Thesis completed by Johan Arvidsson, Alex Rasooli and Pontus Winroth, students at master program Product development and Design at the School of Engineering in Jönköping Sweden. The project comprises 30 ECTS credits and was carried out during the semester in the autumn of 2007.It was carried out in cooperation with Eksjöverken AB, subcontractor within the truck industry with special knowledge within the area of complicated machinery construction work. Job initiators at Eksjöverken were Mats Svanberg and Kjell Nygard. Dag Holmgren was acting as a tutor from the university. The task was to develop tools for trucks, primary toolboxes but in case of time also under run protection.

Mulitresistent staphylococcus aureus (MRSA) is a bacteria that is resistent against penicillin, this makes it difficulte to treat. MRSA causes woundinfections and other seriouse conditions. If MRSA establishes in an hospital environment it often spreads fast. Common ways of spreading MRSA is through direct or indirect contact. The nurse should work according to guidelines, apply hygienic routines and prevent the spread of infections.

This essay examines possible maternal deaths in paleodemographic analyses and grave material by comparing three cemeteries: Nya L?d?se, Helgeandsholmen and V?sterhus. By comparing mortality patterns and burial practices, the aim is to investigate possible signs of obstetric care during medieval and early modern Sweden. The results show a higher death rate for adult women in all three burial places, indicating possible maternal deaths. Fetuses and small children were found in all cemeteries and potential evidence of medical knowledge were found in Nya L?d?se.

A substation must be properly protected against lightning and other external effects to the equipment in the station or staff, for that we use relay protection. They should also protect against internal errors which may occur as ground faults. There are different types of protection relays, but most common are overcurrent-, distance-, residual current- and differential protection.The purpose of this thesis was to deepen our knowledge of relay protection and to use the theoretical knowledge we got from the university studies in the work process. In the process we discovered which parameters were the most essential and calculated these for all relay protections on the substation. We also carry out a comparison between two brands of relay protection, ABB and Alstom.During our work we will test and simulate the over-current relays in a program called NEPLAN, the program will also calculate the fault currents.

Vårt sätt att kommunicera med varandra är i hög grad situationsberoende. Ett tillfälle när samtalets form kan ha stor betydelse är i kontakten mellan läkare och patient och då speciellt när läkaren behöver förmedla tråkiga nyheter till patienten. I denna studie undersöktes faktorer som påverkar hur läkaren upplever sin förmåga att genomföra samtal med ?bad news? för patienten. Nio läkare på två sjukhus i Mellansverige intervjuades.

The purpose of this project was to further develop and complete a quadcopter that had been built in an earlier course at KTH, so that it could be used for demonstration and education at the school. The quadcopter was at the beginning of the project completed when it came to hardware, and there was some software functionality implemented but no system for automatic stabilization. The main goal of the project was to implement such a system, and to combine it with the previous functionality to make the quadcopter operable and able to fly. To create a functioning and stable ground multiple basic software features has been implemented, and on top of that additional software to improve the safety, stability and functionality. The most important part is the control system that is responsible for converting sensor and control signals to suitable motor values.

Abstract Title: A conjoint analysis of packaging attributes. How can the attributes of a product?s packaging best look like to attract the consumer? Authors: Linda Granberg & Helena Niklasson Supervisor: Jan Svanberg Department: School of Management, Blekinge Institute of Technology Course: Bachelor?s thesis in Business Administration, 15 credits Purpose: The purpose is to find out how visual and technical attributes on product packaging affects the consumers tendency to want to buy the product. Method: Conjoint analysis and a quantitative survey. Results: When developing a package for a food product we?ve reached the conclusion that it is most important to have clear product information on it.

This thesis describes the development ofa linear guidance system suited for NORCAN's aluminium profiles. The work took place at LP Innovation, a small technical consulting company, located in Uppsala. The work started with gathering and searching for information. A lot of the information was found in product catalogs, but my supervisor was also a great source of knowledge, as well as the other engineers at the company. I also had the opportunity to work with the rea lprofiles, to get a feeling and greater understanding how they were supposed to be used. With the use of sketching and CAD, a number of concepts were generated.

This report examines the industrialization of a newly developed household machine on behalf of Technogarden Engineering Resources in Karlstad, Sweden. The report is a part of the final course in the Bachelor Program in Mechanical Engineering at Karlstad University and takes place in spring 2014.An innovator, an investor and a engineering consultant firm have through collaboration developed a new type of gruel machine. The product is in its final stage of construction and is planned to be manufactured in a production located in Sweden, autumn of 2014.To compete against today?s trend in outsourcing manufacturing to low cost countries for better profitability, the industrialization of the gruel machine must be done with a minimum amount of resources in order to become successful, which also describes the problem of this study. Using pre-study material in form of Lean production literature, visiting a successful production site and gathering data from involved engineers a specification was developed which describes what this industrialization must achieve and which requests can be accomplished.

Sammanfattning/Abstract Bengtsson, Jenny (2008) Vårdlärares syn på betygskriterier i Medicinsk grundkurs. (Teatcher´s ideas about graderequiement in Medical basic course.) Examensarbete. Lärarutbildningen 90hp. Malmö Högskola. Syftet är att undersöka hur vårdlärare på komvux och gymnasiets omvårdnadsprogram ser på betygskriterierna i Medicinsk grundkurs. Det gjordes sex djupintervjuer av vårdlärare verksamma inom omvårdnadsprogrammet. Resultatet visar att lärare, både inom Komvux samt gymnasieskolans omvårdnadsprogram, som undervisar i medicinsk grundkurs tolkar betygskriterierna på skilda sätt.

AbstractProblem-based learning (PBL) was from the beginning developed in medical school, but is today used in education in other programmes as well. Investigations about PBL have been conducted in different disciplines and there is also metastudies. In this paper, a metastudy of 8 bachelor degree papers have been conducted. The questions answered were: which methods were used to investigate PBL in primary, lower secondary and upper secondary school,which advantages were found in working according to the PBL method, which disadvantages were found in working according to the PBL method and did teachers and students views about advantages and disadvantages about PBL as a method differ and if they did, how? The results showed that mostly qualitative methods were used to investigate the PBL as a method, mostly abilities of social qualities and independence were trained in working according to PBL, a disadvantage was that working according to the PBL method was considered more resourse consuming than traditional teaching methods and teachers and students views about PBL did not differ considerably.

The purpose of this master thesis was to study the librarians?assignment at the public accesses computers, especially howthe librarians perceive what their task is and what their taskshould be.In order to answer these questions a series of ten qualitativeinterviews ?inspired by the phenomenographic approach ?was conducted with librarians who were employed at smallpublic libraries in municipalities with 5 000 - 25 000residents in Sweden.The conclusions in the master thesis were that librarianshave both similarities and differences in how they perceivetheir tasks at the public computers. The most essential taskwas helping the user with information seeking. Thelibrarians also perceived that it should be included in theirduties to help users with the technical/practical issues at thepublic computers. Competence, time and assets were finallythree outlying factors which affected in what extent thelibrarians were able to help the users..

This Degree Project is carried through in association with Fototext in Guthenburg. The firmsees benefits using?Soft Proof? technology for both economic and time-saving. The reasonfor ?Soft Proofing? for internal/ external production is to estimate and controll documentswithout using digital or chemical printing output.The different technical solutions to ?Soft Proof?, knowledges and facts aboutColorManagement together with PDF-workflow is going to pattern for a correct succesfull?Soft Proofing? on the monitor.Acrobat 5 in association with Photoshop 6 are effectively used in ?Soft Proofing? technic.The advance and capacity of the graphical softwares which are explained in this reporthelps the users to begin to experiment with ?Soft Proof?.

This paper describes the Swedish reconnaissance squads in the engineer battalions, their equipment, tasks and organization. An analysis is made to compare the present weapons and fire power of the reconnaissance squad with an extended weapon alternative. The analysis focuses on the abilities effect, protection and movement in different situations typical of a reconnaissance squad.The facts that are presented in this paper are mostly founded on the new field manual FältarbR Dyktjänst 2007, which regulates much of the reconnaissance activities. The aim of this paper is the making of a contribution in the developing progress of the new field manual and the reconnaissance squads in Swedish engineer battalions.The result of the analysis shows that the extended weapon alternative would be an asset..

This report is a thesis work for a B.Sc. in Forestry exam at the School for Forest Engineers, SLU. The work was an assignment from Södra Skogsägarna and the aim of the work was to investigate the economical and biological output after mechanical planting with Eco-Planter compared with traditional manual planting. Eco-Planter is a tool for mechanized planting, fixed at the end of the boom on a conventional harvester. The study confirms that manual planting is less expensive under normal conditions. However, the differences between mechanized and manual planting are not that big and with technical development and/or increased labor costs together with an improved work organization the system with Eco-Planter could be competitive. The biological output, e.g. planting result and survival rate, seems to be quite good.