Design of a house requires knowledge of both technology and economics. Heating and ventilation shall be designed, costs are calculated and estimated and requirements must be fulfilled. Which heating system is to be elected is also a difficult choice, especially with rising energy prices as a factor.The choice of energy system is not always given, because it depends on several factors. Below is a comparison between district heating, geothermal heat pump and electric boiler from an economic standpoint. In a previous report appears district heating and geothermal heat pump as the best options.

The aim of this report was to investigate the economy of passive houses. The work was focused on economy in total and on the economy of different components such as windows, insulation, heat exchanger and the air tightness of the climate shell. No attention was paid on the comfort factor or to the impacts on the environment.Two houses, aspiring to be passive were chosen; A big one and a small one. Hence, comparisons considering the size of the building have been possible to do as well.The comparisons were made by calculating ?break even? between two concepts; passive and BBR- concept.

This study examines the use of building modeling and energy simulations in the design process  of  a  building.  The  take-off  point  is  the  notion  of  energy  simulations  being needed early and throughout the building design process, and that the lack of energy simulations may be explained by the fact that they are time consuming and therefore often too expensive. A greater interoperability between software tools used by relevant disciplines,  such  as  the  architect  and  the  energy  specialist,  would  create  smoother workflows, which would reduce this cost and open up for more frequent and iterative energy  simulation  processes.  The  study  is  an  assessment  of  the  modeling  tool  Revit and  the  simulation  tool  Virtual  Environment  and  whether  they  can  create  smoother workflows, and make leeway for a more frequent use of energy simulations throughout the  design  process.  It  also  investigates  the  limitations  of  what  can  be  examined  by simulations in Virtual Environment. This will hopefully help clarify the future role of energy  simulations  in  design  processes.  The  method  is  a  trial  by  error  approach  of testing the two software tools by building and simulating a model. The results of these tests  show  that  the  workflow  is  not  optimal  (and  therefore  time  consuming)  for frequent  and  iterative simulations  throughout the  design  process,  but  it  also  reveals some  great  possibilities  of  what  can  be  performed  with  these  two  powerful  tools  at hand.  Further  development  with  regards  on  platform  independency  of  the  building information  model,  including  seamless  exporting  and  importing,  seems  necessary  to strengthen the future role of energy simulations..

This project was started within the Market-Design programme of Elforsk, with the aim of developing representative test systems of Swedish distribution networks. Using such test systems as a basis for reliability and customer interruption cost calculations makes it feasible to analyse the network tariff regulation of Swedish power  istribution companies. In particular, it enables studies of the incentives for companies to invest in system reliability. Until now, the available test systems are either not representative of Swedish conditions, or too small in scale and limited in function.Within this project we have created two test systems. In order to represent the diversity of actual Swedish distribution networks, we have created one test system for urban environments and another for rural environments.

Umeå Energi are working towards a goal, that in the year of 2018, they will be completely climate neutral. As a part of this, one target is to reduce their grid losses by 4 % of the 2012 level, which corresponds to an overall reduction of the grid losses of just over 1.7 GWh. In many residential areas, the distribution grid is designed and rated for electric heating as the heating in the houses. As many of the houses later has been converted to other types of heating, their electricity use has decreased and the total power output from many of the secondary substations has decreased significantly. Because of this, many of these stations today are well oversized, which in turn means that the energy losses in these stations are unnecessarily high.In this degree project, 25 secondary substations have been studied, all located in residential areas in and around central Umeå.

Sweden is a country that has made some progress in developing energy efficient solutions. The problem in Sweden is that many houses and apartment buildings are old and have inefficient ventilation- and heating systems. This energy is lost when systems are inefficient, which then results in huge economic costs. Luckily, more and more people are becoming aware of this, which means that Sweden is on track to become even better within energy efficiency.Energy use for the housing- and service sector amounts to 166 TWh of total use at 616 TWh. Without distribution and conversion losses, these figures show that the housing- and service sector accounts for almost 40 % of the country's total energy consumption.

This thesis investigated the possibilities to resume cultivation of an old manor house built of timber and what this would mean from an energy and moisture perspective. The building in this case study is named Sofiedals mansion and was built in 1858 in Valbo 11 kilometers west of Gävle.The structure of the house was documented and used as a starting-point for carrying out calculations focused on energy and moisture aspects. With the help of a number of computer programs and a conducted air tightness test, the buildings energy consumption were calculated and compared with the current building regulations.In addition, the building was analyzed considering energy retrofitting and what it meant for moisture problems. The energy retrofitting consisted of additional insulation, decreasing the buildings permeability through air sealing; window and door replacements. When a building is equipped with natural ventilation it is difficult to know its precise performance and how an energy retrofitting affects it.

AbstractThe purpose of project is to study the possibility for Borås Energy & Environment to build and run a commercial ethanol production facility in Borås. The project also studies the technology for the production of ethanol using renewable energy, e.g. lignocelluloses with focus on two processes, svag-syra hydrolyse and enzymatic hydrolyse. The technology of the process is based of hydrolysation of biomass (hemicelluloses and cellulose) to sugar and extract it to ethanol. These two techniques will compare with each other to determine which of them that it?s more suitable for ethanol production.

New technology makes it possible to remotely measure all consumers in a power network onan hourly basis and store the values in a database.This thesis work describes the conversion process between automatic meter reading systemMActor and calculation software Xpower.Then the possible differences between calculations of power networks using load curves incombination with a yearly estimate of consumption and calculations using hourly measuredvalues is examined.The result of the comparison shows that, for the power network under inspection, nosignificant difference could be noticed. This does not mean that calculations using hourlymeasured values would be unnecessary. I believe that in a near future calculations using hourmeasurements will be the primary choice for many power companies to whom technology isavailable.Also some basic calculations of fundamental power network parameters, such as power factorand loses, are presented using hourly measured distribution transformers in combinations withits hourly measured loads.The report is written in Swedish.

This thesis has been carried out on behalf of IV Produkt AB and intends to set an average ratio of thermal energy losses in apartment buildings that were built during the 1960-1990. This shall be derived by analyzing the total district energy consumption that has been divided into three parts: heat energy losses (the actual heating requirements), the heating of domestic hot water and heating energy consumption for the controlled ventilation.Three different residential areas that were built during the years 1962-1966 and one that was built in 1993 has been analyzed. All residential areas are located in Växjö urban and contains between four and six apartment buildings.The analyzed objects have a mechanical exhaust ventilation systems and district heating as the heating method. No own laboratory work or experiments have been done in this thesis, the calculations have been done on the basis of parameters from VEAB, interviews with property managers, and literature studies. By calculations, we have got a result that is reported in Chapter 6.

Self-driving cars are soon to become a reality to the commercial market. A self-driving car does not have a human operator, which enables some interesting characteristics. The main benefits are considered to be:The number of accidents and traffic jams should be reduced.Enhanced comfort.Energy usage could be decreased while capacity could be increased.This study concerns the causes for improved energy efficiency. The reason for improved energy efficiency is mainly because of the variation in terms of acceleration, braking and distance holding are reduced. The vehicles are more intelligent and can work together as a unity.

As a part of the fight against the global warming the energy production needs to be more efficient and redirected towards sustainable options. One alternative is cogeneration, which means that electricity and heat is produced in one plant. The purpose with this survey is to examine if there are any commercial available combined heat and power techniques, based on combustion of solid moist biomass, which are suitable to small-scale applications. The technique must be able to produce between 2 and 10 MW thermal and the heat demand is a Swedish district-heating system. When already published reports had been studied, the Organic Rankine Cycle (ORC) was chosen as the most suitable technique.

Hungary?s share of renewable energy in 2010 was 7.9 %, and their renewable energy goal for 2020 is 14.65 %. Geothermal energy is one option that could help to achieve the goal, since Hungary has favorable bedrock, the temperature gradient is above average and thepermeability is high. Today Hungary is importing just over half of its primary energy supply. Because of political conflicts between nations Hungary wants to expand its own production of energy.

This report is the result of a degree project in building engineering, at an advanced level. The project evaluated a building from a technical and historical point of view, and focused on its energy consumption, particularly the energy used for heating. The building in question was a small apartment building in Strömsholm, Sweden. It was made in 1902, from vertical logs, a not so common form of the traditional log house. The goal of the project was to evaluate if the energy consumption could be reduced in accordance with building preservation regulations, that is without damaging any of the building?s cultural or historical values.The building was surveyed with the help of archive and literature studies, interviews and inspections.

The purpose of this thesis is to identify power structures and instruments of power within the Jehovah?s witnesses and investigate how they affect the baptized youths baptized within the organization. The material consists of qualitative in-depth interviews and is analyzed with Foucault's theories of power. The results show that the participants have a very strict relationship to the rules of the congregation and also that they take great care in observing these rules carefully. It becomes evident that young members are exposed to disciplinary measures from the organization.