Today there is an even higher demand on IT-projects success rate compared to a few years ago. IT-projects must be handled more efficiently and result in a more profitable investment. In order to make the handling of IT-projects more efficient and create profitability the developers must have a broad understanding of the IT-projects characteristics and which factors that affect the result of the projects. Changes within IT-projects are often carried out through the development of a system. Since this change is more common when it comes to IT-projects it is important to handle risk and change within these kinds of projects in order to prevent and avoid uncontrolled changes.

An inflammatory reaction is induced after release of proinflammatory mediators such asinterleukin 1 and 6 and tumour necrosis factor ?. These mediators stimulate the liver tosuppress the syntheses of albumin and endure the syntheses of acute phase protein forinstance C-reactive protein. The aim of this paper was to perform a method validation on animmune turbidimetric assay to quantify C-reactive protein in canine serum at the laboratory atSkara Animals Hospital, Skara, Sweden. The validation involved evaluation of the assaylinearity, precision, stability and recovery.The method was proved to be linear for both TruLab control and Medinor control.

Lake Bornsjön is situated 30 km southwest of Stockholm in a rift valley lake and consist three basins outstretched in northwest-southeast direction. The surface area is 6,7 km2 with a maximum depth of 18,3 meters, a mean depth of 9,8 meters and a retention time of the water of 6,5 years. The drainage area is 42 km2 and consists mainly of arable land (ca 1000 ha) and productive forestry land (2500 ha), but in the drainage area there are also restored and fairly newly constructed wetlands.Today the Stockholm area receives its drinking water from Lake Mälaren, but if there would be any pollution of this source, Lake Bornsjön would act as the water source. The area surrounding the lake was bought already in 1899 by Stockholm Stad for protection of the lake and was taken over 1993 by Stockholm Vatten AB. It has been a water protection area from 1988 and it was also accepted as a nature reserve in 1995.

This essay examines the using of consensus method for decision making within the World Council of Churches (WCC) and the process that led to the decision to adopt its usage. The main question of my essay is why the method was introduced to the WCC and what motives lay behind its introduction. Other questions are how the consensus method works; both in theory and in practice, and what the predecessors and prototypes for the method are.The consensus method belongs to a broad Christian tradition of spiritual discernment and spiritual decision making. The New Testament, in particular Acts, gives examples of decision making in the early church which show that discerning God's will was considered essential. However the most influential model for the consensus method have been the decision making process of the Religious Society of Friends or Quakers, and also the consensus model of the Uniting Church in Australia.

Every observation method has its advantages and disadvantages and a well-adopted method gives more reliable results. Factors affecting the choice of the most appropriate methods for recording foraging behaviours include species, group size, environment, seasons and age. The focus for this study was to determine which method is most appropriate for studying the foraging behaviour of a troop of 89 olive baboons (Papio anubis) living in a riverine forest by the Southern Ewaso Ng'iro River by Lale'enok Resource Centre in Kenya. To determine this, a literature study was carried out to compare methods from monkeys and apes. I found instantaneous sampling was the most common method with intervals of 5 minutes in most cited studies.

A design methodology to mitigate timing problems due to long wire delays is proposed. The timing problems are taking care of at architecture level instead of layout level in this design method so that no change is needed when the whole design goes to backend design. Hence design iterations are avoided by using this design methodology. The proposed design method is based on STARI architecture, and a novel initialization mechanism is proposed in this paper. Low frequency global clock is used to synchronize the communication and PLLs are used to provide high frequency working clocks.

The aim was to explore how the first page of a student newspaper has been changed over time since it was founded in the 1960´s.This thesis explores how the front page of the student newspaper Lösnummer has been changed since it was founded in 1966. It concerns the location and frequency of elements and it is based on theories of layout, the first page and visual communicationIn addition, the thesis develops a new kind of method for determining the location of elements on the type area. The method is based on the hexadecimal number system. It is formed as a grid which is placed on the first page to determine the location of the elements.It concludes that the frequency of elements had its peak during the 1970´s and has ever since decreased gradually. Image placement has gone from being scattered all over the front page to be centered and increase in size. .

The purpose of this work is to examine how ecotourism exists in Sweden. In order to answer this, the essay has been based on a qualitative method, which means that the authors have mainly used depth interviews for information gathering. Some of the empirical work is also done using the qualitative method, by gathering statistics, figures and scientific articles. The essay is divided into various chapters to give the essay a clear structure and for the convenience of the reader. The part that have been of most use and support for authors is the depth interviews with the interviewees.

In this masters thesis we consider a method for experimental identification of the inertial parameters of an industrial robot, using measured torques and joint angles. A dynamic model of the first three joints of the robot has been identified.To achieve good identification results, it is important to carefully choose the trajectory for the experimental identification. A method to generate trajectories using two suggested design criteria has been used and evaluated using an ABB industrial robot, and one of them yields good identification results..

Title: Eurythmics, and building boats -A study in tacit knowledge.The education of eurhythmics at Malmö Academy of Music, is a program where a major part of the tutoring is oral; very little written information about the method is used. This essay will examine the forms in which the current knowledge base exists, as well as the methods in which this information is transmitted from teacher to student, and in which form the knowledge about the method of eurhythmics is existing. The tools for analysis are the theories on tacit knowledge. Interviews and written surveys are used as qualitative research methods. The content of these interviews and surveys are presented in the results chapter.

Steel is an excellent material to build with, but consideration must be given to the fact that unprotected steel corrodes, rusts, therefore, as a rule, the steel must be protected in some way. This can be done by reducing the tendency of the steel to corrode by using stainless steel or by treating the steel with a protection method. The two most common methods of protection are corrosion protection paint and zinc coating. To determine the method, the corrosive category must first be evaluated and this is done in accordance to EN ISO 12944-2:1998.Stainless steel is available in many varieties but only some of them have properties that make them suitable for use as construction steels. There are many factors to be considered in the design of stainless steel to prevent corrosion from occurring.

Background: The lack of knowledge regarding preschool children's mental health prompted Uppsala University, in collaboration with Uppsala Kommun, to start a study in which children aged 3, 4, and 5 years are screened using the "Strength and Difficulties Questionnaire" (SDQ). This screening method has been introduced into the majority of Uppsala County child care centers (BVC), and the nurses' experience of working with this method is examined in this paper.Method: A qualitative approach with semi-structured questions was used to interview ten nurses who pioneered the SDQ Method. The interviews where recorded, transcribed and analyzed using content analysis.Results: Three themes and nine categories were identified from the interviews. The themes were: "Attitude and motivation are important when working with the form", "Clearer overall picture with preschool answer", and "A tool to identify difficulties". The results show that the nurses were satisfied with the form.

AHA is a Swedish abbreviation of "reveal threatened park and avenue trees" and is a method to assess the conservation value of individual trees, mainly in the park environments but also in natural stands. This method has previously only been practiced in southern Sweden (Sörensson 2008). To see if this method could provide satisfactory results in northern Sweden, I have studied it in areas around the Umeå River. This was done by studying the relationship between trees with different classifications of conservation value (as classed by the AHA method) and their content of species (species richness and abundance). Insects were collected using trunk window traps in a period of 13 weeks during the summer of 2014.

Nowadays Wireless LAN is playing a more and more important role in network systems. After 1999, in which the IEEE organization published its Wireless Local Network standard 802.11[1], many people saw the advantages of the standard but also the lack of support for multimedia streaming. A lot of research work has been done on the proposed IEEE 802.11e standard draft during the past 4 years. It is supposed to be able to fully support Quality of Service. The final version will be published early in 2004.

Drivsystemoberoende energiåtervinning är kärnan i detta examensarbete. Målet har varit att analysera pneumatikens potential att återvinna energi och agera som en gemensam plattform för alla fordonstillverkare oavsett inriktning på drivsystem. En kompressor har används för energiformsomvandling, lufttankar för energilagring och luftmotor för återomvandling till kinetisk energi. Utgångspunkten för systemet har varit att utföra så stora delar av bromsarbetet som möjligt. Hållfasthetsberäkningarna styrker att måttlig energiåtervinning är möjlig utan anpassning av belastade komponenter, så som drivaxlar.