Ocean Thermal Energy Conversion, OTEC, is a sustainable energy conversion technology that is not yet commercialized. OTEC is a technology that utilizes the temperature difference in oceans between the warm surface water and the cold water at 1 000 m depth to run a Rankine Cycle. This technology can produce electricity and provide synergies like fresh water, air conditioning and aquaculture. A simulation program for three alternative OTEC systems has been created in order to decide which OTEC system is most profitable; closed, open or hybrid system. In this simulation a production cost analysis is performed in order to investigate and decide which one of the three systems that has the lowest production cost. The production cost analysis also analyzes if the profitability is affected by the size of the facility. After these analyzes, the most profitable of the three different OTEC-systems is expanded by an installation of solar collectors in order to see if the thermal efficiency is improved. The result shows that the most profitable system varies with the size of the facility.

AbstractThis report intends through a case study to investigate if lightweight concrete isappropriate as main material in the outer wall of a seven storey residential building.A technical design is carried out in accordance with the definitions and requirementsfor passive houses, given by FEBY?s1 ?Demand specification for passive houses?.A literature review is also carried out for a comparison between regular bolt wall andlight weight concrete wall, with a focus on the safety of moisture.The lightweight concrete block used in the report is as a celblock produced by thecompany H+H Sweden AB.The methods used have resulted in compliance with requirements andrecommendations from authorities. Calculations of energy, noise and moisture riskassessment has been carried out.The work has resulted in the conclusion that the lightweight concrete itself is notable to isolate in the extent necessary to obtain chosen U-value of 0,1 W/m2 ° C,without getting to thick. Therefore additional insulation is needed. There are fewrelevant reference objects built with only light weight concrete.

Biogas is increasingly used for fuel in for example vehicles and it´s produced in a biogas processconsisting of the steps of pretreatment, digestion and gas cleaning. The pretreatment is a method usedto increase the gas production and / or destroy pathogens. The digestion is the stage when anaerobicmicroorganisms convert bio-mass of a substrate to a raw gas containing about 65% of methane. Thegas cleaning is used to increase the methane content to about 97% so the gas can be used for motors invehicles. The biogas part of the Ekeby sewage plant in Eskilstuna is using multiple substrates.

More efficient energy consumption is essential to secure a sustainable future, not least within the building and real estate sector which answers for approximately 40 % of the EU countries total energy consumption. One part of EU: s work to reduce the energy consumption is the directive on energy performance of buildings which among other things have lead to stricter demands on energy performance in new and renovated buildings.One of the difficulties with making buildings more energy effective is that it often demands big investments and although it results in lower operating costs the extent of these savings and therefore also the repayment time can be difficult to decide beforehand. To make it interesting for property owners and also tenants to invest in energy efficient buildings powerful incentives are needed. Favorable loans to energy efficiency projects are one example of governmental instruments that have been tested in other European countries with good results.Reduced operating costs appear to be the main incentive for property owners to make their buildings more energy efficient. The best result of an energy efficiency project is usually achieved by cooperation between property owners and tenants but in order to make that interesting it is important that both parts can profit from the savings.

In this Bachelor Thesis (20 p.), we present the history and development of "Intelligent Houses", and most important- explore some of the future possibilities in this area. The project has been carried out through an interdisciplinary cooperation between three different educations at the Blekinge Institute of Technology. By conducting a dialogue with various actors with different professions, we have been trying to identify needs within the concept of "Intelligent Houses", were the end user is not only the tenant or homeowner. Through Participatory Design methods, such as a Future Workshop, we have brought the users together to discuss their own and each others needs and hindrances in their respective work practice, and how intelligent house technology could improve their work conditions. We have also been testing a highly sophisticated CO/CO2/Moisture/Temperature/Enthalpy multi-sensor & controller, originally developed for regulating indoor climate systems.

Compressed air is an energy source that is widely used in today's trucks and buses.Compressor located next to the engine supplies the pneumatic system with the compressed air and is lubricated with the engine oil. Some of the oil follows the air flow in both liquid and solid phase. The solid phase, namely the carbon particles are created due to the high temperature in the compression chamber.Oil- and particles carryover softens and destroys the rubber material in the air valves and disturbs the mechanical function of various components in the pneumatic system. In order to reduce oil- and particles carryover is an Air Processing System (APS) set downstream the compressor.No method for establishment of oil- and particles carryover from the compressor exists at the moment. Therefore the filtration efficiency of APS is currently unknown.

In this report a new gear concept is evaluated using the magnetic finite element method (FEM)software MagNet and Ansys as well as the mechanical FEM software Abaqus. The gear conceptis evaluated in terms of maximum torque capability, torsional stiffness, gear ratio and efficiency.ABB Corporate Research has proposed a new gear concept which should be less expensive thangearboxes used today. The new concept is called aMagnetic Harmonic Traction Drive and usesthe principles of a harmonic drive gear to achieve a high reduction ratio. The gear conceptreplaces the wave generator used in traditional harmonic drives with magnets and uses tractioninstead of gear teeth to transfer the torque. The main components in the gearbox are the magnets,the flexspline, the magnetic portion and the circular spline.

Energy Director is a control and measuring system for energy consumption and is part of the product portfolio of E.ON AG for more efficient use of energy, offered to business customers. As of today, the system has only one parameter of control, namely power, and the objective of this essay has been to investigate whether other ones could be added. The emphasis is on the environmental perspective, which is why carbon dioxide has served as an example for this parameter in question.Parallel with the study of Energy Director electricity on the margin, calculations of carbon dioxide equivalents and also the Swedish trade of electricity have all been highlighted. Results indicate that when reductions in energy are made it is endorsed to omit from electricity on the margin rather than some mean distributed electricity, under certain conditions, and in addition the calculations of the reductions should be modified regarding the efficiency of the power stations fuelled by lignite and bituminous coal. Sweden practices trade with the Nordic countries as well as Poland and Germany.

The coproduct, dried distillers grains + solubles (DDGS) from ethanol production based on wheat contains much rumen degradable protein and fiber with low digestibility. To compliment this quality in an effective way a grass silage low in protein and much digestible fiber is needed. The aim of the study was to investigate the effects of adjusting the crude-protein concentration and fiber quality of the silage when feeding DDGS and of varying the inclusion level of DDGS, when feeding the adjusted grass silage, on intake, milk yield and composition, faecal traits and feed efficiency. Four different total mixed rations were compared. The normal grass-clover silage had a crude protein content of 17,8 % and an NDF content of 46,2 % of dry matter. The adapted grass silage had a crude protein content of 14,6 % and an NDF content of 52,9 % of dry matter. The diets were formulated to have similar nutritional content except for A + 4 which had a higher content of rumen degradable crude protein and a lower concentration of NDF.

This qualitative study involves the implementation of Lean and Kaizen methods in a Swedish service industry. Lean philosophy is based on a method to achieve more with less. In practical terms this means that the use of an organization's resources is improved. The origin of Lean is the Toyota Production System. Now, Kaizen methods give managers and employees a better more efficient system to reach their goals within the organization or company.

Background ? The last 20 years healthcare has been facing increased demands on efficiency and increased customer satisfaction. This despite reduced resources and increasing demand. These demands are presents in all departments within healthcare organisations, including medical laboratories that currently receive an ever-increasing number of remittances. Laboratory flows are quickly becoming overloaded with samples and related materials.

TitleEnergy-efficiency ? of slab blocks built in the sixtiesAuthorsRichard Sandahl and Kim SöderbergEducationHalmstad University, Section for economy and technique Construction Engineering 180 ECTSSupervisorMargaretha Borgström, Universitylector construction physics, Halmstad UniversityContact person at HFABUlf Johansson Heating, sanitation and energy co-ordinatorReportExamination paper at the construction engineering program is performed in cooperation with HFAB (Halmstad real estate concern Inc.)AimThis examinations work is done in cooperation with HFAB and there project on the block around the street Maratonvägen. HFAB:s dwelling stock on this area are going through a bigger renovation and in relation to this they are looking on the possibilities to make this building more energy efficient. That is why this examination paper has as purpose to answer the question if it is possible to make slab blocks built in the sixties more energy efficient. This is done by calculate energy efficient measures on a chosen apartment block at Maratonvägen in Halmstad, in an energy and expense perspective.MethodThe examination paper is based on different methods, mainly calculation but also qualitative conversation studies, economic calculations and literature studies.

Bachelor Thesis Music & Event Management School of Economics at Linneaus University of Kalmar, Economics, 2FE40E, Spring 2013 Author: Johan Hagelberg, Sofia Prins & Oskar Sjögren Supervisor: Petter Boye Examinator: Thomas Karlsson Titel: Det svåraste som finns är att tänka i nya banor - En studie kring personalhantering och effektivisering av arbetet på svenska musikfestivaler.Purpose: The purpose of this study is to investigate how different music festivals in Sweden can work to increase the efficiency by managing the workforce and internal knowledge.Method: The study was based on a qualitativ method with an abductive approach. The majority of the data comes from qualitativ interviews with persons in the industry.Conclusion: The music festivals in Sweden are acting under a constant economic pressure which leads to an experienced need for a larger workforce - mosty non-profit. The result of this study shows that the larger workforces are both unmotivated and decreases the effeciency of the work. The study aims to highlight the diffrenses between non-profit and commersial festivals and the way they work with human resource management and personal in different levels of the organization..

Mål - Att spara 1 GWh underhållsenergi på Karlshamsverket.Metod - Att lokalisera de största energisänkorna på kraftverket, göra mätningar eller uppskattningar på hur mycket energi dessa förbrukar, för att där efter ge förslag på tekniska åtgärder, med tillhörande ekonomiska beräkningar som ska reducera energiförbrukningen..

Sandvik Wire needed a review of the administrative part of the order fulfillment process and especially the work around packing and the inventory of finished goods. Therefore we acquired the assignment to investigate the administrative part of the order fulfillment process in the company with the purpose to identify potential for improvement. This investigation was performed with focus on the terminal and packing functions. The purpose with the investigation was also to identify critical factors for an efficient order fulfillment process and investigate if information quality is such a factor.Data was collected through interviews and observations on Sandvik Wire. With the help of this data the information and material flows was mapped, the work within terminal and packing, and adjacent functions was investigated.