When I got the opportunity to write this examination did I want to write about something that I both was interest in and also can use in the future. I think it?s going to be difficult to carry on the milk production with only 28 cows. I wanted to investigate the possibility to increase the herd of cows. I also wanted to compare this cost with a new cow house the cows where milked with a robot.

SammanfattningEn ånganna monterades i EGR (Exhaust Gas Recirculation) slingan på en 12,7 liters Scania Euro V motor (DC1306). En modell som beskriver Rankine cykel togs fram med vatten som köldmedium i simuleringsverktyget GT-Power. Ångpannan i GT-power modellen kalibrerades m.h.a experimentell data.Simuleringarna visade att det optimala ångtrycket, det trycket där högst effekt kan erhållas från expandern, är beroende av EGR temperaturen. Det innebär att ju högre EGR inloppstemperatur desto högre optimalt ångtryck. EGR temperaturen i punkt 2 i ESC cykeln är 514? C för denna motor, vilket resulterar i ett optimalt tryck på 120 bar enligt simuleringen.

The housing sector of today represents for almost 40% of the energy consumption, an energy consumption of which the major part consists of non-renewable energy sources. This is not sustainable and utilization of new energy-efficient technologies in buildings can be a step in the right direction, towards a sustainable energy society.This report has been made on behalf of and in cooperation with Älvstranden Utveckling AB in Gothenburg to examine how future energy-efficient technologies can affect the energy demand in energy-efficient multi-dwelling buildings.The report is based on Älvstrandens passive house, Hamnhuset, a house whose energy consumption is far below the BBR's requirements. The report looks at the opportunities for improvement within windows, insulation, solar energy technologies, as well as white goods. Computer simulations are then made to apply the selected technologies into a reference building. Technologies are selected from an energy efficient perspective and no account has been taken of other aspects such as the economy.

In developing countries such as Vietnam the population consumes more animal products for example milk and meat than before which requires greater livestock production. Ruminants contributes to more methane emission which creates a dilemma between food production and its environmental impact. By feeding ruminants with nutritive crops which humans can not assimilate the animal performance will increase in terms of better growth and milk production without inpinging on food that can be consumed directly by humans. Increasing animal performance reduces methane emission in terms of amount of methane in kg-1 milk and meat which today is much greater in developing countries than developed countries. The aim of the study was to investigate tropical tannin-rich legumes for their potential as a feed supplement for ruminants made in vitro.

By using steady-state measurements for predicting emissions under a dynamic drive cycle wouldsave a lot of time and money for the exhaust aftertreatment specialists at Volvo cars. The idea forthis thesis has been to investigate if statistical regression models can be used with good accuracy.Questions included are for example if common operating variables such as engine speed, air-fuelratio etc. is sufficient to predict engine-out emissions over the engine operating range with goodaccuracy. Focus was set on the modelling of warm engine, but also the more complex engineheat-up phase was investigated since it is a great contributor to total emissions. While NOxcouldnot be measured because of malfunctioning measurement equipment, only HC, CO andtemperature at inlet of first catalytic converter has been modelled.

At Sandvik Materials Technology, Argon gas is used as furnace atmosphere when heattreating hot rolled wire. Upon heating chromium steel wire, a rich oxidelayer forms on the wire surface. The abstract of this masters thesis is to enhance the understanding of the constitution of the oxidelayers and the influence of the furnace atmosphere. This will be achieved by performing a number of annealing experiments on laboratory level. Also, the aim is to understand the chemical reactions and physical mecanisms controlling the pickling process.

Understensho?jden is Stockholm's largest eco-village which was built in the early 1990s with the vision of enabling ecological living for people. However the ecovillage is no longer considered as environmentally friendly because of its relatively high energy consumption, and non-updated energy system. The purpose of this study is therefore to investigate how Understensho?jden should reduce their energy consumption and upgrade its energy system by using Blower-Door, IR-camera and Design Builder.

This paper describes the work done trying to diminish the noise present in the signal from an IR-detector. The project was aiming towards two different kinds of applications; heat protection and presence detection. The hypothesis was that the signal-noise ratio would decrease if a filter and a proper installation were used for the detector. Some experiments were executed to determine what kind of filter were the most suitable for each application and how these could be installed. After executing the experiments and evaluate the results we recommend to use a specific filter for each application.

On 1 January 2007 abolished Sweden as one of the last countries in EU the wealth tax. This wealth tax was in Sweden for almost 100 years. As the great debate in the context of tax reform in 1910 was not so much about the introduction of a wealth tax. The discussion was instead on the wealth tax would be proportional or progressive together with the income tax.When the government with and there finance minister, Carl Swartz, presented its government bill, 1910:88, 11 March 1910, the draft regulation on income and wealth tax was said, that now they had finally made a shift in the direct tax to the state. A change had been sought and it would have been great difficulties to be overcome and it would have been deeply entrenched ideas about this tax reform impossible.Despite all the protests from the wealthy in society, so continue this conservative government through reform with the strong support of many conservative politicians who had most to lose from this tax reform.

The Swedish building and property management sector are responsible for about 30 % of the total energy use. In order to take environmental consideration, different environmental assessment tools and standards are used. Miljo?byggnad, Svanen, FEBY12 and PHI are some of these. There has been increased interest to certify buildings and therefore it is of interest to evaluate the assessment of the energy field to see if relevant energy aspects are assessed.

Uvån Hagfors Teknologi AB (UHT) has developed a process ? GRANSHOT® ? for quicksolidification of metals in water baths. In the process liquid metal is splintered ? granulated ?into small drops. The drops are rapidly cooled in a water bath where all the heat energy from theliquid metal is transferred into the water.

At Forsmark nuclear power plant a new course called "education in everyday safety" has been started in an attempt to improve the safety culture. The goal is to spread the of expectations and approach the maintenance management has set, to all employees working at the plants. During the course, theory is mixed with practical tasks to reach a common view how work should be done to achieve safety for the plant and the people that work there.The practical tasks are done inside "maintenance simulators". They are built inside 20 ft containers which contains two dummy pipe systems. On the pipe systems some valves, a flow meter and a pump has been installed.

Rapporten handlar om framtagning av användarvänlig konstruktionslösning till en frekvensstyrd filterkärra och görs på uppdrag av Lars-Olof Larsson vid Filterteknik AB i Karlstad. Kursen är Examensarbete högskoleingenjörsexamen i maskinteknik, MSGC17 vid fakulteten för teknik- och naturvetenskap på Karlstads universitet under vårterminen 2014.I detta examensarbete tas en konstruktionslösning fram till en frekvensstyrd filterkärra som är en blivande produkt och ersättare till två tidigare filterkärror. Filterkärrans uppgift är att filtrera olika oljor från vatten och partiklar. En testkörningsprototyp fanns från början och huvudkomponenterna var utvalda. Genom produktutvecklingsprocessens metodik har ett antal prototyper tagits fram och utifrån det har den med bäst lösning valts och arbetats vidare med. Resultatet blev en kärra med samma ramstomme som tidigare liknade kärror.

The thesis investigates if it is possible to replace several pumpimpellers with one controllable pumpimpeller, with a economical and a manufacturing analisys aspect. The studied pumpimpeller is mounted on a midrange wastewaterpump, N3127MT.In the thesis a contemplated manufacturing process is evaluated for a concept that are supposed to act as a controllable pumpimpeller. The pumpimpeller are studied in a manufacturing and flow matter and are presented in the thesis.The manufacturing cost is also estimated, and this has been compared to the storage cost and other costs that the existing pumpimpeller generates.The thesis also shows that the concept has minor losses in cutting quality aswell as the effiency comparing to the existing pumpimpeller.The concept also raises the manufacturing cost and this increasing cost makes the presented concept to expensive to carry through.An investigation of the costs that the existing pumpimpeller produces has also been done, and this shows that there is not that much expenses to earn regarding to for example the storage cost. The storage cost includes information from Flygt?s central storagecenter in Lindas, Sweden and Metz, France, and also an inventory about the pumpimpellers located at Flygt?s different distributors worldwide.The thesis shows that a controllable pumpimpeller will generally increase the cost for the pumpimpeller and the performance of the pumpimpeller will decrease..

This report is the result of a thesis conducted at the consulting firm Bjerking AB andis the final part of the Bachelor Programme in Construction Engineering at Universityof Uppsala. The work aims to investigate the costs and how the choice of ventilationsystem affects building projects during a long-term period. This report covers costssuch as investment, maintenance and energy but also how they affect residents andbuilders. Building regulations for energy consumption are expected to be tougher;therefore a comparison of two different heat recovery ventilation systems(HRV-system) was made. One system is based on a centrally placed unit that coversthe whole buildings ventilation through vertical shafts.