In this thesis a possible cost effective runner change of some of the units in the hydroelectric power station Olidan is investigated. The possibility to drive a unit at the same efficiency point through a change of the turbine shaft speed and the rate of discharge is tested. Furthermore the theories behind model testing, determination of efficiency increase from model to prototype and efficiency measurements shall be discussed and analyzed with Olidan as a starting point.A predicted curve has been built on information from model tests and field measurements on the existing runners and runner data from the test of the new model. The predicted curve shows the difference in efficiency between an existing runner and a modern one. It is the difference in efficiency that is used in the calculations that are to show whether changing to a pair of new runners will be cost effective or not.

The objective of this M. Eng. Diploma work was to validate the new version, CASMO-5M, and compare the results with CASMO-4E, by using the same input in both programs. The tasks that were included in this work was to compare TIP-measures, k-effective curves (warm), k-effective curves (cold), the effect of void on k-effective, the isothermal temperature coefficient (ITC), the moderator temperature coefficient (MTC), damping ratio calculations, internal effect in a fuel bundle of a BA-rod, the speed of BA-out burn, impact of xenon, falling control rod, margins and isotopes.The TIP-measures showed that the differences were small for all reactors, at most, 6% nodal improvement by C5M (Casmo-5M) for Oskarshamn 3. The warm measurements of k-effective showed that C5M had a higher value for all cycles of Oskarshamn 1, 2 and 3 in comparison to C4E (Casmo-4E).

This study explores the different effects on attitude and behaviour three frequently used advertising techniques have. The techniques compared are social influence and egoistic and altruistic benefit-appeals. The results showed that ads featuring social influence had statistically significant higher mean values regarding attitude towards the ad compared to both the other ads, and significantly higher mean values regarding brand attitude compared to the ad appealing to egoistic motivations. Though, all advertising effectiveness measures used in this study - that is, attitude and intention variables - indicated that social influence was more effective than the other advertising messages. Thus, in accord with earlier studies, it can be stated with confidence that social influence is an effective tool to use in marketing communications..

In sectors with high skill requirements, recruiting is a core part of a company's development. Initially, the companies attract talented employees by creating an interest in the organization. Further, the challenge remains to match potential workers expectations with the company?s requirements and conditions. This is crucial since an unsuccessful recruitment involves high costs.

The purpose of this study is to investigate the reading methods that pedagogues, active in classes 1-3, use in the first stage of learning to read and how they consider their own choices of methods. In the theoretical background I sort out the basic differences between synthetic and analytic methods of acquiring the skills of reading. The analytic reading method means that the skills of reading starts with the complete text in order to later analyze the parts of the text. The synthetic method approach is based on a reading method where the parts are linked as a whole. The two methods are considered antipodes but can also be looked upon as complements in the current governing documents.

The purpose with our study is to investigate in which way a public field of action has succeeded to make the economic management more effective and also find out which factors/activities that have contributed to get the result of the budget in balance. We also want to find out in which degree the balanced scorecard (BSC) has contributed to the positive result of the budget. Method: We had started out from the qualitative method theory which is based on the hermeneutic theory, because we will interpret and understand. With this starting point we have chosen to use a case study with semi-standardised interviews supplemented with information from different documents, and to get the theoretic connection we have studied literature in the subject field. The analyse and even the theoretic connection have then started from, for this study, a special analyse model. Results: Througt systematic and target-concentrated management and through cooperated factors, with stress on a leadership that is both professional, visionary and un-combined, and there the staff´s is seen as a important resource, and there it is a clear strategy and objective to keep the cost of the activity within assigned budgetframe, has a public field of action, as the clinic of hab./rehab.

In cooperate with Asko Cylinda we have developed a new heat system too short the processtime and reduce the energy consume in a dishwasher and still have it too be a class AAA.The environment and quality is important for the company too still be the number one onthe market, If they want too keep that position the product developed of new innovations willbe very important. The systems we have developed are more effective and reduce energy uptoo 25 %. The process time is reduced too less than two hours, from the today two andhalf-hour. The solutions are too heat up the rinse water and the dishwater at the same time,with a new heating system and it make are solutions unique and effective. Its good for thedish and the environment.

This essay talks about how teachers in schools are working with a particular focus on students with autistic syndrome. The aim is to investigate the methods used for these students, who develop their learning and achieve the goals of the school. The methods that were used in this study were two interviews in two different schools in central Sweden where teachers and professionals were interviewed. One part of the study was to compare both schools to see which methods they used and when they used them. My interest for autistic students started during my practice in a school.

This major project in Building Engineering has its focus on inquiring into what methods has been used in the planning process of the residential buildingLjusbojen 1. This project has been conducted in cooperation with Kadesjös Ingenjörsbyrå AB, an engineering contractor firm which also acts as the property developer. Initially several different general methods for planning residential buildings have been presented. After the methods from the process of building Ljusbojen 1 has been analyzed compared to the general methods presented in part 1. This shows what the determining factors are during the planning process; factors such as cost, quality, time management, know-how and environmental issues.

Abstract The purpose of writing this thesis was to improve methods during requirements engineering phase. Usercentred system engineering has some problem areas, which are examined and verified to create a new guideline for developers. This guideline tends to make requirements engineering more effective and help developers create more concrete requirements. It is not uncommon that system development projects ends up with unsatisfied users or delay in deliveries. The reasons are different kinds of communication problems between users and developers during verification of requirements. There is a therapy model, called solution-focused therapy, used in family and individual therapy. The model focuses on solutions for the future instead of problems in the past.

Efficient numerical methods for option pricing is an active field of research. This project has the goal to examine possible ways to improve an established method of numerical pricing. The method is based on an adaptive finite difference method in price and uses the backwards differentiation formula of order 2, BDF2, in time. The project will focus on improvements to the time integration through implementation of discontinuous Galerkin methods, dG. Empirical convergence and accuracy results are obtained for equidistant dG-methods up to order 3 and performance is compared to BDF2.

This thesis compares four relevance feedback methods. The Rocchio and Ide dec-hi algorithms for the vector space model and the binary independence model and Okapi BM25 within the probabilistic framework. This is done in a custom-made Information Retrieval system utilizing a collection containing 131 896 LA-Times articles which is part of the TREC ad-hoc collection. The methods are compared on two grounds, using only the relevance information from the 20 highest ranked documents from an initial search and also by using all available relevance information. Although a significant effect of choice of method could be found on the first ground, post-hoc analysis could not determine any statistically significant differences between the methods where Rocchio, Ide dec-hi and Okapi BM25 performed equivalent.

The chief aim of this study is to investigate the impact of context on written peer response. A second aim is to explore students? attitudes towards peer response. The investigation has taken place at an upper secondary school in the south-east of Sweden, involving 20 students in grade 2 and 3 in the course Swedish C. The investigation is based on the students? comments on their peers? speech drafts and six qualitative interviews.

Shear Strength and Deformation Characteristics of Uppsala Clay with CRS and Standard OedometerTyra Morell Bonin & Magdalena MählerTo see how much a clay compact under different pressure one can use several different methods and in this project, two methods were used, the Standard Oedometer and a CRS apparatus. A Standard Oedometer is a full-time manual device and the CRS apparatus is a modern electric and automatic device. The aim of the project was to see similarities and differences between the two methods and examine which method that were most reliable. This has been done with repeated laboratory tests and afterward evaluations. With this information one can get a picture of how the clay will behave and how it will deform in nature.

The aim of this study was to in laboratory experiments investigate how addition of urea, ECOX and structural materials can optimize sanitization during composting of sewage sludge. Today we strive for a sustainable society and the importance of closing the nutrient loop increases. It has therefore become even more important to safely reuse plant nutrients from human excreta to agricultural land. Partly because it increases the sustainability of society as the world's supply of many nutrients are finite, partly because it promotes human health, both by reducing disease transmission and by increasing Agricultural production. An untapped resource such as sewage sludge that is rich in nutrients and humus-forming materials could replace parts of the commercial fertilizers used in Sweden today. owever, sewage sludge contains undesirable substances such as heavy metals and drug residues, and pathogenic microorganisms.