The district heating load is seasonally dependent, with a low load during periods of high ambient temperature. Thermal energy storage (TES) has the potential to shift heating loads from winter to summer, thus reducing cost and environmental impact of District Heat production. In this study, a concept of high temperature borehole thermal energy storage (HT-BTES) together with a pellet heating plant for temperature boost, is presented and evaluated by its technical limitations, its ability to supply heat, its function within the district heating system, as well as its environmental impact and economic viability in Gothenburg, Sweden, a city with access to high quantities of waste heat.The concept has proven potentially environmentally friendly and potentially profitable if its design is balanced to achieve a good enough supply temperature from the HT-BTES. The size of the heat storage, the distance between boreholes and low borehole thermal resistance are key parameters to achieve high temperature. Profitability increases if a location with lower temperature demand, as well as risk of future shortage of supply, can be met.

District heating covers most of the residential areas and industries in the twoneighbouring Swedish municipalities Nyköping and Oxelösund. In Nyköping,Vattenfall AB Värme produces heat in a bio-fuelled CHP plant. In Oxelösund,waste heat and use of waste gases from the steel production at SSABOxelösund is the basis in the district heating system.This report examines the environmental consequences of a connection betweenthe two district heating systems. A broad system approach is used and the focusis on environmental effects in the system.A system analysis has been performed on the result of simulations of differentheat and electricity production alternatives. The alternatives simulated wereone where Vattenfall Nyköping covers the base load in the joint district heatingsystem and two where the power plant at SSAB Oxelösund supplies the heatbase load.The conclusion in this report is that the consequences of connecting the twodistrict heating systems can be both positive and negative, depending onsystem boundaries and on the environmental focus.

Floating housing is a concept gaining ground in Sweden. The dwellings are different in many ways from traditional homes, not only regarding flotation, but also several other technologies. The purpose of this thesis is to emphasize the qualities that exist in living on water. The ambition was to present a proposal for a floating residential area located in Jönköping, containing homes of varying sizes, and to present their technologies. In order to find inspiration and solutions studies have been made on existing floating homes in Stockholm and Kalmar, focusing on their technical and functional solutions.

Water is the most essential resource for life. In cases where drinking water is processed from surface water it is important to ensure the raw water is of good quality, and is suitable for processing through the water treatment plant.The drinking water for Västerås is sourced from Västeråsfjärden, in the western side of Lake Mälaren. The city itself is home to marinas, ports, a wastewater treatment plant, the Svartån outlet, sewage pumping stations and stormwater outlets. Because of the negative effects these activities have on surface water quality, Mälarenergi AB is interested in relocating the raw water intake point to Granfjärden, 10 km east of Västeråsfjärden. At Granfjärden the intake point would be less exposed to the activities in Västerås, and could be placed at a greater depth, resulting in better water quality.In this Master?s thesis the water quality and the pollution risks at Västeråsfjärden and Granfjärden sites are compared.

The focus of this study was to examine the nutrients and benthic organisms of the bay ?Mönsteråsviken?, which is influenced by eutrophication. The purpose was also to look at an interesting gradient forming in the bay, namely the distance from the river outflow of Lillån. At 18 sampling sites in the bay samples of water, sediments and benthic organisms were collected in late April of 2011. The water was analyzed for nitrate, phosphate and chlorophyll.

The aim with my master thesis is to develop and test the applicability of methods to quantify and map solute advective travel times and pollutant transport at the catchment scale. Such quantification and mapping can increase the understanding of catchment-scale pollutant transport in general and contribute to the identification of the main sources of water pollution and the most efficient measures to reduce such pollution. The study area is the catchment of Oxundaån, about 20 km north of Stockholm. For detailed GIS modeling of water flow and catchment-scale contaminant transport in water, I´ve used new high-resolution elevation maps, land cover maps and soil maps combined with other available relevant data..

ABB I-R Waterjet Systems combines the robotics and motion expertise of ABB Flexible Automation with high-pressure intensifier/pumping technology from Ingersoll-Rand to provide and continue to develop innovative waterjet cutting systems for global markets. The purpose of this assignment is to develop a process water purifier. The purifier should be applicable as an option to ABB I-R?s production cell Cutting-Box. At first hand the process water should be purified well enough to let out in the municipal sewage system, but the ultimate solution is purifying the process water to the range that recycling is possible. When investigating the different principle of purifying water, a research of different products and their manufactories was done. These different products were compared and the principle of filtration was the most applicable, as most of the products were designed for far larger applications. As the process water contains quite large amount of particles, it is necessary to perform the filtration in different steps. The process water purifier is therefore composed of a module of coarse filtration and one of micro filtration. In the module of coarse filtration the mainly amount of fibres and particles are eliminated. They are kept back in the container unit with the larger fragments and dumped with these when the container is emptied. In the module of micro filtration the filtration is performed in two steps. In the first step particles larger than 50?m are eliminated, in the second step the micro filter is setting the range of purifying, in this case 10?m.

Ocean Thermal Energy Conversion (OTEC) is a technology that utilizes the temperaturedifference in oceans between the warm surface water and the cold water at 1000 m depthto produce electricity. The purpose of this report is to investigate if OTEC with its synergiescould become a commercially feasible energy solution for a small island. A literature reviewis conducted to explore the different OTEC technologies and to what extent the threesynergies; fresh water, air conditioning and aquaculture, could be used. In order to calculatethe profitability of these synergies there is also a study conducted on the conventionalmethods and cost of fresh water production, aquaculture and air conditioning. A model is setup using a scenario of a small tropical Island with population of 100 000 people.

The environmental work in Sweden has developed a lot over the past fifty years. Today, most companies have some kind of environmental work. Environmental activities are regulated by the Environmental Code, which applies in parallel with other laws. This report is an environmental review for Bräcke Diakoni. The report aims to find out how much environmental impact Bräcke Diakoni has.

The focus of this study was to examine the nutrients and benthic organisms of the bay ?Mönsteråsviken?, which is influenced by eutrophication. The purpose was also to look at an interesting gradient forming in the bay, namely the distance from the river outflow of Lillån. At 18 sampling sites in the bay samples of water, sediments and benthic organisms were collected in late April of 2011. The water was analyzed for nitrate, phosphate and chlorophyll.

Perfluorinated substances (PF) are environmental pollutants that are used to coat fibres of so called ?all weather clothes? to make them water resistant. PF are effectively spread through water. Waste water treatment plants (WWTPs) are a pollutant source of these substances. PF are poisonous to different kinds of organisms, and supposedly also to human beings, if concentrations are sufficiently high.Perfluorinated substances have been investigated at three waste water treatment plants in Stockholm during the 2000?s.

Akademiska hus is a real estate company that specializes in providing Swedish universities with housing facilities for educational and research purposes. The company strives to reduce its use of energy by 40% between the years 2000 and 2025. The aim of this thesis is to determine which measures can be taken to reduce the need of purchased energy in a building that is used by theSwedishUniversityof Agricultural Sciences inUppsala.In order to determine the results of various changes to the building envelope and ventilation system, the building was modelled in the computer simulation program VIP-Energy. Other proposed changes to make the use of energy more efficient concerned water use and lighting. The need of purchased energy can also be reduced by producing electricity or heat on site, using solar energy.Results show that economically viable measures include upgrading windows and faucets, adjusting control systems for ventilation and lighting, and installing roof mounted solar panels for power production.

Stump treatment today requires large quantities of clean water mixed with the protective product Rotstop, to fully cover the stump surface. In order to reduce the water consumption without reducing the coverage of the stump surface, the pressure in the stump treatment device can be increased. Therefore, the Phlebiopsis gigantea (Fr.) Jül. suspension used as a biological control agent to prevent Heterobasidion annosum (Fr.) Bref. infection was pressure-tested.

The continuous process of urbanization results in demands on research and development for ecological and sustainable city development. Because of this, the current systems for wastewater treatment may have to be improved. In order to evaluate new technologies for municipal wastewater treatment, a development project has been initiated for the new district Hammarby Sjöstad in Stockholm. The project is lead by the company Stockholm Water. High environmental standards have been put up for the district, as it must be twice as good as an ordinary new district.

Energy is an important issue in the current world which significantly affects sustainability and development. Energy generation and use are major sources of CO2 emissions which is one of the most important driving factors in global climate changes. The amount of energy used in house hold section can lead to estimation of the amount of CO2 emitted within this section which subsequently would be a ground to better management and maintaining a sustainable society. This study which is a bachelor?s project in sustainable energy, deals with estimation of CO2 emission from different types of residential houses in Sweden. An extensive literature review on energy use in Sweden by different residential sectors has been conducted.