Sökresultat:
628 Uppsatser om Friendly Fire - Sida 13 av 42
Vätedriven förbränningsmotor : Klarläggande av framtida hållbarhet
Today when new and harder demands on CO2 emissions are developed, vehicle manufacturers must work to develop new engine solutions to new kinds of fuels to replace fossil fuels. A fuel that could be applied is hydrogen. When hydrogen is combusted only water vapor occurs. Hydrogen is known to be explosive and flammable. These properties are both good and bad for combustion.
Den militära nyttan med geografiska informationssystem kopplat till eldlednings- och observationsinstrumentet vid precisionsbekämpning.
I takt med Försvarsmaktens ökade engagemang internationellt och det faktum att alla insatsförband inom Försvarsmakten ska kunna verka på alla konfliktnivåer och i en urban miljö kommer nya krav och behov på bekämpningsförmågan att uppstå avseende precisionsbekämpning.Med hjälp av ett GIS kopplat till EOI:et vid en insats i en urban miljö kan en rad vinster erhållas för att stödja artilleriet vad avser precisionsbekämpning. Exempel på sådana områden är: målverifiering, justering av målkoordinater, lägesuppfattning avseende målets närmiljö, redovisning och presentation av verkansområde inför en insats för dimensionering av verkan..
Materialval i utfackningsväggar
The aim of this report is to give a concise description of curtain walls, what it is and why they are used. It is also a description of six different but commonly used design technologies. By giving a detailed description of the different types and there special properties, the pros and cons will be clarified. The three most interesting alternatives were selected to be included in a test, to show the best alternative from a certain point of view.The parameters are:? Environment? Cost? Ergonomics? Isolation against noise and fire? DurabilityThese are important parameters in the planning and design phase.
Social hållberhet genom medborgardialoger : exemplet Husby
Understensho?jden is Stockholm's largest eco-village which was built in the early 1990s with the vision of enabling ecological living for people. However the ecovillage is no longer considered as environmentally friendly because of its relatively high energy consumption, and non-updated energy system. The purpose of this study is therefore to investigate how Understensho?jden should reduce their energy consumption and upgrade its energy system by using Blower-Door, IR-camera and Design Builder.
Miljöarkeologi i Umeå stads hamn och slagfältsarkeologi på Krutbrånet : Två fallstudier inom historisk arkeologi i Umeås 1800-tal
This master thesis deals with two case studies in environmental archaeology and battlefield archaeology focusing on two major events in the late history of the Swedish coastal town Umeå and its nearby village Sävar. Established in the early 1600's, Umeå was known for its export of timber and import of cereals. The town has suffered from numerous fires, the fire in 1888 being the most devastating. Few written records of the town remain from before the 1900's. The latest war in Sweden's history is documented in historical sources and took place at Krutbrånet, Sävar where the Swedish troops suffered defeat against the russian forces in 1809.
Att bygga i trä eller lättbetong : en jämförelse mellan väggkonstruktioner
Hudiksvall Municipality will build a new preschool. The goal is that the pre-school should reflect the municipality's environmental goals and meet building regulations. The wall structures that are compared in the report is an insulated wooden frame and a frame of lightweight concrete blocks from H + HWall structures are compared within the areas of U-values, air tightness, thermal storage capacity, fire ratings, moisture, durability, emissions and environment. In these categories the two wall structures will be rated in a scale from 1 to 5 and then the categories are weighted against each other. The weighting is based on Hudiksvall Municipality's assessment of the categories importanse for their final selection.The results of the comparison show that the concrete structure is recommended for the construction of pre-school with 27.55 points against the wooden structures 23.70 points.
Pamiro
This report describes the work with creating a CMS (Content Manager System). A CMS is a web tool so you easy can publish materials on your web page. With a CM Scan you can without any knowledge of programming web pages create and maintain a web page. This will result in that you and your organisation save time and money. You can also split the responsibility for the webpage in different roles, but still keep the control.
CalControl : Kalorikalender för översyn av energiintag
The main reason for doing this kind ofproject was to find out if it was possible to make a relatively advanced application with user friendly tools. We tested the software MIT App Inventor, and the ability to create a useful application for people who wants to get an overview of their energy intake.During the process we found out that it was possible, but minor setbacks occurred. The main idea of our vision; to make a calculator and a registry with different kinds of food and their amount of calories, was completed quite easily. Later on, design alternatives and more advanced functions were not possible for us to make.This might have been because of the short amount of time the project was given, but also, and more likely, because the software did not contain that kind of advanced functions. Even if there were factors that held creativity back, the basic idea was possible to form..
Vilka är dagens krav på gårdsverkstaden? :
After been told that an ordinary winter service for our combine should cost more than
20000 SEK, not included spare parts, I decided to write this paper about today?s
requirement of the workshop on a farm. I think that the lack of proper premises is the
reason way not more of the ordinary machinery maintenance or upkeep is performed on
the farm.
When I did my literature survey I found that the Swedish environmental code, set by the
Swedish law regulate how drain or sewer should be built. The environmental code
however leaves a lot for your own interpretation. It might not be so bad but it must be
very hard for the local environmental office to interpretation the regulations, since they
are the ones that gives permission for the sewer in your workshop.
Modernisering av driv- och vändstation för timmersortering
The purpose of the rebuild of Notnäs AB timber sorting line is to renew the existing drive and turning ends of the transport chain, which has become old. This means that Notnäs AB have problems to get new parts if the gearbox and chain are worn out. They also require that the rebuild should have a maintenance schedule for the new spare parts that will be used in the rebuild. Maintenance workers placed great emphasis on that in a rebuild it shall be a service-friendly design. The maintenance schedule used in Notnäs AB in the current situation is from Statoil and the report uses SKF formulas and recommendations in order to obtain a lubricating schedule.
Maskinsamverkan mellan två halländska gårdar :
After been told that an ordinary winter service for our combine should cost more than
20000 SEK, not included spare parts, I decided to write this paper about today?s
requirement of the workshop on a farm. I think that the lack of proper premises is the
reason way not more of the ordinary machinery maintenance or upkeep is performed on
the farm.
When I did my literature survey I found that the Swedish environmental code, set by the
Swedish law regulate how drain or sewer should be built. The environmental code
however leaves a lot for your own interpretation. It might not be so bad but it must be
very hard for the local environmental office to interpretation the regulations, since they
are the ones that gives permission for the sewer in your workshop.
Analys av miljöaspekter för en planerad svensk fabrik i Kina
A Swedish company, company F, will establish a new factory in China. Company F is adivision within Company F. The factory in China will manufacture wire products. Thepurpose of this final thesis is to analyse which legal and practical measures the company hasto undertake during the process of localization to get approval from the Chineseenvironmental legislation.An analysis of the influencing factors on the environment from the production in theconstruction in Sweden was carried through. A material-balance was analysed according tothe flowchart of the production.
Mekaniserad spaning i dag och i framtiden
Den mekaniserade bataljonens främsta sensor att samla in underlag till underrättelsesektionen är spaningsplutonen. Spaningsplutonen på mekbataljon har bytt organisation över åren och gått från att vara ett terrängbils eller bandvagnsburet förband till sin nuvarande form med stridsfordon 90. Men har förbandet använts på rätt sätt sedan det tillfördes stridsfordon? Hur bör framtidens chefer nyttja plutonen för att maximera effekten?Arbetet baseras på de reglementen som finns idag samt intervjuer med personal tillhörande spaningsplutonerna och bataljonsstaber. Utöver det kommer en jämförelse med US Army Armored Cavalry göras..
Kundcentrerade miljöåtgärder - En studie av Pan Nordic Logistics kunders krav på miljövänliga transporter : Customer centered environmental measures - A study of Pan Nordic Logistics customers demand for environment-friendly transport
Traditional product features such as price, quality and supply service have been extended and nowadays includes environmental aspects as well. It raises new and increasing demands on haulier companies. The transport sector is responsible for a large part of the pollutants causing today?s environmental problems. The business is being closely monitored and to operate environmental friendly is seen as one of the most important elements for the industry?s future development.
Förbränning av träpellets och pelleterad halm i en 40 kW rosterreaktor
The project focus on combustion of softwood pellets and pellets in a 40 kW grate fire reactor at TEC-Lab. Dept Applied Physics and Electronics at Umeå University. Experiments were performed at four primary airs to fuel ratios (0.7 to 1.3), where aspects such as temperature profile, levels of gases (CO and NO), sintering-/-slagging and unburned fraction of the ashes were studied. Four different fuel loads were used for wood pellets (10, 20 and 30 kW) and one fuel load for straw (10 kW). Combustion of straw proved very difficult to ignite, and also led to other combustion-related technical problem such as slag formation due to the relatively low melting temperature-/-slag temperature of the straw.