AbstractThis report intends through a case study to investigate if lightweight concrete isappropriate as main material in the outer wall of a seven storey residential building.A technical design is carried out in accordance with the definitions and requirementsfor passive houses, given by FEBY?s1 ?Demand specification for passive houses?.A literature review is also carried out for a comparison between regular bolt wall andlight weight concrete wall, with a focus on the safety of moisture.The lightweight concrete block used in the report is as a celblock produced by thecompany H+H Sweden AB.The methods used have resulted in compliance with requirements andrecommendations from authorities. Calculations of energy, noise and moisture riskassessment has been carried out.The work has resulted in the conclusion that the lightweight concrete itself is notable to isolate in the extent necessary to obtain chosen U-value of 0,1 W/m2 ° C,without getting to thick. Therefore additional insulation is needed. There are fewrelevant reference objects built with only light weight concrete.

Studiens syfte är att undersöka arterna Buxbaumia viridis och Nowellia curvifolia för att kunna förutse var man hittar dessa signalarter. Detta gjordes genom att död liggande ved undersöktes i Ycke naturreservat samt en närliggande brukas skog, Östergötlands län.Resultaten visar att faktorerna som är avgörande för B. virids är markkontakt och nedbrytningsklass. B. viridis föredrar att växa på lågor i de högre nedbrytningsklasserna (4-7) och med stor andel markkontakt, över 80 %.

The control of indoor temperature must be able to handle large time constants and both measureable disturbances like outdoor temperature, and non-measurable disturbances, like waste heat from appliances. Due to cheaper microcontrollers (small computers with designated tasks) with better performance, more advanced and computation-demanding methods for control can be used.In this thesis, Generalized Predictive Control (GPC) has been implemented and tested on a theoretically derived model of a house. GPC states that a model of the system is estimated in every sample, and the control is carried out simultaneously, based on predictions of the model. Disturbances like solar radiation can be estimated and used in the control as well. The control signals are determined by quadratic programming, which makes it possible to consider conditions, for example limitations on the control signals.GPC requires a number of parameters to be defined, like model order and control signal penalty, but is relatively robust for variations in them.

Cittaslow is an international organization founded in Italy in 1999 by a few towns in Northern Italy, in order to stop the trend of people moving to bigger cities. The aim was to show the advantages of small towns and to strengthen their identities. Falköping is, since the certification in the summer 2008, the first Cittaslow in Sweden. Cittaslow is an international organization founded in Italy in 1999 by a few towns in Northern Italy, in order to stop the trend of people moving to bigger cities. The aim was to show the advantages of small towns and to strengthen their identities.

Glass has sophisticated front properties and are used as facades in high buildings. During cold periods, these glass facades could cause thermal discomfort, due to cold downdraught. Cold downdraught can be countered by placing heaters under glass surfaces. Nowadays technology offers highly insulating windows, which is why there is an interest to investigate the indoor climate with only underfloor heating. The research in this area is limited, and few empirical methods are available.

This report is a study in voltagelevel in connection with regeneration of brake energy from the tramtype M31 in Gothenburg.In the act of braking, the tram M31 uses electrical braking where the electrical motors generates energy and if possible send it back to the overheadline, where other trams in the nearby can use this regenerated energy for its own driving force. In cases where no other energyconsumers are located in the same section, there is a resistance witch task is to convert this energy into heat. The regulation of this resistance appears to cause an increase in the voltagelevel into far too high levels.Investigations of the trams regulationequipment and its construction have been done. Further have measurements on the overheadline been performed in order to map the voltagevariations during a longer period of time.The result have been showing that the voltagelevel during regeneration often is as high as 880V-920V, more extreme values have not been observed in a large scale. The values are especially high compared to the nominal voltagelevel.

This report is a study in voltagelevel in connection with regeneration of brake energy from the tramtype M31 in Gothenburg.In the act of braking, the tram M31 uses electrical braking where the electrical motors generates energy and if possible send it back to the overheadline, where other trams in the nearby can use this regenerated energy for its own driving force. In cases where no other energyconsumers are located in the same section, there is a resistance witch task is to convert this energy into heat. The regulation of this resistance appears to cause an increase in the voltagelevel into far too high levels.Investigations of the trams regulationequipment and its construction have been done. Further have measurements on the overheadline been performed in order to map the voltagevariations during a longer period of time.The result have been showing that the voltagelevel during regeneration often is as high as 880V-920V, more extreme values have not been observed in a large scale. The values are especially high compared to the nominal voltagelevel.

This report is a study in voltagelevel in connection with regeneration of brake energy from the tramtype M31 in Gothenburg.In the act of braking, the tram M31 uses electrical braking where the electrical motors generates energy and if possible send it back to the overheadline, where other trams in the nearby can use this regenerated energy for its own driving force. In cases where no other energyconsumers are located in the same section, there is a resistance witch task is to convert this energy into heat. The regulation of this resistance appears to cause an increase in the voltagelevel into far too high levels.Investigations of the trams regulationequipment and its construction have been done. Further have measurements on the overheadline been performed in order to map the voltagevariations during a longer period of time.The result have been showing that the voltagelevel during regeneration often is as high as 880V-920V, more extreme values have not been observed in a large scale. The values are especially high compared to the nominal voltagelevel.

Minnets tematiska och berättartekniska funktion i Eyvind Johnsons roman Strändernas svall (Fredrik Smeds, C-uppsats i Litteraturvetenskap, Karlstads universitet, Institutionen för kultur och kommunikation, vt 2003). Författaren redogör först för romanens handling och jämför kompositionen med den i Odysséen. Vidare studeras berättare och synvinkel. Därefter följer en genomgång av minnena och berättelserna, främst Odyssevs?, men även Nestors och Menelaos?.

Detta examensarbete har utförts på Sapa Heat Transfer i Finspång och har tagit upp frågan med hur den interna hanteringen av produkterna kan orsaka defekter. I arbetet har en typ av defekt undersökts särskilt och denna defekt kan ses som ett exempel. Företaget tillverkar aluminiumband till värmeväxlare, främst till fordonsindustrin. Banden levereras på rullar med en diameter upp till 1700 mm, och en bredd mellan 12 mm och 1440 mm. Syftet med detta examensarbete är undersöka en defekt som är orsakad av den interna hanteringen, det vill säga det som sker mellan produktionsstegen.

This paper deals with archaeological prospection of an Iron Age farm site in Toland, Fresta parish, Uppland County in Sweden. The purpose of the paper has been to see whether the geophysical methods applied (GPR & EM-38) could produce useful results that could motivate its use in similar surveys in the future. Geochemistry has been used for the purpose of identifying possible activity areas on the site. The results have shown that it is possible with a GPR survey to identify postholes originating from the Migration Period longhouse at the site. The combining of several methods have been important for the identification and interpretation of several areas of interest..

Detta examensarbete jämför två övervakningsverktyg för servrar i ett nätverk, Zabbix och op5 Monitor. Båda är open source och används aktivt av organisationer för att övervaka organisationsservrarnas processorlast, I/O-kö på hårddiskarna, status på tjänster och mycket mer. Dessa två övervakningsverktyg testas och jämförs med varandra ur perspektiven användarvänlighet, funktionalitet och prestanda. Resultaten visar att i de flesta fallen är Zabbix mer användarvänligt medan op5 Monitor i de flesta fallen har bättre funktionalitet. Det visar sig också att op5 Monitor har något högre prestanda än inte bara Zabbix utan även de övervakningssystem som testades av Robin Rudeklint år 2010..

This report is a study in voltagelevel in connection with regeneration of brake energy from the tramtype M31 in Gothenburg.In the act of braking, the tram M31 uses electrical braking where the electrical motors generates energy and if possible send it back to the overheadline, where other trams in the nearby can use this regenerated energy for its own driving force. In cases where no other energyconsumers are located in the same section, there is a resistance witch task is to convert this energy into heat. The regulation of this resistance appears to cause an increase in the voltagelevel into far too high levels.Investigations of the trams regulationequipment and its construction have been done. Further have measurements on the overheadline been performed in order to map the voltagevariations during a longer period of time.The result have been showing that the voltagelevel during regeneration often is as high as 880V-920V, more extreme values have not been observed in a large scale. The values are especially high compared to the nominal voltagelevel.

This report is a study in voltagelevel in connection with regeneration of brake energy from the tramtype M31 in Gothenburg.In the act of braking, the tram M31 uses electrical braking where the electrical motors generates energy and if possible send it back to the overheadline, where other trams in the nearby can use this regenerated energy for its own driving force. In cases where no other energyconsumers are located in the same section, there is a resistance witch task is to convert this energy into heat. The regulation of this resistance appears to cause an increase in the voltagelevel into far too high levels.Investigations of the trams regulationequipment and its construction have been done. Further have measurements on the overheadline been performed in order to map the voltagevariations during a longer period of time.The result have been showing that the voltagelevel during regeneration often is as high as 880V-920V, more extreme values have not been observed in a large scale. The values are especially high compared to the nominal voltagelevel.

The purpose of this project was to further develop and complete a quadcopter that had been built in an earlier course at KTH, so that it could be used for demonstration and education at the school. The quadcopter was at the beginning of the project completed when it came to hardware, and there was some software functionality implemented but no system for automatic stabilization. The main goal of the project was to implement such a system, and to combine it with the previous functionality to make the quadcopter operable and able to fly. To create a functioning and stable ground multiple basic software features has been implemented, and on top of that additional software to improve the safety, stability and functionality. The most important part is the control system that is responsible for converting sensor and control signals to suitable motor values.