Abstrakt Social Engineering är konsten att manipulera människor, för att på så sätt vinna deras förtroende. Med hjälp av detta förtroende kan attackeraren sedan kringgå säkerhetssystem och få tillgång till organisationers information. Vi har i denna uppsats genomfört elva intervjuer på tre stora organisationer med både IT-chefer och övrig personal. Med dessa intervjuer har vi sedan försökt få en bild av hur medvetenheten ser ut samt vilka åtgärder organisationerna tar för att förhindra Social Engineering. Med denna uppsats vill vi belysa den ovisshet som råder kring Social Engineering, men även farorna och hur effektiv en attack av denna typ kan vara.

The aim of this study is to find a method to incorporate the energydemand of a building in the investment cost estimate.The study is based on an actual apartment block. The significant energyaspects are identified, and changed to more energy efficient options.These are then simulated using the energy calculation program VIP+.The calculated energy need is used in the investment cost estimate, andthe simulated alternatives are compared in regards to their economicalprofitability.Depending on the focus, different alternatives are the most advantageous.Since this study aims to show which alternative is the mosteconomically profitable, the annual profit is the parameter of mostimportance. This means that individual measuring of heating and hotwater use is the recommended change of the original house. A changeof the windows to new ones with a U-value of 1,0 as well as 0,8W/m2K also results in a positive change of the annual profit comparedto the original house..

The purpose with this study is to compare different systems of grain storage from a financial point of view. Grain that is supposed to be fed to laying hens. The systems that were compared were different airtight storage of grain and a system of conventional storage. To make this case study I choose to compare four different systems. In the case study there was one system with bin drying of the grain, two systems with airtight storage of the grain and one system where you buy dried grain during the season. I made several of capital investment appraisal where I found the cost of each system, then I took the cost and divided it with the total grain use and calculated the cost for each kilogram of grain, and also the cost of the feed. Then I compared the cost from my case study with the cost of buying feed. All the systems except for one, gave a lower cost for the hen feed than buying feed from a dealer The best system, witch were bin drying lower the cost with about 80 000:- SEK.

Användning av mjukvaruverktyg när reverse engineering utförs är ett måste för att få ett användbart resultat enligt Hainaut (2002). Kudrass m fl (1997) visar på brister som kan uppstå när mjukvaruverktyg används. Gemensamt för de forskare som har studerats i detta arbete är att de hävdar att företag saknar kunskap för att utföra reverse engineering med mjukvaruverktyg. Har forskarna rätt i att det saknas kunskap eller har företagen mer kunskap än vad forskarna tror? Då dessa forskare har en klar koppling till tillverkning av mjukvaruverktyg så är eventuellt inte deras påstående opartiska och därför är det intressant att se om deras påstående stämmer med verkligheten.

The Income Tax Act is enacted what criteria must be met to obtain a tax reduction of household work. Household work is the common term for ROT- and RUT-works. The purpose of the tax reduction is to increase job opportunities and to discourage that undocumented work performs.It is only for the labor cost as tax reduction is given for. The concept of labor cost is defined in law as it is not comprised of cost of materials, equipment or travel. The preliminary work provides no closer explanation what the labor cost includes.

After the deregulation of the Swedish pharmacy market customers can be lost due to stock-outs. Optimization of pharmacy inventory levels has thus become increasingly important. To minimize inventory costs while considering the cost of shortages the latter must be estimated. However, the shortage cost is very difficult to compute. Thus, the aim of this paper is to estimate the pharmacy-specific shortage cost parameter and its relation to other inventory costs.

Previous research has discussed how voluntary disclosure relates to the cost of equity capital. Theories of estimation risk support a negative association between disclosure and cost of equity capital, as empirically documented by Botosan (1997) among others. In this Bachelor thesis we investigate whether such a relationship exists on the Swedish capital market. Using the CAPM to estimate the cost of equity capital and a disclosure index based on Aktiespararen?s annual evaluation of corporate disclosure, we test a model where disclosure explains cost of equity capital.

Denna uppsats har som syfte att klargöra hur långt det är tillåtet att med reverse engineering experimentera med en patentskyddad uppfinning innan patentintrång föreligger. Främst förs en diskussion om hur långt det är tillåtet att experimenteramed en patentskyddad uppfinning, utifrån patentlagens experimentundantag, utan att kränka ensamrätten som patentet ger. För att svara på denna fråga börjar diskussionen ur ett svenskt perspektiv i den svenska patentlagen, med ett instick ilagen om skydd för företagshemligheter. Diskussionen förs sedan ut i Europa för att se hur bedömningen av reverse engineering och experimentundantaget gjorts där och till sist vänds blicken mot USA. Bedömningen som görs är att reverse engineering ges ganska fria händer så länge målet för processen är att finna ny kunskap utöver den kunskap som finns inbäddat i patentet.

In order to reduce the number of casualties and injured from accidents the rescue service must become more efficient and flexible. It is noted that far more people is injured and killed in traffic accidents than from fires. During the daytime the number of accidents in about three times higher than during the night, even so today the number of fire fighters on duty is the same day and night.Two computer models for simulation of different locations of the rescue services are used to determine the best options for placement of the rescue services. A cost-benefit analysis is also used to determine if today's fire stations are efficient for the society from an economical point of view.The results of the different models are that the fire station in Lund is misplaced. The number of ladders in Malmö can be reduced.

This thesis gives suggestions as to how to design a wooden-based wave-power buoy. The thesiswas carried out at Uppsala University in collaboration with the Division of Electricity and AppliedMechanical Engineering. The product was conceived and developed taking into consideration anumber of requirements put forward by the supervisor, Magnus Rahm. The most importantdemands were that the material used should be able to withstand pressure from the sea withoutbeing damaged and that the production costs should be low.Department of Engineering Sciences, Division of Electricity at Uppsala University was visitedseveral times to discuss issues including the various ideas with the supervisor Magnus Rahm, andwith several people in the department.The work started by studying available literature in order to get background information aboutsuitable methods available for the project and to see how similar projects were carried out. Thereason for this was to get a better understanding of this particular problem and how to solve it.After consulting the supervisor, the group decided to construct four different buoys using fourdifferent materials.

This thesis gives suggestions as to how to design a wooden-based wave-power buoy. The thesiswas carried out at Uppsala University in collaboration with the Division of Electricity and AppliedMechanical Engineering. The product was conceived and developed taking into consideration anumber of requirements put forward by the supervisor, Magnus Rahm. The most importantdemands were that the material used should be able to withstand pressure from the sea withoutbeing damaged and that the production costs should be low.Department of Engineering Sciences, Division of Electricity at Uppsala University was visitedseveral times to discuss issues including the various ideas with the supervisor Magnus Rahm, andwith several people in the department.The work started by studying available literature in order to get background information aboutsuitable methods available for the project and to see how similar projects were carried out. Thereason for this was to get a better understanding of this particular problem and how to solve it.After consulting the supervisor, the group decided to construct four different buoys using fourdifferent materials.

This report covers a description of the military support attainable to society and made available by the Swedish Armed Forces, in the event of a crisis. The main focal point is the needs of the rescue services..

AbstractThe purpose of this study was to identify problems that may occur in the execution of a civil engineering project and suggest measures to reduce the risk of errors. The study was conducted in cooperation with a civil engineering company in the Gothenburg area. During two weeks in February 2012, a field study took place on two construction sites where disruption and problems that took more than 15 minutes to correct were noted. During the field study we identified 39 such occurrences in the projects and then these were classified into different categories according to their cause.The two largest categories were "Design" and "Planning", which accounted for half of the errors that were discovered.In the study results were evaluated to decide whether it was possible to detect discrepancies at an earlier stage. The cost to fix an error in the design stage may be significantly less than to correct the problem in production.According to the evaluation, 55% of the errors could have been detected earlier if there was a greater degree of observation for such issues by everyone involved in the project.

Costs of maintenance on combines are a subject of interest thus it constitute a large investment and cost for the individual farmer. Therefore it is important to have up to date knowledge and the right facts to be able to do reliable calculations on one of the largest investments for a farmer. The aim of this study was to compare costs of maintenance on combine/threshingmachine with the computer program for advising environmental issues in agriculture, STANK. Interviews took place and data were collected by handing out questionnaires to 20 farmers. A similar study conducted by Neuman (2003) investigated costs of maintenance and compared these with STANK. The results of this study have also been compared and examined related to data from SLA - Skogs och Lantarbetsgivarförbundet. The result shows that 18 out of 20 combines were given a higher cost of maintenance when using STANK compared to the numbers in this study.

Several technical solutions are ready to step forward as the new generation of propellant, and this report aims to explore the possibility of commercializing fuel cell cars. The report is based on current research and data from today's technology and engineering solutions that are estimated to be commercially realized before 2020.A mapping of today?s different fuel cell options has shown that the most suitable fuel cell option is the Proton Exchange Membrane Fuel Cell, which uses hydrogen as fuel. The report is focusing on a techno-economic well-to-wheel analysis of hydrogen and the energy balance and costs in a system perspective. The basis for this analysis consists of two centralized methods of production, steam methane reforming (SMR), and alkaline water electrolysis.