linköpings tekniska högskola utvecklat ett skärmstativ för nya generationens JAS 39 Gripen E. Vid testflygning är stativet placerat vid planets stjärtkon och på stativet ska en skärm fästas. Skärmens funktion är att stabilisera flygplanet genom att ge det ett tippmoment vid okontrollerade spinnfall.Detta kandidatarbete hade till uppgift att designa och dimensionera ett stativ efter givna lastfall, begränsad volym, deformationskrav och givna infästningspunkter, samtidigt som fokus skulle ligga på viktreducering. För att möjliggöra detta togs en CAD-modell fram i Creo Parametric 2.0, som sedan exporterades till Ansys Workbench 14.0 där det utfördes beräkningar enligt finita elementmetoden. Under projektets gång testades olika material, tvärsnitt och konstruktioner, vilka utvärderades för att få fram en så lätt och hållbar konstruktion som möjligt.  Resultatet blev ett stativ med fackverksstruktur, som är gjord av fyrkantiga balkar med yttermått 70 mm och innermått 63,8 mm.

Sweden is the country that has got the largest amount of elderly in the adult population in the world. The physical activity level decreases as we grow old and we experience muscle mass loss and a bone density reduction. This leads to an increased risk for falls and subsequent fractures. The purpose of this study was to investigate whether an exercise program could affect muscle function and balance ability to prevent falls. 17 women (age 64-79) participated in this study and was assigned to a control group (n=7) and an intervention group (n=10).

This essay examines pull-out strength of threaded rods fixed into glulam timber. The technology is intended to be used in hidden joints between glulam components. The work began with a study of literature focusing on current research within the topic, mainly to create a base of knowledge before the testing was initiated. Studies of scientific articles reveals a lack of research within this area, which makes it difficult to develop standards and calculation models for these joints. The drill holes in the tests have a diameter of 7 mm.

This paper deals with the opportunities for the technique of condensation, for wood fired household heaters, on the Swedish market. In this project the condenser is preceded by a scrubber and both energy exchange and separation of unburnt particles have been studied. The facility studied is connected to a wood stove at 30 kW. The tests would show that the effect from the stove never reached above 16 kW. This might be a result of the low temperature of the water going into the stove, from the condenser. In addition to this the wood was not of highest quality and the stove could have needed some maintenance before the tests.

Abstract PurposeThis thesis aims to focus on how master students administer scholarly articles after they have found them. The purpose of the study is to detect how and to what extent people administer their articles from a personal information management-perspective (PIM).MethodTo answer the research questions, a web-based questionnaire survey was distributed which was announced to around 2,000 master students from different universities in Sweden. Most of the items in the survey focused on individual storage methods. The respondents were asked to rate the frequency of their different information administration behaviors on a seven level Likert-type-scale. Subsequently, items concerning specific information administration behaviors were posed, followed by questions on the respondent's sociodemographic status.

Introduction: This study aimed to investigate the validity and reliability of the 20m multistage shuttle run test (MST) for elite ice hockey players as a predictor of the maximal aerobic capacity and the how the result is affected by the players age, aerobic and anaerobic capacity, body composition and test surface. The purpose of this was to find out the potential of the 20-m shuttle run test as a measuringtool for the maximal aerobic capacity in frequent testing periods during the season. It is very interesting to be able to administer this easily because the competative phase of the season is very long compared to the pre-seasonal phase and earlier studies have shown that the aerobic capacity is being lowered during this competative phase of the season for elite icehockey players.Methods: 34 elite ice hockey players participated in this study (20.0±3.6 yrs, BMI 24.2±1.6 and VO2-max 58.0±4.8 ml O2?kg-1?min-1). During 3-5 days they underwent 2 MST tests (wood and rubber surface), treadmill running with VO2-max assessed with open-circuit technique, Wingate10% and FFM-assessment with underwater-technique.

Flow measurement is one of the greatest challenges in order to calculate efficiency in hydropower. Most hydropower plants in Sweden use differential pressure methods for flow measurement. These methods are dependent on constant conditions in the waterways. A change in these conditions, like turbine improvements, prevents differential pressure methods to verify efficiency improvements. Since efficiency improvements can?t be verified by one measurement system, another method, which isn?t affected by changing conditions, can be used.

Wireless communication is becoming more common, a relatively new technology within the area is Bluetooth Low Energy. It?s been developed to be energy efficient and in regard to compatibility. Alongside the growth of wireless technology, scientists and companies are looking for new areas of use. One of these is localization, which means to determine the position of a moving device with the use of stationary devices, an example of this would be GPS.This report means to evaluate indoor localization using Bluetooth Low Energy and was made for Combitech AB in Jönköping.

Pharmaceuticals that are found in marine ecosystems are a threatening environmental concern, which is known to harm both animal and plant life. One of the reasons for this problem is that the waste water treatment techniques are not optimized to clear waste water from its pharmaceuticals contain. In this master thesis four Swedish treatment wetlands were studied, and their ability to reduce numerous pharmaceuticals in waste water. The four treatment wetlands that were studied were those in Oxelösund, Trosa, Nynäshamn and Eskilstuna. Two ecotoxicological tests and chemical analysis were used.

The report aims to investigate how well a certain type of affordable embedded single board computer can hold up against today's more expensive computers in a computer system by doing various tests on a system with the specified requirements. The system has a Raspberry Pi as the single board computer which task is to control a camera based on coordinates obtained from a server as well as capture and stream a video signal on a network.The researches were conducted to check how much network traffic a single-chip computer sent in different video formats and how much CPU utilization was required. Studies were also made to ensure the accuracy of the camera control. The researches have been experimental, where several tests have been performed and analyzed.The results show that a sufficiently good accuracy can be obtained from the camera steering unit, in which two different servos have been investigated. When the video format MJPEG and H.264 are used, the single-chip computer is able to transmit a video signal up to 1280x720 at 15 fps.

When drivers overnight in the truck lots of electric energy is consumed by heaters, fans, lights and other extra equipment. If the engine is not running, this energy is taken from the lead/acid batteries of the truck which then needs to be recharged during operating hours. The fact that the charge acceptance of the lead/acid batteries is dependent on the temperature makes it hard to fully recharge the batteries at lower temperatures. A negative charge balance can lead to starting problems within a few days use in cold climate.In this thesis work, the effects of different battery charging concept are evaluated on the most common Scania battery (175Ah). A battery model is implemented in Matlab and some simulations of charging are made.

Since January 2005 new rules have been introduced from the International Financial Reporting Standards for accounting of Business Combinations. Goodwill, which is the difference between the purchase price and the value of the net assets in an acquired firm, should no longer be amortized but should instead be treated as an object for yearly impairment tests. Nevertheless, there are many companies making the tests but not impairing goodwill. The theoretical frame of reference looks at goodwill from its two parts; true goodwill and false goodwill. False goodwill is defined as a measurement bias and constitutes a certain percentage of the operating net assets.

The aim of this study is to provide a comprehensive overview of C?ronis beeswax varnish by Lefranc & Bourgeois; its contents, aging properties, solubility, and possible removal methods, with G?teborgs Konstmuseum?s ?Gothenburg Museum of Art? collection as the stud??s material? The purpose of the study is to provide a basis for decision-making regarding the treatment of works treated with C?ronis wax varnish. The study is based on contemporary conservation theory and interpretation-based decision-making and utilizes FTIR, microscopy, and solubility tests to examine the properties of the varnish. The study shows that C?ronis does not appear to be harmful to the treated works and has retained its solubility properties and transparency over time.

Osseointegrated titanium implants have become a commonly used method in edentulous jaws and today there are success rates in the magnitude of 82 % in the lower jaw and 98 % in the upper. During first year after implantation a fully normal marginal bone loss of 1-2 mm occurs. If the bone loss continues there is a risk of implant failure. High tensions in bone and inflammation caused by bacteria are possible reasons for this problem. It has been shown that a leakage of bacterias occurs between the parts of the implant and there are theories that this has effects on the marginal bone loss. The aim of this thesis has been to increase the knowledge about microbial leakage with help of in vitro tests and virtual simulations.

Vehicle simulators are becoming more common in vehicle industries. Company earns lot of money on simulations instead of real tests. Real tests are necessary but not made so extensively as before.In this thesis the building of an vehice simulator will be described and a comparison between three different cruise controls. The three cruise controls are PI-regulator, a regulator who regulates after positions in the terrain and a MPC-regulator. The reason for choosing this three is to see the difference between simple regulation and more complex regulation with respect to fuel consumption, travel time and complexity.The vehicle simulator is made in Matlab/Simulink, Visual Studio and Open Scene Graph.