As a small and land scarce country, effective waste management is ofoutmost importance in Singapore. In this study the production of biogasthrough anaerobic digestion from the organic fraction of municipal solidwaste (OFMSW) was compared to incineration of the waste. At the momentalmost all of the OFMSW in Singapore is incinerated. Three differentscenarios were compared to the reference scenario (incineration): one with alarge scale biogas plant that can treat half of all OFMSW in Singapore, onewith a medium scale biogas plant about 15 times smaller than the large oneand one with a small scale biogas plant that can treat waste from e.g. ashopping center or a food center.By using life cycle assessment (LCA) the different scenarios were comparedin terms of global warming potential (GWP), acidification, eutrophication,energy use and land use.

As demand for renewable energy is increasing rapidly, the market for biomass pellets is expected to continue to grow in the near future. Most of the new raw materials that are discussed for pellet production have one thing in common; the production costs will increase compared to using traditional raw materials such as sawdust and planer shavings. The aim of this thesis is to investigate to what degree increased use of new raw materials for pellet production will affect the general pellet prices in Sweden and to survey what plans Swedish pellet producers have concerning new raw materials. To investigate the raw material situation of the Swedish pellet producers an industry survey was performed. Literature studies were also made on previous research in the subject field. Calculations of the production costs for pellets were done for the raw materials sawdust, wet sawmill chips and energy wood respectively. New raw materials are already used by the large-scale pellet producers in Sweden.

Syftet med studien var att undersöka skillnader i stress, återhämtning samt coping hos individer som genomfört tävlingsinriktad diet jämfört med de som dietat av icke-tävlingsmässiga skäl. 86 individer (64 män och 21 kvinnor) deltog där medelåldern var 25. Metoden i studien var kvantitativ och bestod av ett tredelat formulär innehållandes de svensköversatta instrumenten Recovery-Stress Questionnaire for Athletes (RESTQ-Sport) (Kellmann & Kallus, 2001) och Brief COPE (Muhonen & Torkelson, 2005), samt ett egenkomponerat formulär där informanterna fick kategorisera sig som en av tre diettyper: I) Bodybuilding (BB, n=26), Annat tävlingssammanhang (AT, n=32) samt Icke-tävlingssammanhang (IT, n=28). Resultatet visade en statistisk skillnad i stress mellan de olika diettyperna, där BB upplevde mer stress jämfört med IT, samt att BB upplevde mer av stressdelskalan utmattning än IT. De implikationer som framhävts har riktat sig mot att sprida en bättre förståelse för återhämtning hos dietister inom allmänvård likväl som dietcoacher inom bodybuilding..

Under 2011 började MacBat AB ta fram ett elenergilager kallat Macbat Energy Storage System (MESS), vilket är uppbyggt av 360 stycken tvåvolts bly-syrabatterier inhysta i ett 20 fots container. Då bly-syrabatterier är känsliga för värme är den här studien inriktad på att utreda hur stort kylbehovet blir under olika förutsättningar där kyldistribution, drifttemperatur på batterierna, klimat, isolering och termiska tröghet är varierande parameterar. Det ska även avgöras vilken konfiguration av kyldistribution och isolering som ger lägst kylbehov för de studerade klimaten, vilka är av varmtempererad, arid och tropisk karaktär.För att besvara studiens två mål togs fyra matematiska modeller fram i SIMULINK. Två luftkylda och två vattenkylda där en av varje var isolerad med 100 mm mineralull medan den andra var oisolerad. För samtliga modeller varierades drifttemperaturen mellan 25 ? 35 °C och de studerade klimaten utgjordes av Phnom Phen, Kambodja, Djibouti, Djibouti, Bagdad, Irak samt London, England.

Disinfection methods for drinking-water produced at the two water works of Stockholm Water Co are compared in this study. Three different nethods are compared; disinfection with chlorine gas, disinfection with sodium hypochlorite and disinfection with UV-light and monochloramine. The method used is Life cycle assessment, LCA. LCA is defined as the compilation and evaluation of the inputs, outputs and potential environmental impact of a product system shroughout its life cycle. The environmental burden is compared for the three different disinfection methods.

The background for my thesis is the fact that with rising electricity and oil prices it becomes interesting to calculate on alternative heating systems. I have chosen to calculate upon my parents? farm, which today heats the dwelling house with wood. This is very time-consuming work, time which could be spent on other work. The main objective for this study is to compare three different heating systems to decide how they differ considering effort and cost. The result from the calculations was that grain-heating system demanded the least amount of work, but the total cost was a little higher compared to chips heating. Chips heating required half as much work as today?s wood heating and had a little lower total costs compared with the corn heating. Which system to choose largely depends on how the own work is valued.

It?s a fact that the climate is affected by the vehicle that runs on the worlds roads. But theconstruction of the road itself is rarely thought of as a climate threat. Svevia and the Swedish roadadministration have opposite views of how the construction of roads should be carried thru. It?sthe difference between those two construction methods that is the base in our thesis.The amount of energy use or the emissions are not analyzed for neither the Swedish roadadministrations nor Svevias construction models.

The climate changes that are occuring in the world have resulted in that the EU callingfor a 20 % reduction in energy consumption to the year 2020, to reach that goal theEU want the public sector to go forth as a good example. Västfastigheter owns andmanage the hospital buildings in the Västra Götaland region. To be able to reducetheir energy usage Västfastigheter has hired several consulting firms to chart out theenergy consumption on each hospital building. The biggest energy savings potentialhave been calculated and what the cost will be to perform each action. The energyaudit have been completed and stand as the decision basis for Västfastigheter?s choiceon which action packages that should be implemented.

Electronic article surveillance (EAS) is widely used in shops and libraries together with an RF-tag attached to the goods or books in order to prevent shoplifting. By implementing the addition of a moisture sensor to the RF-tag, other functions become possible, including the ability to use as an alarm with regards to frozen goods, which have been shipped but which have melted and have, subsequently, refrozen. In- relation to care for the elderly, one time-consuming step involves checking whether there is the necessity for a change of diaper and this can, instead, be based on an RF-tag with an EAS-system alarm. A preliminary investigation was made using the moisture sensors, which involved how the resistance changes when liquid and/or heat is applied. A simulation of the LCCR circuit (RF-tag with the sensor) was conducted in order to determine how the resonance frequency changes for different resistances levels.

The design of the building envelope affects the energy consumption of a building. As the energy requirements for new buildings are becoming more demanding, the performance of the building envelope must be improved. Energy efficiency and durability are important attributes to consider.This report includes investigations of the building envelope, moisture and passive solar energy. It is based on the analysis of two different buildings with different designs. These buildings stand as reference for two of the companies who are working on a new, climate smart, residential area in Uppsala, Sweden.Studies and analyses on energy consumption and moisture transportation were made.

The aim of our thesis was to describe how the connection between co-dependent relatives and the alcohol-dependent influences the family into changes in their teamwork.Our purpose was also to answer the following questions: How is it living with an alcoholic? Are there any differences in how men and women feel and behave in their relationship with an alcoholic? Are factors like cultural belonging, genre or social class important for how the co-dependent relatives feels and behaves and handle their co-dependency?To answer these questions we made twelve thematic qualitative interviews with six adult children to alcoholics and six people married to alcoholics. We compared the results of these interviews with earlier research. We also applied System Theory and Goffman's Role Theory, as well as Bourdieu´s Capital and Habitus concept.We believe that co-dependency is a family divergence that is very similar to family disease, but that a change in attitude can trigger recovery. According to the interviews many spouses stand by their alcoholic husbands and do actions that perpetuate the alcoholic dependence and thereby hold back any recovery.

This is a report written for an examination project C-level, on the subject of energy. The examination project is a product of the FVB Sweden AB (district heating bureau). It started with a meeting with Stefan Jonsson FVB Sweden AB, were he explained the content of the project, and from this a presentation of the problem was made. The problem that needed to be solved was how they could control the valves in the system to provide heating to everyone in the system. The valves are often oversized so the pump in the heating plant would have to be enormous to be able to provide enough flow to be sufficient, if everyone in the system had there valves fully opened. I came up with two solutions to the problem, one was a wireless network that could keep track of the valves and the other solution was an extra sensor that was placed on the radiator.

This thesis tries to clarify why more houses such as passive houses is not built and at the same time the differences is described with the conventional construction as a starting point. Sweden has set environmental objectives to reduce energy consumption in buildings by 50 percent by the year 2050 compared to 1995. The passivehouse concept could have a significant role, particularly in the reconstruction of buildings with high energy consumption. For sustainable building the passivehouse technology is an economically viable concept while benefiting the environment. Initially an introduction is given of the background to the problem, purpose and objective of the thesis.

The district heating load is seasonally dependent, with a low load during periods of high ambient temperature. Thermal energy storage (TES) has the potential to shift heating loads from winter to summer, thus reducing cost and environmental impact of District Heat production. In this study, a concept of high temperature borehole thermal energy storage (HT-BTES) together with a pellet heating plant for temperature boost, is presented and evaluated by its technical limitations, its ability to supply heat, its function within the district heating system, as well as its environmental impact and economic viability in Gothenburg, Sweden, a city with access to high quantities of waste heat.The concept has proven potentially environmentally friendly and potentially profitable if its design is balanced to achieve a good enough supply temperature from the HT-BTES. The size of the heat storage, the distance between boreholes and low borehole thermal resistance are key parameters to achieve high temperature. Profitability increases if a location with lower temperature demand, as well as risk of future shortage of supply, can be met.

When implementing syncronous filters with global clock nets, a substantial amount of energy is consumed in the clock net. Hence, it is interesting to reduce the size of the clock net, which in turn will reduce the total energy consumption. One way to acheive this, is to create a SIC (Structured Interfacing of Computational elements) since such a structure can be created without a global clock net. Our results show that a fifth order wavedigital filter with a sample rate of at least 10M samples/sec may be achieved.