In order to reach the environmental targets, set up by the EU, there are many measures taken to make Sweden more energy efficient. In the housing and real estate sector, an installation of an exhaust air heat pump that reuses the heat in the exhaust air in order to lower the amount of acquired energy, is an example of such an action. The recovered energy can then be used for heating of radiators and tap water. This report aims to evaluate and compare three different systems using exhaust air heat pumps regarding COP, degree of coverage and cost savings. This study was delimited to only account for apartment buildings.The theory chapter describes the different conditions and factors that affect a building?s energy balance.

Future emission legislation puts great emphasis on increasing the efficiency of the engine, thereby reducing fuel consumption. The tribological contact between cylinder liner and piston ring is where an great amount of energy is lost due to friction, and by reducing these losses an reduction in fuel consumption can be achieved.The aim of this thesis was to evaluate the tested piston ring coatings against a plasma sprayed cylinder liner and rank these combinations of materials for friction and wear resistance. The coatings that were tested was Cr + Al2O3, (Al,Cr)N, two types of CrN and WC / C.The experimental tests were performed with a so-called pin-plate, where used oil with addition of an acidic mixture of sulfuric and nitric acid to mimic the acidic condensate formed when exhausts recirculate, were added with a continuous flow. The results were then analyzed by weighing, studies by optical microscopy and scanning electron microscopy (SEM) and profile measurements.The results from each material combination were that the plasma coated cylinder liner wears too aggressively in order to yield a ranking of the piston ring coatings based on the parameters of friction and wear resistance. It is therefore proposed that an alternative coating on the cylinder liner should be developed, lacking the large abrasive wear on piston rings and that can withstand the corrosive environment resulting in engines equipped with EGR.

This report is a study in voltagelevel in connection with regeneration of brake energy from the tramtype M31 in Gothenburg.In the act of braking, the tram M31 uses electrical braking where the electrical motors generates energy and if possible send it back to the overheadline, where other trams in the nearby can use this regenerated energy for its own driving force. In cases where no other energyconsumers are located in the same section, there is a resistance witch task is to convert this energy into heat. The regulation of this resistance appears to cause an increase in the voltagelevel into far too high levels.Investigations of the trams regulationequipment and its construction have been done. Further have measurements on the overheadline been performed in order to map the voltagevariations during a longer period of time.The result have been showing that the voltagelevel during regeneration often is as high as 880V-920V, more extreme values have not been observed in a large scale. The values are especially high compared to the nominal voltagelevel.

This diploma work has been carried out in collaboration with the building contractor Sh Bygg Fastighetsutveckling AB in Uppsala with the intention to investigate how the height of a building affects various energy aspects such as transmission losses, infiltration, and the specific energy usage. Three different reference objects have been studied. The reference objects have been simulated for four different heights in the calculation program VIP-Energy.The results show that an increase in floor number can lead to both advantages and disadvantages. As the number of floors increases, transmission losses per square meter floor area decreases. However, as the height of the building increases, the reduction rate decreases.

In order to accomplish that a construction is correctly built, it is critical to obtain a well functioning control mechanism throughout the project. The way to enable this is not by having an independent inspector constantly at your side. Today it is praxis to use check lists and have people responsible of quality to make sure that these are followed. This is where discretionary inspections play their part. These among others are documents needed to com-plete the check list.

The purpose of this study was to investigate the association between physical activity and perceived stress, energy and musculoskeletal disorders among office-workers and warehouse-workers and also to see if there were any differences depending on work-place and gender. The method that was used to collect data was three different validated questionnaires that measured stress and energy (the Stress-Energy questionnaire), musculoskeletal disorders (intensity and localization of pain, a Pain Drawing questionnaire with a VAS-scale) and physical activity (IPAQ ? the short version). Eighty-eight workers participated in the study. Forty-seven of them were office-workers and forty-one were warehouse-workers.

This project investigated the current market regarding wireless net and the communication between the tools used for diagnostics/maintenance and an embedded system. Based on documentation obtained through interviews a demo system was created based on Bluetooth Low Energy (BLE) communication between an embedded system and an Android device.This report intends to describe the tools and methods used in the design of the demo system and the result of an analysis of the BLE communication.Bluetooth Low Energy is an exciting protocol with wide applicability within the industrial field. This project investigated the communicational possibilities between a Smartphone and a Raspberry Pi and based on the results that emerged the conclusion can be drawn that BLE is a protocol with many beneficial applications within industrial IT..

The study was conducted at a business in the social service. The purpose was to examine how the business works with human resource planning. In order to answer the purpose two questions was formulated, which human resource planning strategy does the business use? And, how do businesses need to act according to the theory of strategic manpower to achieve human resource planning? Survey data collection was done through a qualitative research design, where interviews with five employees in the business took place.The study shows that the business is using a own made strategy in order to achieve human resource planning. The strategy consists of two steps, in step one they do an background analysis and step two a needs analysis where a goal- and responsibility description are designed and then a set of requirements.

The purpose of this master thesis is to investigate how nearby forests affect the energy production in wind turbines. To reach the purpose a case study is performed on three wind turbines sited on a field in a north-south line at Andersfält in the municipality of Halmstad, Sweden. Approximately 100 meters south of the southern wind turbine a forest is situated. The case study is divided into three sub studies where the difference in energy production, the affect of the forest and a wind meteorology model, WAsP, is studied. The result show that the forest have a significant influence and that the WAsP-model gives an incorrect result of the energy production in wind turbines sited near a forest..

På uppdrag av Sweco Systems i Umeå har detta examensarbete utförts under våren 2013. Syftet var att undersöka huruvida något av de energiberäknings-program som används på företaget kan anses vara lämpligt vid energikartläggningar av befintliga fastigheter.Inledningsvis utfördes en energikartläggning av fastigheten Odin 12 i Umeå, som i huvudsak utgörs av gallerian MVG. Med resultaten från denna energikartläggning som grund beräknades därefter fastighetens energianvändning i två olika program ? VIP-Energy och IDA Indoor Climate and Energy.Resultaten från den inledande kartläggningen visar att fastigheten har ett lågt behov av fjärrvärme, vilket förklaras av fastighetens höga elförbrukning. Den stora användningen av el genererar stora mängder internvärme som, förutom att sänka fjärrvärmebehovet, även medför att fastigheten under hela året har ett kylbehov.Utvärderingen av de två beräkningsprogrammen visar att VIP-Energy är ett lämpligt program att använda vid energikartläggningar.

Our study illustrates the nature and characteristics of the virtual world Second Life. We have identified that the online community aims to satisfy hedonistic needs through social and conspicuous consumption, for online use only, concentrating on socially accepted identity construction..

An energy study has been performed on two blocks in an area called Gävle Strand. The buildings are owned by a tenant-owner?s association called brf Carolina and were built by the company Skanska 2008. The builder as well as brf Carolina are pussled by the fact that electricity use is higher than expected while heating is less. Skanska is also very interested in finding out how much heat recovery from stale exhaust air through a geo-thermal heat pump is contributing to the general heating requirement and energy balance in four out of the ten buildings located on the properties.To find possible answers to the higher electricity use a literature survey on user behaviour was conducted.

The purpose of this study was to investigate the association between physical activity and perceived stress, energy and musculoskeletal disorders among office-workers and warehouse-workers and also to see if there were any differences depending on work-place and gender. The method that was used to collect data was three different validated questionnaires that measured stress and energy (the Stress-Energy questionnaire), musculoskeletal disorders (intensity and localization of pain, a Pain Drawing questionnaire with a VAS-scale) and physical activity (IPAQ ? the short version). Eighty-eight workers participated in the study. Forty-seven of them were office-workers and forty-one were warehouse-workers.

The incineration of waste is steadily increasing in Sweden and so is the production of ashes. The bottom ash has for many years been used as construction material in landfills. Now many of the nation's landfills are closed and there is a great need to find another beneficial use for the ash. Bottom ash is a gravel-like material and with its material properties it can replace natural gravel in parts of roads and surface constructions. Today this use is only approved within landfill areas where leachate is collected and checked.

This report is a study in voltagelevel in connection with regeneration of brake energy from the tramtype M31 in Gothenburg.In the act of braking, the tram M31 uses electrical braking where the electrical motors generates energy and if possible send it back to the overheadline, where other trams in the nearby can use this regenerated energy for its own driving force. In cases where no other energyconsumers are located in the same section, there is a resistance witch task is to convert this energy into heat. The regulation of this resistance appears to cause an increase in the voltagelevel into far too high levels.Investigations of the trams regulationequipment and its construction have been done. Further have measurements on the overheadline been performed in order to map the voltagevariations during a longer period of time.The result have been showing that the voltagelevel during regeneration often is as high as 880V-920V, more extreme values have not been observed in a large scale. The values are especially high compared to the nominal voltagelevel.