The number of data centers and their capacity is increasing throughout the world. Theenergy used in these data centers and the emissions from the use are increasing at thesame rate. The total use of energy will double from 2008 to 2011 based on the trends indata centers use. Research in this area says that the emissions from data centers willhave surpassed the level of airline traffic in 2020. The index used today to compare howefficient a data center is, called PUE, is lacking some information.

Titel: Value stream mapping in practice ? A case study at Light MyFireAuthors: David Rydman and Tomas ÖnnemarMentor: Veronica Ülgen SvenssonExaminer: Åsa GustafssonBackground: Companies push their prices in today's markets to be competitive, which means that companies need to find ways to reduce costs while maintaining profits. (Cudney, 2009) According to Bergman and Klefsjö 2007, the basic rule of quality improvement says "there is always a way to achieve higher quality at a lower cost". One way is to improve a company's processes to get a more efficient Flow and improvements that may cut costs. (Bergman & Klefsjö, 2007) Why it's important to look at the processes are that they often contain waste that can be eliminated.

The thesis aims to compare differentpiping materials in heating systems interms of cost as well as to illustratethe impact of energy characteristics ofdifferent materials over its servicelife. The methods used for costcalculations regarding piping are alsoto be examined to highlight thedifferences between template basedcalculations and more carefully executedones. The work is delimited to discusspipes of steel, copper, plastics andcomposites. The aim is that the resultcan be compiled to illustrate the prosand cons of various materials whenevaluating investments.The main object of the survey is part ofa heating system in the office-block KVSommaren located in southern Stockholm.The configured piping system is designedwith the mentioned piping materials andis used to make up the data for Flow andcost calculations. The differentmaterials are calculated in both aconventional manner with a supplementarycost for additional fittings and with amore accurate quantification of thecomponents.

AbstractIn urban societies people spend more and more time indoors, which put great demands on the indoor environment. If the ventilation is to manage the removal of unwanted substances in the indoor air, a good mixing of the air is required. The question arises that, whether the buoyancy forces will counteract a good mixing of the indoor air or not?This report aims to clear up the difficulties whether you need to consider the buoyancy forces or not, when adjusting a ventilation unit. For studying the indoor mixing of the air a two dimensional model is constructed in COMSOL Multiphysics.

Läroplanen (Lpo 94) kräver att skolans undervisning ska rikta sig mot varje enskild individs behov, bakgrund och förutsättningar för att på bästa sätt förbereda och fostra varje elev till en framtida verksam medborgare. Forskning på området betonar även den om vikten av individanpassad undervisning. Problematiken ligger i att skolan är uppbyggd efter grupper vilket försvårar detta krav/målsättning. Kunskapsskolan är en skolan som växt upp till följd av Lpo 94 och har som mål att skapa en individuell lärandemiljö. Med utgångspunkt i detta är mitt syfte att undersöka hur medvetenheten är hos lärare på Kunskapsskolan gällande individuellt lärande.

Every observation method has its advantages and disadvantages and a well-adopted method gives more reliable results. Factors affecting the choice of the most appropriate methods for recording foraging behaviours include species, group size, environment, seasons and age. The focus for this study was to determine which method is most appropriate for studying the foraging behaviour of a troop of 89 olive baboons (Papio anubis) living in a riverine forest by the Southern Ewaso Ng'iro River by Lale'enok Resource Centre in Kenya. To determine this, a literature study was carried out to compare methods from monkeys and apes. I found instantaneous sampling was the most common method with intervals of 5 minutes in most cited studies.

Two of the main approach roads into the city of Enköping are Salavägen and Stockholmsvägen. They are connected to each other through the street Bangårdsgatan in the roundabout Salatullen and crossing Fannakorset, respectively. These crossings are from time to time heavily loaded, which is why the municipality plan for a new street in parallel to Bangårdsgatan. The traffic will then be spread out and is thereby reducing the density. The new street is actually an extension of the existing Mästergatan, a side street to Salavägen, to the east and connecting it to Stockholmsvägen or a street nearby.The purpose of this Master thesis is to show how the new street can be drawn in order to discharge the traffic in the area between the roundabout Salatullen and the crossing Fannakorset.

Thermia Värme AB is one of the market leading manufactures of heat pumps. In order tomaintain this position, the company wants to improve the vibration characteristics of theirproducts. The aim of this thesis is to develop product design changes that lead to a reductionof vibrations in the heat pump Thermia Diplomat 8.The main cause for vibrations in the system is Flow pulsation and mechanical forces inducedby the scroll compressor. Vibration is transmitted through the compressor piping and receivedby the heat exchangers, from where it is further transmitted to the connection points for theradiator and heat source circuits.A number of design changes in order to improve the vibration characteristics have beenevaluated through calculations and practical experiments. The changes have included thecompressor and heat exchanger mountings, the compressor suction and discharge line pipingand also pulsation dampening.The results of the experiments show that the vibration levels in the connections for the heatingand brine circuits can be decreased strikingly through changes in suction and discharge linepiping.

With background in the rapidly growing need to find solutions for sustainable energy production and the increasing interest for wind power, this report was written. With take-off point from the wind power plant Big Glenn, which has been built in the harbour of Gothenburg, a model of the adjacent power grid has been created in Simulink/SimPowerSystems. Parameters for the power grid and its components has been provided by Göteborg Energi Nät, that has also been the supplier of measurement data of produced power, the power need from loads in the vicinity, voltage levels, current values and also the variation of power factor at the wind power plant.The SimPowerSystems model has been used to perform simulations of power Flow in the grid. These simulated values have then been compared to the measured values to verify the functionality of the model. Further, the model has been used to perform simulations of a grid fault, which causes a voltage drop.

Gunsta is situated about 10 km east of Uppsala. Today there are plans to establish 1000 new households in Gunsta before year 2030. The required energy for heating houses and water would be distributed via a district heating system, which also includes 200 existing residences. The annual required energy, according to this study, would be 16.2 GWh with a maximal peak effect of 6.9 MW. To meet this need, the study suggests a system with heat pumps to upgrade the 31?C water from a 1.8 kilometre deep borehole.

The purpose of this project is to study Partab's material distribution process, furthermore identify critical problem areas within the company. Further the aim is to provide suggestions to new work procedures regarding material distribution and related processes. Appropriate literature has been used as a support in this process. The main goal of a commercial company is to generate cash Flow, and maximize the return on investment. Streamlining material supply and the use of material is a part of this process. Virum and Persson define logistics as: "Logistics is the approach and principles founding the process of planning, development, coordination, organisation, management, and control of material distribution from supplier to user".

By conducting interviews, studies as well as scanning the current scientific landscape, this paper examines the opportunities of increasing current capacity within the public transportation system in Stockholm with simple financial means for the benefit of the travelers. The paper focuses on the central station of the subway system and how adjustments of processes carried out in relation to the turnstiles could increase performance within areas of interest, given the preferences of the travelers. The theoretical framework of the paper includes models from the field of capacity management as well as theories related to the pedestrian behavior. Applying these theories and models to the collected data, the paper derives some main conclusions. First of, people using the public transportations system, and especially the subway, consider speed and dependability as the most important performance objectives for the caretakers of the public transportation system, SL and MTR to master.

Detta examensarbete har skrivits inom ämnet informationsdesign, som en del av kandidatprogrammet Informationsdesign med inriktning mot Rumslig gestaltning. Platsen som har studerats är Folkets park i Malmö, som i skrivande stund står inför en större ombyggnation. Detta examensarbete har både tagit utgångspunkt i parkens nuvarande, samt föreslagna utformning, vilket gjort att jag under processen behövt växla mellan dessa två olika perspektiv. Syftet med examensarbetet har varit att ta fram ett koncept som kan förbättra målgruppens möjligheter att orientera sig i parken efter den föreslagna ombyggnationen.  Genom teorier, platsanalyser och intervjuer har människors beteendemönster vid informationssökning i rumsliga sammanhang undersökts, med särskild fokus på hur detta kan fungera i Folkets park.

Water logistics has long been a problem in order to effectively carry out stump treatment in both thinning and final felling. It is important that the stump treatment? equipment is configured as well as a sufficient amount of water is carried out on the harvester to get a cost? effective treatment. The Flow control of the equipment has improved and water can be dispensed more efficient, but still the amount of water on the machine is a crucial factor in the total cost estimate. The knowledge of the tools available to bring water as well as the internal logistics of loading and transport to the felling site is deficient. Increased focus on "smart" solutions to manage water cost is of great importance in order to combat Hetrobasidion spp in both thinning and final felling. The purpose of the study is to describe and summarize different solutions of water logistics at stump treatment in final felling.

The purpose of this study has been to examine how customers, by interacting with each other, can communicate and create the image of a brand. We find this topic to be relevant since there are no previous studies conducted concerning the customers influence on the brand image. Our ambition has been to describe in what ways and to what extent the customer can affect and influence the brand image by communicating with other customers. To fulfill our purposed we have targeted three important questions which are:? In which ways can the customer affect the communicated image of a brand?? To what extent can the customer influence the brand image and the perceived value?? Who has control over the brand, the customer or the company?For this study we have used a qualitative approach in which we have conducted eight personal interviews with brand consultants and the editor of the magazine Dagens Media which has given us the foundation for our analysis.