The cost of forwarding corresponds to about one tenth of the forestry industries raw material cost. This gives a motive to do good follow-ups to get a good overview of the forwarding distance and, thus, enable improvements. Follow-ups are also justified by the possibility to make more accurate calculations of the harvesting costs, if better estimations of forwarding distance are achieved. Today (2009) Stora Enso has GPS and vehicle-computers in most of their forwarders. These are used mainly for the forwarder to follow the tracks of the harvester and for the planning leader to see how the forwarder has been driving within the stand.

This master?s degree project concerns the combination of a multi dwelling passive house with solar energy for the generation of electricity and domestic hot water (DHW). Different alternatives with either solar thermal systems or photovoltaic (PV) systems are compared with two reference alternatives producing DHW from electricity or district heating. The economical comparison uses a life cycle cost (LCC) perspective based on the present value of expenditures for investment, energy and annual operating and maintenance.The energy yields from the solar energy systems were calculated by hand and with simulation software. Calculation and dimensioning of PV systems were carried out with a software called PVSYST.

The society of today is largely dependent on electricity and the dependence does not show any signs of declining. Reliability of supply will become increasingly important in the future and it is therefore important to investigate factors affecting the failure rates in electrical components.Sweden was hit by several severe storms during the 00?s. As a result of this many overhead lines in forests were cablified. In urban areas underground cable systems have been the norm for many years.

Det här kandidatarbetet undersöker hur Physically based rendering kan påverkar en 3D-grafikers arbete. Målet är att skapa förståelse kring physically based rendering och hur denna tekniken kan komma att påverkar en 3D-grafikers arbete. För att undersöka problemområdet skapades en virtuell miljö i 3D med hjälp av physically based rendering. Arbetsupplevelsen jämfördes senare med det tidigare arbetssättet. Undersökningen beskriver tidigare arbetsätt och hur arbetet har ändrats med physically based rendering.

In 2010, Airwatergreen AB started testing their new technology, the Airwaterwell, an atmospherical water generator of their own design that is running on solar heat, with a production capacity of three litres of water per day and m2. The purpose was to focus on foreign aid organizations as main purchasers for project investments towards rural communities in developing countries that suffer from lack of, or compromised quality of drinking water. In order to further understand if this technology would bring a positive impact in the developing countries, the company contacted the Swedish University of Agriculture for a socio-economic study of the Airwaterwells? potential. The authors elected Cost benefit analysis as the appropriate method for conducting the study and India became the study region because of its many problems with water related issues such as diseases as well as insufficient water supply for households. The regions that this study is based on are Gujarat, Haryana and Uttar Pradesh given their differences in income, health situation and poverty rate.

AbstractThe purpose of project is to study the possibility for Borås Energy & Environment to build and run a commercial ethanol production facility in Borås. The project also studies the technology for the production of ethanol using renewable energy, e.g. lignocelluloses with focus on two processes, svag-syra hydrolyse and enzymatic hydrolyse. The technology of the process is based of hydrolysation of biomass (hemicelluloses and cellulose) to sugar and extract it to ethanol. These two techniques will compare with each other to determine which of them that it?s more suitable for ethanol production.

The increasing road traffic in Sweden will require investments in the infrastructure that the tax withdrawal of today will not allow according to a new government report, SOU 2006:33. An existing willingness to pay for those investments has therefore become an alternative to increases in taxation to be able to cover the costs. A proposal to let the willingness to pay, alternatively increases in taxation that act proportional, decide how a cost is distributed can be said to be related, but not fully correspond, with different theories of justice described by Robert Nozick and John Rawls. It can therefore be interesting to see how the two different theories of justice are edified and how they distribute a joint cost. The aim of the first part of the thesis is to present and criticize Rawls' and Nozick's theories of justice in a common formulated economic model.

Purpose: We will understand and explain Dell?s value gap through an extended intellectual capital theory. This will be done by deriving the value to the different parts of the intellectual capital value scheme. We will also use value scheme to describe the ongoing strategy shift. Methodology: The qualitative method and an abductive reasoning have been employed during the progress.

The aim with this study was to investigate the effects a change of manufacturing process would have on the mechanical properties of drill bits made of a WC/Co composite used for stone cutting. The method used today is sintering, where the material is heated in a conventional sintering oven. The other method was microwave sintering, where the material is heated by radiation in the microwave region. Also an investigation of the manufacturing cost were made.The main difference between the two heating methods is that the conventional way is a rather slow process and the microwave method is very fast. The material is also heated homogeniously in the method with mirowaves, aposed to the case with the conventional sintering where the material is heated from the outside in.This makes the material harder and more wear resistent.

Sustainability reports have during the last decade had a strong development. Both in terms of establishing a sustainability assurance, in its form, and get it assured together with standards, principles and regulations which organisations and accountants have utilized. The growth of sustainability reports and the choice of getting them assured have in particular favoured the accounting business. Due to this result, some critics have voiced that assuring a sustainability report gain accounting firms more than it gains the actual organisation. Other say that it is necessary in order to increase the credibility and the eligibility of the report, while it also has become a requirement from stakeholders.

The public sector in Sweden outsources its core business to a very large extent, whileinsisting on running its IT operations internally in a traditional way. IT as a service ingeneral and cloud computing in particular has become incredibly popular in recentyears, offering cost efficiency and greater ability for the business to concentrate on itscore activities, which is why it should be a promising alternative to the traditional wayof running IT internally. To achieve an understanding of why IT as a service has yetto take off in the public sector, a study of its use of IT/IS, what the effect of IT as aservice is, and the opportunities and challenges that cloud computing represents, isnecessary.The study, which was conducted using a qualitative hermeneutic approach, was initiatedby a literature review, followed by six in-depth interviews with five respondents,all of which hold many years of experience in the area. The outcome of the interviewsindicated that IT as a service should represent a promising and feasible way of reachinghigher levels of cost control, and a greater focus on core activities. Furthermore,the results indicated that Swedish legislation along with a high level of businesscomplexitymight be reasons for the low amount of IT as a service in the public sector.Through careful analysis and examination of the business? current situation, as well ascomprehensive knowledge of Swedish legislation with regards to the implications ofLagen om offentlig upphandling, the public sector can avoid IT as a service becomingmore expensive and more complicated than necessary, and achieve cost efficiencyalong with a greater focus on its core activities through it.Future research could examine the possibility of a framework for the integration ofcloud services within the public sector?s IT/IS environment, and whether there is aspecific size of a cloud implementation at which it?s more cost efficient to go withtraditional IT operations..

Industrial buildings are increasing all over Sweden. Farmers are building new modern facilities and the government chooses to build new halls to invest i youth sports. Glulam is the most common framework but there are limitations because of the transport. Therefore, there is a need to develop new solutions to increase the use of glulam.The maximum torque in the eaves was found in the frame with a roof pitch of 18 degrees and a wingspan of 25 meters. Using hand calculations according to Eurocode and comparison with the computer software StatCon, the maximum torque, shear force and utilization rate is calculated.

This thesis analyses the prerequisites, profitability and competitiveness of eucalyptus plantation on the Iberian Peninsula and in Brazil. The thesis has a macro perspective and analyses a typical hectare of eucalyptus in each studied region. A survey methodology was used as a strategy to cover a broad perspective using expert respondents. The regions studied on the Iberian Peninsula were the ones found suitable for eucalyptus plantations from an economic point of view. The studied regions were Huelva in the South West of Spain, Galicia in the North West of Spain and Portugal.

The economic prerequisite to many farmers in Sweden after the EU membership and the new agriculture policy has generated large demands on the farm management. Until year 2004 you got a grant based on what you had produced and not on consumer demand. In 2005 a new economic aid (Mid Term Revue) was introduced and the conditions has changed again. Due to this I have chosen to do a cost-benefit analysis on a case, to investigate if the present production is sustainable in the future. My conclusion is that the profitability is acceptable even if the farm has a high debt. But to make the production more profitable the products produced should be refined as much as possible at the farm, to get maximum economic return.

AbstractThe dependency of fossil fuels in the transport sector causes large emissions of carbondioxide. This problem can we reduce by using vehicle gas from digested solid manure and leftover of pasture. I have studied the potential for this in the county of Västernorrland. Thepurpose is to investigate how much vehicle gas that can be extracted.One central, large scale digestion and upgrade plant should be placed in Härnösand. Theamount of pasture and manure that is economical and practical available is enough to produce2,7-3,5 millions Nm3 vehicle gas.