Benthic diatoms are used in Sweden for monitoring water quality in run-ning water; the method is also frequently used in other countries in Europe. One of the problems of the diatom method is the need for sedimentation of the fresh sample, to be able to decant the over standing water and add alco-hol as a preservations solution. To my knowledge, no results have been published about how long the settling time must be to ensure that the ben-thic diatoms really have settled down to avoid a loss of the diatoms when decanting the over standing water. The aim of my investigation was to improve the Swedish method where the benthic diatoms are used for water quality monitoring. I wanted to find out the appropriate time necessary to wait until all diatoms have settled down before decanting the over standing water. First, fresh benthic diatom samples were taken in the river Fyrisån and the lake Mälaren on different days. After arriving in the laboratory, I waited three different times (30 min, 60 and 180 min) for the diatoms to settle.

According to the Employment Protection Act, the permanent employment is the main condition of employment in Sweden. Nevertheless, nowadays a large number of employers choose to apply other conditions of employment than the permanent employment in their businesses. The rapid technical development and the demands for shorter perspective investment in companies on the Swedish labour market have started the requirement for a more flexible workforce. On-call employment is one of the conditions of employment that is increasing the most. This condition of employment is adjusted by the parties on the labour market.

The purpose of this report is to investigate and compare the difference between stand-thinning machines and strip-road thinning machines, and how they affect the stand on behalf of future growth, theoretical economic result, wind impact, snow pressure and density of stand. The investigation is regarding the first commercial thinning of pine stands, after pre-commercial thinning that was well conducted. The investigation area was located near Katrineholm, Sweden. The measurements that were measured were strength of thinning and amounts of wind throws, snow-breaks and hauling damages. The results that emerged, was that thinning with strip-road machines had a significantly higher strength of thinning over all, as compared with the stand- thinning machines (45 percent versus 30 percent). Comparisons between wind-throws, snow-breaks and hauling damages of the stand could not establish any significant differences between the two methods that were investigated. Conclusions, over all, were that if forest owners want to have more timber volume left for second thinning and final cut of the stand, the forest owners should choose the method with stand-thinning machines. From the point of view of gentle treatment of the stand and ground damages the choice should be the same. However, the method with strip-road thinning machines is the most common and accessible method in Sweden. Most likely it is the most economical way to manage the stand for forest owners in present time. If the method with stand-thinning machines is becoming more common in Sweden, it is suggested for forest owners to consider the stand-thinning method as a candidate for treatment due to economic aspects..

This is a final thesis done at BT, considering one of their forklift truck models called Reflex. The first part of this report is about a preliminary investigation investigating what kind of diagnostic systems BTwants to use, and also which demands there are to meet all expectations on such system. Secondly a diagnostic system, which will show if the drive wheel is worn out, will be presented. In the preliminary investigation, two kinds of diagnostic systems were mentioned. These were Model based diagnosis and Predictive analysis.

The purpose of this thesis is to investigate the function of the museum library. The methodused consisted partly of literary studies, and partly of field investigations, conducted mainlyin the form of interviews.Two different sets of field studies have been conducted. The first one is an investigation ofthe museum libraries in Goteborg. After a preliminary study, three of these have been selectedfor further investigation. These are the libraries of Göteborgs Konstmuseum, GöteborgsStadsmuseum and Röhsska museet.

This bachelor thesis is an exploratory investigation about the phenomenon 'Gamification', which by some definitions is about implementing game elements into non-game contexts. For example exercise services as Runkeeper and Nike Plus who both are available on android and iOS platforms. This study is mainly about the potential value of gamified systems and services for companies and its users and how such a system or service is developed. The thesis also discusses the development aspect of gamified systems in order to give the reader a more ?in depth? understanding about the phenomenon.

Our increasingly globalized world has contributed to that more Swedish companies has expanded their business to more distant areas. One of these Swedish companies that now stands before their first international expansion is the Swedish fast-food chain Max AB. Max has chosen to start their expansion in Saudi Arabia, a country far away from Sweden, not only in terms of geographical distance but also in cultural. The cultural differences that Max will encounter may affect the business and result in to various adaptations that must be done in order to establish successfully. The thesis investigates the existing circumstances for the fastfood business in Saudi Arabia and shows which adaptations international fast-food chains should or must do as a result of the cultural distances they encounter.

What is the?self? and to become ?one-self?? To resolve this questions possibility I´ve been using the philosopher Søren Kierkegaard metaphysic paradoxes. This essay about the ?self? shows the reader the difference between describing a transcendent and immanent phenomenon and if it´s possible to become or to not become ourselves. The process is a key of the ?self? which Kierkegaard explains the ?self? in and for it-self.

This essay was written in order to elucidate how the priests-to-be and working priests experience the preparation for preaching during their training and if their identity as preachers depends on their preaching; how they refer to rhetoric and what the preparation training looks like.There is no Swedish research within this field, and even the existing international studies concentrate mostly on writing preparation within other occupations, e.g. economics, health care and public sectors. These studies also show that there are several discrepancies between the university preparation for professional writing and speaking and the professional discourse.In order to carry out the investigation the author has interviewed priests-to-be and working priests and examined the syllabi for homiletics and rhetoric. The result of this analysis offers a better insight into the nature of the training in preparing sermons that Swedish priests obtain during their professional education. The author refers to the results of other scientific investigations concerning preparation for professional writing and speaking and concludes that there are similar difficulties within the priest training, e.g.

Background: Employees acting towards company goals and having a strong desire to remain in the organisation are very important for the success of a company. In order to generate such organisational commitment of the employees, the knowledge about what motivates and satisfies them is essential. Purpose: The purpose of this thesis is to investigate and analyse the factors which motivate employees, under consideration of individual characteristics. Limitation: Age, gender, marital status, work area, position and the years a person has been working in the company represent the individual characteristics examined in this study. Realisation: Literature research as well as a practical survey consisting of mail questionnaires and personal interviews were carried out in order to best serve the purpose of this thesis.

This master thesis has been carried out on behalf of Stoneridge Electronics AB and is an investigation ofhow intelligent switches can replace the traditionally used direct controlled switches. The concept ofintelligent switches is that the switches contain electronic identification components which, by connectingthem to a network, give the same function independent of the location of the switch. This infers anincreased flexibility and configurability which can be a great advantage in development, production andcustomization in the commercial vehicle industry. Especially in the current situation when commercialvehicle manufacturers provides more and more functions and dashboard configurations.LIN (Local Interconnect Network) is a network protocol introduced in 1999. It is a simpler and lower costcomplement to CAN (Controller Area Network) and is adapted for applications where the demands forbandwidth are lower, for example reading sensors and switchers.

Abstract The purpose of writing this thesis was to improve methods during requirements engineering phase. Usercentred system engineering has some problem areas, which are examined and verified to create a new guideline for developers. This guideline tends to make requirements engineering more effective and help developers create more concrete requirements. It is not uncommon that system development projects ends up with unsatisfied users or delay in deliveries. The reasons are different kinds of communication problems between users and developers during verification of requirements. There is a therapy model, called solution-focused therapy, used in family and individual therapy. The model focuses on solutions for the future instead of problems in the past.

The Swedish Transport Administration manage nearly 4,000 railway bridges in different condition and age around the country. These bridges is in constant need of maintenance and requires continuous inspections. This thesis is designed as a damage investigation on a single-track railway bridge south of Solvarbo in Säter municipality. The railway bridge is in operation and serves over 10,000 trains a year, everything from speed trains to freight trains. The bridge is built as a beam bridge, simply supported over a road.

The lily pad creatures arose out of my childhood memories of nature. This project has been an ongoing investigation of a workprocess as well as an exploration of my own sense of artistic idiom. I wanted to develop my knowledge in pattern design and focus on the artistic expression. I want the pattern to invite participation in storytelling in the same way that nature has inspired me..

Sandvik Wire needed a review of the administrative part of the order fulfillment process and especially the work around packing and the inventory of finished goods. Therefore we acquired the assignment to investigate the administrative part of the order fulfillment process in the company with the purpose to identify potential for improvement. This investigation was performed with focus on the terminal and packing functions. The purpose with the investigation was also to identify critical factors for an efficient order fulfillment process and investigate if information quality is such a factor.Data was collected through interviews and observations on Sandvik Wire. With the help of this data the information and material flows was mapped, the work within terminal and packing, and adjacent functions was investigated.