With new energy directives in place, the Swedish Social Service (SSS) stands beforethe challenge how to reduce the energy demand in its locales. It is a complex matter,as the locales are rented from various property owners and it becomes a question ofhow to reduce the operational electricity and influence the property owners to workmore with energy efficiency. This thesis takes a balanced research approach in threeparts. Firstly a qualitative part in form of interviews with personnel at the SSS and itsproperty owners, secondly a quantitative part of descriptive nature in form of energystatistics and thirdly a literature review of Energy Management (EM) Supply ChainManagement(SCM), Green Supply Chain Management(GSCM) and EnviromentalPerformance Indicators (EPI). This in order to be able to give normativerecommendations of how the SSS should act to reduce its energy consumption in itslocales and provide new insights on how EM, SCM, GSCM and EPI can be applied ineffect.

The Swedish Government has set a target to reduce energy consumption through energy efficiency within the construction and real estate sector. The purpose of the study is to examine how energy efficiency within this sector could affect the district heating volume in the future, on basis of Vattenfalls district heating system in Uppsala.An Excel model has been created to study how energy effficiency measures affects district heating demand in buildings by 2045, based on technical and economicalconditions. Furthermore, an interview study has been conducted to examine incentives for district heating customers to invest in energy efficiency measures.Result of the Excel model shows that the district heating volume of Vattenfall in 2045 is expected to 931 GWh, which corresponds to a volume decrease of 10,6 %. Based on the study?s theoretical framework only 15 %, 1 024 GWh, of the technical-economical potential is assumed to be implemented.

Since energy simulations are used to verify that projected residential buildings will reach the current energy requirements it is important that the results are reliable.This report investigates the extent of uncertainty in energy simulations, estimates the causes of the uncertainty and its economic and environmental consequences.The method used in this report is based on three validation methods; empirical validation, analytical validation and comparative validation. The analysis was carried out for five multi-family dwellings in Uppsala with installed meters for energy measurements. One of these objects, Klockarlunden, was studied in more detail than the others.The results show that the deviations are between 10 and 29% for the studied objects, which means that the uncertainty is estimated to be at least 29%. All simulations underestimate the buildings need of energy. The simulation for Klockarlunden can predict the energy consumption to be within the range of 46-98 kWh/m2year with 90% confidence level based on the current uncertainty.

Climate change is the modern society?s common issue. The developed countries areconsuming more than what is sustainable, and the climate change due to the use offossil fuels can be seen clearly. EU has specified goals, in order to stop furtherdamage, which demand that every member state have to reduce its energyconsumption by 20 % before 2020 and 50 % before 2050, relative to 1995.The Swedish government uses a number of instruments to encourage reduction in theusage of energy, but every individual has to contribute to reach the goals.With increasing energy price the cost of living is going up. A lot of people are lookingfor ways to save energy and not be affected as much by the increasing price.Investments for insulation, replacement of windows and replacing old heating systemfor a new efficient heat pump is getting more and more common.This thesis is about investigating the possibilities in becoming independent from buyingenergy for households.

In Sweden the residential and commercial sector is a major user of energy, why the Swedish government has set a specific goal to half the energy usage in buildings by 2050, compared to 1995. The Swedish Energy Agency has therefore started the campaign ?Halvera Mera? to encourage demonstration projects that will show how to renovate in an energy efficient way, and in doing so prove that it is possible to reduce a building?s energy usage by half and still make a profit. These projects are intended to serve as good examples and give inspiration to residential owners to perform energy efficient renovations. To make sure that these projects serve their purpose, it is important to know what will inspire and what will impede a residential owner to invest in energy efficiency improvements.

The European Council agreed in 2008 on a climate and energy package to combat global warming. This package is valid for each EU member country and means that greenhouse gas emissions must fall by at least 20% and the EU's energy use to 20%, consisting of Renewable Energy in 2020. The Swedish Government has set stringent climate and energy with the intention to set an example for the rest of Europe. For example, renewable energy sources account for at least 50% of energy use and our climate emissions to fall by 40% by 2020. A combination of these goals and a steadily rising oil price has led to an increased demand for wood fuel in the form of such branches and tops.

The purpose of this master thesis is to investigate different types of measures for making buildings more energy efficient and to estimate their profitability. The calculations were performed with the building simulation program VIP+ and the evaluation of the profitability with the life cycle cost method. Furthermore, it was examined how losses in the distribution of secondary systems of district heating can be avoided. Options to replace district heating with a local district heating system based on bio-energy have been investigated. The possibilities of achieving more efficient thermal energy consumption and production for the chosen estate were also examined.The object of the study has been a residential estate with 133 detached houses in Uppsala, built in 1974.

AbstractThe purpose of project is to study the possibility for Borås Energy & Environment to build and run a commercial ethanol production facility in Borås. The project also studies the technology for the production of ethanol using renewable energy, e.g. lignocelluloses with focus on two processes, svag-syra hydrolyse and enzymatic hydrolyse. The technology of the process is based of hydrolysation of biomass (hemicelluloses and cellulose) to sugar and extract it to ethanol. These two techniques will compare with each other to determine which of them that it?s more suitable for ethanol production.

Design of a house requires knowledge of both technology and economics. Heating and ventilation shall be designed, costs are calculated and estimated and requirements must be fulfilled. Which heating system is to be elected is also a difficult choice, especially with rising energy prices as a factor.The choice of energy system is not always given, because it depends on several factors. Below is a comparison between district heating, geothermal heat pump and electric boiler from an economic standpoint. In a previous report appears district heating and geothermal heat pump as the best options.

This study examines the use of building modeling and energy simulations in the design process  of  a  building.  The  take-off  point  is  the  notion  of  energy  simulations  being needed early and throughout the building design process, and that the lack of energy simulations may be explained by the fact that they are time consuming and therefore often too expensive. A greater interoperability between software tools used by relevant disciplines,  such  as  the  architect  and  the  energy  specialist,  would  create  smoother workflows, which would reduce this cost and open up for more frequent and iterative energy  simulation  processes.  The  study  is  an  assessment  of  the  modeling  tool  Revit and  the  simulation  tool  Virtual  Environment  and  whether  they  can  create  smoother workflows, and make leeway for a more frequent use of energy simulations throughout the  design  process.  It  also  investigates  the  limitations  of  what  can  be  examined  by simulations in Virtual Environment. This will hopefully help clarify the future role of energy  simulations  in  design  processes.  The  method  is  a  trial  by  error  approach  of testing the two software tools by building and simulating a model. The results of these tests  show  that  the  workflow  is  not  optimal  (and  therefore  time  consuming)  for frequent  and  iterative simulations  throughout the  design  process,  but  it  also  reveals some  great  possibilities  of  what  can  be  performed  with  these  two  powerful  tools  at hand.  Further  development  with  regards  on  platform  independency  of  the  building information  model,  including  seamless  exporting  and  importing,  seems  necessary  to strengthen the future role of energy simulations..

Oxygen consumption and carbon dioxide production are usual measurements within the sports and training physiology. The same measurements are also common when it comes to establish the amount of energy that is used during work and to establish the intensity of work. The volume of oxygen that is consumed contra the volume of carbon dioxide that is produced can be used to calculate the metabolic rate within the human body. This calculation shows the percent relationship between carbohydrates and fat in the metabolism. The first accurate method to measure the breathing gases for use in metabolic calculation was established in the early twenty century when the Douglas bag method was introduced.

This thesis investigated the possibilities to resume cultivation of an old manor house built of timber and what this would mean from an energy and moisture perspective. The building in this case study is named Sofiedals mansion and was built in 1858 in Valbo 11 kilometers west of Gävle.The structure of the house was documented and used as a starting-point for carrying out calculations focused on energy and moisture aspects. With the help of a number of computer programs and a conducted air tightness test, the buildings energy consumption were calculated and compared with the current building regulations.In addition, the building was analyzed considering energy retrofitting and what it meant for moisture problems. The energy retrofitting consisted of additional insulation, decreasing the buildings permeability through air sealing; window and door replacements. When a building is equipped with natural ventilation it is difficult to know its precise performance and how an energy retrofitting affects it.

Increased resource efficiency in an energy system could result in large economic and environmental benefits. Tekniska verken i Linköping AB (Tekniska verken) is responsible for the district heating network in Linköping. Their vision is to create the world?s most resource efficient region. An important step towards this vision is more efficient usage of produced heat, something which could be achieved through integration of a seasonal heat storage in the energy system.

Problems with the current energy system, which partially relies on non-renewable fuels, are increasingly recognized. Emissions of greenhouse gases from fossil fuels may speed up global warming, which in turn leads to a number of negative consequences. Nuclear energy is risky and relies on consumption of a scarce resource. This leads to a demand of renewable energy that is also economically feasible. One possible renewable source of energy is solar energy.

This thesis has been carried out on behalf of IV Produkt AB and intends to set an average ratio of thermal energy losses in apartment buildings that were built during the 1960-1990. This shall be derived by analyzing the total district energy consumption that has been divided into three parts: heat energy losses (the actual heating requirements), the heating of domestic hot water and heating energy consumption for the controlled ventilation.Three different residential areas that were built during the years 1962-1966 and one that was built in 1993 has been analyzed. All residential areas are located in Växjö urban and contains between four and six apartment buildings.The analyzed objects have a mechanical exhaust ventilation systems and district heating as the heating method. No own laboratory work or experiments have been done in this thesis, the calculations have been done on the basis of parameters from VEAB, interviews with property managers, and literature studies. By calculations, we have got a result that is reported in Chapter 6.