The aim of this study is to examine whether the two factors SMB and HML in the Fama-French Three Factor Model proxy for default risk. The study is based on companies noted on the Stockholm Stock Exchange between 2003 and 2008. These companies are used to create the factors SMB and HML, as well as a default risk factor we call RMS. In a first set of regressions, we examine the explanatory power of the original Fama-French model on a set of portfolios consisting of Swedish companies of different size and book-to-market ratio. The default risk factor RMS is then added to the original Fama-French model.

This master thesis was a continuation of a previous study in the diesel exhaust characterization, which is part of the academical work embedded in the EMIR-1 project. The main objective of this thesis work was to finish the installation and make the proper modifications of the particulate mass measuring system located in one of the engine test cells at KTH, in order to be able to measure the mass of the particles from the exhaust of diesel engines.This experiment requires a diluted flow sample from the exhaust that should be sent to the device that makes possible the measurement of particle mass, called TEOM. In the first stage of this project, the objective was to study and make the proper modifications in the existing KTH diluter because there were several problems to obtain a constant dilution ratio from it during tests.This modifications were made and it resulted in a great improvement in the maximum inlet and outlet flow that this diluter can handle. Therefore another modification is proposed for controlling the inlet exhaust flow so it will be possible to regulate the dilution ratio and make it constant along a wide range of engine loads and speeds.The second and most important stage was to make particulate mass measurements possible by analyzing the frequency signal from the TEOM device. The idea was to obtain the frequency of oscillation from the tapered element in the TEOM, and therefore with the proper correlations, be able to predict the particulate mass concentration in the exhaust flow from the engine.An electrical problem in the TEOM circuit was detected and corrected, so the signal that carries the frequency from the TEOM can be analyzed properly.

The control of indoor temperature must be able to handle large time constants and both measureable disturbances like outdoor temperature, and non-measurable disturbances, like waste heat from appliances. Due to cheaper microcontrollers (small computers with designated tasks) with better performance, more advanced and computation-demanding methods for control can be used.In this thesis, Generalized Predictive Control (GPC) has been implemented and tested on a theoretically derived model of a house. GPC states that a model of the system is estimated in every sample, and the control is carried out simultaneously, based on predictions of the model. Disturbances like solar radiation can be estimated and used in the control as well. The control signals are determined by quadratic programming, which makes it possible to consider conditions, for example limitations on the control signals.GPC requires a number of parameters to be defined, like model order and control signal penalty, but is relatively robust for variations in them.

Bankruptcy is a problem for the society in form of high costs for including suppliers, customers, employees, investors, banks, insurance companies etc. The purpose of this study is to confirm or dismiss a bankruptcy prediction model that has been developed in a previous Swedish study, in order to predict bankruptcy with help of specific key figures. The model has only been tested in a larger perspective where the population consisted of all small firms in Sweden, in this study the model´s reliability is tested by that it instead been applied to a minor perspective, where the population only includes Stockholm. With a quantitative approach of 12 different key figures from a total of 60 Swedish smaller registered companies in Stockholm between the years 2005-2007, has been studied. The companies are divided into two groups, companies with good financial health and companies that have ended up in bankruptcy.The results shows that the model is applicable in a smaller population, but some of the key figures do not generate essential or any type of information about bankruptcy, but the majority of the key figures in the model did.

A frequently asked question in real estate marketing is at what time of the year it is optimal to invest or sell. The aim of the project was to answer this question and to generate a prediction model over real estate located in the centre of Stockholm that takes seasons into account. With acquired sales statistics in Stockholm between 2010 and 2013 it was possible to perform a linear least square regression, also known as Ordinary Least Square (OLS), with describing qualities and season of sale as parameters. Statistical problems such as Multicollinearity and Heteroskedasticity have been taken into account when deriving the model. The result was a highly accurate prediction model indicating the profitability of investing in real estate during the summer and selling during the autumn..

Nowadays the majority of the thinnings made in Swedish forests are done by machines, harvesters and forwarders. The most common model in thinning with a harvester is strip-road operated thinning and stand-operated thinning with one intermediate passage between the strip-roads. This study is a time study with some quality follow ups on a strip-road operated thinning model, a stand-operated thinning model with one intermediate passage between the strip-roads and a stand-operated thinning model with two intermediate passages between the strip-roads. The machines in the study were a small harvester (Forestline MPM C90) and a medium sized forwarder (Timberjack 1110). The study was made in Litsnäset outside the city of Östersund in Sweden and was made during the autumn 2007. In a lodgepole pine stand six study units (0,6 ha) were thinned with the three different models, two study units per model.

Internal working models of attachment are claimed to be unconscious structures operating outside the conscious awareness. Existing measures of attachment are almost exclusively explicit, either self-reports or interviews and it is questionable whether these instruments are able to tap into unconscious attachment attitudes. The main purpose of the present study is to develop Implicit Association Test (IAT) tools for assessing adult attachment and to examine their construct validity. Two sets of implicit attachment measures, based on the two-dimensional attachment model (Bartholomew & Horowitz, 1991), were developed. Convergent validity was assessed by examining (1) the relationship between implicit model of self and implicit self-esteem and (2) the relationship between the implicit model of other and implicit sociability.

Together with NCC and Sweco we measured the air-flow on a semi-detached house in Jönköping. When a pressure measurement is made, the house gets exposed to over- and under pressure. This is done in order to examine the houses climate shell. The climate shell of the semi-detached house we tested exceeded the required air thickness in BBR-2002, hence, measures have to be taken.This report also displays the importance of building air thick houses and what consequences a non air-thick house can have for the ones residing the house. A discussion of different measures is on for the addressed problems with the flow-measurement and the alternative construction-solutions.Furthermore we have described in this report of how to account for the performance of the air pressure, what kind of equipment we used and how we came up with the results.

In this final thesis two simulation models have been integrated. The simulation models are models of JAS 39 Gripen?s fuel system, software and hardware. The time consuming and costly work to develop software has made the department of fuel system to build two models in Xmath/Systembuild. The software model also simplifies the comprehension of how the software in the control computer of the fuel system works.

 This study was conducted in autumn 2008 on the Company AB, which is currently in a growth phase. The company manufactures hydraulic systems for the heavy vehicle industry and has annual sales of approximately 250 MSEK with 165 employees.The rapid growth and unchanged planning is the starting point for this report. It all began in 2005 when the company received an unusually large order. During this period, the first priority was to satisfy customers and all other focus was disregarded. This has primarily resulted in a messy production and long throughput times.

This report brings up the question - ?Is BIM profitable when planning a single-family home??.The methodology for finding the answer to this question is firstly to state the definitions of BIMand the company that is projecting by using the BIM-model. The answer is then obtained byanalyses of the factors of profitability with respect to: time, opportunity of revision, problemvisualization, preference adjustments and energy. A BIM-model has been made simultaneously asthe writing has proceeded to get a perception of how a BIM-model really matters for the analysis.The analysis shows that the answer for the question depends on further factors. The factors thatare mostly discussed are the company?s intentions and the complexity of the house.

The background to this report is the author?s ambition to understand individuals? work situation, how it?s formed in interaction between the individual and factors in the work-setting. Such an ambition is well in line with the concept of Human-Technology-Organization (HTO), a cross-scientific approach that puts a system-oriented perspective on how human, technolog-ical and organizational factors interact within work systems.The aim of this report was to explore managers? work-situation and generate an understanding of it from an HTO-perspective by using an organizational model as a framework for an interview guide and to analyze the work situation from an HTO-perspective following the ques-tions at issue:1. How does the managers experience their work situation?2.

Handling product returns has become a critical activity for organizations as the volume of gods flowing back through the supply chain rapidly increases. Few research studies have published specific empirical data concerning the reverse logistics practices of companies. Information technology and information support has long been recognized as a competitive weapon ? capable of enhancing company performance and achieving efficient reverse logistics. Reverse logistics is very unlike the forward, as it is more reactive and also has less visibility.

In this thesis, a transparent model of the human head has been constructed which was filled with a substance that represented the brain. This model was later crash tested. This was done in order to examine how a transparent model of the human head can be constructed to generate accurate data from crash tests. It was also done in order to examine how impacts on the front of the head can deform the rear of the brain. When a head is decelerating, the brain moves forward inside the skull and may hit the front of the skull.

Syftet med studien var att ta reda på hur gymnasieungdomar upplever utomhuspedagogiska moment i undervisningen. Det är en kvalitativ undersökning gjord vid Bernadottegymnasiet i Stockholm. Studien baseras på deltagande observationer under drygt två fältdygn och på semi-strukturerade intervjufrågor med tolv elever, i tre fokusgrupper. Resultatet visar att elever upplever utomhuspedagogiska undervisningsmoment positivt.